在MapInfo中实现区域对象样点布设功能

随着GIS在森林资源管理中应用的不断深入，在GIS系统中实现林业专业抽样设计功能是非常必要的。本文使用MapBasic鳊程语言实现三种样点布设功能。操作时，用鼠标点击欲布样点区域，在弹出对话框中作出回答，就能得到样点布设图和样点坐标表。     

两结构高效阻尼控制体系试验研究

本文通过模拟地震动振动台试验，研究了两个相邻结构模型的地震响应，结构模型采用一种高效阻尼装置(High Efficient Damper for Multi—Structure System即HEDMS)连接。非线性时程分析与振动台试验结果都证明了该阻尼装置能高效发挥软钢阻尼器的耗能能力，从而显著减轻两结构模型的地震响应。同时，研究还指出了进行阻尼装置设计时应该注意的一些问题。     

Geohydrological models and earthquake effects at Yucca Mountain, Nevada

 Yucca Mountain, the proposed site for the high-level nuclear waste repository, is located just south of where the present water table begins a sharp rise in elevation. This large hydraulic gradient is a regional feature that extends for over 100 km. Yucca Mountain and its vicinity are underlain by faulted and fractured tuffs with hydraulic conductivities controlled by flow through the fractures. Close to and parallel with the region of large hydraulic gradient, and surrounding the core of the Timber Mountain Caldera, there is a 10- to 20-km-wide zone containing few faults and thus, most likely, few open fractures. Consequently, this zone should have a relatively low hydraulic conductivity, and this inference is supported by the available conductivity measurements in wells near the large hydraulic gradient. Also, slug injection tests indicate significantly higher pressures for fracture opening in wells located near the large hydraulic gradient compared to the opening pressures in wells further to the south, hence implying that lower extensional stresses prevail to the north with consequently fewer open fractures there. Analytical and numerical modeling shows that such a boundary between media of high and low conductivity can produce the observed, large hydraulic gradient, with the high conductivity medium having a lower elevation than the water table. Further, as fractures can close due to tectonic activity, the conductivity of the Yucca Mountain tuffs can be reduced to a value near that for the hydraulic barrier due to strain release by a moderate earthquake. Under these conditions, simulations show that the elevation of the steady-state water table could rise between 150 and 250 m at the repository site. This elevation rise is due to the projected shift in the location of the large hydraulic gradient to the south in response to a moderate earthquake, near magnitude 6, along one of the major normal faults adjacent to Yucca Mountain. As the proposed repository would only be 200–400 m above the present water table, this predicted rise in the water table indicates a potential hazard involving water intrusion. Received: 7 June 1996 / Accepted: 19 November 1996     

Qualitätsanforderungen an Oberflächengewässer: Zielvorgaben,Qualitätsziele und chemische Gewässergüteklassifizierung

Quality Requirements for Fresh Waters: Water Quality Targets, Water Quality Objectives, and Chemical Water Quality Classification In the Federal Republic of Germany, water quality requirements for the protection of inland surface waters against hazardous substances are formulated on the basis of a quality targets derivation concept developed jointly by the Federal Government and the Federal States. The quality requirements were termed “water quality targets” in order to make it clear that the values derived are orientational values rather than legally binding limit values. The international comparison of quality requirements for surface waters shows that, on the whole, the national quality targets ensure a high level of protection. According to present scientific knowledge, impairments of uses, such as supply of drinking water, or risks to aquatic communities need not to be expected if the quality targets are complied with. A comparison of water quality data with the water quality targets makes it possible, on the one hand, to identify those substances whose inputs must be further reduced; on the other hand, it also shows that, for a number of substances, there is no need at present for concern over their adversely water quality. A further differentiation of the aquatic hazard potential of pollutants allows a water quality classification system to be developed on the basis of the quality targets derivation concept. The basic elements of this water quality classification system are presented, and its application is explained by way of examples.     

Untersuchung der Sorptionseigenschaften des Kationenaustauschers KB-2M mit Makronetzstruktur zur Abtrennung von Zinkionen aus Ab- und Spülwässern

Study of Sorptional Properties of the Cation Exchanger KB-2M with Macroreticular Structure for Recovery of Zinc Ions from Sewage and Rinsing Water Although a number of ion-exchange methods have been employed for the recovery of some transition metals from industrial effluents, knowledge about ion-exchange resins with macroreticular structure is poor. The present paper describes the mechanism of sorption on such exchangers and their application for recovery of zinc from sewage rinsing water. Ion exchanger of macroreticular structure are polymers with long-chained cross-linking agents. We have synthesized carboxylic ion-exchange resins by hydrolysis of copolymerisates of methyl acrylate with different cross-linking agents: divinylbenzene, divinyl sulfide, divinyl ester of ethylene glycol and divinyl ester of di- or triethylene glycol. The sorption process on modifications of the carboxylic resins KB-2 of various structure was studied with different methods: potentiometric titration, infrared spectroscopy, electron microscopy, X-ray structural analysis. The initial zinc concentration in rinsing water was 0.05 mol/L at pH from 3 to 6. For the sorption, 0.2…1.0 g of resin were equilibrated with 100 mL of zinc solution. After equilibrium (12 h), the resin was separated from solution. The zinc ions were determined by atomic absorption spectrometry after stripping with 100 mL of 10% sulfuric acid. The distribution ratio D was calculated (D: mmole of Zn sorbed per gram of resin divided by mmole of Zn per millilitre of solution). By means of infrared spectroscopy, the mechanism of sorption of zinc ions from rinsing water was determined. There may be a possibility of the formation of complexes in the cation-exchange resin phase. It was found out in this paper that the cation-exchanger KB-2M of macroreticular structure is the most effective for the sorption of the Zn²⁺-ions from sewage and rinsing water.     

