尕斯库勒盐湖中CO_2-卤水-盐岩相互作用模拟研究

利用PHREEQC软件模拟CO2侵入后,尕斯库勒盐湖中CO2-卤水-岩盐之间的相互作用。CO2侵入卤水层后,卤水中元素的化学形态种类和大小发生变化,特别是碳酸盐型的络合物形态增多。CO2侵入后,除了碳酸盐、石盐和硫酸盐矿物达到饱和被析出外,其余矿物的不饱和程度加剧,卤水的TDS增大,pH值减小。卤水中U的含量在CO2侵入后发生沉淀而减小。研究成果对深入评估区域内盐水层CO2地质封存的环境风险和利用CO2分离提取盐湖卤水中的铀元素提供理论依据。     

纳米氧化物颗粒对水基钻井液润滑性能影响的试验研究

通过在水基钻井液中添加纳米氧化物颗粒,来改善其润滑性能。选用了Al2O3、TiO2及SiO2三种纳米氧化物颗粒作为钻井液改性添加剂,利用极压润滑仪及销盘摩擦磨损实验仪研究了添加不同种类和浓度纳米颗粒氧化物对水基钻井液的润滑性能及减摩效果的影响。结果表明,所添加的3种球形纳米颗粒均有润滑减阻减摩的效果,其中SiO2颗粒的钻井液的润滑性能、滤失性能以及减摩效果都是最好的。当纳米SiO2颗粒加量为0.4%时,滤失量最小,润滑系数降低率达到15.6%,摩擦系数降低率为32.0%,磨痕轨迹平滑,减摩效果最为明显。当纳米颗粒浓度超过0.5%时,减摩效果降低,磨盘脱层磨损明显。     

低固相冲洗液在赣南再里地区的应用研究

钻进过程中,孔壁的稳定性和冲洗液的渗漏是影响钻进效率和钻孔质量的重要因素。孔内情况越复杂,施工周期越长,对冲洗液性能的要求也越高。赣南再里地区施工区构造发育复杂,地层中存在大量的松散、胶结性差的砂岩以及高岭土、绿泥石等水敏性地层,钻探施工钻孔容易缩径,孔壁稳定性差,极易出现剥落、掉块、坍塌等现象,试验采用了低固相不分散冲洗液,取得了良好的钻进效果。     

CO2加富对塔玛亚历山大藻叶绿素荧光参数及产毒的影响

由大气中CO_2浓度升高引起的海洋酸化,是全球性的重大环境问题之一。本研究采用实验生态学的方法,以塔玛亚历山大藻(Alexandrium tamarense)为研究对象,分析其在CO_2加富条件下叶绿素荧光动力学参数及产毒特征的变化。调制叶绿素荧光结果显示,CO_2加富对塔玛亚历山大藻的PSⅡ最大光化学量子产量(Fv/Fm)、最大相对电子传递效率(r ETRmax)有显著影响(P0.05),且随着培养时间的增长Fv/Fm、r ETRmax均降低,对半饱和光强(Ik)、快速光曲线初始斜率(α)却无显著影响(P0.05)。结果说明CO_2加富能促进塔玛亚历山大藻的PSⅡ最大光化学量子产量,提高其最大光能转换效率和相对最大电子传递效率。高效液相色谱法分析结果显示,该株塔玛亚历山大藻主要产漆沟藻毒素1(GTX1)、漆沟藻毒素4(GTX4)、N-磺酰氨甲酰基毒素(C1)及N-磺酰氨甲酰基毒素(C2)四种PSTs毒素,CO_2加富不改变主要麻痹性贝毒(PSTs)的种类组成,但能显著提高氨基甲酸酯类毒素(GTX1、GTX4)产量(P0.05),而降低N-磺酰氨甲酰基类毒素(C1、C2)产量(P0.05),说明加富能使塔玛亚历山大藻所产毒素发生转化,进而影响藻细胞的整体毒性。     

Pressure characteristics of bubble collapse near a rigid wall in compressible fluid

High speed liquid jet and shockwave can be produced when a bubble collapses near a rigid wall, which may cause severe damage to solid structures. A hybrid algorithm was adopted to simulate bubble motion and associated pressures near a wall combining Level Set-Modified Ghost Fluid-Discontinuous Galerkin (LS-MGF-DG) method and boundary element method (BEM). Numerical results were compared with experimental data to validate the presented algorithm. Jet formation was simulated by BEM and the induced pressure on the wall was calculated with auxiliary function. The pressure at the point on the wall where the jet points to reaches its peak value after the jet penetrates the bubble. Bubble collapse and rebounding were simulated by the LS-MGF-DG method. Shock-wave is induced when the bubble collapse toroidally to a minimum volume and the pressure at wall center reaches the maximum due to shockwave superposition. A third pressure peak is found associated with the bubble rebounds and bubble splitting. In the case studied, a higher pressure was found due to collapse shockwave than bubble jet and affects a larger area of the wall. In addition, the three pressure peaks due to jet impact, collapse impact as well as bubble rebounding and splitting decrease with the increase of the standoff distance.     

