水合物分解对海底边坡稳定影响的数值模拟分析

海底边坡失稳会给人类造成巨大危害,部分海底边坡失稳案例被证实与水合物分解有关。由于海底条件的复杂性,人们很难直接观察水合物分解引起的海底边坡失稳过程。数值模拟可以相对准确地预测水合物分解可能引起的海底边坡失稳状况。通过选用基于ABAQUS软件的有限元强度折减法,模拟海底边坡失稳的过程并得到相应结果,分析了水合物分解程度、水合物带上覆厚度、边坡角度等因素对海底边坡稳定性的影响。结果表明,正常情况下,塑性区首先在坡脚区域出现并逐渐向上发展至坡顶;当水合物分解达到一定程度后,塑性区首先出现在水合物带,随后自水合物带向上发展至坡顶,并和随后在坡脚出现的塑性区形成贯通边坡的塑性带。水合物埋藏越深,越有可能造成大规模的滑坡;边坡角度高于15°时,水合物分解会急剧促进边坡失稳。     

Wave-ice interaction in the North-West Barents Sea

The results of field work on drift ice during wave propagation are analyzed and presented. The field work was performed in the Barents Sea, and the main focus of the paper is on wave processes in the MIZ. A model of wave damping in broken ice is formulated and applied to interpret the field work results. It is confirmed that waves of higher frequencies are subjected to stronger damping when they propagate below the ice. This reduces the frequency of most energetic wave with increasing distance from the ice edge. Difference of wave spectra measured in two relatively close locations within the MIZ is discussed. The complicated geometry and dynamics of the MIZ in the North-West Barents Sea allow waves from the Atlantic Ocean and south regions of the Barents Sea to penetrate into different locations of the MIZ.     

新型硫木质素复合浆液的研制及其性质研究

在原硫木质素浆液的基础上，通过加入适量的无机物（D）可以得到一种新型硫木质素复合浆液，与以前的硫木质素液相比，硫木质素复合浆液强度更高，价格更低廉，浆液胶凝时间更易调控，这种性能优良的新型复合浆液在工程中将有良好的应用前景。     

撬力对螺栓抗拉连接承载力的影响

螺栓抗拉连接中的撬力降低连接的极限承载能力和疲劳性能,在设计中需加以考虑。现行《钢结构设计规范》（GB50017—2003）无相关计算方法的规定。本文利用有限元方法对T形连接抗拉性能进行分析,通过对多个不同尺寸和材料特性的试件进行调查,讨论了各参数对撬力的影响。有限元计算结果和已有分析方法比较发现,AISC—LRFD方法因忽略了螺栓头对翼缘抗弯承载力的提高,低估了翼缘刚度较小情况下的撬力。若对AISC—LRFD计算模型中螺栓线处的弯矩不加以限制,其结果和有限元与试验吻合良好。     

Species selection and assessment of eco-engineering effects of seedlings for biogeomorphological landscape experiments

Landscape experiments of fluvial environments such as rivers and deltas are often conducted with live seedlings to investigate effects of biogeomorphological interactions on morphology and stratigraphy. However, such experiments have been limited to a single species, usually alfalfa (Medicago sativa), whereas important environments in nature have many different vegetation types and eco-engineering effects. Landscape experimentation would therefore benefit from a larger choice of tested plant species. For the purpose of experimental design our objective was to identify fast-germinating and fast-growing species and determine their sensitivity to flow conditions during and after settling, their maximum growth, hydraulic resistance and added bank strength. We tested germination time and seedling growth rate of 18 candidate species with readily available seeds that are fast growing and occur at waterlines, plus Medicago sativa as a control. We selected five species that germinate and develop within days and measured properties and eco-engineering effects depending on plant age and density, targeting typical experimental conditions of 0–0.3 m/s flow velocity and 0–30 mm water depth. Tested eco-engineering effects include bank strength and flow resistance. We found that Rumex hydrolapathum can represent riparian trees. The much smaller Veronica beccabunga and Lotus pedunculatus can represent grass and saltmarsh species as they grow in dense patches with high flow resistance but are readily erodible. Sorghum bicolor grows into tall, straight shoots, which add significantly to bank strength, but adds little flow resistance and may represent sparse hardwood trees. Medicago sativa also grows densely under water, suggesting a use for mangroves and perhaps peat. In stronger and deeper flows the application of all species changes accordingly. These species can now be used in a range of landscape experiments to investigate combined effects on living landscape patterns and possible facilitation between species. The testing and treatment methodology can be applied to new species and other laboratory conditions. © 2019 The Authors. Earth Surface Processes and Landforms Published by John Wiley & Sons Ltd. © 2019 The Authors Earth Surface Processes and Landforms Published by John Wiley & Sons Ltd © 2019 The Authors Earth Surface Processes and Landforms Published by John Wiley & Sons Ltd.     

