Estimation of Uplift Capacity of Rapidly Loaded Plate Anchors in Soft Clay

Plate anchors are extensively used in civil engineering constructions as they provide an economical alternative to gravity and other embedded anchors. The rate of loading is one of the important factors that affects the magnitude of soil resistance as well as soil suction force. This article outlines the effect of pullout rate on uplift behavior of plate anchors (70 mm diameter) buried in soft saturated clay by varying the pullout rate from 1.4 mm/min to 21.0 mm/min. The variation of breakout force and suction force with embedment depth and rate of pull are presented. A correlation between the rate of increase of undrained strength of clay and anchor capacity with rate of strain has been established. Finally an empirical equation has been proposed that includes the rate of pull in the estimation of breakout capacity of anchors.     

Assessment of spatial variation in carbon utilization by benthic and pelagic invertebrates in a temperate South African estuary using stable isotope signatures

Stable isotope analyses (δ¹³C and δ¹⁵N) were used to evaluate the spatial variations in carbon flow from primary producers to consumers at two sites in the temperate and permanently open Kariega Estuary on the southeastern coast of South Africa during October 2005 and February 2006. One site was located opposite a salt marsh while the second was upstream of the marsh. Except for significantly enriched δ¹³C values of Zostera capensis and surface sediments near the salt marsh, the δ¹³C and δ¹⁵N signatures of the producers were similar between sites. The invertebrates were clustered into groups roughly corresponding to the predominant feeding modes. The suspension feeders showed δ¹³C values closest to the seston, whereas the deposit feeders, detritivores and scavengers/predators had more enriched δ¹³C values reflecting primary carbon sources that were likely a combination of seston, Spartina maritima and Z. capensis at the upstream site, with an increased influence of benthic algae and Z. capensis at the salt marsh site. The δ¹⁵N signatures of the consumers showed a stepwise continuum rather than distinct levels of fractionation, indicating highly complex trophic linkages and significant dietary overlap among the species. Consumers exhibited significantly enriched δ¹³C values at the salt marsh site, an effect that was attributed to enriched Z. capensis detritus in this region in addition to increased phytoplankton biomass in their diets compared with invertebrates living upstream. The data reinforce the concept that between-site variations in the stable isotope ratios of consumers can result not only from dietary shifts, but also from alterations in the isotope ratios of primary producers.     

共反射面元叠加技术在南海北部莺—琼盆地中的应用

随着莺—琼盆地油气勘探开发的不断深入,2 700 m以下的中深层地震资料品质迫切需要提高,而改善信噪比提高成像质量则是需要深入研究的重点内容之一。基于共反射面元(CRS)叠加在改善中深层地震资料信噪比方面具有理论和技术应用优势,由于考虑了反射层的局部特征和第一菲涅耳带内的全部反射,对复杂地质问题的适应性得以增强,真正实现了高信噪比叠加,从而改善中深层低信噪比区的成像质量。通过理论研究分析、模型试处理及莺—琼盆地实际地震资料处理中具体的应用与试验,取得了明显的效果,即该区中深层地震资料信噪比显著增强,大大提高了解释的可靠程度。总之,共反射面元叠加技术在莺—琼盆地具有较高的推广应用价值。     

关于修改港工钢筋混凝土规范小偏心受压构件正截面强度计算的建议

本文提出在小偏心受压构件正截面强度计算中，取消弯曲抗压强度ｆｃｍ（Ｒｗ），采用轴心抗压强度ｆｃ，这与构件的实际破坏形态相符。对小偏心受压构件正截面强度计算提出了设计建议。特别是对工程上大量应用的矩形截面对称配筋小偏压构件提示了简捷的设计方法，与以往的近似计算方法相比具有物理概念明确，精度高，方法简捷的特点。     

土的周期加载实验的研究

作者对室内土的周期加载实验进行了较全面的综述。包括实验设备、方法、结果及分析模型 ,并对以后的研究提出建议。随着海上石油的开发及海岸构筑物的建设 ,迫切需要对海底土动力学特性进行研究。掌握目前世界在这一领域的研究现状有助于在高超点上开展创新工作和解关键问题。     

