跨孔条件下椭球模型的视电阻率异常特征

在跨孔条件下，利用积分方程法计算了孔区内外不同位置、不同产状的三维椭球体模型视电阻率异常。根据所得的典型数值模拟结果，借助视电阻率异常信息剖面图，对异常进行研究，总结了异常特征及其变化规律，并以此为基础分析和认识了其他模型的异常特征。     

Paleomagnetic studies of the Late Mesozoic deformation stage in the southern Primorye region

The analysis of paleomagnetic data available for the southern Primiorye region revealed that the studied objects were magnetized under regional remagnetization presumably during the Late Mesozoic folding and this magnetization can be interpreted as being synfolding. The interpretation is based on the parameter that characterizes the folding completion degree immediately before regional remagnetization. It is shown that the relaxation of Late Mesozoic horizontal stresses was irregular. The obtained estimates of the degree of folding completion are consistent with the available geological data and Talitskii’s model for tectonic deformations.     

联合剖面法在地下热水勘探中的应用

联合剖面法是勘查地下热水中一种比较简便的方法,近年来得到了广泛应用。应用此法并结合区域地质和构造特征,了解地热田地质结构、热储、盖层、热储类型等。根据联合剖面装置获得的低阻正交点,推断出断裂构造的位置,为确定井位及温泉开发利用提供重要依据。     

张掖市平山湖地区煤岩层物性规律研究与测井方法应用

通过对平山湖地区11口井的测井资料进行分析,初步掌握了该区含煤岩层的地球物理特性及其在视电阻率、密度、自然伽马、声波时差、自然电位等测井曲线上的响应特征。总结出一套适合该地区的测井方法,如各种测井参数的数据计算方法与曲线处理技巧,为该类地区使用TYSC-3Q测井仪器进行测井提供了参考依据。针对该地区煤层具有中高阻、低密度、低放射性、高时差、弱自然电位的物性特征,以多个实例介绍了煤层在不同测井参数曲线上的识别方法及定量解释原则。     

压裂支撑剂密度测定方法及应用研究

论证了支撑剂体积密度、视密度和绝对密度的概念与内涵,降低概念混用现象的发生。结合SY/T5018-2006和SY/T5018-2014两个标准,重新设计了测定视密度的方法、步骤和计算式。分析得出100 ml规格密度瓶是50 ml规格密度瓶测量值稳定性的7倍以上;用纯水做测试液比煤油的测量值稳定性高出2倍左右;选用100 ml规格的密度瓶,样品质量大于40 g后,会使测量值更趋稳定。支撑剂的密度指标主要用于压裂施工中的产品优选、压裂液携砂能力、地层造缝能力和变密度加砂压裂等方面。建议除非支撑剂为典型的亲油性物质,否则宜选择纯水、100 ml规格密度瓶、40 g左右支撑剂样品组合开展实验为宜。     

磁法在煤火探测中的应用

对采自宁夏汝箕沟煤田上覆盖层的原岩样品在温度作用下的磁性变化进行了系统研究.通过分析煤火区不同燃烧阶段围岩的温度变化情况,对原岩样品进行了模拟“燃烧”试验,试验结果表明,岩石磁性在不同温度作用条件下存在明显差异,从而从岩石磁性的角度讨论了磁法勘探圈定煤田火烧区的可行性.最后,采用人机交互法对地面实测磁异常剖面进行反演,有效地圈定了煤火区着火点的位置及范围.     

1991年江淮暴雨时期的能量和水汽循环研究

通过对 1991年 5～ 7月江淮暴雨期全球范围的水汽输送和不同降水过程中江淮暴雨区及其临近区域的水汽收支和视热源和视水汽汇的计算分析得到了以下结论 :( 1)从水汽输送的机制来看 ,一方面 ,有大量的水汽以定常涡动的方式从孟加拉湾及南海输送到中国江淮地区 ;另一方面 ,江淮地区的瞬变涡动水汽向北输出 ,这可能与江淮地区频繁活动的α和β中尺度系统有关 ,它们将江淮地区汇集的充沛的水汽除了大部分以降水形式降下外 ,剩余部分继续向水汽较少的高纬地区输出 ,以维持全球水汽的平衡。( 2 )在降水过程中 ,局地蒸发项在水汽的供应中或再循环中十分重要 ,其数值一般为降水量的 13 ～ 12 ,这与1998年的降水情况相似。( 3 )在降水过程中 ,暴雨区的水汽主要是从南边界和西边界流入的 ,东边界和北边界则流出 ,并且水汽的流入、流出主要在中低层进行。 (a)在流入边界上 ,水汽通量的垂直分布存在差异 ,暴雨区西边界和南边界的水汽流入的垂直差异可能与其所在的地理位置有密切关系。 (b)对于暴雨区 ,不同强度的降水过程水汽的主要来源有所不同。( 4)在 5次降水过程中 ,视热源和视水汽汇的较大值对应降水的大值区 ,表明了水汽凝结加热对大气加热所起的主要作用。梅雨期降水 ,以对流性降水为主 ,对流活动随季节变化     

