Occurrence of hypogenic caves in a karst region: Examples from central Italy

The caves of the Umbria and Marche regions in central Italy are made up of three-dimensional maze systems that display different general morphologies due to the various geological and structural contexts. At the same time, the internal morphologies of the passages, galleries, and shafts present some similarity, with solutional galleries characterized by cupolas and blind pits, anastamotic passages, roof pendants, and phreatic passages situated at different levels. Some of these caves are still active, as is the case for Frassassi Gorge, Parrano Gorge, and Acquasanta Terme, with galleries that reach the phreatic zone, where there is a rising of highly mineralized water, rich in hydrosulfydric acid, and with erosion of limestone walls and the formation of gypsum. Elsewhere there are fossil caves, such as Monte Cucco and Pozzi della Piana, where large speleothems of gypsum are present 500 m or more above the regional water table. In all of these important karst systems it is possible to recognize basal input points through fracture and intergranular porosity networks at the base of the oxidizing zone in the core of the anticline, where mineralized water rises up from the Triassic evaporitic layers in small hydrogeological circuits. Different underground morphologies can derive from the presence of a water table related to an external stream or from the confined setting of the carbonate rocks, underlying low permeable sedimentary cover, where artesian conditions can occur.     

突变理论在工程地质中的应用

本文说明了突变理论应用于工程地质中的一般方法。着重通过实例介绍尖点突变理论在工程地质中的应用现状,其中包括用突变理论评价层状结构斜坡、地下洞室的顶板冒落及活断层的稳定性,以及斜坡失稳的时间预报等问题。同时对其应用前景作了展望。     

试论岩溶在沉积—改造铅锌矿床形成中的作用

在碳酸盐岩地区广泛分布着一些沉积—改造铅锌矿床.其主要改造作用目前一般概括为地下(热)水作用.本文通过比较地下水改造成矿作用与岩溶作用之间的关系,论证岩溶在矿床形成中起着重要作用,即地下水改造富积成矿作用主要为岩溶作用.     

河南平顶山平煤矿区天然地震、爆破、塌陷时频特征分析

选取2019年3月—8月河南平顶山市宝丰县平煤矿区发生的ML 2.0—2.9天然地震、爆破、塌陷等9次震动事件,在区域地质构造背景和波形特征分析基础上,采用短时傅里叶变换(STFT)方法开展时频波谱分析,提取不同类型事件的时频特征。结果显示:(1)天然地震频率成分丰富,且高、低频分布均匀,P波在约3 Hz和8 Hz处存在2个峰值,S波存在多个峰值;(2)爆破事件的时频谱相对集中,以低频为主,P波频率峰值约5Hz,信号主频随时间变化,大致呈线性降低至1—2 Hz;(3)塌陷事件频率成分以4 Hz以下的低频为主,P波无明显峰值且频率成分单一,主频出现在2 Hz左右的面波。本文结果可为今后该矿区震动事件类型判断提供参考依据。     

Was a dacite dome implicated in the 9,500 <Emphasis Type="SmallCaps">b.p.</Emphasis> collapse of Mt Ruapehu? A palaeomagnetic investigation

Constraining the process by which volcanoes become unstable is difficult. Several models have been proposed to explain the driving forces which cause volcanic edifices to catastrophically collapse. These include models for destabilisation of volcanic flanks by wedging due to dyke intrusion and the weakening of mechanical properties by pressurisation of pore fluids. It is not known which, if any, of the models are relevant to particular sector collapse events. Recent developments in the palaeomagnetic estimation of emplacement temperatures of volcaniclastic rocks have shown that even relatively low emplacement temperatures can be recorded by volcaniclastics with high fidelity. We have carried out a palaeomagnetic study of emplacement temperatures to investigate the role of igneous activity in the initiation of the 9,500 b.p. Murimotu sector collapse of Mt Ruapehu, New Zealand. This debris avalanche deposit has three fades which are stratigraphically superimposed, and the lowermost fades contains three lithological assemblages representing different segments of the edifice which were transported with little internal mixing within the flow. We have determined that some of the dacite-bearing assemblage 1, fades 1 was hot (∼350 °C) during transport and emplacement, whereas none of the other lithological assemblages of fades contained hot material. Our interpretation is that a dacite dome was active on the ancient Ruapehu edifice immediately prior to the Murimotu sector collapse. The partially cooled carapace of the dome and material shed from this part was incorporated into the avalanche deposit, along with cold lavas and volcaniclastics. We have not found evidence for incorporation of material at or close to magmatic temperatures, at least in the sampled locations. Our palaeomagnetic work allows us to develop a comprehensive, new palaeomagnetic classification of volcaniclastics. Published online: 25 January 2003 Editorial responsibility: D. Dingwell     

