Some breakage characteristics of ultra-fine wet grinding with a centrifugal mill

A centrifugal mill is a high-power intensity media mill that can be used for ultra-fine grinding, employing centrifugal forces generated by gyration of the axis of the mill tube in a circle. The mill charge motion is quite different depending on the ratio of the gyration diameter to the mill diameter (G / D ratio), varying from a motion similar to that of a conventional tumbling media mill to that of a vibration mill. In this study, a centrifugal mill was constructed with an arrangement where the gyration diameter could be readily adjusted. The batch grinding characteristics of three different minerals (limestone, talc and illite) in water with dispersing agent were investigated at various G / D ratios. It was found that the optimum G / D ratio in terms of the specific energy consumption to give a desired fineness of product was different for the three minerals. This was due to their different reactions to the breakage mechanisms provided by the mill charge motion at varying G / D ratios. The size distributions became progressively narrower at increased grinding times, and particles finer than about 0.1 μm were not detected even for prolonged grinding times. Measurement of specific surface areas indicated that this was not due to an artifact of the size measurements by laser diffractometry. This implies that there is a limitation in which particles finer than 0.1 μm are not produced under the conditions tested in this type of mill, but further investigation is needed for experimental verification of this limit of comminution.     

Fracture analysis in the south-western Corinth rift (Greece) and implications on fault hydraulic behavior

This paper reviews the data concerning the fracture network and the hydraulic characteristics of faults in an active zone of the Gulf of Corinth. Pressure gap measured through fault planes shows that in this area the active normal faults (Aigion, Helike) act, at least temporarily and locally, as transversal seal. The analysis of the carbonate cements in the fractures on both the hangingwall and the footwall of the faults also suggests that they have acted as local seals during the whole fault zone evolution. However, the pressure and the characteristics of the water samples measured in the wells indicate that meteoric water circulates from the highest part of the relief to the coast, which means it goes through the fault zones. Field quantitative analysis and core studies from the AIG-10 well have been performed to define both regional and fault-related fracture networks. Then laboratory thin section observations have been done to recognize the different fault rocks characterizing the fault zone components. These two kinds of approach give information on the permeability characteristics of the fault zone. To synthesize the data, a schematic conceptual 3D fluid flow modeling has been performed taking into account fault zone permeability architecture, sedimentation, fluid flow, fault vertical offset and meteoric water influx, as well as compaction water flow. This modeling allows us to fit all the data with a model where the fault segments act as a seal whereas the relays between these segments allow for the regional flow from the Peloponnese topographic highs to the coast.     

Geochemistry of recent hydrothermal systems of Mendeleev Volcano （Kuril Islands） and surrounding waters

On the Kuril Islands there are 85 volcanoes, 39 of which are active. Hot springs and mud pots are wide spread in this area and have significant inputs on the chemical composition of the surrounding surface waters and environment. We present results of trace elements as well as data on H, O, S, and He isotope ratios for hydrothermal systems of the Mendeleev Volcano （Kunashir Island） and surrounding surface waters. Water and gas samples were taken from springs and holes as well as creeks and the Lesnaya River. Among the thermal water types, three main groups can be distinguished. The first group includes the waters, in which SO4^- ion predominant. The water temperature on the surface reaches 97℃, and TDS varies from a few g/L to 7 g/L. These waters are acid to superacid with pH values ranging 0.6 to 2.3. The second group is sodium-chloride waters. A maximum TDS is 14.2 g/L. The waters are neutral or alkaline; pH varies from 6.9 to 8.2. The third group is the sodium-chloride-sulfate-bicarbonate water. The Stolbovskie springs, located in the periphery of the Mendeleev Volcano are representative of this type. The pH of these waters is close to neutral. TDS is 1.9 g/L. They are rather the derivatives of sodium-chloride waters arisen from dilution of them by subsurface waters. The Kuslyi Creek and Lesnaya River are located near the Mendeleev Volcano. The most acid springs discharge into the Kislyi Creek as a result pH of this creek being 2.5, and contents of most elements rather high. For example, the contents of dissolved solids of Si, Fe, Al, Mn, Zn, in waters of the Kislaya Creek are 22.1, 8.1, 6.2, 1.29, and 0.28 mg/L, and correspondently. The water of the Lesnaya River, （Before the Kislyi Creek, pH is about 8 with TDS 102 mg/L, but after the Kuslyi Creek, pH decreases and the concentrations of chemical elements increase. Debit of the Kislayi Creek in summer season is about 370 L/sec. It means that every day only this small creek inputs in the Lesnay River about 706 kg of Si;     

