广东旅游休闲产业空间布局模式的构建

从大珠三角与其周边地区的地理梯度特征,可见大珠三角在广东地理、经济、文化中的核心地位,其周边地区的边缘地位。这种“核心”与“边缘”或“中心”与“外围”的关系实际上构造了一个相对稳定的旅游系统,前者主要成为旅游客源地,后者主要成为旅游接待地。大珠三角城际在空间上的逐步融合,构成了广东“环大珠三角城市群游憩带”和“点-轴树状游憩网”,以及“南部濒海游憩廊”的旅游休闲产业空间布局模式。     

辛安煤矿1402工作面临空窄煤柱采掘响应及动态加固

随着我国煤炭资源去产能整合煤矿的增多,复采工作面临空窄煤柱采动失稳问题日益凸显,已严重制约矿井安全高效生产。为此,针对辛安煤矿复采1402工作面辅运巷道5号钻场临空窄煤柱稳定性控制的工程难题,运用数值模拟与理论分析相结合的方法,探究5号钻场临空窄煤柱稳定性采掘扰动响应特征,提出5号钻场临空窄煤柱动态注浆加固技术方案并开展现场应用和效果检验。研究结果表明：1402工作面辅运巷道掘进对5号钻场临空窄煤柱稳定性影响较小;在1402工作面回采期间,距5号钻场18~6 m范围,临空窄煤柱集中垂直应力由非对称马鞍形分布逐渐过渡为拱形分布;距5号钻场6 m时,临空窄煤柱承载叠加垂直应力超过煤体强度,塑性区完全贯通,极易破坏失稳;现场采用MP364型注浆材料及专用注浆设备对5号钻场临空窄煤柱前后5 m区域进行加固,动态注浆始终超前工作面10 m,通过深孔窥视和气体监测手段验证临空窄煤柱良好的封堵固化效果,保障了工作面安全回采,为我国整合矿井类似条件下煤柱稳定性控制提供借鉴和参考。移动阅读     

不同围压下岩石中泊松比的各向异性

由弹性波纵横波速比计算得到的泊松比,在利用地震波反演地下结构和物质组成时,可以提供比单纯地利用纵波或者横波波速更强的约束. 为了研究不同岩石中泊松比及其各向异性随围压的变化,选取19块典型的岩石样品,在不同围压下沿相互正交的3个方向同时测量纵、横波速度,并通过计算得到了泊松比及其各向异性. 结果表明,在大部分样品中泊松比各向异性与纵波速度各向异性有一定的相关性,但在有的样品中泊松比各向异性与纵波速度各向异性没有明显的关系,甚至表现出完全相反的变化规律. 由于泊松比也表现出很强的各向异性,在排除微裂隙的影响后有的仍可以达到30髎以上,在利用实际地震波传播数据通过泊松比反演地下物质结构时必须考虑其各向异性的影响.     

石器功能研究的现代模拟实验: 石刀表面残留物中淀粉粒来源分析

淀粉粒分析在国内外环境考古学研究中得到了大量应用,但是目前国内还没有关于淀粉粒分析、石器功能与植物利用关系的现代过程研究。本研究针对石刀这一新石器时代重要的生产和生活工具开展现代过程的模拟实验,尝试利用淀粉粒分析方法验证石刀功能及其加工的植物类型。我们利用打制的简易石片模拟石刀,对未成熟和成熟的小麦(Triticum aestivum L.)进行了共两次割穗操作,提取并观察石片割穗后不同部位表面残留物中的淀粉粒形态及其组合。实验结果表明,石片表面残留物中的淀粉粒主要来源于小麦秸秆; 小麦秸秆淀粉粒的A型和B型淀粉粒(未成熟和成熟小麦秸秆淀粉粒——A+B型淀粉粒,含量分别为90.91 ％ 和92.59 ％ )分别与其成熟籽粒的A型和B型淀粉粒形态、大小相似,具备形态鉴定的特征; 小麦秸秆中还发现了独特的多面体型淀粉粒(未成熟和成熟小麦秸秆多面体型淀粉粒含量分别为9.09 ％ 和7.41 ％ ),这是小麦种子中缺少的类型。根据本次现代实验模拟的结果,考古遗址出土石刀上提取到的淀粉粒很可能来自于植物收割(或切削)过程的残留物,结合淀粉粒分析、石刀形制和出土状况进行分析,可以获取出土石刀功能与古人类植物利用的信息。     

基于Xu-White模型横波速度预测的误差分析

在砂泥岩剖面中,基于Gassmann方程和Xu-White岩石物理模型,利用常规测井资料及实验室岩石物理数据进行横波速度估算.模型中考虑了泥质砂岩中基质性质、泥质含量、孔隙度大小和孔隙形状以及孔隙饱含流体性质对岩石速度的影响.综合分析了模型中砂、泥岩和孔隙流体弹性参数以及孔隙纵横比等输入参数的误差对预测横波速度精度的影响.数值模型试验表明,在Xu-White模型中采用变化的孔隙纵横比估算出的横波速度远远比采用固定孔隙纵横比估算出的横波速度准确.     

