地图扫描采样分辨率的研究

本文提醒注意在当前国内生产中常被忽视的地图扫描采样分辨率问题 ,从理论上分析了采样分辨率过低所造成的成果质量问题 ,并提出工程实践中可操作的方法建议。     

等离子体发射光谱法测定大气颗粒物中的无机元素

建立了用等离子体发射光谱（ＩＣＰ－ＡＥＳ）测定大气颗粒物中无机元素的分析方法,包括样品消解体系的选择,仪器的操作条件及采样滤膜的选择,产对自行采样分析测得的无机元素数据作了初步的讨论。实验结果表明：采用ＨＮＯ３－ＨＣｌＯ４消解体系,操作方便,样品消解较完全;选用石英滤膜查减低空白值,保证测定质量以及同时在一张滤膜上测定大气颗粒物中的有机碳、元素碳及无机元素;内标法可有效降低由于仪器漂移等因素对测定     

WITSEG集沙仪:风洞用多路集沙仪

风沙流通量廓线(风沙流结构)是以不同轨迹运动的沙粒在垂直方向上的宏观反映。建立风沙流通量廓线函数需要测定不同高度的输沙率。为此,我们设计了适用于风洞实验的多路集沙仪(WITSEG集沙仪),并通过风洞实验对其进行了检验。WITSEG集沙仪高60 cm,由60个进沙口和集沙盒组成,每个进沙口高1 cm。该集沙仪可以测量风沙流中60个不同高度的输沙率。在设计WITSEG集沙仪时,着重实用性和集沙效率。为了使用方便,带有进沙口的入口段、集沙盒和保护盖板设计为活动式。为了提高集沙效率,入口段设计成楔形,使得进沙口宽0.5 cm,而集沙盒宽度为1.5 cm。每个集沙盒留有两个过滤网排气孔,以减小集沙盒内的静压、提高采集效率。风洞实验检验表明,用WITSEG集沙仪测得的风沙流结构和总输沙率与风速的关系与已广泛接受的结论非常一致。WITSEG集沙仪能观测输沙率随高度的详细变化,是研究风沙流结构的较好工具。     

土地利用变化遥感监测精度评价系统——以随机抽样为基础的方法

中国正在采用遥感技术对 5 0万以上市区非农人口城市的建设用地扩展情况进行分期监测 ,监测结果的精度评价是该项工作的一个重要方面。本文提出以分层随机抽样的方法来获取对遥感监测的精度分析 ,内容包括监测精度评价的指标系统、分层随机抽样样本容量的确定和在各层的分配、抽样评价的工作步骤以及抽样调查的统计分析和结果表达 ,并以北京和重庆 2 0 0 1年的遥感监测数据和实地调查数据为基础进行了精度评价的实际演练。     

On the sampling errors from raingauges and microwave attenuation measurements

The sampling error formalism by North and Nakamoto (1989) has been widely referenced in research papers on sampling using space-borne sensors or ground-borne sensors. However, their formalism is found to not only underestimate the sampling error, especially for the raingauge network case, but also not be applicable for the cases of using a line of raingauges or microwave attenuation measurements. In this paper, the sampling error formalism has been revised and applied to the same sampling design and the same rainrate model as in North and Nakamoto (1989) for the comparison. The sampling error estimated using the revised formula was found to be more than 50% higher than that by North and Nakamoto (1989). For the case of using a line of raingauges we found that the sampling error converges to a certain value, not zero as in North and Nakamoto formalism, as the number of gauges increases. The microwave attenuation measurements case, which is the same as the case of using a line of infinite raingauges, also gives non-zero sampling errors. Finally, the combined sampling using both satellite and ground-borne sensors (e.g., raingauge network, a line of raingauges, or microwave attenuation measurements) was reviewed to check their design orthogonality and estimated the sampling errors for the combination of satellite and raingauge network case to see its behavior depending on various settings of these two different measurements.     