On the last explosions of carbonatite pipe G3b, Gross Brukkaros, Namibia

 Pipe G3b is part of the Upper Cretaceous carbonatitic Gross Brukkaros Volcanic Field in southern Namibia. The pipe represents the root zone of a diatreme and is located 2800 m west of the rim of Gross Brukkaros, a downsag caldera. The pipe is exposed approximately 550 m below the original Upper Cretaceous land surface. It cuts down into its own feeder dyke, 0.3 m thick. The pipe coalesced from two small pipes and in plan view is 19 m long and 12 m wide. It consists of fragmented Cambrian Nama quartzites and shales of the Fish River subgroup. Despite intensive brecciation, the stratigraphic sequence of the country rocks is almost preserved in the pipe. In addition, the feeder dyke became fragmented too and can be traced in a 2- to 3-m-wide zone full of carbonatite blocks along the southern margin of the pipe. The void space of the breccia is 30–50% in volume. Finally, after the disruption of country rocks and feeder dyke, a little carbonatite magma intruded some of the void space. The breccia of pipe G3b is considered to represent a root zone at the transition from the feeder dyke into a diatreme above. Formation of the breccia required a shock wave thought to have been associated with a last explosion of the diatreme immediately above the present level of exposure. The explosion can be shown to have been phreatomagmatic in origin. Received: 11 October 1996 / Accepted: 6 March 1997     

高地应力下硬岩的本构模型研究

传统的本构模型在模拟高地应力下硬岩破坏的范围和深度方面并不理想。针对高应力下的拉西瓦花岗岩,通过真三轴压缩试验模拟了开挖时应力路径的演化。在摩尔-库仑强度准则、格里菲斯强度准则、德鲁克-普拉格准则、双剪统一强度理论和霍克-布朗强度准则的基础上,考虑十二面单元体主剪面上主剪应力、正应力和静水压力的共同作用,提出了一个有关高应力下硬岩的三剪强度准则。根据试验结果,利用遗传算法全局寻优的功能,搜索出了三剪强度准则的参数。预测样本和与摩尔-库仑强度准则、德鲁克-普拉格准则、双剪统一强度理论的比较表明,该三剪强度准则与试验结果吻合,适用于高地应力下的硬岩。根据试验得到的应力-应变关系曲线,建立了基于三剪强度准则和应变软化的弹-脆-塑性本构模型,并用FLAC3D提供的基于C++的用户自定义模型工具UDM,创建了用户自定义模型的动态链接库,嵌入了FLAC3D软件。采用遗传算法-FLAC方法,搜索得到了基于岩石试样和岩体的本构模型参数。计算结果与实测情况吻合,表明建立的本构模型适用于高地应力下的硬岩,为高地应力下硬岩地下工程的安全性和稳定性分析奠定了基础。     

外加剂对低温水泥浆性能的影响试验研究

为解决在普通硅酸盐水泥（P.O42.5）或混凝土施工中遭遇低温环境而不能顺利凝固的问题。对普遍使用的硅酸盐水泥进行了基础性能测试试验,使用早强剂与高效减水剂对水泥进行调整性能,寻找出最佳的调整方案,对比调整前后水泥浆及水泥石强度等各项数据。结果表明10%早强剂、2‰JSS高效减水剂的调整方案较好地改善了水泥浆的流动性、凝结时间、水化热放热速率、结石率及水泥石的早期强度等问题。研究成果对低温条件下的混凝土施工有一定的参考价值。     

百色重塑膨胀土抗剪强度的试验研究

通过对不同初始含水率、不同干密度下百色重塑膨胀土直剪试验,研究了百色击实重塑膨胀土在不同垂直压力下的峰值强度和残余强度,分析了其抗剪强度的作用机制。研究表明：随着干密度的增加,土体的峰值强度增大,残余强度变化不大;随着上覆荷载的增加,土体的抗剪强度明显增加,表明物理处治技术填筑膨胀土路堤能保证其强度和稳定性;干密度对重塑膨胀土的峰值强度影响较大,而对残余强度影响很小;重塑膨胀土的残余强度与它的结构、应力历史、起始含水率没有关系,而只取决于黏土颗粒的形态、大小、含量和矿物成分等因素。     

频率对K_0固结饱和粘土动力特性影响的试验分析

通过循环三轴试验,研究了k0固结饱和粘土在0.5 Hz、0.1 Hz与0.01 Hz循环应力作用下,循环强度与土样破坏时最终累积孔压的变化。结果表明,当循环频率从0.1 Hz减少至0.01 Hz时,若循环应力作用下三轴土样发生应力反向,k0固结饱和粘土循环强度大约降低3%左右;若没有应力反向,且当循环破坏次数从10变化至1 000时,循环强度的降低不超过1%,若循环破坏次数大于1 000时,循环频率的改变对循环强度基本没有影响。对于有应力反向情况,循环频率减小将导致最终累积孔压比增加;对于无应力反向情况,循环频率改变对最终累积孔压比的影响并不显著。循环频率对最终累积孔压比的影响与其对循环强度的影响一致。