Metamorphism in Archaean greenstone belts: calculated fluid compositions and implications for gold mineralization

An inescapable consequence of the metamorphism of greenstone belt sequences is the release of a large volume of metamorphic fluid of low salinity with chemical characteristics controlled by the mineral assemblages involved in the devolatilization reactions. For mafic and ultramafic sequences, the composition of fluids released at upper greenschist to lower amphibolite facies conditions for the necessary relatively hot geotherm corresponds to those inferred for greenstone gold deposits (X_CO2= 0.2–0.3). This result follows from the calculation of mineral equilibria in the model system CaO–MgO–FeO–Al₂O₃–SiO₂–H₂O–CO₂, using a new, expanded, internally consistent dataset. Greenstone metamorphism cannot have involved much crustal over-thickening, because very shallow levels of greenstone belts are preserved. Such orogeny can be accounted for if compressive deformation of the crust is accompanied by thinning of the mantle lithosphere. In this case, the observed metamorphism, which was contemporaneous with deformation, is of the low-P high-T type. For this type of metamorphism, the metamorphic peak should have occurred earlier at deeper levels in the crust; i.e. the piezothermal array should be of the ‘deeper-earlier’type. However, at shallow crustal levels, the piezothermal array is likely to have been of ‘deeper-later’type, as a consequence of erosion. Thus, while the lower crust reached maximum temperatures, and partially melted to produce the observed granites, mid-crustal levels were releasing fluids prograde into shallow crustal levels that were already retrograde. We propose that these fluids are responsible for the gold mineralization. Thus, the contemporaneity of igneous activity and gold mineralization is a natural consequence of the thermal evolution, and does not mean that the mineralization has to be a consequence of igneous processes. Upward migration of metamorphic fluid, via appropriate structurally controlled pathways, will bring the fluid into contact with mineral assemblages that have equilibrated with a fluid with significantly lower X_CO2. These assemblages are therefore grossly out of equilibrium with the fluid. In the case of infiltrated metabasic rocks, intense carbonation and sulphidation is predicted. If, as seems reasonable, gold is mobilized by the fluid generated by devolatilization, then the combination of processes proposed, most of which are an inevitable consequence of the metamorphism, leads to the formation of greenstone gold deposits predominantly from metamorphic fluids.     

Computational modeling of cyclic mobility and post-liquefaction site response

Under seismic excitation, liquefied clean medium to dense cohesionless soils may regain a high level of shear resistance at large shear strain excursions. This pattern of response, known as a form of cyclic mobility, has been documented by a large body of laboratory sample tests and centrifuge experiments. A plasticity-based constitutive model is developed with emphasis on simulating the cyclic mobility response mechanism and associated pattern of shear strain accumulation. This constitutive model is incorporated into a two-phase (solid–fluid), fully coupled finite element code. Calibration of the constitutive model is described, based on a unique set of laboratory triaxial tests (monotonic and cyclic) and dynamic centrifuge experiments. In this experimental series, Nevada sand at a relative density of about 40% is employed. The calibration effort focused on reproducing the salient characteristics of dynamic site response as dictated by the cyclic mobility mechanism. Finally, using the calibrated model, a numerical simulation is conducted to highlight the effect of excitation frequency content on post-liquefaction ground deformations.     

江苏高邮地震台地磁变化与地震关系的初探

分析了江苏高邮地磁台1980年至2002年地磁垂直分量日变幅逐日比值的高值异常与江苏及邻区ML5．0以上地震之间的关系，发现它们之间有良好的对应关系，通过分析地磁垂直分量谐波幅度的逐日比，提出了适用于高邮地磁台的地震分析预报参数，并对其内检预报效能进行了评价。     

路基施工沉降观测精度要求及数据处理

本文通过对路基施工沉降观测的精度分析,提出了路基施工沉降观测的精度要求；根据路基施工沉降观测的特点，提出了相应的观测措施及数据处理方法。     

丽江7.0级地震地下流体异常特征

通过对１９９６年２月３日云南丽江Ｍｓ７．０地震前震中周围水位、水氡、水汞、泉点宏观等地下流体共７１个台项观测资料的异常及综合特征分析，初步认为震前异常数量较多，异常时间分布具有整体性、同步性、集中性的特点，但异常主要集中在短期阶段，临震异常不突出；突间分布具有集中性和非均匀性，孕震区至远场影响区的异常比例最高，震源区内为相对“盲区”，且突出而肯定的宏观异常极少；异常的时空演变特征复杂，总体没有规律     

禾青井动水位对断层蠕动与慢地震过程的响应初析

以湖南禾青井深井水位观测的异常图象为例进行定性分析，发现动水位观测有可能直接反映出断层的滑动或断层的慢地震过程，前者可能为地下水物理参量的观测与研究提供亲折思路，后者则可能对震源物理学的发展和地震预报水平的提高具有特殊的意义。     

Preliminary results on kinematic model of tectonic blocks derived from high precision GPS observations in Southwest China

ＰｒｅｌｉｍｉｎａｒｙｒｅｓｕｌｔｓｏｎｋｉｎｅｍａｔｉｃｍｏｄｅｌｏｆｔｅｃｔｏｎｉｃｂｌｏｃｋｓｄｅｒｉｖｅｄｆｒｏｍｈｉｇｈｐｒｅｃｉｓｉｏｎＧＰＳｏｂｓｅｒｖａｔｉｏｎｓｉｎＳｏｕｔｈｗｅｓｔＣｈｉｎａＬＩＲＥＮＨＵＡＮＧ１）（黄立人）...     

Noise reduction and detection of weak, coherent signals through phase-weighted stacks

We present a new tool for efficient incoherent noise reduction for array data employing complex trace analysis. An amplitude-unbiased coherency measure is designed based on the instantaneous phase, which is used to weight the samples of an ordinary, linear stack. The result is called the phase-weighted stack (PWS) and is cleaned from incoherent noise. PWS thus permits detection of weak but coherent arrivals. The method presented can easily be extended to phase-weighted cross-correlations or be applied in the τ p domain. We illustrate and discuss the advantages and disadvantages of PWS in comparison with other coherency measures and present examples. We further show that our non-linear stacking technique enables us to detect a weak lower-mantle P -to- S conversion from a depth of approximately 840 km on array data. Hints of an 840 km discontinuity have been reported; however, such a discontinuity is not yet established due to the lack of further evidence.     

Applicability of a Backprojection Algorithm to Reconstruct Images of Subsurface Horizontal Planes for Laboratory Experiments in Electrical Resistance Tomography

This paper describes the use of a backprojection algorithm to reconstruct subsurface images of the electrical resistivity in horizontal planes parallel to the surface. The algorithm can be applied to detect buried objects such as tanks or pipes and possible leakages from them. Two imaging strategies are compared: juxtaposition of vertical planes, and 3D reconstruction from the sensitivity matrix corresponding to the entire volume whose surface is explored. The electrode arrays used for voltage measurement are the dipole–dipole array and a modified Schlumberger array. A personal computer controls current injection, electrode switching, and voltage detection. The system injects 1 kHz, 20 V peak-to-peak square waveforms, thus avoiding electrode polarization effects. Experimental laboratory measurements show that the algorithm detects localized objects such as an insulating sphere and a conductive cylinder immersed in water. Furthermore, covering half of the cylinder by a rubber sleeve to simulate a nonconductive leak, yields a distinct image for the leak. The backprojection algorithm does not need any regularization parameter and it is very fast in inverting the sensitivity matrix because it approximates the inverse matrix by its transposed. The dipole–dipole array usually yields a lower overall pixel error than the modified Schlumberger array but both allow the detection of simulated underground leaks.