电子经纬仪测量系统在偏置型抛物面天线检测中的应用

将电子经纬仪工业测量系统模拟摄影测量系统,把经纬仪水平角、垂直角观测值化算为虚拟像点坐标观测值,按摄影测量光束法平差进行二台或多台经纬仪间的系统定代间坐标解算,从而实现了经纬仪在任意姿态下的空间坐标测量功能。在光束法平差的基础上开发了中文版ＴＳＳＴ２．００工业测量系统软件。最后介绍了偏置型抛物面天线的数学模型和ＴＳＳＴ工业测量系统在其检测中的应用。     

第14届世界无损检测大会工业CT的层析成像技术

介绍了新近１４届世界无损检测大会有关情况，并对工业ＣＴ的发展动态进行了简要的分析。     

Comparison of runoff characteristics of two adjacent basins in a tropical rainforest using a modified hydrologic cycle model with outflow

We propose a new runoff model including an outflow process that was applied to two adjacent basins (CL, TL) located in Lambir Hills National Park in north‐central Sarawak, Malaysia. Rainfall, runoff, topography, and soil layer thickness were observed. About 19% of annual runoff was observed in the CL basin (21.97 ha), whereas about 46% was observed in the TL basin (23.25 ha). It was inferred that the CL basin has an outflow because of low base flow, small runoff peak, and excessive water loss. By incorporating the outflow process into the HYdrological CYcle MODEL, good agreement between the data generated by the model and that observed was shown, with the exception of the data from the rainless period. Then, the fitting parameters for each basin were exchanged, except for the outflow parameter, and the characteristics of each basin were compared by calculating virtual runoff. As a result, the low base flow of the CL basin was estimated by the movement of the rainwater that escaped from the basin as deep percolation or lateral flow (11% of rainfall). The potential of the CL basin for mitigating flood and drought appeared to be higher than that of the TL basin. This is consistent with the topographic characteristics of the CL basin, which has a gentler slope than the TL basin. Copyright © 2012 John Wiley & Sons, Ltd.     

Role of time variant and invariant terms on soil moisture spatio-temporal variability in a subhumid coastal wetland

The knowledge of soil moisture spatio-temporal variability is highly relevant for water resources management. This paper reports an analysis of the spatial–temporal variability of soil moisture data for a small to medium-scale soil-sensors network in a coastal wetland of southwestern Spain. Measurements were taken from five sites located in the Doñana National Park over the time-period of one hydrological year from September 2017 to September 2018. The total area of the soil-sensors network shows an extension about 25 × 3 km. Soil moisture data was separated into time invariant (the temporal mean of the whole period at each site) and time-variant terms (the deviations of soil moisture from the mean, or anomalies). The time-invariant component was generally the main contributor to the total spatial variance of soil moisture and it was mostly controlled by the groundwater levels in the area. Nevertheless, the time variant terms have a huge effect on soil moisture variability in very dry states. Characteristic convex time-dependent patterns for this field site were found between spatially averaged soil moisture and its variability. This information could be used for the up and downscaling of soil moisture from satellite data. Those patterns of relation between spatial mean and variability of soil moisture were only affected by heavy rainfalls giving rise to hysteretic behaviour. This study shows that even though groundwater level is a time-variant variable, it significantly affects soil moisture's time-variant but also time-invariant terms due to the different average groundwater level depths at the different sites.     

基于环境DNA宏条形码技术的水体无脊椎动物多样性研究：以广州海珠湖为例

于2021年1月,利用环境DNA宏条形码（eDNA）技术,对广州海珠国家湿地公园海珠湖的水体和沉积物进行无脊椎动物多样性和群落结构调查,并比较了eDNA和传统形态学鉴定对浮游动物的检出能力。结果表明：eDNA检出海珠湖无脊椎动物9门16纲34目71科93属137个可操作分类单元（OTUs）;其中,水采样品中共检出9门50属68个OTUs,网采样品中共检出6门27属35个OTUs,沉积物休眠卵样品中共检出9门70属103个OTUs。水采和网采样品中,主要的无脊椎动物均为轮虫动物门和节肢动物门;沉积物中主要的无脊椎动物为环节动物门和节肢动物门。沉积物休眠卵OTU丰富度最高,水采样品的OTU丰富度高于网采样品。比较浮游动物的形态鉴定和eDNA鉴定,发现后者在属水平上能鉴定出更多的种类;形态学鉴定的桡足类（100%）和多数轮虫（58.82%）可被eDNA注释出,而eDNA注释出的多数桡足类（71.43%）和轮虫（58.82%）在形态学鉴定中未发现;eDNA未注释出枝角类。结果表明,eDNA在无脊椎动物调查中具有较高的应用潜力,与传统形态学鉴定组合应用能更全面地了解无脊椎动物的种类和水生生物多样...     