Rock fracturing by explosive energy: review of state-of-the-art

A study of the dynamic rock fracture initiation and propagation due to explosive energy is presented through a detailed state-of-the-art review. Explosive energy dissipation in crushing and fracturing is examined and the various means to enhance the explosive energy utilization for dynamic rock fracturing are reviewed. The study highlights the need for a better understanding of the dynamic fracturing process particularly in the presence of in situ stresses in the rock mass.     

Genesis of monazite and Y zoning in garnet from the Black Hills, South Dakota

The paragenesis of monazite in metapelitic rocks from the contact aureole of the Harney Peak Granite, Black Hills, South Dakota, was investigated using zoning patterns of monazite and garnet, electron microprobe dating of monazite, bulk-rock compositions, and major phase mineral equilibria. The area is characterized by low-pressure and high-temperature metamorphism with metamorphic zones ranging from garnet to sillimanite zones. Garnet porphyroblasts containing euhedral Y annuli are observed from the garnet to sillimanite zones. Although major phase mineral equilibria predict resorption of garnet at the staurolite isograd and regrowth at the andalusite isograd, textural and mass balance analyses suggest that the formation of the Y annuli is not related to the resorption-and-regrowth of garnet having formed instead during garnet growth in the garnet zone. Monazite grains in Black Hills pelites were divided into two generations on the basis of zoning patterns of Y and U: monazite 1 with low-Y and -U and monazite 2 with high-Y and -U. Monazite 1 occurs in the garnet zone and persists into the sillimanite zone as cores shielded by monazite 2 which starts to form in the andalusite zone. Pelites containing garnet porphyroblasts with Y annuli and monazite 1 with patchy Th zoning are more calcic than those with garnet with no Y annuli and monazite with concentric Th zoning. Monazite 1 is attributed to breakdown of allanite in the garnet zone, additionally giving rise to the Y annuli observed in garnet. Monazite 2 grows in the andalusite zone, probably at the expense of garnet and monazite 1 in the andalusite and sillimanite zones. The ages of the two different generations of monazite are within the precision of chemical dating of electron microprobe. The electron microprobe ages of all monazites from the Black Hills show a single ca. 1713 Ma population, close to the intrusion age of the Harney Peak Granite (1715 Ma). This study demonstrates that Y zoning in garnet and monazite are critical to the interpretation of monazite petrogenesis and therefore monazite ages.     

Preservation/exhumation of ultrahigh-pressure subduction complexes

Ultrahigh-pressure (UHP) metamorphic terranes reflect subduction of continental crust to depths of 90–140 km in Phanerozoic contractional orogens. Rocks are intensely overprinted by lower pressure mineral assemblages; traces of relict UHP phases are preserved only under kinetically inhibiting circumstances. Most UHP complexes present in the upper crust are thin, imbricate sheets consisting chiefly of felsic units ± serpentinites; dense mafic and peridotitic rocks make up less than  10% of each exhumed subduction complex. Roundtrip prograde–retrograde P–T paths are completed in 10–20 Myr, and rates of ascent to mid-crustal levels approximate descent velocities. Late-stage domical uplifts typify many UHP complexes.

