胶东三甲金矿床流体包裹体特征

三甲金矿是胶东牟平-乳山金成矿带内重要的石英脉型金矿,金主要产于黄铁矿和多金属硫化物石英脉中。流体包裹体研究表明,三甲金矿蚀变岩石和各成矿阶段金矿石中的流体包裹体主要有三种类型：H2O-CO2包裹体、富CO2包裹体和H2O溶液包裹体。早期乳白色石英中主要赋存原生的H2O-CO2包裹体;成矿期黄铁矿石英脉和多金属硫化物石英脉中的富CO2包裹体主要为原生,随机分布,气液比变化较大,常与早期H2O溶液包裹体共生且均一温度接近,显示不混溶流体包裹体组合特征;在成矿晚期的石英和方解石中主要发育原生H2O溶液包裹体。显微测温结果显示,成矿前（第1阶段）H2O-CO2包裹体的完全均一温度（Tb．TOT,至液相）为280℃至416℃,成矿期（第Ⅱ和Ⅲ阶段）富CO2包裹体的完全均一温度为210—330℃,同期的H2O溶液包裹体均一温度为253～377℃,成矿后（第Ⅳ阶段）H2O溶液包裹体的均一温度为176—207℃。成矿流体为低盐度的CO2-H2O-NaCl型热液,成矿应力场转变导致的流体减压沸腾作用可能是三甲金矿金沉淀成矿的主要原因。     

西洋东大港水道流速垂线分布研究

对辐射沙洲海域东大港4#站位连续2个潮周期的流速测量资料进行了分析、研究,拟合给出了流速垂线分布关系,并根据实际测量资料确定了该站位6个水层的浑水水流尾流函数项表达式。这些表达式表明浑水水流尾流函数是相对深度和摩阻速度的函数。探讨分析了尾流函数的空间分布和潮周期过程。非恒定流的水流尾流函数项的准确表达,对于揭示含沙水流流速结构及水、沙相影响作用规律将起到启发和推动作用。     

辐射沙洲南翼“水道-沙洲”系统与西太阳沙的稳定

通过对江苏岸外辐射沙洲动态和西太阳沙海域动力泥沙环境的分析,论述了西太阳沙演变的宏观背景;由实测固定断面资料、地形资料的对比得出近40年来西太阳沙表面形态和水下地形的变化;结合西太阳沙表面泥沙在波浪和波流共同作用下运动特性的水槽试验研究,分析了西太阳沙冲淤变化的动力机制。从“烂沙洋水道-西太阳沙-西太阳沙南水道”系统的角度研究了西太阳沙演变的控制因素和演变规律。     

Modeling bed-load transport of coarse sediments in the Great Bay Estuary, New Hampshire

Current, sea level and bed-load transport are investigated in the Lower Piscataqua River section of the Great Bay Estuary, New Hampshire, USA—a well-mixed and geometrically complex system with low freshwater input, having main channel tidal currents ranging between 0.5 and 2 m s⁻¹. Current and sea level forced by the M₂M₄M₆ tides at the estuarine mouth are simulated by a vertically averaged, non-linear, time-stepping finite element model. The hydrodynamic model uses a fixed boundary computational domain and accounts for flooding–drying of tidal flats by making use of a groundwater component. Inertia terms are neglected in comparison with pressure gradient and bottom friction terms, which is consistent with the observed principal dynamic balance for this section of the system. The accuracy of hydrodynamic predictions in the study area is demonstrated by comparison with four tidal elevation stations and two cross-section averaged current measurements. Simulated current is then used to model bed-load transport in the vicinity of a rapidly growing shoal located in the main channel of the lower system. Consisting of coarse sand and gravel, the shoal must be dredged every five to eight years. Two approaches are taken—an Eulerian parametric method in which nodal bed-load flux vectors are averaged over the tidal cycle and a Lagrangian particle tracking approach in which a finite number of sediment particles are released and tracked. Both methods yield pathways and accumulations in agreement with the observed shoal formation and the long-term rate of sediment accumulation in the shoal area.     