AN APPARENT TEMPERATURE MODEL BASED ON THERMAL EQUILIBRIUM

In this paper,a comprehensive analysis and review of the advances in the research of human body comfort degree is made.Based on the studies of human thermal equilibrium theories contributed by previous researchers,different apparent temperature models corresponding to different environments are set up in accordance with the current situation and the characteristics of metabolism in different groups of people in China.After case studies and comparison with present dominant human body comfort degree statistical models,it is proved that the apparent temperature models have high rationality and wide adaptability.Furthermore,the comfort scaling standard according to apparent temperature is suggested,which is suitable for the middle latitude regions in China.     

VICARIOUS RADIOMETRIC CALIBRATION OF SATELLITE FY-ID SENSORS AT VISIBLE AND NEAR INFRARED CHANNELS

For the problem of in-flight test site radiometric calibration for the FY-1D Meteorological Satellite onboard sensor's visible and near infrared channels,this paper described the calibration method,satellite-ground synchronous observation data acquired at China Dunhuang Calibration Test Site,parameter derivation and radiative transfer computation during the calibration,and the calibration result analysis.At FY-1D seven channels (with central wavelength at Channels 1:630 nm,2:865 nm;6:1610 nm;7:455 nm,8:505 nm;9:555 nm;10:932 nm),calibration coefficients obtained during the ground site calibration were compared with that respectively of prelaunch calibration.It is demonstrated that results of FY-1D onboard two sensors' (A and B) at channels 1,2,6 and 10 were close to pre-calibration,and the absolute difference of Gobi desert reflectance computed using test site and pre-launch calibration coefficients was no more than 2%. At other channels,large pre-launch calibration errors resulted in a poor consistency between the test site and pre-launch calibration.The errors can be corrected by the test site calibration results. Based on a rough estimation,the overall error of the calibration was about 6%. The paper also presented the in-flight vicarious calibration at the visible and near infrared channels of FY-1C sensor A which was launched in 1999 and has been put into operational mode since 2002.The results exhibit that FY-1C sensor's response has 23% attenuation at Channels 7 and 8,while only minor degradation at the other channels was found. During the mission,calibrations were also conducted at NOAA-17's Channels 1 and 2 (1:430-830 nm,2:500-1072 nm).A very good consistency has been achieved between the test site and pre-launched calibration results.     

Paleomagnetism and tectonics of Karaginsky Island, Bering Sea

Abstract Rocks from Karaginsky accretionary prism (Karaginsky Island, Bering Sea) yield both prefolding (close to original) and postfolding magnetic vectors. The prefolding vectors suggest that the Maastrichtian–Paleocene volcanic–terrigenous sequences of Karaginsky Island formed at approximately 40°N to 50°N ( n = 45, D _G = 325, I _G = 57, K _G = 6, α_95G = 8, F _G = 15.06, D _S = 332, I _S = 63, K _S = 20, α_95S = 4.5, F _S = 0.3297, F _cr = 2.64) and were not originally part of either Eurasia ( F = 19, Δ F = 6.5) or North America ( F = 17, Δ F = 4.4). The geologic blocks rotated insignificantly counterclockwise about the horizontal plane, suggesting that the structure of Karaginsky Island arose without major strike-slip motions. Analysis of secondary magnetizations (for example, n = 28, D _G = 311, I _G = − 50, K _G = 9, α_95G = 8.7, F _G = 2.44; D _S = 293, I _S = − 41, K _S = 5, α_95S = 11, F _S = 12.04, F _cr = 2.65) reveals that the development of this framework involved at least two stages of deformation. During the second stage the sequences must have been tilted to west-northwest and northwest directions at 45–65°. This agrees with the northwest vergence of the structure of Karaginsky Island.