This article describes absolute calibration results for both JASON-1 and TOPEX Side B (TSB) altimeters obtained at the Lake Erie calibration site, Marblehead, Ohio, USA. Using 15 overflights, the estimated JASON altimeter bias at Marblehead is 58 ± 38 mm, with an uncertainty of 19 mm based on detailed error analysis. Assuming that the TSB bias is negligible, relative bias estimates using both data from the TSB-JASON formation flight period and data from 48 water level gauges around the entire Great Lakes confirmed the Marblehead results. Global analyses using both the formation flight data and dual-satellite (TSB and JASON) crossovers yield a similar relative bias estimate of 146 ± 59 mm, which agrees well with open ocean absolute calibration results obtained at Harvest, Corsica, and Bass Strait (e.g., Watson et al. 2003). We find that there is a strong dependence of bias estimates on the choice of sea state bias (SSB) models. Results indicate that the invariant JASON instrument bias estimated oceanwide is 71 mm, with additional biases of 76 mm or 28 mm contributed by the choice of Collecte Localisation Satellites (CLS) SSB or Center for Space Research (CSR) SSB model, respectively. Similar analysis in the Great Lakes yields the invariant JASON instrument bias at 19 mm, with the SSB contributed biases at 58 mm or 13 mm, respectively. The reason for the discrepancy is currently unknown and warrants further investigation. Finally, comparison of the TOPEX/POSEIDON mission (1992-2002) data with the Great Lakes water level gauge measurements yields a negligible TOPEX altimeter drift of 0.1 mm/yr. 相似文献
Despite the severity of tropical cyclone ‘Winifred’, which crossed the Great Barrier Reef on 1 February 1986, there were little long-term effects on lagoon surface sediments from reefs in its path. Short-term effects were apparent only at one particularly exposed area. These were: an increase in proportion of the coarse fraction, the establishment of sand ripples, and the destruction of the mounds produced by callianassid shrimps (normally the dominant topographic feature). Within six weeks this area was indistinguishable from a typical reef lagoon. This is probably the result of sediment reworking by callianassid shrimp, involving selective burial of the coarse fragments and transport to the surface of finer particles. Sediment turnover rates by callianassids are commensurate with change to the sediment within the relatively short period observed. The sediment fauna responded quickly to the changes in sediment type. Immediately after the cyclone the disturbed area supported a fauna typical of the coarse sediments on the shallow reef flat, as the sediment reverted to a more normal type so the fauna changed back to that typical of a reef lagoon. 相似文献
The formation of incised valleys on continental shelves is generally attributed to fluvial erosion under low sea level conditions. However, there are exceptions. A multibeam sonar survey at the northern end of Australia's Great Barrier Reef, adjacent to the southern edge of the Gulf of Papua, mapped a shelf valley system up to 220 m deep that extends for more than 90 km across the continental shelf. This is the deepest shelf valley yet found in the Great Barrier Reef and is well below the maximum depth of fluvial incision that could have occurred under a − 120 m, eustatic sea level low-stand, as what occurred on this margin during the last ice age. These valleys appear to have formed by a combination of reef growth and tidal current scour, probably in relation to a sea level at around 30–50 m below its present position.
Tidally incised depressions in the valley floor exhibit closed bathymetric contours at both ends. Valley floor sediments are mainly calcareous muddy, gravelly sand on the middle shelf, giving way to well-sorted, gravely sand containing a large relict fraction on the outer shelf. The valley extends between broad platform reefs and framework coral growth, which accumulated through the late Quaternary, coincides with tidal current scour to produce steep-sided (locally vertical) valley walls. The deepest segments of the valley were probably the sites of lakes during the last ice age, when Torres Strait formed an emergent land-bridge between Australia and Papua New Guinea. Numerical modeling predicts that the strongest tidal currents occur over the deepest, outer-shelf segment of the valley when sea level is about 40–50 m below its present position. These results are consistent with a Pleistocene age and relict origin of the valley.
Based on these observations, we propose a new conceptual model for the formation of tidally incised shelf valleys. Tidal erosion on meso- to macro-tidal, rimmed carbonate shelves is enhanced during sea level rise and fall when a tidal, hydraulic pressure gradient is established between the shelf-lagoon and the adjacent ocean basin. Tidal flows attain a maximum, and channel incision is greatest, when a large hydraulic pressure gradient coincides with small channel cross sections. Our tidal-incision model may explain the observation of other workers, that sediment is exported from the Great Barrier Reef shelf to the adjacent ocean basins during intermediate (rather than last glacial maximum) low-stand, sea level positions. The model may apply to other rimmed shelves, both modern and ancient. 相似文献
Faulting in Middle Jurassic reservoirs occurred at shallow depth during regional extension. Clean sandstones (<15% clay) deformed without significant grain fracturing and permeability reduction. Faults in impure sandstones (15–40% clay) experienced significant syn-deformation compaction and permeability reduction. Enhanced compaction during deeper burial reduced their permeabilities further from an average of 0.05 mD at <2.5 km to 0.001 mD at >4 km. Clay-rich sediments (>40% clay) deformed to produce clay smears with very low permeabilities (<0.001 mD). Faulting in the Rotliegendes occurred at greater depth during both basin extension and inversion. Extensional faulting produced cataclasites with permeability reductions of <10–>106; their permeabilities range from 0.2 to 0.0001 mD and are inversely related to their maximum burial depth. Faults formed or reactivated during inversion experienced permeability increase. These results can be extrapolated to other hydrocarbon reservoirs if differences in stress and temperature history are taken into account.The permeability of most (>80%) faults is not sufficiently low, compared to their wallrock, to retard single-phase fluid flow on a km-scale. Nevertheless, most faults could retard the flow of a non-wetting phase if present at low saturations. It may be necessary to incorporate the two-phase fluid flow properties of fault rocks into reservoir simulators using upscaling or pseudoisation techniques. Fault property data should be calibrated against production data before it can be used confidently. 相似文献