二三维联动的虚拟校园设计与实现

传统的2维地理信息系统技术成熟但缺乏3维可视化和分析的能力,而目前的3维地理信息系统发展可拥有3维可视化分析能力,然而还缺少2维地理信息系统的便捷。以二三维联动为开发思路的地理信息系统能够解决这对矛盾。本文基于二三维联动GIS的设计方案,以虚拟校园设计与实现为应用实例,利用ArcEngine（AE）实现二三维联动GIS系统的开发设计,对GIS系统的开发做出了一种新的、有益的尝试。     

岩石中的渗透率、流体流动及热液成矿作用

热液成因的固体金属矿床形成过程中都曾拥有一段流动的历史。成矿物质以溶液的形式从矿源地穿过孔隙或断裂达到了现在的栖身之所,在此过程中流体通过的路径决定了它们的走向,而溶液本身也改变了路径的特征。因此,对于此类矿床的研究不能仅仅囿于眼之所见,而应将古流体流动的观念融入其中,并考察它们的跋涉之路。文中总结了近年来国内外在岩石孔隙、断裂介质及与其相关渗透率对热液成矿作用的控制等领域的研究成果和最新进展,对岩石渗透率、渗透率的影响因素、岩石中流体流动的特征等问题进行了阐述,讨论了渗透率对于热液成矿作用深度、成矿规模、矿质沉淀机制等方面的重要影响,藉此在固体金属矿床研究中强化流"体运动"的观念,并促进构造地质学和成矿作用地球化学间一个新研究方向的发展。     

Fluid–Sediment Interaction in a Marine Shallow-Water Hydrothermal System in the Wakamiko Submarine Crater, South Kyushu, Japan

The Wakamiko submarine crater is a small depression located in Kagoshima Bay, southwest Japan. Marine shallow‐water hydrothermal activity associated with fumarolic gas emissions at the crater sea floor (water depth 200 m) is considered to be related with magmatic activity of the Aira Caldera. During the NT05‐13 dive expedition conducted in August 2005 using remotely operated vehicle Hyper‐Dolphine (Japan Agency for Marine‐Earth Science and Technology), an active shimmering site was discovered (tentatively named the North site) at approximately 1 km from the previously known site (tentatively named the South site). Surface sediment (up to 30 cm) was cored from six localities including these active sites, and the alteration minerals and pore fluid chemistry were studied. The pore fluids of these sites showed a drastic change in chemical profile from that of seawater, even at 30 cm below the surface, which is attributed to mixing of the ascending hydrothermal component and seawater. The hydrothermal component of the North site is estimated to be derived from a hydrothermal aquifer at 230°C based on the hydrothermal end‐member composition. Occurrence of illite/smectite interstratified minerals in the North site sediment is attributed to in situ fluid–sediment interaction at a temperature around 150°C, which is in accordance with the pore fluid chemistry. In contrast, montmorillonite was identified as the dominant alteration mineral in the South site sediment. Together with the significant low potassium concentration of the hydrothermal end‐member, the abundant occurrence of low‐temperature alteration mineral suggests that the hydrothermal aquifer in the South site is not as high as 200°C. Moreover, the montmorillonite is likely to be unstable with the present pore fluid chemistry at the measured temperature (117°C). This disagreement implies unstable hydrothermal activity at the South site, in contrast to the equilibrium between the pore fluid and alteration minerals in the North site sediment. This difference may reflect the thermal and/or hydrological structure of the Wakamiko Crater hydrothermal system.     

Geochemical Eccentricity of Ground Water Allied to Weathering of Basalts from the Deccan Volcanic Province,India: Insinuation on CO<Subscript>2</Subscript> Consumption

Analyses of 72 samples from Upper Panjhara basin in the northern part of Deccan Plateau, India, indicate that geochemical incongruity of groundwater is largely a function of mineral composition of the basaltic lithology. Higher proportion of alkaline earth elements to total cations and HCO₃>Cl + SO₄ reflect weathering of primary silicates as chief source of ions. Inputs of Cl, SO₄, and NO₃ are related to rainfall and localized anthropogenic factors. Groundwater from recharge area representing Ca + Mg–HCO₃ type progressively evolves to Ca + Na–HCO₃ and Na–Ca–HCO₃ class along flow direction replicates the role of cation exchange and precipitation processes. While the post-monsoon chemistry is controlled by silicate mineral dissolution + cation exchange reactions, pre-monsoon variability is attributable chiefly to precipitation reactions + anthropogenic factors. Positive correlations between Mg vs HCO₃ and Ca + Mg vs HCO₃ supports selective dissolution of olivine and pyroxene as dominant process in post-monsoon followed by dissolution of plagioclase feldspar and secondary carbonates. The pre-monsoon data however, points toward the dissolution of plagioclase and precipitation of CaCO₃ supported by improved correlation coefficients between Na + Ca vs HCO₃ and negative correlation of Ca vs HCO₃, respectively. It is proposed that the eccentricity in the composition of groundwater from the Panjhara basin is a function of selective dissolution of olivine > pyroxene followed by plagioclase feldspar. The data suggest siallitization (L < R and R _k) as dominant mechanism of chemical weathering of basalts, stimulating monosiallitic (kaolinite) and bisiallitic (montmorillonite) products. The chemical denudation rates for Panjhara basin worked out separately for the ground and surface water component range from 6.98 to 36.65 tons/km²/yr, respectively. The values of the CO₂ consumption rates range between 0.18 × 10⁶ mol//km²/yr (groundwater) and 0.9 × 10⁶ mol/km²/yr (surface water), which indicates that the groundwater forms a considerable fraction of CO₂ consumption, an inference, that is, not taken into contemplation in most of the studies.     

