Experimental investigation of drag coefficients of gobi surfaces

The response of gobi surfaces to the near-surface air flow can be characterized quantitatively by drag coefficients. By using wind tunnel tests, an attempt is made to define the relationship between the drag coefficients of gobi surfaces and gravel size and coverage. It is concluded that the drag coefficients of gobi surfaces tend to be constants when gravel coverage is over 40%-50%. Consequently, we think that the gobi deflation planes expanding vastly in the arid Northwestern China are aerodynamically stable, at least not the supplying sources of current dust storms, and therefore the emphasis on dust storm control should be paid on the so-called "earth gobi" that has low gravel coverage. The prediction model for drag coefficients of gobi surfaces has been developed by regressing drag coefficients on gravel size and coverage, the predicted results are in reasonably good agreement with wind tunnel results (R 2 = 0.94). The change of drag coefficients with gravel friction Reynolds number implies that the development extent of drag effect increases with gravel size and coverage.     

不同温压下岩石弹性波速度、衰减及各向异性与组构的关系

结合岩石组构分析 ,阐述了岩石弹性波传播速度和衰减以及它们的各向异性与岩石组构之间的关系。在不同温压条件下对具有很强晶格优选方位的岩石样品的研究表明 ,随着围压的增加 ,波速和Q值均增大 ,但是在相互正交的 3个方向上 (垂直或平行于层理面及线理方向 )增大的速度并不相同 ,这与微裂隙的逐渐闭合密切相关。观测到的波速和Q值的各向异性具有不同的形成机理 ,波速各向异性主要与定向分布的微裂隙和主要矿物的晶格优选方位等构造因素有关 ;高围压下Q值各向异性与速度各向异性正好相反 ,可能是由于定向排列的矿物晶体沿不同方向其边界之间接触程度不同造成的。对岩石组构的研究不仅可以揭示岩体的变形机制、变形的动力学过程及其有关的热力学信息 ,还可以对宏观岩石的各种物理性质 ,尤其是力学特性 ,从微观机理上加以解释。文中特别强调了岩石组构分析对研究岩石物理性质的各向异性具有十分重要的意义。     

碎石土地基湿陷性研究

主要以甘南330 kV变电所碎石土地基的现场浸水载荷试验和室内实验为基础,根据湿陷变形的特征,分析了影响碎石土地基湿陷变形的主要影响因素,探讨了碎石土地基的湿陷机理。认为碎石等大骨架颗粒与细粒胶结物相填充的特殊结构是碎石土地基湿陷最主要的原因。碎石土由于浸水骨架颗粒之间抗剪、抗压强度降低而导致碎石土结构破坏,随之填充在骨架颗粒之间的细颗粒产生二次湿陷,两者引起土体体积减小所导致。     

井周钻孔补砾工艺在修井中的应用

提出了通过井周钻孔恢复旧井填砾层，提高管井涌水量的方法，通过在某电厂供水管井中的实践，证明效果良好。     

中国西南天山西域砾岩的磁性地层年代与地质意义*

西域组是我国西部一重要并广泛引用的晚新生代地层,关于其年代和成因至今尚存争议。在西南天山喀什远源盆地喀什-阿图什褶皱带不同构造部位选择有代表性的5~6个晚新生代地层剖面开展了详细的沉积学、磁性地层年代学对比研究,据此限定了不同构造的起始变形时间以及西域砾岩的沉积年代。西域砾岩并非一年代地层单位,作为一岩石地层单位,其底界具有穿时特征,从山体(北)向喀什前陆盆地(南)逐渐变新。其底界年龄在盆地北部近源区约为15.5Ma^[1],在盆地中部中源区约为8.6Ma^[1],在盆地南部远源区的阿图什背斜为1.9Ma,喀什背斜为1.6~0.7Ma。这一穿时的砾岩沉积楔体的起始堆积起因于盆地北部边界逆冲断层(KBT)的活动。构造变形是由北南脉冲式迁移扩展的,其速率是非均匀的,在约15.5Ma至4.0Ma期间为1.4~3.4mm/a,在约4.0Ma以来剧增至>10mm/a。西域砾岩沉积前缘向南进积速率与构造变形前缘迁移速率有很好的一致性,但在时间上较构造变形可能滞后2.0Ma。这表明构造变形前缘向南的脉冲式扩展是西域砾岩进积并发生侧向和垂向上岩相突变的主因。     

Compressional behavior of clayey sand and transition fines content

Clayey sand can be considered as a composite matrix of coarse and fine grains. The interaction between coarser and finer grain matrices affects the overall stress–strain behavior of these soils. Intergranular void ratio, e_s (which is the void ratio of the coarser grain matrix) can be utilized as an alternative parameter to express the compressive response of such soils. Oedometer tests conducted on reconstituted kaolinite–sand mixtures indicate that initial conditions, percentage of fines, and stress conditions influence the compression characteristics evidently. Tests showed that, up to a fraction of fines, which is named as transition fines content (FC_t), compression behavior of the mixtures is mainly controlled by the sand grains. When concentration of fines exceeds FC_t, kaolinite controls the compression. It was found that FC_t varies between 19% and 34% depending on the above mentioned factors. This range of fines content is also consistent with various values reported in literature regarding the strength alteration. Performed direct shear tests revealed that there is also a close relationship between transition fines content and shear strength, which is harmonic with the oedometer test results.     

