中下扬子区二叠系露头层序地层研究

按新近国际年代地层划分方案（ICS，2000），下扬子区二叠纪地层自下向上分为3统，9阶和相对应的华南传统6阶划分。二叠系从阿瑟尔阶至长兴阶（44Ma)共划分出14个三级层序，每个三级层序平均时限约为3.14Ma，其中“紫松阶”）相当阿瑟尔＋2／3萨克马尔阶）1个（船山组中上部）、“隆林阶、（相当1／3萨克马尔阶＋阿丁斯克阶）2个（分别对应船山组上部和梁山组或镇江组）、“栖霞阶”（相当库班甘德阶＋1／3罗德阶）3个（栖霞组），“茅口阶”（相当于2／3罗德阶＋沃德阶＋卡皮丹阶）4个（孤峰组，茅口组，堰桥组，银屏组和武穴组），吴家坪阶2个（龙潭组或吴家坪组），长兴阶2个（长兴组或大隆组）；共归并为4个层序组（sequence set)。     

武汉市区第四系含水层地下水有机污染敏感性研究

在详细调查武汉市水文地质条件和地下水污染现状的基础上，获得了高精度的武汉市水环境中微量有机污染物的组成数据。所检测出的有机组分达30余种，以苯及相关苯系物为主，污染程度较高的地下水主要分布在人口密集区和工业，商业区，应用改进的DRASTIC模型－地下水污染敏感性评价模型，在GIS平台上，编制了武汉市区地下水污染敏感性分区图。根据其评价结果，建议集中对那些敏感性相对较高的区域采取有效的环保措施，开发利用时应作出风险评价。     

Structural damage detection using the optimal weights of the approximating artificial neural networks

This work presents a novel neural network‐based approach to detect structural damage. The proposed approach comprises two steps. The first step, system identification, involves using neural system identification networks (NSINs) to identify the undamaged and damaged states of a structural system. The partial derivatives of the outputs with respect to the inputs of the NSIN, which identifies the system in a certain undamaged or damaged state, have a negligible variation with different system errors. This loosely defined unique property enables these partial derivatives to quantitatively indicate system damage from the model parameters. The second step, structural damage detection, involves using the neural damage detection network (NDDN) to detect the location and extent of the structural damage. The input to the NDDN is taken as the aforementioned partial derivatives of NSIN, and the output of the NDDN identifies the damage level for each member in the structure. Moreover, SDOF and MDOF examples are presented to demonstrate the feasibility of using the proposed method for damage detection of linear structures. Copyright © 2001 John Wiley & Sons, Ltd.     

Parameter identification of inelastic structures under dynamic loads

The generalized model of differential hysteresis contains 13 control parameters with which it can curve‐fit practically any hysteretic trace. Three identification algorithms are developed to estimate the control parameters of hysteresis for different classes of inelastic structures. These algorithms are based upon the simplex, extended Kalman filter, and generalized reduced gradient methods. Novel techniques such as global search and internal constraints are incorporated to facilitate convergence and stability. Effectiveness of the devised algorithms is demonstrated through simulations of two inelastic systems with both pinching and degradation characteristics in their hysteretic traces. Owing to very modest computing requirements, these identification algorithms may become acceptable as a design tool for mapping the hysteretic traces of inelastic structures. Copyright © 2002 John Wiley & Sons, Ltd.     

Selective controlled base isolation system with magnetorheological dampers

A base isolation system composed of low‐damping isolation bearings and magnetorheological (MR) fluid dampers is described. The MR fluid changes its properties under the influence of a magnetic field resulting in a damper with characteristics that may be modified in real time. This feature enables optimal control under changing excitations in a stable and cost‐effective manner. The voltage is applied according to a selective control strategy. According to the proposed approach the dampers are activated only within a given range of the base displacements. The selective control improves the efficiency of the system and significantly reduces the control forces required for an optimal structural behaviour. Models of five‐ and eight‐storey buildings are used to study the efficiency of the proposed system. Copyright © 2002 John Wiley & Sons, Ltd.     

