青藏高原东南缘多尺度重力场及构造含义

本文基于EGM2008重力场模型研究了青藏高原东南缘均衡重力异常和多尺度的布格重力异常特征,以鲁甸和景谷地震为例,认识其深部构造环境和动力学过程,为该区域的构造运动和地震孕育环境研究提供依据。结果表明,研究区布格重力异常和均衡重力异常与地质构造格局相关性较好,川滇地块剧烈的区域布格重力异常和非均衡状态与其强烈的地壳变形、断裂及地震活动密切相关。强震多分布在断裂带两侧重力异常的过渡地带和高梯度带,断裂带两侧横向和垂向的显著介质密度差异是强震孕育的深部构造背景。布格重力异常和均衡重力异常揭示的鲁甸、景谷震源区深浅差异性的重力异常特征,暗示鲁甸和景谷地震孕震环境的不同。     

利用AMDAR数据分析厦门、泉州双雷达三维风场反演误差

利用2016年全年进出厦门机场和晋江机场航班的AMDAR(Aircraft Meteorological DAta Relay)数据对双雷达反演风场进行检验,分析了厦门、泉州双雷达风场反演的总体误差,研究结果表明:1)验证了双雷达连线附近区域反演风场的平均绝对误差较大,发现了与两部雷达连线的夹角小于15°和大于165°的区域的反演结果的平均绝对误差明显大于误差的年平均值。2)对于反演风向而言,误差随着高度增加而减小。对于反演风速而言,高度在9 km以下的反演误差在5 m/s左右,而9 km以上的反演误差较小。3)剔除了双雷达连线附近区域(与两部雷达连线的夹角小于15°和大于165°的区域)和反射率因子小于5 dBZ以及等于100 dBZ(剔除非气象回波)的反演结果后,双雷达反演风场误差较小,相对于AMDAR数据的风向年平均绝对误差为29.4°,风速年平均绝对误差为3.28 m/s,总体误差在可接受范围之内,反演结果接近"真值",该反演方法稳定可靠。     

盘山山前地下水与矿泉水污染成因分析

文章利用主成分分析方法,结合揭示变量和样品之间在成因或空间上联系的对应分析,通过SPSS统计分析软件,对盘山山前地区地下水和矿泉水污染成因进行分析。研究表明,盘山山前存在地下水和矿泉水污染;局部范围的污染主要是由于食品厂等企业的排污引起的,污染成分主要是Cl-和NO3—N,主要污染地区是塔院地区,其次是西大佛塔至南营,污染程度与至污染源的距离有关;大部分地区存在三氮面状污染,农业氮肥的施用是其主要原因。     

医巫闾山变质核杂岩中金矿的稳定同位素特征

医巫闾山变质核杂岩中金矿及相关岩石的氢、氧、铅、硅、碳、硫稳定同位素测试结果为:成矿流体δD为-97‰~-72‰,δ18O为0.3‰~3.8‰,在δ18O-δD分布图上,位于变质水、岩浆水与当地雨水之间;其他稳定同位素数据及综合资料均说明,以排山楼金矿为代表的该区金矿成矿具有长期性、复杂性和多源性;医巫闾山变质核杂岩构造系统对区内金矿有一定控制作用.     

ANNUAL VARIATIONS OF TEMPERATURE ON FOUR URBAN UNDERLYING SURFACES AND FITTING ANALYSIS

Based on the observed 2-year temperature data for four kinds of typical urban underlying surfaces, including asphalt, cement, bare land and grass land, the annual variations and influencing factors of land surface temperature are analyzed. Then fitting equations for surface temperature are established. It is shown that the annual variation of daily average, maximum and minimum temperature and daily temperature range on the four urban underlying surfaces is consistent with the change in air temperature. The difference of temperature on different underlying surfaces in the summer half year (May to October) is much more evident than that in the winter half year (December to the following April). The daily average and maximum temperatures of asphalt, cement, bare land and grass land are higher than air temperature due to the atmospheric heating in the daytime, with that of asphalt being the highest, followed in turn by cement, bare land and grass land. Moreover, the daily average, maximum and minimum temperature on the four urban underlying surfaces are strongly impacted by total cloud amount, daily average relative humidity and sunshine hours. The land surface can be cooled (warmed) by increased total cloud amount (relative humidity). The changes in temperature on bare land and grass land are influenced by both the total cloud amount and the daily average relative humidity. The temperature parameters of the four land surfaces are significantly correlated with daily average, maximum and minimum temperature, sunshine hours, daily average relative humidity and total cloud amount, respectively. The analysis also indicates that the range of fitting parameter of a linear regression equation between the surface temperature of the four kinds of typical land surface and the air temperature is from 0.809 to 0.971, passing the F-test with a confidence level of 0.99.     

