分布式传感器网络系统的网络预测控制

本文针对分布式传感器网络系统的Fornasini-Marchesini （FM）状态空间模型,对系统的预测控制器设计问题进行研究.特别是针对所考虑的二维FM传感器网络系统,提出了一种新的网络预测控制方案来补偿通信时滞.首先,根据李雅普诺夫稳定性理论,给出了二维系统保持稳定的充分条件;然后利用稳定性条件,提出了一种新的预测控制器设计策略并保证系统的控制性能;最后,通过一个数值实例验证了所设计控制器的有效性.     

SL3-1型双翻斗雨量传感器常见故障处理及误差调节

通过对SL3-1型双翻斗雨量传感器结构和工作原理进行分析,找出雨量传感器易发生故障现象、原因和维修方法,总结雨量传感器在校准过程中的注意事项和误差调节方法,供同行借鉴参考。     

电偶源频率电磁测深视电阻率多参量联合反演效果检验

通过大量的数值模拟试验 ,对电偶源频率电磁测深 (FEMS)视电阻率多参量联合反演的效果进行了检验和对比 .结果表明 ,多参量联合反演具有较快的收敛速度和较高的拟合精度     

Long-term Sensor Drift Found in Recovered Argo Profiling Floats

We recovered three Argo profiling floats after 2 to 2.5 years of operation, and recalibrated their temperature, conductivity, and pressure sensors. The results demonstrate that these floats exhibited a significant drift in salinity of −0.0074 to −0.0125, primarily due to the conductivity sensor drift. Combined with the recalibration result for another previously recovered float, the indication is that the negative salinity drift increases nearly in proportion to the operating period of floats. The increasing rate is −0.0041 (±0.0015) year⁻¹, which yields a salinity drift of −0.016 (±0.006) for the expected float lifetime of four years. The present result suggests that reducing the float surfacing time would improve the accuracy of the salinity measurements.     

高精度CTD剖面仪电导率传感器的研究和实验

高精度CTD剖面仪是海洋863项目的重要组成部分，是海洋调查和水文观测必不可少的仪器，本文详细论述了CTD剖面仪中电导率传感器的研制方法和过程，并给出传感器现已达到的水平，提出还需要进一步进行的工作和深入研究的问题。     

长偶极大功率可控源电磁波响应特征研究

地球物理学中关于电磁波勘探研究通常采用的是地球半空间模型.然而,对于几十公里的有限长电缆源（长偶极源）,远距离电磁波场探测必须要考虑电离层的影响,它是一个全空间问题.关于包含电离层、空气层和地球介质（我们称“地-电离层”模式）的电磁波场特征的研究在国外较少,国内几乎是空白.本文采用全空间积分方程法首先对小尺度的可控源电磁波场特征进行了研究,由于此时电离层的影响可忽略,它应该和半空间成熟的CSAMT模拟结果一致,对比结果表明,二者是一致的,验证了全空间模拟方法的可靠性和有效性.随后进行了50 km长电缆电离层和空气层高度都为100 km的“地-电离层”模式大尺度电磁波场模拟,以探讨大尺度可控源电磁波场的特征.给定频率的“地-电离层”模式电磁场的衰减曲线表明长电缆远距离电磁波场由于受电离层的作用存在衰减逐渐变小的过渡场和衰减变小的波导场.为了探讨复杂介质“地-电离层”模式电磁波特征,对“地-电离层”模式的典型地盾和地台多层介质模型进行了数值模拟,得到了偶极源长度50 km、电流200A、收发距离远达1600 km和2500 km的合理的电磁场结果.最后,对一简单含油储层结构模型进行了长偶极、大功率、远距离电磁波场响应计算.储层横向不均匀复杂结构模拟的结果表明,考虑电离层和大气层的“地-电离层”模式大尺度深层复杂介质模拟时,电磁场对深部目标体仍有很好的异常响应.     

Electromagnetic emissions during dilating fracture of a rock

A lot of experiments on electromagnetic emissions (EMEs) have been reported under axial compressive fracture, shear fracture, indentation fracture and stick–slip (friction) in lab and blasting in situ, but there are rare reports on the in-lab experimental work on EMEs during dilating fracture of a rock which is helpful in studying and understanding EMEs related to slow earthquakes and the earthquakes due to volcanic activities and water level changes of reservoirs. Therefore, in the present paper in order to check whether there are detectable EMEs during dilating fracture of a rock in lab, dilating fracture experiments were conducted. The dry cuboid specimens of initially intact granodiorite and limestone were tested inside magnetic field free space (MFFS) at room temperature. We arranged evenly 20 EME antennas whose resonance frequencies range from 2.5 kHz to 540 kHz close to rock specimens. Our experimental results strongly indicate that detectable EMEs could generate during dilating fracture of a rock. They were recorded only associated with some but not all phases of fracture. Their waveforms often took on the trend that a peak arrived at first and then attenuated sharply and followed by a series of low-amplitude oscillations. The electromagnetic (EM) signals after eliminating the effects of EME antennae via deconvolution had the maximum peak-to-peak amplitudes of about 80.0 mV and 40.5 mV for granodiorite and limestone, respectively. Their main spectral components often concentrated in the band of several kHz to ∼60 kHz and of several kHz to ∼280 kHz. The emission of electrons and charged particles from fracture surfaces and/or micro-fracture electrification could be possible mechanisms for our experimental results.     

国外遥感卫星发展简介（1）

从美国发射其第一颗遥感卫星一陆地卫星－1算起的30余年里，世界范围内商业遥感卫星技术已经有了巨大的进步，越来越多的国家和国际团体拥有自己的遥感卫星。除了更多各类的遥感器得以使用外，卫星的图像分辨率和覆盖能力也有了很大的改进。未来的发展更加令人振奋。国外遥感卫星（包括已经发射和计划要发射的卫星）简介是根据从国内外出版物中获得的信息整编而成，旨在给遥感应用提供一个现在和未来图像信息源的总的概念。     

面向应用的CBERS-02星高分辨率相机成像数值模拟技术框架

技术框架研究的目标是准确仿真卫星高分辨率相机成像过程中辐射和几何质量的下降情况,从应用方的角度建立评价高分辨率卫星相机在国土资源领域的应用潜力和技术框架,并以CBERS-02B星HR相机在轨成像模拟为例进行了原理验证,同时对今后以国土资源应用评价为目标的高分辨率相机在轨成像模拟改进方案提出了建议。     

Parallel finite element algorithm with domain decomposition for three-dimensional magnetotelluric modelling

We present a new finite element (FE) method for magnetotelluric modelling of three-dimensional conductivity structures. Maxwell's equations are treated as a system of first-order partial differential equations for the secondary fields. Absorbing boundary conditions are introduced, minimizing undesired boundary effects and allowing the use of small computational domains. The numerical algorithm presented here is an iterative, domain decomposition procedure employing a nonconforming FE space. It does not use global matrices, therefore allowing the modellization of large and complicated structures. The algorithm is naturally parallellizable, and we show results obtained in the IBM SP2 parallel supercomputer at Purdue University. The accuracy of the numerical method is verified by checking the computed solutions with the results of COMMEMI, the international project on the comparison of modelling methods for electromagnetic induction.