近海海洋石油平台导管架喷涂金属层防腐

锌、铝及其合金涂层对钢铁的防护，不仅对阴极起保护作用(Gartland，1987)， 对涂层本身也具有良好的抗腐蚀性能。此外，涂层中金属微粒表面形成的致密氧化膜，也起到了防腐蚀的作用。在不同大气环境下，锌、铝有良好的耐蚀性，其腐蚀速率比钢铁要低得多(李言涛，1998)。采用热喷涂锌、铝及其合金涂层对钢铁构件和构筑物进行长效防护早在20世纪20年代就已开始应用，至今仍是普遍采用的防护措施，并在继续发展(李守本等，1989)。20年代初，法国首先用于海水闸门的防腐；40年代美国用于墨西哥湾的海上井架和海上输油管以及舰船的防腐；60年代英、法、德等国海军将这一技术扩大应用到舰船的上部结构和船壳。而金属热喷涂技术在海洋工程中使用非常有限，第一次使用热喷铝涂层防护近海平台的实例是Conoco公司在北海的Murchison结构上的锥形塔，并且已获得了4a良好的使用效能(Fisher et al.，1987；Shaw et al.，1985)。1984年6月，Hutton张力支柱平台(TLP)在北海下水(水深148 m)安装。系链、升降机和锥形塔均采用火焰热喷涂技术喷涂铝涂层进行防护(Tyson，1985)。1992年6月，Hotton平台使用8a后，对升降机绳索进行观察，在飞溅区没有发现腐蚀现象，也没有检测到褐色渗漏效应(Fisher et al.，1995)。     

塔里木盆地的构造演化

从地震大剖面显示，塔里木盆地发育为手风琴式的演化史。大体上形成有3层“断-坳”结构：①震旦系的“断”，古生界-三叠系的“坳”；②侏罗系的“断”，上白垩系的“坳”；③古近系的“断”，新近系的“坳”。断陷与坳陷分别由拉张与挤压应力场所致，这种应力场的变化是由相邻洋壳板块俯冲倾角由小到大的变化所引起的。由于地壳的多旋回运动，多次发生构造沉积演变，构成了多套生储盖组合，多领域、多种圈闭类型的油气藏，从震旦系-古生界-中生界-新生界，各断陷-坳陷结构的盆地都有可能形成油气藏的地质条件。     

土工布充砂袋的应用及其研究进展

对土工布充砂袋技术和国内外的应用进行了介绍。鉴于土工布充砂袋属于一种新兴起的土工新材料和新技术，在设计和工程实际中还存在着许多急待解决的问题，着重对各种典型状态和典型环境下的土工布充砂袋的变形、应力和土工布充砂袋堆的稳定性研究进展进行综述，最后提出进一步研究的思路。     

东亚岛弧地形横剖面与板块运动

通过对东亚岛弧横剖面形态的系统分析，并结合弧前的构造应力的分析，作者认为，东亚岛弧形成于板块东移的构造环境中，横剖面形态存在两种基本类型即内缓外陡型和内陡外缓型，这两种不同的横剖面具有不同的弧前应力，前者表现弧前挤压，后者表现弧前引张，这反映地貌形态与构造应力之间的密切关系。     

Regression Formulations for the Stress at Hot Spot of Multiplanar Tubular DT Joints

- Stress concentration analysis of multiplanar tubular DT joints plays an important role in the fatigue design of offshore platforms. A semi-analytic method for stress analysis under the condition of any loads is briefly introduced in the paper. Nineteen multiplanar tubular DT joints with one of two braces of the same dimension subjected to axial loads and out- of- plane bending moments are computed for parametric stress analysis by using the present method. The influence of geometrical parameters on the stresses of multiplanar tubular DT joints is discussed and compared with corresponding uniplanar T joints. The regression formulae for the stress at hot spot of multiplanar DT joints are found by modification of SCF of corresponding uniplanar T joints. The parametric formulae for the maximum stress by superposition. Finally, the influences of stiffening effect and load-interaction effect on the maximum stress of DT joints are discussed.     