Risk assessment of the impact of pyroclastic currents on the towns located around Vesuvio: a non-linear structural inverse analysis

In a.d. 79, the catastrophic eruption of Vesuvio, which later was described in two famous letters by Pliny the Younger to Tacitus the Historian, destroyed Pompeii, Hercolaneum, Oplontis and Stabiae, resulting in many thousand of victims. After a few hours of the eruption, the several-kilometre-high volcanic column began to collapse, provoking strong air shocks as well as destructive pyroclastic density currents, which travelled down the volcano slopes. In 2000, an archaeological excavation survey, which was performed on the east slope of the volcano in the Terzigno–Vesuvio area at a distance of about 5 km from the vent, brought to light the ruins of several Roman villas that were completely destroyed by these currents during the a.d. 79 eruption. The present paper proposes a new structural analysis, which starts from the study of the damage produced on partially collapsed masonry walls, and determines the dynamic pressures of the currents that overran this site. The non-linear structural analysis, which is based on strength values obtained by means of experimental tests, is of the 'inverse type' and takes into account the limit behaviour of the ancient Roman masonry. The values of the dynamic pressures that were capable of producing the collapse of the masonry walls were obtained by utilising a modern limit analysis theory. The obtained results show that dynamic pressures of a few kPa (1–5) were able to cause masonry buildings to collapse. These values are consistent with those proposed in some of the latest volcanological studies made by numerical simulations of pyroclastic flow propagation. It is shown here that these dynamic pressures are even able to determine the collapse of both modern reinforced concrete and masonry wall buildings that are largely present in the area. Therefore, in possible future eruptions, dynamic pressures of this magnitude would flatten a large urbanised area, where ~700,000 people are currently living. The obtained results give a better definition of both the risk to pyroclastic currents in possible Vesuvio eruptions and provide new guidelines for construction in the neighbouring zones.Editorial responsibility: A. Woods     

Application of matrix analysis in delineating sinkhole risk areas along highway (I-70 near Frederick,Maryland)

Sinkhole collapse in the area of Maryland Interstate 70 (I-70) and nearby roadways south of Frederick, Maryland, has been posing a threat to the safety of the highway operation as well as other structures. The occurrence of sinkholes is associated with intensive land development. However, the geological conditions that have been developing over the past 200 million years in the Frederick Valley control the locations of the sinkholes. Within an area of approximately 8 km², 138 sinkholes are recorded and their spatial distribution is irregular, but clustered. The clustering indicates the existence of an interaction between the sinkholes. The point pattern of sinkholes is considered to be a sample of a Gibbsian point process from which the hard-core Strauss Model is developed. The radius of influence is calculated for the recorded sinkholes which are most likely to occur within 30 m of an existing sinkhole. The stochastic analysis of the existing sinkholes is biased toward the areas with intensive land use. This bias is adjusted by considering (1) topography, (2) proximity to topographic depressions, (3) interpreted rock formation, (4) soil type, (5) geophysical anomalies, (6) proximity to geologic structures, and (7) thickness of overburden. Based on the properties of each factor, a scoring system is developed and the average relative risk score for individual 30-m segments of the study area is calculated. The areas designated by higher risk levels would have greater risk of a sinkhole collapse than the areas designated by lower risk levels. This risk assessment approach can be updated as more information becomes available.     