Sialic crust may be deeply subducted, reflecting profound underflow of an oceanic plate prior to collisional suturing. Exhumation involves decompression through the P–T stability fields of lower pressure metamorphic facies. Scattered UHP relics are retained in strong, refractory, watertight host minerals (e.g., zircon, pyroxene, garnet) typified by low rates of intracrystalline diffusion. Isolation of such inclusions from the recrystallizing rock matrix impedes back reaction. Thin-aspect ratio, ductile-deformed nappes are formed in the subduction zone; heat is conducted away from UHP complexes as they rise along the subduction channel. The low aggregate density of continental crust is much less than that of the mantle it displaces during underflow; its rapid ascent to mid-crustal levels is driven by buoyancy. Return to shallow levels does not require removal of the overlying mantle wedge. Late-stage underplating, structural contraction, tectonic aneurysms and/or plate shallowing convey mid-crustal UHP décollements surfaceward in domical uplifts where they are exposed by erosion. Unless these situations are mutually satisfied, UHP complexes are completely transformed to low-pressure assemblages, obliterating all evidence of profound subduction.     

Secular variations of the upper crust composition: Implication of geochemical data on the Upper Precambrian shales from the Southern Urals western flank and Uchur-Maya region

In the mid-1980s, it was concluded based on geochemical study that Th, Sc, La concentrations and ratios Th/Sc, La/Sc and Eu/Eu* did not wary significantly in the post-Archean time. It was impossible to judge about compositional variations of upper crust during the Riphean and Vendian, because data of that time characterized a limited number of samples from the post-Archean basins of Australia, New Zealand, and Antarctic. Considered in this work are variations of Eu/Eu*, LREE/HREE, Th/Sc, and La/Sc ratios in Upper Precambrian fine-grained siliciclastic rock of the Southern Urals western flank (Bashkirian meganticlinorium) and Uchur-Maya region (Uchur-Maya plate and Yudoma-Maya belt). As is established, only the Eu anomaly in the studied siliciclastic rocks is practically identical to this parameter of the average post-Archean shale. Three other parameters plot on the Riphean-Vendian variation curves with positive and negative excursions of diverse magnitude, which do not coincide always in time. It is assumed that these excursions likely mark stages of local geodynamic activity, destruction of pre-Riphean cratons, and progressing recycling of sedimentary material during the Riphean.     

R＆D投入的区位模式与区域经济发展

基于对中国R＆D投入的区位模式的实证检验，从投入一产出绩效的角度认为集中投入的区位模式具有较强的适宜性。利用聚类分析技术，按照R＆D的投入强度和及其对经济的带动效应、科技化效应、产业化效应将中国各省区划分为6类地区，具有代表性的是科技化模式和产业化模式。其中前者适合于技术存置较高的少数地区，而后者具有较强的借鉴意义。     

Asking the right questions: environmental conflict in the case of Azerbaijan

This paper contributes an empirical test of key themes of the literature on natural resource conflict. Survey and interview data from an ongoing project in Azerbaijan provide insights into an unexpected lack of conflict in Azerbaijan related to the environment, resources and energy despite the predictions of resource conflict literature. We contend that questions about public perceptions about the environment and other daily concerns are critical if we are to understand who is likely (or unlikely) to be involved in conflict and why. The data presented in this paper demonstrate that Azerbaijani citizens rank environmental and resource issues among their immediate concerns and their top concerns for the country. However, compared to other day-to-day concerns such as the Nagorno-Karabakh conflict and economic concerns, environment-related concerns do not appear to be sufficient to motivate widespread violent conflict or citizen dissent related to environmental or natural resource conditions.     

The geography of suicide terrorism in Israel

Palestinian suicide terrorism has been a key feature in the latest phase of the Israeli–Palestinian conflict. During the past decade, and particularly since September 2000, there has been a substantial increase in the use of this type of warfare. Recent studies suggest that, contrary to common belief, suicide terrorism is highly rational and driven by strategic considerations. This article explores the rationality of Palestinian suicide terrorism from a geographical perspective. It is argued that suicide terrorism works along two parallel paths: rationality and randomness. It complies with geographical fundamentals, and target selection is highly rational, subject to spatial considerations such as distance, agglomeration, and accessibility. As the permeability to Israel became more difficult, suicide bombers and their organizers had to adopt more flexible practices which emphasized other spatial considerations. Timing is of importance both for strategic and tactical reasoning. Obstructing negotiations and peace talks has been a salient objective, but the exact timing of suicide bombings has been influenced by tactical considerations, which aim at maximizing casualties.