Ein kompetitiver Immunoassay zur Bestimmung des Herbizids Fluazifop in Trink- und Grundwasser

A Competitive Immunoassay for the Determination of the Herbicide Fluazifop in Drinking Water and Groundwater A competitive solid-phase enzyme immunoassay using rabbit polyclonal antibodies was developed for the detection of the herbicide fluazifop [(RS)-2-[4-(5-trifluoromethyl-2-pyridyloxy)phenoxy]propionic acid] in drinking water and groundwater. Present regulatory limits for drinking water in Germany were taken as the critical level. The carrier protein was bovine serum albumin; horseradish peroxidase was used as marker enzyme with 3,3′,5,5′-tetramethylbenzidine as substrate. A high concentration of high-affinity antibodies in the serum, optimization of test conditions (antibody and enzyme tracer concentration, incubation time etc.), and very low cross reactivities to substances of similar structures led to a highly sensitive and specific ELISA with a detection limit below 0.1 μg/L for fluazifop as free acid. On testing the suitability of the assay's use as a screening test with one hundred drinking-water samples, the three samples which had been spiked in the laboratory were recognized as positive with respect to their fluazifop content. Confirmation by gas chromatography-mass spectrometry showed the test results of two other samples to be false positive. False negative results did not appear. The concentration was in the detection limit region of 0.1 μg/L.     

结构动力模型试验相似理论及其验证

通过几何比尺为2的两个有机玻璃模型的结构动力试验，验证了结构动力模型试验的弹性相似律和弹性力一重力相似律。得到了以下结论：(1)大小模型频率符合相似律，一阶频率误差为2．7％、4．1％，二阶频率误差为O、6．05％。弹性相似律比弹性力一重力相似律更适合于频率预测的试验。(2)大小模型的加速度、应变符合相似律，弹性相似律的加速度误差为-1．55％～8．75％，应变误差为O．377％～7．297％。弹性力-重力相似律的加速度误差为3．07％～4．158％，应变误差为6．849％～12．959％。(3)不同相似律大小模型的时问比尺吻合很好。加速度与应变时程曲线的波形一致，既无漏峰也无错峰。     

大同市(平原区)地下水超采现状及治理措施

通过分析大同市平原区地下水超采现状,指出地下水超采容易引起的水环境问题,针对日益紧张的水资源供需矛盾和地下水起采引起的水环境问题,提出了超采区的治理措施.     

Distribution of trace metals in the Odra River system: Water–suspended matter–sediments

Extensive investigations of trace metals concentrations in water, suspended particulate matter (SPM) and bottom sediments of the whole Odra River system were carried out over the years 1997–2000. The vertical distribution of selected metals and their mobility were also studied in the sediment cores from upper and middle river sections. Significant levels of metal contamination were found. Median concentrations (Cd, Pb, Cu, Zn and As) in the SPM and sediments were (mg kg⁻¹) 7.1 and 8.9 Cd, 128 and 146 Pb, 81 and 119 Cu, 1198 and 1204 Zn, 48 and 54 As, respectively. The highest metal pollution of the Odra River solids was found with cadmium, zinc, lead and arsenic, showing high similarity in their frequency distributions in both SPM and sediments. Cd, Zn and As appear to be of particular concern because of the high levels, that appear to be bioavailable, and their high mobility. The exchangeable and carbonate chemical forms of Cd and Zn reached up to 50% of their total amount. Besides the determination of total metal concentration, the metal chemical forms in river solids were investigated. The results of very wide studies of the Odra River system through 4 years suggest that metal pollution decreased, especially for Zn, Pb and Cu. Among all metals studied in the Odra River sediments, substantial reductions of Cd contamination were observed neither in the period after ’97 flood, nor if compared with the earlier results obtained before ’97. No essential differences of the metal contents were observed among the samples for the same river compartment, from the same locality, taken within the five sampling campaigns. The pattern of spatial and vertical metal distributions in the river solids indicates that a variety of sources might be responsible for the contamination; very intensive, historical and current mining and smelting activities probably are the most important ones.     

Temporal and spatial variations in water flow and sediment load in Narmada River Basin, India: natural and man-made factors

The Narmada River flows through the Deccan volcanics and transports water and sediments to the adjacent Arabian Sea. In a first-ever attempt, spatial and temporal (annual, seasonal, monthly and daily) variations in water discharge and sediment loads of Narmada River and its tributaries and the probable causes for these variations are discussed. The study has been carried out with data from twenty-two years of daily water discharge at nineteen locations and sediment concentrations data at fourteen locations in the entire Narmada River Basin. Water flow in the river is a major factor influencing sediment loads in the river. The monsoon season, which accounts for 85 to 95% of total annual rainfall in the basin, is the main source of water flow in the river. Almost 85 to 98% of annual sediment loads in the river are transported during the monsoon season (June to November). The average annual sediment flux to the Arabian Sea at Garudeshwar (farthest downstream location) is 34.29×10⁶ t year⁻¹ with a water discharge of 23.57 km³ year⁻¹. These numbers are the latest and revised estimates for Narmada River. Water flow in the river is influenced by rainfall, catchment area and groundwater inputs, whereas rainfall intensity, geology/soil characteristics of the catchment area and presence of reservoirs/dams play a major role in sediment discharge. The largest dam in the basin, namely Sardar Sarovar Dam, traps almost 60–80% of sediments carried by the river before it reaches the Arabian Sea.