Anthropogenic affects on lake sedimentation process: a case study from Lake Sapanca, NW Turkey

Lake Sapanca in NW Turkey is a fault originated freshwater basin fed by seasonally variable flows of 15 streams. Considerations of lake–river interaction, supported by statistical measures of 47 bottom samples, suggest that sediment transport and deposition within the lake is controlled by two types of human constructed structures in addition to natural factors: (1) the dykes constructed in the front of streams, which feed the lake by strong flows, to prevent the filling of lakebed by coarse-grained sediments; (2) the constructed regulator on the outflowing Çarksuyu stream results in a higher sedimentation rate of clay-sized material on the NE corner of the lake, which is extraordinary in the shelf environment.     

Experimental study on the deterioration and natural remediation of the Ariake Sea tidal mud caused by the sea laver treatment acid practice and the upward seepage of pore water liquid

This study presents a laboratory study of the following two aspects: (1) the influence of sea laver treatment acid on the geoenvironmental properties of Ariake Sea tidal mud, and (2) the natural remediation effect on the sea laver treatment acid contaminated Ariake Sea tidal mud caused by the upward seepage of pore water liquid in the mud. Firstly, the mechanisms of the transport of sea laver treatment acid in the Ariake Sea tidal mud and the generation mechanisms of the upward seepage flow in the Ariake Sea tidal mud are discussed. Secondly, a series of one-dimensional laboratory infiltration tests were carried out to investigate the deterioration of the Ariake Sea tidal mud caused by the sea laver acid treatment practice. Test results reveal that the acid treatment practice caused considerable change in the geochemical properties of the mud in terms of increase in sulfide content and decrease in pH value. After the treatment by the sea laver treatment acid, the sulfide content of the mud even exceeded the safe limit value for the benthos, which represents undesirable living condition for benthos. Thirdly, series of laboratory fresh seawater infiltration tests for the deteriorated Iida site mud were conducted to illustrate this natural remediation efficiency. It is found that with the infiltration of the fresh seawater, the sulfide content of the Iida site mud was considerably reduced and pH value increased to an acceptable range for benthos living in the tidal flat mud. With the increase in the infiltration time and the hydraulic gradient, the remediation efficiency could be increased.     

Geotechnical properties of evaporite soils of the Dead Sea area

The Dead Sea Basin is the lowest point on earth and is tectonically subsiding. During the Holocene Period the climate became much drier with increasing evaporation whereby initially lacustrine sediments were deposited from the non-marine brines, giving a multi-layered stratigraphy of lime carbonate and halite sediments. The lime carbonate sediments are comprised of laminated, clay to silt sized, clastic sediments (calcite) and authigenic aragonite and gypsum. The halite commonly appears as rock salt. Chemical industries, based on harvesting the salts from the Dead Sea, have developed on both the Israeli and the Jordanian sides of the basin. The lime carbonate soils are used for dike construction, and these soils, together with significant salt layers, are encountered in the foundations of structures, dikes, and tailings dams, requiring definition of their geotechnical properties. Use of standard soil mechanics definitions and testing approaches for the lime carbonates have been found inapplicable, particularly in view of their exceptionally high saline content, and it has been necessary to develop new concepts. The rock salt is encountered at shallow depths, with unit weights considerably lower than those usually discussed in the literature, and with correspondingly different mechanical properties. The geotechnical properties of these soils, and approaches used to define them, are discussed in the paper.     

Planktonic foraminifers in the southern Bering Sea: Changes in composition and productivity during the Late Pleistocene-Holocene

Taxonomic composition and distribution of planktonic foraminifers are studied in section of Core GC-11 that penetrated through Upper Quaternary sediments of the Bowers Ridge western slope, the southern Bering Sea. As is shown, structure of foraminiferal assemblage and productivity have varied substantially during the last 32000 calendar years in response to changes in surface water temperatures and water mass circulation in the northern part of the Pacific, the Bering Sea included. The productivity was maximal during deglaciation epoch, being notably lower in the Holocene and minimal at the glaciation time.     

First U–Pb SHRIMP age of the Hauterivian stage, Neuquén Basin, Argentina

A high-resolution ion-microprobe (SHRIMP) U–Pb zircon age from a tuff layer intercalated in the ammonoid bearing sedimentary succession of the Neuquén Basin in Argentina provides a robust geochronologic date to add to the absolute ages and to improve the relative chronology of the Early Cretaceous Hauterivian stage. The tuff layer appears interbedded between shales of the upper member (Agua de la Mula) of the Agrio Formation within the Spitidiscus riccardii ammonoid zone (base of the Late Hauterivian) yielding a date of 132.5 ± 1.3 Ma. This date confirms and supports an accurate correlation between the ammonoid biostratigraphy of the Neuquén Basin with the Western Mediterranean Province of the Tethys during the Early Cretaceous and matches with the most recently published time scale. It also casts doubts on the validity of K–Ar ages on glauconite-grains recently reported from the Lower Cretaceous of the Vocontian Basin of France.     