南沙海域万安盆地地质构造特征

利用在南沙海域万安盆地所采集的地震、重磁资料及钻井、地质资料，对该盆地的地震反向特征，沉积特征、区域地质、构造特征及构造发展史进行了的简要的论述，本文以该区Ｔｇ深度资料为基础，并利用ＣＣＯＰ年刊发表的新生代基底深度资料，初步圈定了万安盆地的边界，并对盆地二级构造单元进行了划分，将盆地划分为５坳３隆、坳隆相间的构造格局。     

水深对超浅吃水拖轮系柱拖力的影响

超浅吃水拖轮在浅海对钻井平台进行拖带和井位定位时,必须了解超浅吃水拖轮浅水系柱拖力特性,才能充分利用海潮条件和自身能力完成钻井平台的拖带和定位任务。     

珠江口海水密度的研究

用磁力浮沉子密度测量装置,在１５ ～２５ ℃之间的三个温度下测定了珠江口２０ 个水样的密度。结果表明,测定值皆高于相应条件下国际标准海水状态方程的计算值,在海水盐度范围０．０８～３３ ．４４６ ,密度平均偏差范围为２ ．４ ～５４．０ ×１０ － ３ｋｇ／ｍ３ 。测定密度和计算密度的偏差随盐度的降低而增大,与盐度的变化成直线相关：与（Ｃａ２ ＋ ）／Ｓ、ＳＯ４２ － ／Ｓ比和比碱度之间皆呈指数曲线相关。珠江口水样（Ｃａ２ ＋ ）／Ｃ１ 、ＳＯ４２ － ／Ｃ１ 和比碱度平均值分别超出大洋水平均值１７ ．８ ％ 、８ ．２１ ％ 和１５２ ％ ,其余的Ｎａ ＋ ／Ｃ１、Ｋ＋ ／Ｃ１ 和Ｓｒ２ ＋ ／Ｃ１ 比值与大洋水无明显差别,基本类同。珠江口海水的高碱度、高（Ｃａ２ ＋ ）／Ｃ１ 和高ＳＯ４２ － ／Ｃ１ 是造成其海水密度正偏差的主要因素。经计算机拟合,首次导出了珠江口海水密度的状态方程,该方程计算值与实验值的平均标准偏差为±２．５×１０－ ３ｋｇ／ｍ３ 。     

Production of the Crab Elamenopsis kempiHymenosomatidae in the Garmat-Ali Region, Basrah, Iraq

Abstract. The production of the hymenosomatid crab Elamenopsis kempi was calculated for a period of 18 months from a subtidal area of the Garmat-Ali river, southern Iraq. The highest average individual somatic energy was attained in spring. Maximum population biomass and production were attained by the summer cohort and the minimum values were exhibited by the overwintering cohort. The fluctuations of the average population biomass were followed throughout the sampling period. Average total annual population production was 13.2 g DW · m^-2· a^-1 and the P/B ratio was 5.9. These values were compared with those of the most common crustaceans in the region.     

Effect of upward internal flow on dynamics of riser model subject to shear current

Numerical study about vortex-induced vibration(VIV) related to a flexible riser model in consideration of internal flow progressing inside has been performed.The main objective of this work is to investigate the coupled fluid-structure interaction(FSI) taking place between tensioned riser model,external shear current and upward-progressing internal flow(from ocean bottom to surface).A CAE technology behind the current research which combines structural software with the CFD technology has been proposed.According to the result from dynamic analysis,it has been found that the existence of upward-progressing internal flow does play an important role in determining the vibration mode(/dominant frequency),vibration intensity and the magnitude of instantaneous vibration amplitude,when the velocity ratio of internal flow against external current is relatively high.As a rule,the larger the velocity of internal flow is,the more it contributes to the dynamic vibration response of the flexible riser model.In addition,multi-modal vibration phenomenon has been widely observed,for asymmetric curvature along the riser span emerges in the case of external shear current being imposed.