Structural evolution of the Bayanhongor region, west-central Mongolia

Most of previous models suggest that the Central Asia Orogenic Belt grew southward in the Phanerozoic. However, in the Bayanhongor region in west-central Mongolia, volcanic arc, accretionary prism, ophiolite, and passive margin complexes accreted northeastward away from the Baydrag micro-continent, and hence the region constitutes the southwestern part of a crustal-scale syntaxis close to the west. The syntaxis should be original, because presumably reorientation due to strike-slip faulting can be ignored. It is reconfirmed that the Baydrag eventually collided with another micro-continent (the Hangai) to the northeast. A thick sedimentary basin developed along the southern passive margin of the Hangai micro-continent. This region is also characterized by an exhumed metamorphosed accretionary complex and a passive margin complex, which are both bounded by detachment faults as well as basal reverse faults which formed simultaneously as extrusion wedges. This part of the Central Asia Orogenic Belt lacks exhumed crystalline rocks as observed in the Himalayas and other major collisional orogenic belts. In addition, we identified two phases of deformation, which occurred at each phase of zonal accretion as D1 through Cambrian and Devonian, and a synchronous phase of final micro-continental collision of Devonian as D2. The pre-collisional ocean was wide enough to be characterized by a mid-ocean ridge and ocean islands. Two different structural trends of D1 and D2 are observed in accretionary complexes formed to the southwest of the late Cambrian mid-ocean ridge. That is, the relative plate motions on both sides of the mid-ocean ridge were different. Accretionary complexes and passive margin sediments to the northeast of the mid-ocean ridge also experienced two periods of deformation but show the same structural trend. Unmetamorphosed cover sediments on the accretionary prism and on the Hangai micro-continent experienced only the D2 event due to micro-continental collision. These unmetamorphosed sediments form the hanging walls of the detachment faults. Moreover, they were at least partly derived from an active volcanic arc formed at the margin of the Baydrag micro-continent.     

Numerical simulation of migration–accumulation of oil resources

Numerical simulation of oil migration and accumulation is to describe the history of oil migration and accumulation in basin evolution. It is of great value to the evaluation of oil resources and to the determination of the location and amount of oil deposits. This thesis discusses the characteristics of petroleum geology and permeation fluid mechanics. For the three-dimensional problems of Dongying hollow of Shengli Petroleum Oil Field, it puts forward a new model and a kind of modified method of upwind finite difference fractional steps implicit interactive scheme. For the famous hydraulic experiment of secondary migration–accumulation, the numerical simulation test has been done, and both the computational and experimental results are basically identical. For the actual problem of Dongying hollow, the numerical simulation test and the actual conditions are basically coincident. Thus, the well-known problem has been solved.     

Comparison of numerical models of two debris flows in the Cortina d’ Ampezzo area,Dolomites, Italy

The accurate prediction of runout distances, velocities and the knowledge of flow rheology can reduce the casualties and property damage produced by debris flows, providing a means to delineate hazard areas, to estimate hazard intensities for input into risk studies and to provide parameters for the design of protective measures. The application of most of models that describe the propagation and deposition of debris flow requires detailed topography, rheological and hydrological data that are not always available for the debris-flow hazard delineation and estimation. In the Cortina d’Ampezzo area, Eastern Dolomites, Italy, most of the slope instabilities are represented by debris flows; 325 debris-flow prone watersheds have been mapped in the geomorphological hazard map of this area. We compared the results of simulations of two well-documented debris flows in the Cortina d’Ampezzo area, carried on with two different single-phase, non-Newtonian models, the one-dimensional DAN-W and the two-dimensional FLO-2D, to test the possibility to simulate the dynamic behaviour of a debris flow with a model using a limited range of input parameters. FLO-2D model creates a more accurate representation of the hazard area in terms of flooded area, but the results in terms of runout distances and deposits thickness are similar to DAN-W results. Using DAN-W, the most appropriate rheology to describe the debris-flow behaviour is the Voellmy model. When detailed topographical, rheological and hydrological data are not available, DAN-W, which requires less detailed data, is a valuable tool to predict debris-flow hazard. Parameters obtained through back-analysis with both models can be applied to predict hazard in other areas characterized by similar geology, morphology and climate.     

测井仪器的故障分析与排除思路

TYSC-3Q与PSJ-2型数字测井仪是目前煤田测井中常用的二种测井仪器,在使用过程中难免发生诸如测井控制故障、声速探管故障、密度三侧向探管故障、井温、井液电阻率探管故障、电法面板故障、数字测井面板故障、电测井故障等常见故障类型。通过对各类故障因素进行剖析,指出了故障易发生的部位,并详细的介绍了检查的方法及故障的排除步骤。     

洞穴完井工艺在寿阳地区煤层气钻井中的应用

洞穴完井工艺包括钻井、完井、排水采气等工序,为提高煤层渗透率,最大限度的保证煤层气解析与运移,洞穴完井一般要求有效井径3-4m,及一定范围的破碎带。远东能源公司为开采寿阳地区15#煤层中的煤层气,部署了4口生产井．其井身设计为三开结构。钻井主要设备为T685WS顶驱车载钻机及多台不同型号的空压机,采用潜孔锤冲击钻进．以空气、空气泡沫为冲洗介质,钻进至15#目标煤层底板以下46m处完钻,然后利用可伸缩式扩孔器进行扩孔。在扩孔至距三开井底8～10m时．开始采用空气和清水憋压,通过瞬间释放压力,使煤层坍塌,如此反复,至造穴直径达到要求。由于严格按照技术标准及操作流程作业,采取的技术措施合理,4口井均已顺利投入生产,增产效果显著。可见该种洞穴完井技术的应用,不仅可以保护煤层原生结构及环境,并且还能减少煤层气射孔、压裂等环节的费用．对于煤层气井施工具有重要的经济意义。