PWM驱动电机的电流环设计

总结了PWM驱动电机电流环的设计及提取反馈电流的方法，提出了一种无超调的电流环设计方法－－积分反馈校正方法，并探讨了小电流时电流环的设计各种获取电流的方法。     

国外遥感卫星发展简介（1）

从美国发射其第一颗遥感卫星一陆地卫星－1算起的30余年里，世界范围内商业遥感卫星技术已经有了巨大的进步，越来越多的国家和国际团体拥有自己的遥感卫星。除了更多各类的遥感器得以使用外，卫星的图像分辨率和覆盖能力也有了很大的改进。未来的发展更加令人振奋。国外遥感卫星（包括已经发射和计划要发射的卫星）简介是根据从国内外出版物中获得的信息整编而成，旨在给遥感应用提供一个现在和未来图像信息源的总的概念。     

Strain and tilt changes measured during a water injection experiment at the Nojima Fault zone, Japan

Abstract In order to make geophysical and geological investigations of the Nojima Fault on Awaji Island, Japan, three boreholes measuring 1800 m, 800 m and 500 m deep were drilled into the fault zone. The fault is one of the seismic source faults of the 1995 Hyogo-ken Nanbu earthquake of M 7.2. A new multicomponent borehole instrument was installed at the bottom of the 800 m borehole and continuous observations of crustal strain and tilt have been made using this instrument since May 1996. A high-pressure water injection experiment within the 1800 m borehole was done in February and March 1997 to study the geophysical response, behavior, permeability, and other aspects of the fault zone. The injection site was located approximately 140 m horizontally and 800 m vertically from the instrument. Associated with the water injection, contraction of approximately 0.7 × 10⁻⁷ str (almost parallel to the fault) and tilt of approximately 1 × 10^-7 rad in the sense of upheaval toward the injection site were observed. In addition to these controlled experiments, the strainmeter and tiltmeter also recorded daily variations. We interpret strain and tilt changes to be related to groundwater discharge and increased ultra-micro seismicity induced by the injected water.     

数字式智能化锚索预应力传感器的研究与设计

预应力传感器是锚固工程，预应力混凝土工程，预应力桥梁工程等领域进行监测，研究与试验必不可少的测量用传感器，在分析预应力传感器[研究现状的基础上，详细了介绍了数字式智能化锚索预应力传感器的工作原理，结论设计，计量检定结果，主要特点和应用情况。     

乾县台地倾斜潮汐测量结果及动态特征

利用Ｖｅｎｅｄｉｋｏｖ调和分析法分析了乾县地震台１９８３－１９９４年的地倾斜固体潮记录，提取了该地区倾斜固体潮汐因子及其动态变化特征，为地球动力学特别是地球内部结构的深入研究提供了固体潮方面的实测参数。     

云龙台固体潮观测对地震监测能力的评价

对云龙台的水管倾斜仪观测数据进行了倾斜固体潮的潮汐分析，发现ＥＷ和ＮＳ两个分量的振幅因子异常变化与地震有较好的对应关系。由于潮汐分析方法本身的科学性和严密性，故振幅因子误差小、精度高；又因为对潮汐谐波波群的选择，避免了以太阳日为基础的周期性干扰，Ｍ２、Ｏ１波振幅因子的地震异常识别则简易可行，并且可信度高。云龙台的固体潮观测具有较强的地震监测能力。     

A novel ozone sensor for direct eddy flux measurements

A small, lightweight (1.5 kg) and fast-response ozone sensor for direct eddy flux measurements has been built. The basis for detection is the chemiluminescence of an organic dye adsorbed on dry silica gel in the reaction with ozone. The chemiluminescence is monitored with a cheap and small blue-sensitive photomultiplier. At a flow rate of 100 l min^-1 the ozone sensor has a 90% response time of significantly better than 0.1 s with a detection limit lower than 50 ppt at S/N=3. There are no interferences from other atmospheric trace gases like NO_x, H₂O₂ and PAN. Water vapour and SO₂ enhance the chemiluminescence efficiency of the ozone sensor. Since their response times are 22 seconds and 30 minutes, respectively, no correlation between rapid ozone fluctuations and those of these two trace gases is noticed by the ozone sensor when operating at a frequency of 10 Hz.The ozone sensor was tested for several weeks in continuous measurements of ozone fluxes and deposition velocities over different croplands using the eddy correlation technique. Good agreement was found between ozone dry deposition velocities derived from profile measurements and by eddy correlation.     

姑咱台地面周日倾斜响应特征分析

本文介绍了利用安装在三个以上方向的连通管倾斜仪进行地面倾斜计算的对比分析方法,并根据姑咱台安装在三个方向的连通管倾斜仪观测资料对地面倾斜的可靠性以及地面倾斜运动响应特征进行了分析。     

测汞用光纤传感器的初步研制

利用原子吸收原理初步研制了一种测示用光纤传感器,解决了光纤探头部分的技术难题。与传统的测汞仪器相比,该仪器的最大优点是可动的。中介绍了仪器的工作原理及主要技术性能。实验表明,可以利用光纤传感技术来实现汞测量。     

Efficient seismic response data storage and transmission using ARX model‐based sensor data compression algorithm

This paper presents a linear predictor (LP)‐based lossless sensor data compression algorithm for efficient transmission, storage and retrieval of seismic data. Auto‐Regressive with eXogenous input (ARX) model is selected as the model structure of LP. Since earthquake ground motion is typically measured at the base of monitored structures, the ARX model parameters are calculated in a system identification framework using sensor network data and measured input signals. In this way, sensor data compression takes advantage of structural system information to maximize the sensor data compression performance. Numerical simulation results show that several factors including LP order, measurement noise, input and limited sensor number affect the performance of the proposed lossless sensor data compression algorithm concerned. Generally, the lossless data compression algorithm is capable of reducing the size of raw sensor data while causing no information loss in the sensor data. Copyright © 2005 John Wiley & Sons, Ltd.