太平洋潜热通量及其与黄淮夏季降水的关系

研究了1979—2010年太平洋潜热通量的变化特征及其与中国黄淮夏季降水的关系。结果表明,潜热通量的气候场和方差场均存在着明显的季节变化,且各季节气候场的极值中心也是变化幅度较大的区域。黄淮地区降水与前期春季的潜热场相关性最好。定义了黄淮夏季降水指数来研究影响降水的潜热场关键区,发现春季潜热关键区为10°~20°N之间的中东太平洋和热带东太平洋沿岸海区。春季当上述两个海区净潜热通量增多时,后期夏季500hPa和850hPa位势高度异常场中,在太平洋西海岸-阿拉斯加南部一线上均表现为"正—负—正"的分布型,黄淮降水偏多。     

近56a新疆塔里木盆地非对称性增温变化特征分析

基于塔里木盆地25个气象台站1960—2015年的气温数据,采用线性趋势分析、Mann-Kendall检验等方法分析了年、季平均气温、最高气温、最低气温及日较差的时空变化特征。结果表明:56 a来,研究区年平均最高、最低气温在时间变化上呈非对称性增长,年平均最低气温变率为年平均最高气温变率的1.5倍。区域间的变暖幅度大致随纬度差异由北向南递增。不同季节增温幅度亦表现出非对称性,冬季平均气温、最低气温增幅均为全年最高,夏季最低,秋季最高气温增幅最高,夏季最小。四季平均气温的升高主要与最低气温的显著升高关系密切。年平均气温日较差呈显著下降趋势,气候倾向率为-0.19℃/10 a。平均气温和最高气温的气候突变年份基本都发生在1993年前后。     

Impacts of DEM resolution,source, and resampling technique on SWAT-simulated streamflow

The sensitivity of streamflow simulated with the Soil and Water Assessment Tool (SWAT) model to Digital Elevation Model (DEM) resolution, DEM source and DEM resampling technique is still poorly understood. The objective of this study is to compare SWAT model streamflow estimates in the Johor River Basin (JRB), Malaysia for DEMs differing in resolution (from 20 to 1500 m), sources (Shuttle Radar Topography Mission: SRTM v4.1, Advanced Space-borne Thermal Emission and Reflection Radiometer: ASTER GDEM2, EarthEnv-DEM90 and Global Multi-resolution Terrain Elevation Data 2010: GMTED2010) and resampling technique (nearest neighbour, bilinear interpolation, cubic convolution and majority). The key findings were as follows: (1) SRTM v4.1 (Root Mean Square Error (RMSE) = 11.16 m) and EarthEnv-DEM90 (RMSE = 12.4 m) had better vertical accuracy over the JRB compared to the ASTER GDEM2 (RMSE = 16.95 m); (2) Accurate annual streamflow simulations were obtained by using nearly all of the DEM resolutions, as pointed out by a relative error (RE) lower than 7% from 20 to 50 m and from 100 to 800 m DEMs; (3) Prediction errors were the lowest for ASTER GDEM2 (RE = 3.9%), followed by SRTM v4.1 (RE = 5.4%), EarthEnv-DEM90 (RE = 6.3%), and GMTED2010 (RE = 7.3%); (4) the majority and nearest neighbour resampling techniques performed the best (RE of 6.0%), followed by bilinear interpolation (RE of 7.2%) and cubic convolution (7.5%). The study indicates that DEM resolution is the most sensitive SWAT model DEM parameter compared to DEM source and DEM resampling technique for streamflow simulation within SWAT.     

Flow time estimation with spatially variable hillslope velocity in ungauged basins

The automated spatial estimation of the hillslope runoff dynamics is used as a valuable tool for the estimation of the travel time distribution (flow time), a major factor for the hydrologic prediction in ungauged basins. In fact, while the flow time function is usually obtained by rescaling the flow paths with constant channel and hillslope velocities, in this work a spatially distributed kinematic component, as a function of terrain features and in particular slope and land use, is implemented and its influence on the hydrologic response is tested by means of the Width Function Instantaneous Unit Hydrograph (WFIUH) framework. Hillslope surface flow velocities are evaluated by applying different uniform flow formulas within an automated DEM-based (terrain analysis) algorithm. A comparison test of the performances of the Manning, Darcy, Maidment and Soil Conservation Service uniform flow equations is performed for several case studies in Italy pertaining to different climatic and geomorphic conditions. Results provide new insights for a better understanding of the flow time function also introducing a more parsimonious and physically-based calibration scheme of the WFIUH.     

相位相关速度分析方法研究及效果比较

利用统计假设原理及地震信号瞬时相位的相关特性,计算了叠加速度谱。理论模型的试算和实际资料的处理结果表明:与常规速度分析方法相比,该方法具有较高的时间分辨率和速度分辨率,而且抗噪性非常好。该方法不仅不受时窗边界奇异性的影响,还可以有效地避免边缘效应,反映更多反射波信息。该方法对于层速度的精确计算很关键,同时也表明了统计方法用在多道信号估计上是有效的。