相对湿度对静电收集型连续测氡仪检定结果的影响

NR－667A（Ⅲ）型快速连续测氧仪是目前环境氡测量时间响应最短的一种仪器。该仪器在核工业第六研究所标准氡室进行检定时发现，环境相对相对度对仪器检定结果有很大影响。在相对湿度为80％－99％的标准氡室内分别对仪器进行检定，结果在相对湿度为80％时仪器检定合格，而在相对湿度为99％时仪器检定不合格。本从仪器工作原理对检定结果进行。并提出有效的解决方法，当相对湿度太大时，可在仪器进气口安装干燥器对进气进行除湿。     

Fitness-for-Purpose of Reference Material Reference Values in Relation to Traceability of Measurement, as Illustrated by USGS BCR-1, NIST SRM 610 and IAEA NBS28

As in all fields of sample analysis, reference materials play a large role in supporting measurements in the geosciences. While a rather large number of materials are in distribution (> 380), not all are equally effective or fit-for-purpose in supporting laboratory data quality and thereby assuring the desired comparability of measurements between laboratories. Equally important, reference values that are not fit-for-purpose cannot be used effectively to establish traceability links between laboratory measurements and national and international standards. The needed fitness-for-purpose is not achieved for reference values either when more than one reference value has been proposed and a consensus does not exist among users as to which should be used by all, or when reference value uncertainties are too large in comparison to those of routine laboratory measurements. The focus of this review will be, first to outline the current reality, and second to suggest ways in which certifications of RMs can be improved to provide reference values that are universally accepted and more fit-for-purpose in general laboratory use. The discussion will be illustrated largely by current uses of USGS BCR-1, NIST SRM 610 and IAEA NBS28, as these three materials are those for which the largest body of newly published data exists, according to recent bibliographies of the geoanalytical literature published annually in Geostandards Newsletter: The Journal of Geostandards and Geoanalysis.     

人工值守台数字化地震仪标定原理

推导了人工台数字化地震仪的分段标定公式，提出数字化记录系统的微分近似标定和拾震器阻尼衰减法标定的方法，并提供了不同短周期地震仪与数字化地震仪并行的藕合方式和标定计算公式。     

一种计算固体潮观测数据改正值的新方法

从标定前一天和标定当天的地形变前兆数据变化趋势入手，在分析当天数据结构的基础上采用最小二乘法原理，提出了一种计算数采改正值的新方法。经典型实例计算表明，该方法精度较高，效果明显。并对误差的来源作了进一步的分析。     

VS型垂直摆倾斜仪的安装调试与标定要点

本文总结了铁岭地震台安装，调试与标定VS型垂直倾仪的经验。     

桥梁限位器抗震设计方法研究

本文建立了两跨简支梁桥和五跨多跨刚架桥两结构模型，针对限位器的种类、刚度、强度、安装位置，输入地震动等进行了大量工况下的数值模拟研究。研究表明限位器与柱（框架）的刚度比在0.5-2之间较优。将现有的限位器设计方法应用于两算例结构，对现有限位器设计方法进行了比较研究。     

改进的最小二乘法在水文分析计算中的应用

在水分析计算中，经常涉及到变量之间的线性或非线性拟合，而在拟合各种特性曲线时，通常应用以实测资料与拟合曲线间的误差平方和最小作为目标函数的方法——最小二乘法，但这种方法忽视了所有实测点应与拟合曲线间的相对误差尽量不超过某一百分比的原则，为了达到上述要求，提出了非线性的加权最小二乘法及线性相关方程的最小距离平方和法，探讨改进了传统的最小二乘法达到优化的效果。最小距离平方和法与常用的图解法相比，本法所得成果较为客观；与传统的单方向(x或y方向)最小二乘回归法相比，所求线性方程不会因坐标系的选取而改变。最后应用算例进行了初步讨论。     

Gravity variation before Kunlun mountain pass western Ms=8.1 earthquake

The relation between the gravity variation features and Ms=8.1 earthquake in Qinghai-Xizang monitoring area is analyzed preliminarily,by using spatial dynamic variation results of regional gravity field from absolute gravity and relative gravity observation in 1998 and 2000.The results show that:1)Ms\8.1 earthquake in Kulun mountain pass westem occurred in the gravity variation high gradient near gravity‘s high negative variation;2)The Main tectonic deformation and emnergy accumulation before MS=8.1 earthquake are distributed at south side of the epicenter;3)The range of gravity‘s high negative variation at east of the MS=8.1 earthquake epicenter relatively coincides with that rupture region according to field geology investigation;4)Gravity variation distribution in high negative value region is just consistent with the second shear strain‘s high value region of strain field obtained from GPS observation.     

利用GPS位移和主应力方向观测资料进行川滇地区边界力的联合反演研究

在简要介绍了川滇地区的构造格局和构造运动特征的基础上，讨论了不同观测数据同时用于反演的合理性和物理意义，利用1998～2000年观测的9个测点位移数据和1986年以前所测的10个主应力方向数据，将边界力和相对权比λ作为待反演参数，并考虑了主要活动断裂运动特性，进行了弹性有限元数值反演计算。计算结果表明，现今川滇地区的构造活动主要力源仍来源于印度板块与欧亚大陆的碰撞，菲律宾海板块的挤压作用也不可忽略，这一结论说明了该地区现今构造运动的继承性活动特征。     

ADAPT数字遥测地震台网中传递函数的辨识

Adapt系统可以利用脉冲标定波形得到系统的传递函数，它将复杂的传递函数计算过程简化了，用户可以将传递函数的测定作为一种日常工作来做。