牙鲆鱼苗长途运输技术的试验研究

本实验对10个批次，总数为19047尾的不同规格和产地的牙鲆鱼苗长途运输效果进行了研究。结果表明，规格为9-12cm的鱼苗，在水温6－12℃，运输时间为35－50h，采用空运和低温活水车运输，运输死亡率为664尾，死亡率为3.39%，低温活水车短途运输是可行的，尽管长途车运方式成本较低，但由于应激强度较大，对鱼苗的生长性能影响较为严重，驯养10d累计死亡率最高达18.1%，这种模式不可取。低温（6℃）、小规格（9cm)的空运较适合牙鲆鱼苗长途运输。此外，本文还就运输应激反应、预防措施和药物防治进行详细的讨论。     

An Experi mental Study on Wave-Induced Dynamic Stresses in Seabed

1 .IntroductionEvery year ,Taiwanis subjectedtotwo or three typhoonintrusions in average which always causedisasters . Most of the disasters which occur around the coastal zone are due to seabed instability andcoastal structure destruction caused bytyphoo…     

Factors affecting spatial and temporal variability in material exchange between the Southern Everglades wetlands and Florida Bay (USA)

Physical and biological processes controlling spatial and temporal variations in material concentration and exchange between the Southern Everglades wetlands and Florida Bay were studied for 2.5 years in three of the five major creek systems draining the watershed. Daily total nitrogen (TN), and total phosphorus (TP) fluxes were measured for 2 years in Taylor River, and ten 10-day intensive studies were conducted in this creek to estimate the seasonal flux of dissolved inorganic nitrogen (N), phosphorus (P), total organic carbon (TOC), and suspended matter. Four 10-day studies were conducted simultaneously in Taylor, McCormick, and Trout Creeks to study the spatial variation in concentration and flux. The annual fluxes of TOC, TN, and TP from the Southern Everglades were estimated from regression equations. The Southern Everglades watershed, a 460-km² area that includes Taylor Slough and the area south of the C-111 canal, exported 7.1 g C m⁻², 0.46 g N m⁻², and 0.007 g P m⁻², annually. Everglades P flux is three to four orders of magnitude lower than published flux estimates from wetlands influenced by terrigenous sedimentary inputs. These low P flux values reflect both the inherently low P content of Everglades surface water and the efficiency of Everglades carbonate sediments and biota in conserving and recycling this limiting nutrient. The seasonal variation of freshwater input to the watershed was responsible for major temporal variations in N, P, and C export to Florida Bay; approximately 99% of the export occurred during the rainy season. Wind-driven forcing was most important during the later stages of the dry season when low freshwater head coincided with southerly winds, resulting in a net import of water and materials into the wetlands. We also observed an east to west decrease in TN:TP ratio from 212:1 to 127:1. Major spatial gradients in N:P ratios and nutrient concentration and flux among the creek were consistent with the westward decrease in surface water runoff from the P-limited Everglades and increased advection of relatively P-rich Gulf of Mexico (GOM) waters into Florida Bay. Comparison of measured nutrient flux from Everglades surface water inputs from this study with published estimates of other sources of nutrients to Florida Bay (i.e. atmospheric deposition, anthropogenic inputs from the Florida Keys, advection from the GOM) show that Everglades runoff represents only 2% of N inputs and 0.5% of P input to Florida Bay.     

Nonlinear Static Finite Element Stress Analysis of Pipe-in-Pipe Risers

Owing to the complexity of the pipe-in-pipe (PIP) riser system in structure, load and restraint, many problems arise in the structural analysis of the system. This paper presents a new method for nonlinear static finite element stress analysis of the PIP riser system. The finite element (FE) model of the PIP riser system is built via software AutoPIPE 6.1. According to the specialties of a variety of components in the PIP riser system, different elements are used so as to model the system accurately. Allowing for the complication in modeling the effects of seabed restraint, a technique based on the bilinear spring concept is developed to calculate the soil properties. Then, based on a pipeline project, the entire procedure of stress analysis is discussed in detail, including creation of an FE model, processing of input data and analysis of results. A wide range of loading schemes is investigated to ascertain that the stresses remain within the acceptable range of the pipe material strength. Finally, the effects of the location of flanges, the thermal expansion of submarine pipelines and the seabed restraint on stress distribution in the riser and expansion loop are studied, which are valuable for pipeline designers.