西南山区矿调中的地球物理综合找矿技术

为了寻找隐伏矿、深部矿,以四川通安—小牛场地区为研究平台,开展了矿产远景调查,提出了将重力、航磁、地磁、激电等物探手段有机结合,综合应用于西南山区矿产调查的思路,并列举典型实例,逐步分析各种物探异常,最终实现从圈定找矿重点区到确定矿体平面分布形态的目的.以期这一重、磁、电相互结合的模式对今后西南山区的矿产勘查能起到一定的指导作用.     

地下核爆炸地震波二次源特征

层裂是地下核爆炸震源物理过程中最重要的非球对称源过程.对其机制的研究,多基于面波资料,本文基于远场体波资料,利用经验格林函数方法,消除路径及接收场地效应,利用地下核爆炸远场地震波P波数据对震源时间函数进行了反演,结果显示明显的双脉冲特征,该二次源特征不随方位角及震中距变化,说明它源自震源本身,其双脉冲特征与层裂机制相符.     

On the dependence of the saturated hydraulic conductivity upon the effective porosity through a power law model at different scales

We study the scale dependence of the saturated hydraulic conductivity K_s through the effective porosity n_e by means of a newly developed power‐law model (PLM) which allows to use simultaneously measurements at different scales. The model is expressed as product between a single PLM (capturing the impact of the dominating scale) and a characteristic function κ^? accounting for the correction because of the other scale(s). The simple (closed form) expression of the κ^?‐function enables one to easily identify the scales which are relevant for K_s. The proposed model is then applied to a set of real data taken at the experimental site of Montalto Uffugo (Italy), and we show that in this case two (i.e. laboratory and field) scales appear to be the main ones. The implications toward an important application (solute transport) in Hydrology are finally discussed. Copyright © 2016 John Wiley & Sons, Ltd.     

Intensity of in‐lake processes in floodplain lakes within the Bug River zone of fluvial activity

The paper presents a new approach to calculating the erosion and deposition values of floodplain lake basins, the erosion–deposition index (EDI). The EDI is a sum of the basin geometry indices (BGIs), which can be calculated for a separate cross section of the lake. The distribution of processes within the basin was investigated in two selected floodplain lakes with the use of BGIs. Field research was carried out in the Bug River valley from 1 November 2006 to 31 October 2011. The highest erosion was observed in the lakes located close to the parent river. Deposition processes were observed in lakes with high inflow of groundwater. The results showed that EDI values of 48 out of the 71 floodplain lakes ranged from ?0.2 to 0.2. Spatial distribution of erosion and deposition processes within the lake basins resulted from a velocity of water inflowing or flowing through the basin. This was observed especially in contrafluent–confluent lake. Inflow of rivers water via upstream crevasse occurred later than via downstream one, but energy of flowing water was higher, which favoured erosion of this part of the lake basin. Copyright © 2013 John Wiley & Sons, Ltd.     

Bimodal magmatism of the Tucumã area,Carajás province: U-Pb geochronology,classification and processes

Geological mapping of the Tucumã area has enabled the identification of dike swarms intruded into an Archean basement. The disposition of these dikes is consistent with the well-defined NW-SE trending regional faults, and they can reach up to 20 km in length. They were divided into three main groups: (i) felsic dikes (70% of the dikes), composed exclusively of porphyritic rhyolite with euhedral phenocrysts of quartz and feldspars immersed in an aphyric felsite matrix; (ii) mafic dikes, with restricted occurrence, composed of basaltic andesite and subordinate basalt, with a mineralogical assembly consisting dominantly of plagioclase, clinopyroxene, orthopyroxene and olivine; and (iii) intermediate rocks, represented by andesite and dacite. Dacites are found in outcrops associated with felsic dikes, representing different degrees of hybridization or mixture of mafic and felsic magmas. This is evidenced by a large number of mafic enclaves in the felsic dikes and the frequent presence of embayment textures. SHRIMP U-Pb zircon dating of felsic dikes yielded an age of 1880.9 ± 3.3 Ma. The felsic dikes are peraluminous to slightly metaluminous and akin to A2, ferroan and reduced granites. The intermediate and mafic dikes are metaluminous and belong to the tholeiitic series. Geochemical modeling showed that mafic rocks evolved by pyroxene and plagioclase crystallization, while K-feldspar and biotite are the fractionate phases in felsic magma. A simple binary mixture model was used to determine the origin of intermediate rocks. It indicated that mixing 60% of rhyolite and 40% basaltic andesite melts could have generated the dacitic composition, while the andesite liquid could be produced by mixing of 60% and 40% basaltic andesite and rhyolite melts, respectively. The mixing of basaltic and andesitic magmas probably occurred during ascent and storage in the crust, where andesite dikes are likely produced by a more homogeneous mixture at high depths in the continental crust (mixing), while dacite dikes can be generated in the upper crust at a lower temperature, providing a less efficient mixing process (mingling). The affinities observed between the felsic to intermediate rocks of the Rio Maria and São Felix do Xingu areas and the bimodal magmatism of the Tucumã area reinforce the hypothesis that in the Paleoproterozoic the Carajás province was affected by processes involving thermal perturbations in the upper mantle, mafic underplating, and associated crustal extension or transtension. The 1.88 Ga fissure-controlled A-type magmatism of the Tucumã area was emplaced ∼1.0 to ∼0.65 Ga after stabilization of the Archean crust. Its origin is not related to subduction processes but to the disruption of the supercontinent at the end of the Paleoproterozoic.