Main concepts of the "European approach" to karst-groundwater-vulnerability assessment and mapping

In order to achieve some consistency in the establishment of groundwater intrinsic vulnerability maps in Europe, a new approach is proposed by Working Group 1 of the European COST Action 620 on "Vulnerability mapping for the protection of carbonate (karst) aquifers". A general procedure is offered which provides consistency while allowing the required flexibility for application to a continent and under conditions of varying geology, scale, information availability, time, and resources. The proposed methodology is designed to be clearly more physically based than the existing vulnerability-mapping techniques. It takes the specificity of the karstic environments into account without necessarily excluding the applicability to other geological conditions. Combined "core factors" for overlying layers and for concentration of flow account for the relative protection of groundwater from contamination while taking into account any bypass of the overlying layers. A precipitation factor is distinguished for describing characteristics of the input of water to the system. Differentiation is made between groundwater resource intrinsic vulnerability mapping and source intrinsic vulnerability mapping. For the latter, a factor describing the karst network development is relevant. This short technical note describes a first step in the work program of Working Group 1 of the COST Action 620. Future steps are now in progress to quantify the approach and to apply it in various European pilot areas. Electronic Publication     

Reliability of dipole-dipole electrical resistivity tomography for defining depth to bedrock in covered karst terranes

 Sinkhole collapse is one of the main limitations on the development of karst areas, especially where bedrock is covered by unconsolidated material. Studies of sinkhole formation have shown that sinkholes are likely to develop in cutter (enlarged joint) zones as a result of subterranean erosion by flowing groundwater. Because of the irregular distribution of pinnacles and cutters on the bedrock surface, uncertainties arise when "hit-or-miss" borehole drilling is used to locate potential collapse sites. A high-resolution geophysical technique capable of depicting the details of the bedrock surface is essential for guiding the drilling program. Dipole-dipole electrical resistivity tomography (ERT) was used to map the bedrock surface at a site in southern Indiana where limestone is covered by about 9 m of clayey soils. Forty-nine transects were conducted over an area of approximately 42,037 m². The electrode spacing was 3 m. The length of the transects varied from 81 to 249 m. The tomographs were interpreted with the aid of soil borings. The repeatability of ERT was evaluated by comparing the rock surface elevations interpreted from pairs of transects where they crossed each other. The average difference was 2.4 m, with a maximum of 10 m. The discrepancy between interpreted bedrock-surface elevations for a transect intersection may be caused by variations in the subsurface geology normal to the transect. Averaging the elevation data interpreted from different transects improved the ERT results. A bedrock surface map was generated using only the averaged elevation data at the transect junctions. The accuracy of the map was further evaluated using data from four exploratory boreholes. The average difference between interpreted and actual bedrock surface-elevations was less than 0.4 m. The map shows two large troughs in the limestone surface: one coinciding with an existing sinkhole basin, while the other is in alignment with a small topographic valley. Because sinkholes were observed at the same elevation interval in similar valleys in the vicinity, the delineated trough may have implications for future land use at the site. Received: 4 January 1999 · Accepted: 8 March 1999     

东海天然气水合物地热研究及其环境意义

依据地热资料研究天然气水合物稳定带厚度在东海海域的分布情况。东海在地质构造上位于新生代环太平洋构造带西部边缘岛弧的内侧,又是欧亚板块、太平洋板块和菲律宾海板块的相互作用带。依据国际热流委员会(IHFC)提供的东海地热数据,经过统计确定出该区域的热流分布,热流平均值为121·0mW/m2,最小值为73·0mW/m2,最大值为168·0mW/m2。同时利用天然气水合物温压模型计算了稳定带厚度,数据显示稳定带厚度平均值为92·2m,最小值为1·4m,最大值为190·6m,薄于其他已经发现的海洋天然气水合物稳定带厚度(约400m)。天然气水合物大部分分布在条件适宜的陆坡和岛坡上,冲绳海槽底部水合物稳定带厚度相对较薄。统计分析表明本区热流值与水合物稳定带厚度相关性很差,相关系数仅有0·12。这是由于天然气水合物所在海域水深较浅时,海底温度的变化迫使运算所应用的非线性方程影响因子迅速积累,从而导致相关系数降低。最后结合东海陆坡的地质条件,探讨了在天然气水合物存在的情况下,陆坡失稳的可能性及其造成的环境影响。