Ultimate strength of ship hulls under torsion

For a ship hull with large deck openings such as container vessels and some large bulk carriers, the analysis of warping stresses and hatch opening deformations is an essential part of ship structural analyses. It is thus of importance to better understand the ultimate torsional strength characteristics of ships with large hatch openings. The primary aim of the present study is to investigate the ultimate strength characteristics of ship hulls with large hatch openings under torsion. Axial (warping) as well as shear stresses are normally developed for thin-walled beams with open cross sections subjected to torsion. A procedure for calculating these stresses is briefly described. As an illustrative example, the distribution and magnitude of warping and shear stresses for a typical container vessel hull cross section under unit torsion is calculated by the procedure. By theoretical and numerical analyses, it is shown that the influence of torsion induced warping stresses on the ultimate hull girder bending strength is small for ductile hull materials while torsion induced shear stresses will of course reduce the ship hull ultimate bending moment.     

Standard facies models to incorporate all heterogeneity levels in a reservoir model

The construction of reservoir models is frustrated by the fact that core and well cover only a fraction of the reservoir volume and it is therefore difficult to determine features like facies shape, -size, and -distribution, inter- and intra-facies boundaries and lateral trends from them. These features are, however, critical to fluid flow and they should necessarily be incorporated in the reservoir model and we therefore propose to systematically describe geometry and distribution of facies. To this end we make use of “standard facies models” that a priori contain all elements and boundaries of facies for a number of typical depositional environments.     

影响萼花臂尾轮虫种群增长的生态学因子的研究：温度和饵料密度的影响

本文研究了在5个温度梯度和4个饵料密度的20个试验组合下，萼化臂尾轮虫（Brachionuscalyciflorus）的种群增长规律。结果表明，该轮虫实验种群的最适温度范围是28—32℃，临界高温是36－40℃；最适饵料密度是45－65×106个／ml。这两个生态因子的最佳组合是温度32℃，饵料密度为65×106个／ml，此时，种群达最大密度3．4×103个／ml。     

模型沙干重度的变化规律及其在泥沙模型试验中的作用

模型沙干重度在动床模型试验中是影响起动流速比尺和冲淤时间比尺的重要参数，其随淤积历时、粒径变化、埋置深浅和加工方法的不同有着不同的变化规律。通过试验，结合已有的成果，对模型沙干重度受以上几种因素的影响进行了研究，并进一步分析了其变化规律在动床模型试验中的作用。     

Experimental Investigation of Instantaneous Properties of Wave Slamming on the Plate

The purpose of this paper is to investigate the instantaneous properties of wave slamming on the plate structure of an open structure.The advanced instantaneous measuring technique-Particle Image Velocimetry(PIV) is applied to acquire the instantaneous velocity field of wave slamming.From the cross-correlation analysis results of the images captured by the CCD camera,the flow fields of wave impacting on the structure are displayed visually,and the instantaneous whole-field fluid velocity vectors are obtained.The relation between the instantaneous peak impacting pressures and the instantaneous velocities of water particles is studied by probability analysis.     

Changes in distribution patterns of 0-group bivalves in the Wadden Sea: Byssus-drifting releases juveniles from the constraints of hydrography

The large-scale (km) distributional patterns of juvenile bivalves are established by larval settlement and subsequently changed due to actively initiated postlarval migrations (byssus-drifting), resuspension during sediment disturbance, and local differences in mortality. Repeated mapping of 0-group bivalve distribution during two summers was combined with simultaneous registrations of the numbers of drifting specimens. Species differed in their susceptibility to passive resuspension and their activity in byssus-drifting, but the two ways of entry into the water column were independent of each other. As a result, the relative magnitude of byssus-drifting and passive resuspension varied with the species. While hydrographical conditions always determined the changes in the distributional patterns of passively eroded species, this was not the case in active migrations of byssus-drifting bivalves. A comparison of the distributional patterns of juveniles over two consecutive years showed similar patterns in the tellinid clam Macoma balthica and the razor clam Ensis americanus. In these two species spatfall mainly occurred around mean low-tide level. Subsequently, juvenile M. balthica rapidly accumulated in the upper intertidal, whereas juvenile E. americanus accumulated subtidally. In mussels Mytilus edulis the distribution of juveniles only changed in a longshore direction, not in the tidal level occupied. The spatial pattern of cockles Cerastoderma edule changed from aggregation of the early spat in the mid and lower intertidal towards a more uniform distribution of recruits over these tidal flats. There were only a few patches of high abundance left at the end of summer. Finally, in juvenile clams Mya arenaria the spatial patterns of both spatfall and redistribution were unpredictable.On a km-scale, abundance of some species correlated with sediment granulometry. Presumably, this does not reflect a causal relationship but is a consequence of the correlation between grain size distribution and tidal level within the area studied. On a scale of hundreds of metres, there were no consistent correlations between juvenile abundance and sediment granulometry in any species. In summary, it seems that hydrography ruled the initial settlement of larvae to the sediment and strongly influenced the subsequent redistribution of juveniles caused by passive resuspension. The outcome of actively initiated migrations, on the other hand, was only weakly influenced by hydrography. Therefore it is suggested that hydrography plays a dominant role in the initial development of km-scale distributional patterns of just-settled bivalves in the Wadden Sea, while habitat selection is delayed to the byssus-drifting postlarvae phase.