海洋监测即时信息服务的设计与实现

提出了海洋监测即时服务的框架,并对该框架下的海洋监测即时服务应用系统的设计概要、系统组成和功能做了介绍。依据该框架研发即时服务应用系统在多个台站和终端用户得到应用,系统运行良好,为海洋监测信息的即时服务提供了保障。     

El Ni(n)o phenomenon in simple ocean data assimilation data

To study how the air and sea interact with each other during El Nino/La Nina onsets, extended associate pattern analysis (EAPA) is adopted with the simple ocean data assimilation (SODA) data. The results show that as El Nino/La Nina' s parents their behaviors are quite different, there does not exist a relatively independent tropical atmosphere but does exist a relatively independent tropical Pacific Ocean because the air is heated from the bottom surface instead of the top surface and of much stronger baroclinic instability than the sea and has a very large inter-tropical convergence zone covering the most tropical Pacific Ocean. The idea that it is the wester burst and wind convergence, coming from middle latitudes directly that produce the seawater eastward movement and meridional convergence in the upper levels and result in the typical El Nino sea surface temperature warm signal is confirmed again.     

极端波浪条件下黏土质斜坡海床稳定性解析

海洋资源开发引起海底软黏土的结构性破坏,导致土体强度弱化,在百年一遇的极端波浪作用时极易发生斜坡海床的局部失稳甚至大范围海底滑坡,给海洋工程建设和正常运营带来严重影响。目前,主要采用极限平衡法评价这类海底斜坡,但该法只能给出近似解。基于极限分析上限方法,推导了极端波浪诱发的波压力对斜坡海床的做功功率,建立了外力功与内能耗散率平衡方程;利用最优化方法,结合数值积分和强度折减技术,求解了不同时刻的斜坡海床稳定性系数,并针对扰动后的斜坡海床开展了有限元解的对比验证。在此基础上,深入探讨了不同波浪参数(波长、波高和水深)和坡长小于一个波长等极端条件下的海底斜坡稳定性。     

北黄海QuikSCAT 卫星风速与浮标风速的对比分析

对北黄海QuikSCAT散射计矢量风资料与黄海实测浮标站风速资料进行对比分析,结果表明:北黄海QuikSCAT卫星风速和浮标观测风速的大小基本吻合,二者平均偏差是0.26 m/s,相关系数是0.74;风向偏差较大,平均偏差是117.52°。根据卫星风速和浮标风速的对比分析结果,提出了修正方案。修正后的QuikSCAT风向与实测浮标站风向的平均偏差显著提高到20.44°。该修正方案实施简单,修正效果显著,为更准确地使用卫星资料提供了保证。     

海浪预报产品数据库管理系统开发研究

本文介绍海浪预报产品数据库管理系统，包括数据库管理系统的总体设计，硬软件的配置，数据库管理系统的主要内容和解决的关键技术。该数据库管理系统的建成，提供了我国近海和西北太平洋海浪预报的系统性资料，不仅对提高海浪预报准确率提供基础资料，也给海浪中长期预测预报方法研究和区域海洋学研究带来极大帮助。     

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.     

计算数据域特征值的两种算法

设计两种计算数据域特征值的算法。此特征值通常是用线性反馈移位寄存器（ＬＦ－ＳＲ）组成的特征分析器得到的．在数据已按字节存放和速度要求不高的场合下，本算法将是十分方便和有用的．     

ADCP资料处理中的船速计算

船载ADCP具有走航测流的特点,弥补了传统测流仪器只有停船才能观测的不足。它可以同时观测多层海流数据,获取连续性资料。ADCP测得流速是海水相对于船体的速度,在正常观测条件下,船速远大于海水流速,因而船速计算是ADCP资料处理的关键。本文对不同的船速计算方法进行了比较,对使用参考层法计算船速的原理、特点和效果进行了论述。     

海域使用权属数据质量控制系统设计

海域使用权属数据是海域使用科学研究和海域综合管理决策制定的重要依据。文章分析了海域使用权属数据质量控制的现状,研究了海域使用权属问题数据质量控制的判别方法。设计了计算机与人工校验相结合的数据质量控制系统,实现海域使用权属数据系统化的质量控制和管理,为海域使用统计和海域使用管理决策支持提供参考。     

基于云存储技术的海岛信息管理和 展示平台设计与实现

随着海岛遥感影像数据的不断积累,传统数据存储管理方法越来越难以满足需求。针对上述问题,利用云存储技术对海岛影像数据进行分块组织,建立分布式海岛影像数据集,并在优化数据存储的同时,设计了一套海岛信息多形式展示平台。实现了信息检索、数据传输与审核、分析评价、成果展示和共享等功能。