工业CT技术在卫星产品检测中的应用

卫星产品许多都采用了焊接结构。为了保证其使用的安全可靠性,必须对焊缝进行l00％的无损检测。然而对于一些形状复杂的精密电子束焊件,由于产品尺寸小,加之焊缝周围结构的遮挡,使常规方法的应用受到了限制。工业CT技术具有不受试件材料种类、形状结构及表面状况限制的特点,能给出与试件材料密度及尺寸特性相对应的断层扫描图象,分辨率高,在检测复杂构件方面显示出了优势。本文介绍了卫星产品精密复杂焊接件对无损检测技术的具体要求,研究了卫星产品电子束焊缝的工业CT检测方法,包括设备、对比试样、检测工艺、评定方法等,并通过电磁阀、喷注器、自锁阀、减压器、加注/排放阀、单向阀、气滤、过滤器等具体产品检测实例,描述了工业CT技术在卫星产品检测中的应用。实际应用表明：工业CT是检测航天卫星产品精密复杂结构件焊缝缺陷的理想手段,其成象直观,缺陷的定位、定性和定量结果可靠,完全能满足产品的质量控制要求。目前,累计用工业CT检测卫星产品数批若干件,检测焊缝上千条。剔出有超标缺陷的产品40件,避免了隐患。经过工业CT检测的产品,己在"返回式卫星"、"风云二号"、"东方红三号"、"资源一号"、"中星-22号"等型号卫星中取得了成功应用。     

图象恢复在工业CT中的应用

对于以影象增强器为检测系统的目标旋转式工业ＣＴ，分析了其图象退化的因素，采用对一维投影数据进行图象恢复的方法来提高ＣＴ图象质量。文中给出图象恢复公式，从计算机模拟和实验图象恢复的结果可看到所用方法提高了图象清晰度。     

Characterization of industrial wastewaters using gel-permeation chromatography with multicomponent detection

The gel-permeation chromatography system with multicomponent detection of organic carbon, organic nitrogen, organic halogen, and UV/vis absorption measurement is shown to be a useful tool for characterization of industrial wastewaters and wastewater treatment processes. The proposed system was used to investigate biologically treated wastewater from chemical industry, whereby one branch stream was identified to be the main source of persistent halogenated organics. Various treatment processes of pulp mill wastewater were also evaluated revealing that precipitation with aluminium is very effective for the removal of the high molecular fraction whereas the biological treatment is generally less selective. In the biological treatment of tannery wastewaters, it has been shown that the aerobic treatment, in contrast to anaerobic step, causes evident alterations of the composition of the polar DOC fraction. The nitrogen containing compounds are also better decomposed in the aerobic step compared to the anaerobic one.     

Source speciation resolving hydrochemical complexity of coastal aquifers

There is a growing concern of seawater intrusion to freshwater aquifers due to groundwater overexploitation in the eastern coastal belt of Southern India. The problem becomes complex in the regions where industrial effluents are also contaminating the freshwater aquifers. In order to understand the hydrochemical complexity of the system, topographic elevation, static water level measurements, major ion chemistry, ionic cross plots, water type contours and factor analysis were applied for 144 groundwater samples of shallow and deep sources from Quaternary and Tertiary coastal aquifers, located within the industrial zone of 25 km² area near Cuddalore, Southern India. The ionic cross plots indicates dissolution of halite minerals from marine sources and seawater mixing into inland aquifers up to the level of 9.3%. The factor analysis explains three significant factors totaling 86.3% of cumulative sample variance which includes varying contribution from marine, industrial effluent and freshwater sources.