图形软件在编辑出版专题地图中的应用研究

计算机制图(CAC)和电子出版系统的普及和推广,从根本上改变了传统的地图生产工艺。本文结合制图实践,讨论了应用Coreldraw图形软件编辑出版专题地图的适应性、系统条件和工艺流程,并总结了一些制图经验和应该注意的若干问题。     

重力插值方法研究

为了根据离散观测数据构制连续空间重力变化图像，分析和讨论了３种数值插值方法，计算结果表明多面函数方法插值精度最高。由于逐步回归分析筛选核函数中心点的计算繁琐，文中提出根据分形理论和Ｓｈａｎｎｏｎ取样定理来确定核函数中心点。对滇西试验场进行模拟试算，插值精度可达到４～５（１０－８ｍｓ－２）。     

专项气象服务经济效益的评价理论与技术

当前，由于缺乏对气象服务投入量与产出量准确而完整的统计，要对气象服务的各种经济效益作出总体评价是困难的。然而，在专项气象服务中，却不乏原始、完整而准确的资料。作者从此出发，讨论了专项气象服务经济效益评价的理论。并通过实地调查，以彭州市气象局几项专项气象服务为例探讨了评价技术。     

APPLICATION OF MAP AND FILE INFORMATIONVISUALIZATION SYSTEM TO COMPREHENSIVEDIVISION OF NATURAL DISASTERS- Takingthe ChangjiangValleg as an Example

In recent years，scholars at home and abroad have method，and that vanous disasters would be analyzed assynthetically studied natural dlsaste‘theoretically and an Integral．SHI Peilun（1991）putforwad a scientificmethodologlcally，as well as its cases analys。s（CND，term—regional disaster system，which Indicates that1987； MA et al，1990； MARBLE，1990； NE et al，the situation of a disaster（calamity loss）results from1999； PATAK et al，1982； SHI，1991；VAN et al，h…     

LAMOST总控系统程序设计

国家重大科学工程项目LAMOST总控系统的程序设计是一个庞大的软件工程．其总控系统下共包括8个既相互独立又互有关联的子系统．如何通过良好的软件设计方法来处理好这8个子系统之间的关系使其协调运转，以及如何确保软件开发的可维护性、可持续性是研究重点．     

天文光干涉与综合孔径技术的发展

本文简单介绍了光干涉与综合孔径技术发展的历史、国际上用于天文观测的一些著名光干涉仪的技术特点和进展、以及近年来我国开展的与光干涉 ,综合孔径技术有关的工作 ,最后简要介绍了在光学综合孔径技术领域所发展的光纤与集成光学等新技术     

用PCI中断实现射电望远镜跟踪的方法

讨论运用PCI 9054(美国PLX公司生产的接口芯片)作为接口芯片的PCI(Peripheral Component Interconnect)板卡的软硬件设计,以实现天线跟踪的两个时间同步中断。利用标准秒信号中断作为系统时钟同步信号,并同步产生时间间隔为20ms(或40、50ms,可选)的中断信号,来处理天线跟踪指令输出。中断信号通过PCI中断口INTA#接入计算机,在驱动中识别不同的中断信号,并在应用程序响应中断处理后,命令ACU(Antenna Control Unit)机,实现射电天文望远镜的同步跟踪。其控制过程分3部分阐述:硬件设计、驱动程序设计、安装及应用;着重讨论了前两者的设计方法及思路。     

区域GPS网实时计算可降水量的若干问题

目前地基GPS气象学测得的可降水量 (PWV )精度好于 2mm ,但在利用区域GPS网实时计算每个测站上空的PWV时 ,要涉及到很多常规GPS资料处理时所忽略的问题 ,如需考虑数据处理软件和计算方式的选择、站坐标的确定和约束、轨道的使用方法、网外辅助站最佳数量的确定、海潮对实时计算PWV的影响以及实时应用于气象服务时的端部效应等问题。利用上海GPS综合应用网获取的 2 0 0 2年 6、7月份长江三角洲地区入梅前后的数据 ,分析了利用区域性的GPS网实时计算高精度的PWV时要解决的各种问题 ,探讨了其数据处理方案     

利用高光谱数据进行植被生化成分反演方法研究

高光谱数据包含着丰富光谱信息,能够定量地分析物质成分^[1]。由高光谱数据,可以运用多元逐步线性回归方法反演植被生化组分含量,从而达到监测植被生长状况的目的^[2]。本文具体介绍了多元逐步线性回归方法,及其在氮、木质素和纤维素含量估算中的应用。     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.