反循环钻头引射孔倾角的仿真分析

介绍了引射装置的工作原理及其在反循环取心钻头体上的应用。运用FLUENT流体工程仿真软件对30°、45°、60°3种不同倾角引射孔内部形成的负压进行模拟,得到对应压力分布云图与数值,并根据所得结论制造出带有3种角度的引射装置。实验室试验数据与仿真结果比较,二者基本吻合。这说明运用仿真技术对引射结构进行优化设计是可靠的,并且过程简单,与经验法和试验法相比,其成本低,周期短,结论更准确。      

杭州湾地波雷达观测的海流数据取样率分析

根据杭州湾口区两台地波雷达5个半月观测的资料,对其中的3 189个有效观测时次的海流数据取样率(CSR)在空间和时间上的变化规律进行了分析,结果表明,在两台雷达波交叉观测的中心区域各测点的地波雷达观测的海流数据取样率高于外围区域,在中心区域海流数据取样率可达98%以上,向外围区域海流数据取样率逐渐平缓递减,到边缘区域海流数据取样率仅在20%以下;地波雷达观测的海流数据取样率有明显的日变化,白天海流数据取样率明显低于夜间;17时海流数据平均取样率达到最低值(约49%),然后很快上升,至02时达最高值(约74%),然后再缓慢下降至17时为止。同时在10时和20时地波雷达观测的海流数据取样率呈现两个相对低值点,可能与人们在这两个时段通讯繁忙所造成的干扰有一定的关系。海流流速对地波雷达观测的海流数据取样率也有较大影响,呈负相关,流速大时海流数据取样率比流速小时的要低,在海流数据取样率大于98%的中心区域,流速和海流数据取样率的相关系数小于-0.8,在海流数据取样率大于60%的区域,流速和海流数据取样率的相关系数小于-0.6,体现明显的相互关联。地波雷达观测的海流数据取样率和潮汐有着每日4次的良好相干,而似乎和风没有显著的关系。希望这些分析对地波雷达以后的推广使用能积累一些经验和参考意见。     

重点行业企业用地调查中的难点及工作建议

重点行业企业用地调查是落实我国《土壤污染防治行动计划》重要基础性工作.此调查工作目前已开展基础信息采集和初步采样调查两个阶段,信息采集工作为初步采样调查提供地块名单,两者承上启下.调查工作存在的难点主要为地块历史生产活动不明确,导致调查时重点区域及特征污染物的遗漏;调查人员专业水平不均一,对于生产工艺较复杂的地块,难免...     

泌阳凹陷安棚油田核三段储层天然裂缝特征研究

根据岩芯裂缝观察结果,通过与FMI,MAIN成像测井资料进行对比,系统描述天然裂缝在成像测井上的影像特征,对地层裂缝特征参数进行了确定.成果反映出核三段地层中的裂缝主要为垂直裂缝倾角在80°～90°之间.走向在100°～110°左右,宽度一般小于1 mm,裂缝长度主要在30 mm以内.     

GGR Biennial Critical Review: Analytical Developments Since 2014

This GGR biennial critical review covers developments and innovations in key analytical methods published since January 2014, relevant to the chemical, isotopic and crystallographic characterisation of geological and environmental materials. In nine selected analytical fields, publications considered to be of wide significance are summarised, background information is provided and their importance evaluated. In addition to instrumental technologies, this review also presents a summary of new developments in the preparation and characterisation of rock, microanalytical and isotopic reference materials, including a précis of recent changes and revisions to ISO guidelines for reference material characterisation and reporting. Selected reports are provided of isotope ratio determinations by both solution nebulisation MC‐ICP‐MS and laser ablation‐ICP‐MS, as well as of radioactive isotope geochronology by LA‐ICP‐MS. Most of the analytical techniques elaborated continue to provide new applications for geochemical analysis; however, it is noted that instrumental neutron activation analysis has become less popular in recent years, mostly due to the reduced availability of nuclear reactors to act as a neutron source. Many of the newer applications reported here provide analysis at increasingly finer resolution. Examples include atom probe tomography, a very sensitive method providing atomic scale information, nanoscale SIMS, for isotopic imaging of geological and biological samples, and micro‐XRF, which has a spatial resolution many orders of magnitude smaller than conventional XRF.