制造金刚石钻头的快速电镀法研究

总结了两年多来采用较高电流密度法制造金刚石钻头的经验,运用快速电镀法制造金刚石钻头不仅大大提高了生产效率,而且提高了金刚石钻头的质量。     

东太平洋我国开辟区底层海流锚泊观测

“海洋四号”在执行ＤＹ９５－７和ＤＹ９５－９航次调查任务期间,在东太平洋我国开辟区做了２个测站的底层海流观测。观测资料分析表明,底层流的流速在１．２～１２．０ｃｍ／ｓ之间;底层流有月际和日际变化,并发现底层流存在“不活动”期。     

Current Nature of the Kuroshio in the Vicinity of the Kii Peninsula

The Kuroshio flows very close to Cape Shionomisaki when it takes a straight path. The detailed observations of the Kuroshio were made both on board the R/V Seisui-maru of Mie University and on board the R/V Wakayama of the Wakayama Prefectural Fisheries Experimental Station on June 11–14, 1996. It was confirmed that the current zone of the Kuroshio touches the coast and bottom slope just off Cape Shionomiaki, and that the coastal water to the east of the cape was completely separated from that to the west. The relatively high sea level difference between Kushimoto and Uragami could be caused by this separation of the coastal waters when the Kuroshio takes a straight path. This flow is rather curious, as the geostrophic flow, which has a barotropic nature and touches the bottom, would be constrained to follow bottom contours due to the vorticity conservation law. The reason why the Kuroshio leaves the bottom slope to the east of Cape Shionomisaki is attributed to the high curvature of the bottom contours there: if the current were to follow the contours, the centrifugal term in the equation of motion would become large and comparablee to the Coriolis (or pressure gradient) term, and the geostrophic balance would be destroyed. This creates a current-shadow zone just to the east of the cape. As the reason why the current zone of the Kuroshio intrudes into the coastal region to the west of the cape, it is suggested that the Kii Bifurcation Current off the southwest coast of the Kii Peninsula, which is usually found when the Kuroshio takes the straight path, has the effect of drawing the Kuroshio water into the coastal region. The sea level difference between Kushimoto and Uragami is often used to monitor the flow pattern of the Kuroshio near the Kii Peninsula. It should be noted that Uragami is located in the current shadow zone, while Kushimoto lies in the region where the offshore Kuroshio water intrudes into the coastal region. The resulting large sea level difference indicates that the Kuroshio is flowing along the straight path.     

深圳大鹏湾大鹏半岛沿岸海域的一次调查与分析

一九九八年三月,我们在大鹏半岛海域调查时,恰逢深圳大鹏半岛近岸海域赤潮发生。结合我们对该区域内沿海水域调查结果进行分析,给出该海域的潮汐、潮流的基本特征及当时该海域的水质状况,为规划、保护该海域的海洋环境提供科学依据,并为研究赤潮发生成因提供参考资料。     

高频地波雷达单站测量表层海流的原理

运用高频地波雷达测量表层海流矢量,一般均采用双站测量方案,因而,需要大量的人力和昂贵的设备投入。该项研究在分析双站测量原理的基础上,结合海洋学原理和合理的假设,推导并给出了利用单站地波雷达测量表层海流的原理和公式,从而使单站测量表层海流成为可能。可预期该方案虽然在一定程度上,适当降低了空间分辨率,但却可以大幅度降低观测成本,减少人力物力的投入,并显著提高现场观测效率。     

Sedimentary characteristics and genetic mechanism of the giant ancient pockmarks in the Qiongdongnan Basin,northern South China Sea

In the late Miocene, giant ancient pockmarks, which are fairly rare globally, developed in the Qiongdongnan Basin. In this paper, to determine the sedimentary characteristics and genetic mechanism of these giant ancient pockmarks in the Yinggehai Formation of the Qiongdongnan Basin, based on high-resolution 3D seismic data and multiattribute fusion technologies, we analyzed the planar distribution and seismic facies of the ancient pockmarks and compared the characteristics of the ancient pockmar...     

海面水包油乳化液溢油量等效估算方法研究

激光诱导荧光(LIF)是一种主动光学探测技术,该技术已在海面未乳化溢油油种鉴别及油膜厚度评估方面取得了一定的研究成果,但乳化溢油的监测理论基础和探测方法尚未成熟。溢油乳化物的量化会直接影响溢油污染的应急处理和灾害评估,但目前对溢油乳化液溢油量的计算尚未有研究报道。本文以水包油乳化液为研究对象,基于等效思想,根据油量相等建立了水包油乳化液与油膜的荧光检测等效模型,并依据光的辐射传输机理推导出等效油膜厚度的估算公式,最后采用仿真实例对估算方法的适用性和有效性进行了验证。实验结果表明,当水包油乳化液含油率小于12×10^-6,厚度小于5.98 cm时,利用所提出的等效方法能有效计算出水包油实际溢油厚度。该方法可为海面乳化溢油量的估算提供一种创新性的方法,具有良好的借鉴意义和实际应用价值。     

Dynamic analysis of sliding structures with unsynchronized support motions

The dynamic analysis of sliding structures is complicated due to the presence of friction. Synchronization of the kinematics of all the isolation bearings is often granted to simplify the task. This, however, may lead to inaccurate prediction of the structural responses under certain circumstances. Stepped structures or continuous bridges with seismic isolation are notable examples where unsynchronized bearing motions are expected. In this paper, a logically simple and numerically efficient procedure is proposed to solve the dynamic problem of sliding systems with unsynchronized support motions. The motion equations for the sliding and non‐sliding modes of the isolated structure are unified into a single equation that is represented as a difference equation in a discrete‐time state‐space form and the base shear forces between the sliding interfaces can be determined through simple matrix algebraic analysis. The responses of the sliding structure can be obtained recursively from the discrete‐time version of the motion equation with constant integration time step even during the transitions between the non‐sliding and sliding phases. Therefore, both accuracy and efficiency in the dynamic analysis of the highly non‐linear system can be enhanced to a large extent. Rigorous assessment of seismic structures with unsynchronized support motions has been carried out for both a stepped structure and a continuous bridge. Effectiveness of friction pendulum bearings for earthquake protection of such structures has been verified. Moreover, evident unsynchronized sliding motions of the friction bearings have been observed, confirming the necessity to deal with each of the bearings independently in the analytical model. Copyright © 2000 John Wiley & Sons, Ltd.     

龙门山地区历史强震数值模拟

考虑区域地质构造差异、主要活动断裂分布特征和地表附加重力影响,建立反映龙门山地区地表起伏和岩石圈分层的三维粘弹性有限元模型。以GPS为约束重建研究区现今构造应力场,依次模拟龙门山地区1900年以来发生的5次M_S 7.0以上地震,从库仑应力和等效应力角度,分析应力场演化对强震的影响以及强震间的相互作用关系。研究结果表明:从库仑应力角度,有3次地震对后续地震有促进作用,其中汶川地震对芦山地震有触发作用;从等效应力角度,有4次地震对后续地震的发生具有加速作用。