南海东部海域柱样沉积物浊流沉积探讨

利用1998年南海东部陆坡69号柱样、深海盆149号柱样、南部岛礁323号柱样沉积物的粒度、化学、古生物、矿物等鉴定分析测试资料,分析了南海东部海域发生浊流沉积的地质背景、产生浊流沉积的条件和诱发因素,进而发现南海东部浊流沉积发育,在南北陆坡及中部深海盆地均有浊流沉积层。从其出现层位看,为氧同位素2—4期,即晚更新世中晚期。从浊流沉积出现层数分析,具有自北向南浊流发生频次减弱的趋势。从浊流沉积物成分看,南海东部浊流沉积物具有多样性,北部陆坡以陆源为主,中部深海盆以陆源及火山源为主,南部岛礁以生物源为主。     

低围压水平下砂的排水行为(英文)

采用干样沉降法制备样品 ,选用静三轴仪对松砂和密砂样在 10 k Pa至 10 0 k Pa的低围压下的排水行为进行了实验研究 ,并对实验结果作了橡皮膜校正 ,在围压为 10 k Pa的密砂实验中 ,轴向应力的校正值可达到 12 %。实验研究表明低围压下松砂的剪胀性非常明显 ,且存在剪应力极值 ;围压越低 ,松砂和密砂的剪应力极值越小 ,达到最大剪应力所对应的剪应变越小。同时还表明低围压范围内相对密度不同 ,砂的应力应变特性不同 ;此外 ,低围压下砂的内摩擦角高于高围压下的值 ,从而在工程上应重视低围压水平下砂土工程参数的合理选取     

The morphodynamic modelling of tidal sand waves on the shoreface

An artificial sand wave on the Dutch shoreface of the North Sea has been studied in conditions with relatively strong tidal currents in the range of 0.5 to 1 m/s and sediments in the medium sand size range of 0.2 to 0.5 mm. The sand wave is perpendicular to the tidal current and has a maximum height and length of the order of 5 m and 1 km, respectively. The sand wave is dynamically active and shows migration rates of the order of a few metres per year. A numerical morphodynamic model (DELFT3D model) has been used to simulate the morphological behaviour of the sand wave in the North Sea. This model approach is based on the numerical solution of the three-dimensional shallow water equations in combination with a surface wave propagation model (wind waves) and the advection–diffusion equation for the sediment particles with online bed updating after each time step. The model results show that the sand wave grows in the case of dominant bed-load transport (weak tidal currents; relatively coarse sediment; small roughness height; low waves) and that the sand wave decays in the case of dominant suspended transport (strong currents, relatively fine sediment, large roughness height; storm waves).     

Stress Sharing Behavior and Its Mechanism during Consolidation Process in Composite Ground Improved by Sand Compaction Piles with Low Replacement Area Ratio

In order to accurately design a sand compaction pile (SCP) with low replacement area ratio, it is important to understand the mechanical interaction between the sand pile and clay ground and its mechanism during consolidation process in composite ground. In this article, therefore, a series of numerical analyses on composite ground improved by SCP with low replacement area ratio were carried out. The applicability of numerical analyses, in which an elasto-viscoplastic consolidation finite element method was applied, were confirmed by comparing the results obtained from a series of laboratory model tests with the composite ground improved by SCP. Through the results of the numerical analyses, mechanical behavior of the sand pile and clay in composite ground during consolidation is elucidated, together with a stress sharing mechanism between sand pile and clay.     

东南沿海海堤现状调研报告（福建部分）

这部分是福建省正在建设中的四大海堤现状调研，包括达标设计各项指标及其加高加固的技术经验。同时调研了围海工程堵口海堤的施工过程，并对灌砂防渗措施加以评述。最后介绍了兴化湾的莆田海堤试验站和木兰陂水利工程     

A Numerical Model of Coastal Processes of Sand Beaches Based on Long-Term Wave Series

A numerical model of shoreline change of sand beaches based on long-term field wave data is proposed, the explicit and implicit finite difference forms of the model are described, and an application of the model is presented. Results of the application indicate that the model is sensitive to the order of the input wave data, and that the effects of long-term wave series and the effects of the mean annual wave conditions on the model are different. Instead of a single wave condition, the wave series will make the calibration and the verification of the model more practical and the results of the model more reasonable.