Salt weathering in dual-porosity building dolostones

The influence of rock fabric on physical weathering due to the salt crystallization of selected brecciated dolostones is discussed. These dual-porosity dolostones are representative of heterogeneous and anisotropic building rocks, and present highly complex and heterogeneous rock fabric features. The pore structure of the matrix and clasts is described in terms of porosity and pore size distribution, whereas the relative strength for each textural component is assessed using the Knoop hardness test. The whole characterisation process was carried out using the same samples as those used in the standard salt durability test (EN-12370), including connected porosity, the water saturation coefficient, fissure density, compressional wave velocity and waveform energy.

Results show the most important rock fabric elements to be considered are the matrix and clast properties and the nature of fissures. Firstly, a relatively weak matrix was the focus of major granular disintegration as it presents high porosity, low pore radius and reduced strength. Secondly, narrow micro-fissures appear to be important in the decay process due to the effectiveness of crystallization pressure generated by salt growth. On the contrary, macro-fissures do not contribute greatly to rock decay since they act as sinks to consume the high supersaturations caused by growth of large crystals. Additionally, an analysis of stress generated by crystallization was carried out based on the general situation of a lenticular crystal geometry. Finally, the relationships between whole petrophysical properties and durability were established using a principal component analysis. This analysis has clearly established that the durability of rocks affected by salt crystallization mechanisms diminishes in weaker and anisotropic rocks with high porosity and fissure density.     

Experimental Investigation of Eclogite Rheology and Its Fabrics at High Temperature and Pressure

Eclogite plays an important role in mantle convection and geodynamics in subduction zones. An improved understanding of processes in the deeper levels of subduction zones and collision belts requires information on eclogite rheology. However, the deformation processes and associated fabrics in eclogite are not well understood. Incompatible views of deformation mechanism have been proposed for both garnet and omphacite. We present here deformation behaviour of eclogite at temperatures of 1027–1427 °C, confining pressures of 2.5–3.5 GPa, and strain rates of 1 × 10^?5 s^?1 to 5 × 10^?4 s^?1. We obtained a power‐law creep for the high temperature and pressure deformation of a ‘dry’ eclogite (50 vol.% garnet, 40% omphacite and 10% quartz) with A = 10^{3.3 ± 1.0}, n = 3.5 ± 0.4, ΔE =403 ± 30 KJ mol^?1 and ΔV = 27.2 cm³ mol^?1. The two principal minerals of eclogite have greatly different strengths. Progressive increase of garnet results in a smooth increase in strength. Analysis by electron back‐scattered diffraction shows that: (1) garnet displays pole figures with near random distributions of misorientation angle under both dry and wet conditions; (2) omphacite shows pronounced lattice preferred orientations (LPOs), suggesting a dominant dislocation creep mechanism. Further investigation into the water effects on eclogite show: (3) water content does not influence the style of omphacite fabric but increases slightly the fabric strength; (4) grain boundary processes dominate the deformation of garnet under high water fugacity or high shear‐strain conditions, yielding a random LPO similar to that of non‐deforming garnet, despite the strong shape preferred orientation (SPO) observed. {110} [001] slip may dominate the deformation of rutile. Quartz displays complicated and inconsistent LPOs in eclogite. These results are remarkably similar to observations from deformed eclogites in nature.     

东天山秋格明塔什黄山韧性剪切带变形特征分析

东天山秋黄韧性剪切带位于新疆东部两大板块碰撞接合地带,东西延长逾６００ｋｍ,由石炭系组成,规模巨大,分带明显,宏微观变形标志清晰,石英Ｃ轴组构呈点极密型,分为四期变形,序列演化明显,应变测量属平面单剪,剪切位移量达７５ｋｍ以上,存在脆韧性变形转换,变形时代为海西中晚期,强弱应变相间排列的标度不变性特征明显,变形机制属地壳中深层次塑性流变和韧性剪切,与板块间的俯冲碰撞构造演化密切相关。控制着金铜矿分布。     

新类型金矿──萤石型金矿的矿石物质成分及组构特征

浙江东南地区的萤石型金矿,系一新类型金矿床。矿石学研究表明,其主要工业矿物为银金矿,与之共生的矿物有黄铁矿、黄铜矿、方铝矿、闪锌矿、辉银矿等。矿石结构构造有多种,矿床的形成有多期次。成矿与硅化,黄铁矿化和萤石化相关。