钻孔灌注桩施工对邻近运营隧道变形影响研究

桩基施工将引起周边地层位移和邻近隧道结构变形,以南京龙津桥改建项目桩基工程为背景,通过现场实测,分析研究钻孔灌注桩施工全过程各工况条件对地层位移场和邻近既有隧道结构变形的影响规律。结果表明:由于钢套管的护壁作用,钻孔灌注桩施工过程中产生的最大地层位移和隧道结构变形较小,说明采用“钢套管边旋压边取土”、“群桩间跳施工”等工艺,对周围土体扰动影响程度较小,建议近隧桩基工程采用全套管灌注桩的施工方法,监测分析结果可为类似工程提供技术参考。     

Comparison of two methods for seismic hazard assessment in a low-seismicity area

The EGO method, developed by Egozcue et al. and the SRAMSC method, originally developed by Cornell and later programmed by McGuire, to assess the seismic hazard, are compared for the low seismicity area Belgium, The Netherlands, and NW Germany. Using the same input data, the results of the EGO method without the majority criterion and the SRAMSC method with upper bound XII agree very well. The influence of the zoning is investigated for the EGO method. It is not necessary to define the zones for the EGO method so strictly as for the SRAMSC method, but too wide zones can give bad results.     

近45 a来中国西北年极端高、低温的变化及对区域性增暖的响应

利用中国西北五省(区)1960-2004年129个台站逐日最低、最高温度资料,从中统计出年极端高温发生频次、年极端低温发生频次、年极端高温强度、年极端低温强度以及年极端高温和低温开始和结束日期,分析了它们近45 a来的变化情况。结果表明:近45 a来中国西北年极端高温发生频次的增加趋势是明显的,而年极端低温发生频次的减少趋势更显著;中国西北近45 a来年极端高温的强度在不断增强,而极端低温的强度在不断减弱;近45 a来中国西北年极端高温开始日期逐渐提前,结束日期逐渐推迟,而年极端低温的开始日期在逐渐推迟,结束日期在逐渐提前;年极端低温发生频次的减少对于西北区域增暖的响应比年极端高温发生频次增加更显著,而年极端低温强度的减弱要比年极端高温强度的增强对西北区域性增暖的响应偏弱,年极端高温发生频次的增加同年极端高温强度的增强对西北区域性增暖的响应程度基本相当。     

Effects of low molecular weight organic acids on sorption and desorption behavior of p-chlorophenol by yellow earth

Low molecular weight organic acids （LMWOAs） are important components of root exudates. They play an important role in immobilizing and remobilizing contaminants in rhizospheric soil. Effects of four LMWOAs on the sorption and desorption behavior of p-chlorophenol by yellow earth was studied in batch mode. The results showed that the previous application of LMWOAs to enhanced adsorption capacity of p-chlorophenol of the soil in the order of maleic acid〉malic acid〉oxalic acid〉citric acid. However, when LMWOAs were applied to soil where p-chlorophenol had been previously adsorbed, substantial p-chlorophenol was desorbed from soil by oxalic acid, whereas citric acid, malic acid and maleic acid didn＇t desorb as much p-chlorophenol from soil as deionized water.     

自重湿陷性黄土地区桩基设计探讨

根据自重湿陷性黄土的特点、《湿陷性黄土地区建筑规范》（GB50025—2004）和《建筑桩基技术规范》（JGJ94—94）中关于桩基设计的对比分析，通过自重湿陷性黄土场地工程实例分析计算，依据负摩擦产生的机理——中性点理论，论述了自重湿陷性黄土场地中桩基设计应考虑中性点，而不应全部计入负摩阻的观点。     

大变形有限元法分析边坡稳定性

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。     

A Connectivity Index for Discrete Fracture Networks

Connectivity is an important measure for assessing flow transport in rock, especially through fractures. In this paper, rock fracture systems are modelled by a discrete fracture model simulated by a marked point process. A connectivity index is then introduced to quantify the connectivity between any two points in space. Monte Carlo simulation is used to evaluate the connectivity index for stationary cases and relationships between the connectivity index and the parameters of the discrete fracture model are analysed. The average number of intersections per fracture, X_f, and the fracture intensity, P12 (P32), are calculated and the relationships between these parameters and the connectivity index are investigated, concluding that X_f is the more suitable parameter for the classification of rock mass flow properties. The relationships between the connectivity index and the percolation state of the fractured medium are also discussed. An edge correction is briefly discussed and a practical example is used to demonstrate the method of computing the connectivity index.     

Centennial to millennial geomagnetic secular variation

A time-varying spherical harmonic model of the palaeomagnetic field for 0–7 ka is used to investigate large-scale global geomagnetic secular variation on centennial to millennial scales. We study dipole moment evolution over the past 7 kyr, and estimate its rate of change using the Gauss coefficients of degree 1 (dipole coefficients) from the CALS7K.2 field model and by two alternative methods that confirm the robustness of the predicted variations. All methods show substantial dipole moment variation on timescales ranging from centennial to millennial. The dipole moment from CALS7K.2 has the best resolution and is able to resolve the general decrease in dipole moment seen in historical observations since about 1830. The currently observed rate of dipole decay is underestimated by CALS7K.2, but is still not extraordinarily strong in comparison to the rates of change shown by the model over the whole 7 kyr interval. Truly continuous phases of dipole decrease or increase are decadal to centennial in length rather than longer-term features. The general large-scale secular variation shows substantial changes in power in higher spherical harmonic degrees on similar timescales to the dipole. Comparisons are made between statistical variations calculated directly from CALS7K.2 and longer-term palaeosecular variation models: CALS7K.2 has lower overall variance in the dipole and quadrupole terms, but exhibits an imbalance between dispersion in   g ¹₂  and   h ¹₂  , suggestive of long-term non-zonal structure in the secular variations.     

Effect of sampling and linkage on fault length and length–displacement relationship

The power-law exponent (n) in the equation: D=cL ⁿ , with D = maximum displacement and L = fault length, would be affected by deviations of fault trace length. (1) Assuming n=1, numerical simulations on the effect of sampling and linkage on fault length and length–displacement relationship are done in this paper. The results show that: (a) uniform relative deviations, which means all faults within a dataset have the same relative deviation, do not affect the value of n; (b) deviations of the fault length due to unresolved fault tip decrease the values of n and the deviations of n increase with the increasing length deviations; (c) fault linkage and observed dimensions either increase or decrease the value of n depending on the distribution of deviations within a dataset; (d) mixed deviations of the fault lengths are either negative or positive and cause the values of n to either decrease or increase; (e) a dataset combined from two or more datasets with different values of c and orders of magnitude also cause the values of n to deviate. (2) Data including 19 datasets and spanning more than eight orders of fault length magnitudes (10⁻²–10⁵ m) collected from the published literature indicate that the values of n range from 0.55 to 1.5, the average value being 1.0813, and the peak value of n _d (double regression) is 1.0–1.1. Based on above results from the simulations and published data, we propose that the relationship between the maximum displacement and fault length in a single tectonic environment with uniform mechanical properties is linear, and the value of n deviated from 1 is mainly caused by the sampling and linkage effects.