地壳演化与成矿作用——以川滇地洼系“四层楼”铜矿床序列为例

提出川滇地洼系“四层楼”铜矿床序列的形成与陆壳演化的成生联系,是与本区陆壳由前地槽—地槽—地台—地洼演化各阶段与之相匹配的成矿作用的产物.与此同时,并总结了本区“四层楼”铜矿床序列的成矿作用具有明显的继承性、新生性、旋回性及层控性四大特点和多因复成矿床的成矿模式.     

The mitigation of the vibration effects caused by tunnel blasts in urban areas: a case study in Istanbul

Ground vibrations generated by commercial explosives in tunnel construction may cause structural damage in urban areas. Therefore, suppressing the vibration effects and mitigating the possible hazard after blasting is important. We present a new method of controlled blasting that is environmentally friendly, and easy to utilize for tunnel construction. Small charges in this method are detonated sequentially to produce minimum side effects. The efficiency of the charges may be increased based on the previously monitored shots. This method is utilized in a tunnel construction in Istanbul with five experimental shots. In these experiments, the duration and also the quantity of explosives were carefully controlled. We were able to obtain better results with short durations (480 ms) instead of long durations (9,000 ms) although the vibration levels defined as peak particle velocity (PPV) became bigger while the quantity of the explosive charge increased from 3.088 to 9.264 kg.     

Influence of Structural Non-Stationarity of Surface Roughness on Morphological Characterization and Mechanical Deformation of Rock Joints

Summary Structural non-stationarity of surface roughness affects accurate morphological characterization as well as mechanical behaviour of rock joints at the laboratory scale using samples with a size below the stationarity threshold. In this paper, the effect of structural non-stationarity of surface roughness is investigated by studying the scale dependence of surface roughness and mechanical behaviour of rock joints. The results show that the structural non-stationarity mainly affects the accurate characterization of the surface roughness of the fracture samples. It also controls the amount and location of the contact areas during shear tests, which in turn affects the mechanical properties and asperity degradation of the samples. It is concluded that for accurate determination of the morphological and mechanical properties of rock joints at laboratory and field scales, samples with size equal to or larger than the stationarity threshold are required. Author’s address: Nader Fardin, Rock Mechanics Group, Department of Mining Engineering, Faculty of Engineering, University of Tehran, P.O. Box: 11365/4563, Tehran, Iran     

江苏潮滩沉积物激光粒度仪与移液管-筛析分析结果的对比

激光粒度仪的广泛应用带来了与历史数据的对比问题,因此需要建立激光粒度仪与早期分析结果之间的关系。根据江苏海岸潮滩沉积物样品的激光粒度仪和移液管-筛析法分析,对粒度参数、粒度组分等进行了对比,对两种方法的差异进行了分析。结果表明,对于江苏潮滩沉积物粒度参数中平均粒径的激光粒度仪与移液管-筛析分析结果之间有良好的线性关系;筛分法测得的粗颗粒物质较激光法偏少,而移液管法法测得的细颗粒物质较激光法偏多;将样品分类之后再进行两种方法所获粒度参数的回归分析,相关性得以提高,说明不同粒度组成的沉积物对分析结果的对比有不同的影响。两种方法之间的换算关系不仅与研究区域有关,而且与沉积物本身的粒度组成有关。     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。     

基于Mindlin理论Winkler地基参数的Kalman滤波识别

提出了Winkler地基参数的Kalman滤波识别方法。引入Mindlin理论后,推导了Winkler地基上板的控制微分方程。利用Fourier变换,推求了Winkler地基上简支板的Fourier闭式解。推导了Winkler地基参数的Kalman滤波方程,研究了Winkler地基参数的Kalman滤波识别的具体计算步骤。研究表明,运用Kalman滤波理论进行Winkler地基参数的识别,能有效地估计Winkler地基参数;Winkler地基参数的滤波收敛速度和精度受地基参数初始值选取和位移实测资料的影响,且Kalman滤波理论也可用于其他地基模型地基参数的识别。     

GPS变形监测平差计算及不确定度分析

全球定位系统（GPS）是一种全天候、高精度的连续定位系统,它以速度快、方法灵活多样、操作简便等优势被广泛应用于工程测量和变形监测中。结合水厂铁矿GPS边坡变形监测实例,对GPS监测网的星历预报、基线向量平差计算、网平差计算、结果及残差不确定度进行了细致分析研究,以验证GPS技术在边坡变形监测中的可靠性和精度。     

多传感器观测下带乘性噪声系统的逆向滤波与反褶积融合算法

针对多传感器观测环境下带乘性噪声系统的逆向最优滤波与反褶积融合估计问题 ,本文提出了 1种基于极大似然准则的最优融合算法。该算法中各单传感器间并行计算 ,并且融合中心与单传感器处理中心间无反向通讯 ,因而执行效率较高。仿真表明 ,该融合算法产生的逆向滤波与反褶积比单传感器处理结果有较明显提高     

地震折射波的虚拟射线理论及其应用

本文提出了一种地震折射液的虚拟射线理论,根据该理论,只要已知地表层的速度,即可直接由折射波信息提取地震参数,从而可实现折射界面的反演。 文中通过实际介质模型的计算机实验结果,验证了该理论的正确性。     

Internal generation of waves: Delta source function method and source term addition method

In this study, we investigate two internal wave generation methods in numerical modeling of time-dependent equations for water wave propagation, i.e., delta source function method and source term addition method, the latter of which has been called the line source method in literatures. We derive delta source functions for the Boussinesq-type equations and extended mild-slope equations. By applying the fractional step splitting method, we show that the delta source function method is equivalent to the source term addition method employing the energy velocity. This suggests that the energy velocity should be used rather than the phase velocity for the transport of incident wave energy in the source term addition method. Finally, the performance of the delta source function method is verified by accurately generating nonlinear cnoidal waves as well as linear waves for horizontally one-dimensional cases.