Quantitative sinkhole hazard assessment. A case study from the Ebro Valley evaporite alluvial karst (NE Spain)

Quantitative sinkhole hazard assessments in karst areas allow calculation of the potential sinkhole risk and the performance of cost-benefit analyses. These estimations are of practical interest for planning, engineering, and insurance purposes. The sinkhole hazard assessments should include two components: the probability of occurrence of sinkholes (sinkholes/km² year) and the severity of the sinkholes, which mainly refers to the subsidence mechanisms (progressive passive bending or catastrophic collapse) and the size of the sinkholes at the time of formation; a critical engineering design parameter. This requires the compilation of an exhaustive database on recent sinkholes, including information on the: (1) location, (2) chronology (precise date or age range), (3) size, and (4) subsidence mechanisms and rate. This work presents a hazard assessment from an alluvial evaporite karst area (0.81 km²) located in the periphery of the city of Zaragoza (Ebro River valley, NE Spain). Five sinkholes and four locations with features attributable to karstic subsidence where identified in an initial investigation phase providing a preliminary probability of occurrence of 0.14 sinkholes/km² year (11.34% in annual probability). A trenching program conducted in a subsequent investigation phase allowed us to rule out the four probable sinkholes, reducing the probability of occurrence to 0.079 sinkholes/km² year (6.4% in annual probability). The information on the severity indicates that collapse sinkholes 10–15 m in diameter may occur in the area. A detailed study of the deposits and deformational structures exposed by trenching in one of the sinkholes allowed us to infer a modern collapse sinkhole approximately 12 m in diameter and with a vertical throw of 8 m. This collapse structure is superimposed on a subsidence sinkhole around 80 m across that records at least 1.7 m of synsedimentary subsidence. Trenching, in combination with dating techniques, is proposed as a useful methodology to elucidate the origin of depressions with uncertain diagnosis and to gather practical information with predictive utility about particular sinkholes in alluvial karst settings: precise location, subsidence mechanisms and magnitude, and timing and rate of the subsidence episodes.     

南海西部海域新生代构造古地理演化及其对油气勘探的意义

南海西部海域构造复杂,主要发育有北东—北东东向、北西向和近南北向3组深大断裂。其中,北西向断裂与板块汇聚、碰撞有关,多具走滑性质;北东—北东东向断裂具有与中国东部裂谷盆地相似的发育特点,呈张扭性质;近南北向断裂可能是南海在扩张活动期间于洋、陆壳过渡部位形成的走滑调节断裂,是洋盆扩张的西部边界。新生代里,南海经历了4次成盆事件与3期扩张活动,盆地经历了古新世—中始新世陆缘断陷、渐新世—早中新世扩展与中中新世以来的热沉降3个演化阶段。陆缘断陷阶段的充填系列主要是北东—北东东向与北西向的河流—冲积扇、湖泊沼泽等陆相沉积及火山岩等;盆地扩展阶段表现为中-小型断陷、断-坳陷逐渐复合与联合为大-中型坳陷,古地理格局逐渐由河流与湖沼陆相环境演变为滨海至浅海相的沉积环境;热沉降阶段的成盆活动逐渐减弱以至停止,地层表现超覆,盆地出现联合迹象。结合以往勘探与油气资源调查成果分析,认为南海西部海域陆架陆坡区发育的大-中型沉积盆地石油地质条件良好,蕴藏着丰富的油气资源,勘探潜力巨大。     

渤海湾盆地新生界生油岩系底界面温度分布

依据渤海湾盆地2000余口测温井的地温梯度数据、地层岩性描述、分层数据以及钻井资料,计算了该盆地各生油岩系底界面的温度。统计结果表明:渤海湾盆地沙河街组大部分凹陷区地层底界面温度介于90℃至150℃,目前仍具有大量生油的温度条件,而在隆起或一些凸起地区,该地层组段温度普遍小于90℃,未能达到生油的温度指标。东营组和孔店组地层也仍具有一定的生油温度条件。研究还表明:地层温度与地层界面埋深密切相关,温度随界面埋深的增大而升高,沉积厚度大的凹陷区地层界面温度大于沉积厚度小的凸起区或斜坡地带,说明地层界面埋深是决定地温高低的主要控制因素,而地温梯度对地层界面温度的影响相对较小。     

松辽盆地三肇凹陷葡萄花油层成藏模式初探

运用源控含油气系统理论与综合分析技术,按成藏“层次分析”方法,通过对生、储、盖、圈(闭)静态要素及其内生、排、运、聚、散(失)动态过程的综合研究,对松辽盆地中央坳陷的三肇凹陷葡萄花油层成藏条件进行探讨,提出了以次级凹陷为中心、不同类型的油气聚集带紧邻并围绕次级凹陷最低部位呈环带状分布的大型凹陷内成藏模式,并进一步提出永乐次级凹陷中心及其三级聚油环带及徐家围子次级凹陷以西为"网式"运聚特征;在凹陷级成藏模式的指导下,通过对大面积密井网开发区综合解剖,提出三级构造带中单个的局部构造圈闭(群)、单个的(局部构造——)岩性圈闭(群)控油和成藏规律,为认识本区基本控油单元、油水分布规律、油气勘探及扩大新探区提供重要的理论依据。     

川中—川南地区上三叠统沉积相研究

综合分析岩心、露头剖面和测井资料,认为川中—川南地区上三叠统发育三角洲相和湖泊相,其中,三角洲相可进一步划分为三角洲平原、三角洲前缘和前三角洲三个亚相,湖泊相则可细分为滨湖和浅湖两个亚相。不同时期三角洲相和湖泊相发育程度不同。须一段、须三段、须五段和须六段以湖泊沉积为主,由东向西,水体逐渐加深。须二段和须四段以三角洲沉积为主,湖泊沉积分布范围较小。须二段发育时期,研究区北部构造活动强烈,沉积物供给充分,三角洲相主要由北向南延伸;须四段沉积时期,由于北部构造活动逐渐减弱,东南部沉积物供给增加,三角洲相主要由东南向西北方向延伸。随着周缘构造活动的变化,研究区沉积范围逐渐扩大。早期沉积范围仅局限于宜宾—泸州以北地区,中晚期沉积范围扩大,宜宾—泸州以南地区开始接收沉积。