Thermal evolution of the Tertiary Shimanto Belt, Muroto Peninsula, Shikoku, Japan

Abstract The Shimanto accretionary complex on the Muroto Peninsula of Shikoku comprises two major units of Tertiary strata: the Murotohanto Sub-belt (Eocene-Oligocene) and the Nabae Sub-belt (Oligocene-Miocene). Both sub-belts have been affected by thermal overprints following the peak of accretion-related deformation. Palaeotemperatures for the entire Tertiary section range from ～ 140 to 315°C, based upon mean vitrinite reflectance values of 0.9–5.0%R_m. Values of illite crystallinity index are consistent with conditions of advanced diagenesis and anchimetamorphism. Illite/mica b₀ lattice dimensions indicate that burial pressures were probably no greater than 2.5kbar. In general, levels of thermal maturity are higher for the Murotohanto Sub-belt than for the Nabae Sub-belt. The Eocene-Oligocene strata also display a spatial decrease in thermal maturity from south to north and this pattern probably was caused by regional-scale differential uplift following peak heating. Conversely, the palaeothermal structure within the Nabae Sub-belt is fairly uniform, except for the local effects of mafic intrusions at the tip of Cape Muroto. There is a paleotemperature difference of ～ 90°C across the boundary between the Murotohanto and Nabae Sub-belts (Shiina-Narashi fault), and this contrast is consistent with approximately 1200 m of post-metamorphic vertical offset. Subduction prior to Middle Miocene probably involved the Kula or fused Kula-Pacific plate and the background geothermal gradient during the Eocene-Oligocene phase of accretion was ～ 30–35°C/km. Rapid heating of the Shimanto Belt evidently occurred immediately after a Middle Miocene reorganization of the subduction boundary. Hot oceanic lithosphere from the Shikoku Basin first entered the subduction zone at ～ 15 Ma; this event also coincided with the opening of the Sea of Japan and the rapid clockwise rotation of southwest Japan. The background geothermal gradient at that time was ～ 70°C/km. Whether or not all portions of the inherited (Eocene-Oligocene) palaeothermal structure were overprinted during the Middle Miocene remains controversial.     

新疆头屯河地区侏罗系砂岩成分变化及构造环境的探讨

对砂岩矿物成分的定量研究,发现砂岩矿物成熟度的变化与该区构造运动相吻合,源区构造环境为再旋回造山带和岩浆岛弧。     

天津岩溶地热田热储特征研究

从天津大地构造特征和地层分布入手，综合分析了岩溶热储特征.认为天津地区主要大地构造格局从西北向东南依次为冀中拗陷、沧县隆起和黄骅拗陷，主要断裂有北东向的沧东断裂、天津断裂以及北西向的宁河-宝坻断裂.岩溶地热田主要分布在沧县隆起上，发育了王草庄、大城、潘庄、双窑和小韩庄凸起等地热田.研究认为蓟县系雾迷山组在天津全境普遍分布，岩性为深灰色粗晶白云岩、隧石条带状白云岩，裂缝岩溶发育，孔渗性较好，是主要热储层.寒武系、奥陶系热储在沧县隆起核部大面积缺失，在其他地区广泛分布，是主要热储层之一.沧县隆起的热流值较周围地区高，地热水的来源主要为北部蓟县山区，热水运移的最重要通道是大断裂以及不整合面.     

河南晚石炭世含煤地层中的风暴异地煤

河南省晚石炭世含煤地层中,存在着因风暴作用强烈侵蚀滨海泥炭沼泽,而后通过风暴回流把泥炭物质和植物遗体长距离搬运到浅海环境再沉积的风暴异地煤。这种异地煤的直接顶底板是具有风暴沉积特征的浅海碳酸盐岩.煤破碎成粉砂级—泥级,煤层原生结构已完全看不到,煤层下部为含有大量海相动物化石的滞积层,中部为具有类似丘状层理的波状层,上部为水平纹层,其层序特征几乎可与煤层直接顶底板浅海碳酸盐风暴岩类比。研究这种异地煤的沉积背景和形成机制以及这种煤层所反映出的煤质特征、煤岩特征、沉积特征、层序及层序类型特征,不仅可以开拓出一种新型异地成煤类型而扩大煤地质学的研究领域,而且有助于研究古气候、古水深和煤岩层对比等问题。     

青藏高原地面热力异常对夏季江淮流域持续暴雨形成作用的数值试验

本文采用OSU-AGCM大气环流模式，对青藏高原下垫面热力异常与夏季江淮流域暴雨形成的关系进行了数值试验。模拟结果表明，青藏高原下垫面热力状况的异常对东亚环流形势及云量分布异常的影响是形成1991年夏季江淮流域持续性降水的重要原因之一。青藏高原异常热力强迫还可以引起大范围云量的异常分布和云量异常区类似于二维Rossby波列没大圆路径传播的特征。     

珠海市1：2万城区图的设计思想和编制特点

珠海市1：2万城区因是适应近年来该市市区建设迅速发展编制的一幅崭新地图，其遵循的基本原则包括突出城市个性、保证资料现势性、强调地围实用性和注重地图艺术性四个方面．该图在地图内容的表现和图面设计等方面体现了以下特点：表现现代城市街区的功能类型，采用晕渲和明暗等高线显示立体地貌，综合表示花园式城市的绿地景观，图面配置和地图设色的合理化以及文字注记的实用化等．     

激光热透镜光谱法测定地质样品中微量钼的研究

作者对激光热透镜光谱法测定微量钼进行了研究．试验表明，在丙酮介质中，Ｍｏ６＋能被还原成Ｍｏ５＋并形成钼蓝同多酸，最大吸收彼长在６７０ｕｍ处，利用Ｈｅ－Ｎｅ激光器输出的６３２．８ｕｍ的激光作光源，进行微量钼的热透镜法分析测定．两酮的存在能增强热透镜信号强度。钼含量在０．０１—２．０μｇ／ｍＬ范围内与激光热透镜信号强度呈良好的线性关系，方法检出限为０．００５μｇ／ｍＬ钼，已用于地质样品中微量钼的高灵敏度测定．结果满意．