中国海区区域地质编图中重磁图的编制方法

本文简要介绍了局控项目《中国海区１∶５０万区域地质编图（大连幅）》重力异常图、磁力异常图的编制过程，给出了一种以计算机为手段、实现编图自动化的新方法，并分析了该方法与以往编图方法的不同和优点，以国际分幅在中国海区开展区域地质编图尚属首次，在既无海区地质调查规范，又无海区地质调查编图规范的情况下，这一工作无异具有开创性。从理论上系统总结出一套切实可行的编图方法，对于编制中国海区区域地质调查编图规范以     

合浦珠母贝卵子电击脉冲参数的初步研究

运用电脉冲转基因仪对合浦珠母贝卵子进行电脉冲处理以优化电穿孔法转基因的电击参数。实验中调制百分比：100％；脉冲间隔：1．0s：电极距离：2mm；脉冲个数：5个，参数保持不变。用不同的电脉冲参数组合（脉冲电压100-400V、脉冲持续时间0．5～3．0ms、脉冲频率10～50kHz，共28个组合）对卵子电击，然后加入精子进行授精，统计各组受精率和孵化率，以受精率和孵化率达到50％以上为衡量指标。结果表明，合浦珠母贝卵子对低脉冲频率和高电压非常敏感，当频率低于20kHz或脉冲电压高于400V时对卵子损伤较大。脉冲持续时间对其影响不大，适应范围较宽。优化的转基因电击脉冲参教组合为：脉冲电压1.0kV／cm，脉冲持续时间20ms，脉冲频率50kHz，或者脉冲电压1．5kV／cm，脉冲持续时间1．5ms，脉冲频率50kHz。     

A time-varying parameter model of a body oscillating in pitch

Among the assumptions upon which linear time-invariant models of floating bodies are based is that the body motions are so small that any change in the body’s angular position can be disregarded. However, it is often a major design requirement of a wave energy conversion device that the response amplitude is large, thereby invalidating one of the assumptions of the linear model. In particular, the immersed geometry of a body undergoes considerable variation when it is moved in pitch. With regard to this we investigate the difference in performance between a quasi-linear model in which the change of immersed surface is modelled by time-varying parameters and a basic linear model in which the immersed surface is time-invariant. The time-varying parameter model is realized by interpolation between the appropriate parameter values of a set of linear time-invariant (LTI) models derived for the different immersed surfaces that occur at discrete body displacements. It is shown that the responses predicted using the time-varying parameter model are closer to those measured experimentally than those of a standard frequency-domain model. Particular improvement occurs when the responses are large, such as at or near the resonance frequency. A problem which may limit the general use of the model is also discussed.     

The Vema Transverse Ridge (Central Atlantic)

Transverse ridges are elongate reliefs running parallel and adjacent to transform/fracture zones offsetting mid-ocean ridges. A major transverse ridge runs adjacent to the Vema transform (Central Atlantic), that offsets the Mid-Atlantic Ridge by 320 km. Multibeam morphobathymetric coverage of the entire Vema Transverse ridge shows it is an elongated (300 km), narrow (<30 km at the base) relief that constitutes a topographic anomaly rising up to 4 km above the predicted thermal contraction level. Morphology and lithology suggest that the Vema Transverse ridge is an uplifted sliver of oceanic lithosphere. Topographic and lithological asymmetry indicate that the transverse ridge was formed by flexure of a lithospheric sliver, uncoupled on its northern side by the transform fault. The transverse ridge can be subdivided in segments bound by topographic discontinuities that are probably fault-controlled, suggesting some differential uplift and/or tilting of the different segments. Two of the segments are capped by shallow water carbonate platforms, that formed about 3–4 m.y. ago, at which time the crust of the transverse ridge was close to sea level. Sampling by submersible and dredging indicates that a relatively undisturbed section of oceanic lithosphere is exposed on the northern slope of the transverse ridge. Preliminary studies of mantle-derived ultramafic rocks from this section suggest temporal variations in mantle composition. An inactive fracture zone scarp (Lema fracture zone) was mapped south of the Vema Transverse ridge. Based on morphology, a fossil RTI was identified about 80 km west of the presently active RTI, suggesting that a ridge jump might have occurred about 2.2 m.a. Most probable causes for the formation of the Vema Transverse ridge are vertical motions of lithospheric slivers due to small changes in the direction of spreading of the plates bordering the Vema Fracture Zone.     

海洋水色卫星遥感器特性参数探讨

为了评价海洋水色卫星遥感器特性参数的优劣，确定仪器的计量特性及其使用价值，准确的理解和科学的定义仪器的特性参数是非常重要的。作者曾有幸参加了海洋水色卫星的立项论证工作，本文就作者的一些工作体会，对海洋水色卫星遥感器的特性参数作初步探讨。     

西太平洋暖池区海—气通量计算分析

用J.Launiaimen和T.Vihma提出的近地面层湍流通量计算方法,对我国在1992年11月至1993年2月TOGA—COARE—IOP实验中所获资料计算处理。得出所在站位的海一气间显效、潜热及动量通量。指出西大平洋暖池海区游热通量与显效通量之比为10.14:1;风速大于8m/s后各通量随风速的变化率明显增加;动量与热量的块体通量系数Cd和Ce,h随风速变化有相似的规律;Monin—Obukhov大气稳定度参数Z/L与△T/U_(10)之间有较好的统计关系。     

水产饲料膨化机设计刍论

据开发应用水产饲料膨化机实践，初步论述了膨化机生产能力与动力匹配，螺杆设计参数长径比，物料在腔内滞留时间，膨化腔设计及其温度调控，并提出改进设计的见解.     