Multi‐objective optimal design of FLC driven hybrid mass damper for seismically excited structures

Structural vibration control using active or passive control strategy is a viable technology for enhancing structural functionality and safety against natural hazards such as strong earthquakes and high wind gusts. Both the active and passive control systems have their limitations. The passive control system has limited capability to control the structural response whereas the active control system depends on external power. The power requirement for active control of civil engineering structures is usually quite high. Thus, a hybrid control system is a viable solution to alleviate some of the limitations. In this paper a multi‐objective optimal design of a hybrid control system for seismically excited building structures has been proposed. A tuned mass damper (TMD) and an active mass driver (AMD) have been used as the passive and active control components of the hybrid control system, respectively. A fuzzy logic controller (FLC) has been used to drive the AMD as the FLC has inherent robustness and ability to handle the non‐linearities and uncertainties. The genetic algorithm has been used for the optimization of the control system. Peak acceleration and displacement responses non‐dimensionalized with respect to the uncontrolled peak acceleration and displacement responses, respectively, have been used as the two objectives of the multi‐objective optimization problem. The proposed design approach for an optimum hybrid mass damper (HMD) system, driven by FLC has been demonstrated with the help of a numerical example. It is shown that the optimum values of the design parameters of the hybrid control system can be determined without specifying the modes to be controlled. The proposed FLC driven HMD has been found to be very effective for vibration control of seismically excited buildings in comparison with the available results for the same example structure but with a different optimal absorber. Copyright © 2002 John Wiley & Sons, Ltd.     

Active viscous damping system with amplifying braces for control of MDOF structures

The development and the applications of an active controlled viscous damping device with amplifying braces are described. The system of the dampers, defined as active viscous damping system (AVDS), connected to an amplifying brace (AB) is presented herein. Instantaneous control theory with velocity and acceleration feedback is used to obtain the control forces at each time step during an excitation. Control of the damping forces is possible due to the mechanical structure of the proposed AVDS, and the connection to the AB. The proposed system can be efficiently used to enhance the damping of a structure without modifying its stiffness. The added damping forces can be adjusted in a wide range. The efficiency of the presented system is demonstrated by a numerical simulation of a seven‐storey building subjected to earthquakes. The simulation shows a considerable reduction of control forces required for control to the AVDS with AB, compared to the same system without AB. Copyright © 2002 John Wiley & Sons, Ltd.     

基于栅格空间信息定量化的湖南西部地区生态环境综合评价

以湖南西部地区为研究区域,采用遥感影像作为主要数据源,针对区域主要生态问题,利用栅格数据结构为主的数字环境模型,建立了生态环境质量综合评价模型. 对区域生态环境质量的空间分异格局进行了研究,通过将评价结果与数字高程模型迭加分析,研究了生态环境质量的垂直地带性分布规律,探索适合以山高坡陡为主要地貌特征的山区生态评价方法,结果显示,湖南西部地区生态环境综合指数呈正态分布,大部分地区环境质量属一般. 总体环境状况东南部好于西北部,河谷盆地优于山地. 研究表明,利用遥感和地理信息系统技术进行区域生态环境评价,具有数据采集快速、客观,评价和制图自动化,评价结果空间定位精度高,直观性与实用性强等优点.     

青藏高原各拉丹冬地区冰川变化的遥感监测

以位于青藏高原长江源头的各拉丹冬地区冰川为例, 利用2000年的TM数字遥感影像资料、 1969年的航空相片遥感资料、地形图及数字地形模型, 通过遥感图像处理和分析提取研究区小冰期最盛期(LIA)、 1969年和2000年的冰川范围, 并在地理信息系统技术支持下分析该地区冰川的进退情况. 研究结果表明, 该地区1969年冰川面积比小冰期最盛期的冰川面积减少了5.2%, 2000年的冰川面积比1969年的冰川面积减少了1.7%. 从1969年到2000年最大冰川退缩速度为-41.5 m*a-1, 最大冰川前进速度为+21.9 m*a-1. 本区的冰川基本处于稳定状态, 冰川退缩的速度不是太大, 并有前进的冰川存在.     

异珊瑚隔壁的排布系列

异珊瑚原始隔壁数目、后生隔壁的增生部位和方式以及隔壁的排布系列的研究，是探讨异珊瑚的起源、演化和分类的基本前提。通过对3隔壁的Triphyllia和4隔壁的Quadratphyllia二属的研究，结合生物体对称的原则，提出异珊瑚原始隔壁为2条，并认为异珊瑚的后生隔壁发育在原始隔壁所分隔的左右两侧部体腔内缘部位，长隔壁呈树枝状拓布或者末端达中心向某一方面扭曲连接形成轴管构造。依据后生隔壁在体腔内的繁生能力、增殖数量、发生部位、排布方式、分化程度、隔壁始端在外壁中的埋植类型和末端在中心部位的连接类型等方面的不同，异珊瑚隔壁增生大致可划分为7个布系列。