江苏岸外辐射沙脊群东沙稳定性研究

东沙是江苏岸外辐射沙脊群中的第二大沙洲,具有独特的地形地貌和水动力条件,对它进行稳定性研究为揭示整个辐射沙洲及其邻近岸滩的动态演变都非常有益。通过利用多年遥感卫片资料、1998年取得的现场水文泥沙观测资料和东沙滩面表层沉积物资料等,对东沙的地形地貌特征、沉积特征和东沙两侧潮汐通道的水流泥沙特征等进行了详细分析。研究结果表明,东沙的沙脊偏于西侧,西侧滩面较窄、高程较高且岸线较为顺直,东侧滩面较宽、高程较低且岸线较为破碎;西洋和陈家坞槽均处于冲刷状态,净输沙的主要方向为输向槽外或输向条子泥;东沙近三十年来面积有所缩小且有外围向中央收缩的趋势,尤其以向东、向南方向的迁移最为明显。     

Structure and Quaternary tectonic history of the Woodlark triple junction region,Solomon Islands

The Woodlark triple junction region, a topographically and structurally complex triangular area of Quaternary age, lies east of Simbo Ridge and southwest of the New Georgia island group, Solomon Islands, at the junction of the Pacific, Australian and Solomon Sea plates. SeaMARC II side-scan imagery and bathymetry in conjunction with seismic reflection profiles, 3.5 kHz records, and petrologic, magnetic and gravity data show that the active Woodlark spreading centre does not extend into this region.South of the triple junction region, the Woodlark spreading centre reoriented at about 2 Ma into a series of short ESE-trending segments. These segments continued to spread until about 0.5 Ma, when the lithosphere on their northern sides was transferred from the Solomon Sea plate to the Australian plate. Simultaneously the Simbo transform propagated northwards along the western side of the transferred lithosphere, forming a trench-trench-transform triple junction located NNW of Simbo island and a new leaky plate boundary segment that built Simbo Ridge.As the Pacific plate approached, the area east of northern Simbo Ridge was tilted northwards, sheared by dominantly right-lateral faults, elevated, and intruded by arc-related magmas to form Ghizo Ridge. Calc-alkalic magmas sourced beneath the Pacific plate built three large strato-volcanic edifices on the subducting Australian plate: Simbo at the northern end of Simbo Ridge, and Kana Keoki and Coleman seamounts on an extensional fracture adjoining the SE end of Ghizo Ridge.A sediment drape, supplied in part from Simbo and Kana Keoki volcanoes, mantles the east-facing slopes of northern Simbo and Ghizo Ridges and passes distally into sediment ponded in the trench adjoining the Pacific plate. As a consequence of plate convergence, parts of the sediment drape and pond are presently being deformed, and faults are dismembering Kana Keoki and Coleman seamounts.The Woodlark system differs from other modern or Tertiary ridge subduction systems, which show wide variation in character and behaviour. Existing models describing the consequences of ridge subduction are likely to be predictive in only a general way, and deduced rules for the behaviour of oceanic lithosphere in ridge subduction systems may not be generally applicable.     

Baroclinic Buoyancy-Inertia Joint Stability Parameter

At present, the barotropic buoyant stability parameter has been derived from a vertical virtual displacement of a water parcel. The barotropic inertial stability parameter in the eccentrically cyclogeostrophic, basic current field was derived in 2003 from a horizontal cross-stream virtual displacement of a parcel. By expressing acceleration of a parcel due to a virtual displacement, which is arbitrarily sloping within a vertical section across the basic current, in terms of natural coordinates, we derived the vertical component of baroclinic buoyant stability parameter B ₂ ², the horizontal component of baroclinic inertial stability parameter I ₂ ², the baroclinic joint stability parameter J ², its buoyant component B ² and its inertial component I ². B ² is far greater than I ₂ ², and when neglecting relative vorticity except for vertical shear, a downward convex curve of J ² plotted against the slope of a virtual displacement follows a trend of B ² curve. If a parcel displaces along a horizontal surface or an isopycnal surface, however, B ² vanishes, and J ² becomes equal to I ². Actual parcel is apt to displace not only along the bottom slope, but also along the sea surface and an isopycnal interfacial surface, which is approximately equivalent to an isentropic surface, preferred by lateral mixing and exchange of momentum. Such actual displacement makes B ² vanishing, and grants I ² an important role. The present analysis of I ² examining effects due to curvature and horizontal and vertical shear vorticities are useful in deepening our understanding of baroclinic instability in actual oceanic streams.