Investigation of a longfin inshore squid's swimming characteristics and an underwater locomotion during acceleration

In the present study, locomotion of a real longfin inshore squid (Doryteuthis pealeii) was numerically investigated. Geometry of a real squid was obtained using computed tomography (CT) images. In addition to a two-dimensional axisymmetric squid model, a modified squid model with no cavities around her head and an ellipse shaped model were generated with a fineness ratio (the ratio of body length to maximum body diameter) of 7.56. These numerical models were exposed to an acceleration with two different velocity programs. Added mass and basset forces on bodies were calculated during acceleration of the squid models starting from rest. Pressure and viscous drag forces were also calculated due to pressure variation along the squid models and friction on the surface of the models. The effect of a nozzle diameter on jet velocities and propulsive efficiency at all bodies were evaluated when time dependent velocity profiles (from 0 to 10 m/s in 0.5 and 1 s time durations) were set for the inlet of computational domain. The modified squid model required least thrust force during acceleration phase of time dependent velocity profile compared to the other models while the 0.02 m nozzle diameter provided largest propulsive efficiency for all models.     

基于浮标数据的卫星雷达高度计海浪波高数据评价与校正

卫星雷达高度计是海浪有效波高（significant wave height,SWH）观测的重要手段之一,本文利用时空匹配方法对T/P、Jason-1、Envisat、Jason-2、Cryosat-2和HY-2A共6颗卫星雷达高度计SWH数据与NDBC（National Data Buoy Center,NDBC）浮标SWH数据进行对比验证,并对雷达高度计SWH数据进行校正。全部卫星雷达高度计SWH数据时间跨度为1992年9月25日到2015年9月1日,对比验证NDBC浮标共53个,包括7个大洋浮标。精度评价发现除T/P外,各卫星雷达高度计SWH的RMSE都在0.4~0.5 m之间,经过校正后,RMSE都有显著下降,下降程度最大为13.82%;对于大洋浮标,评价结果RMSE在0.20~0.28 m之间,结果明显优于全部NDBC浮标的精度评价结果;HY-2A卫星雷达高度计SWH在经过校正后数据质量与国外其他5颗卫星雷达高度计SWH数据质量差异较小。     

Development of a new method for efficiently calculating of evaporation from the phreatic aquifer in variably saturated flow modeling

In this paper, we proposed a new method that has been developed based on the surface soil moisture content (SSMC) to more efficiently calculate the groundwater evaporation in variably saturated flow modeling. In this method, the empirical formula to calculate evaporation was modified and the value of the formula varies from zero to one as a closed interval. In addition, the simulation code for calculating the groundwater evaporation based on the SSMC method was incorporated into the EOS9 module of Tough2, a variably saturated flow modeling code. Finally, two numerical tests and a case simulation were conducted to verify the feasibility and accuracy of the SSMC method. Simulation results indicate that the SSMC method is capable of appropriately simulating the characteristics of water flow in vadose zone and the amount of evaporation with the variable water table. And such results are in coincidence with the value calculated by the logistic function method, and fit well with the measured data globally rather than locally.     

“中科2号”海湾扇贝(Argopecten irradians)幼虫期壳长遗传力的估计

基于全同胞组内相关法估计"中科2号"海湾扇贝(Argopecten irradians)幼虫期壳长的遗传力。通过平衡巢式交配实验设计构建了7个半同胞和21个全同胞"中科2号"海湾扇贝家系。在家系幼虫期的第1天和第6天分别测定每个全同胞家系的30个幼虫个体的壳长。利用SAS 9.0软件的一般线性模型(GLM)计算表型变量的原因方差组分,估算壳长遗传力。分析结果显示,"中科2号"海湾扇贝幼虫1日龄和6日龄壳长的遗传力分别为0.51和0.58。t检验显示两个日龄壳长遗传力的估计值均不显著(P0.05),且6日龄雌性遗传方差组分大于雄性遗传方差组分,说明雌性遗传方差组分随日龄增长可能存在较大母性效应。较大的加性遗传方差表明选择育种对于"中科2号"海湾扇贝的早期生长尚具有较大的改良潜力。     

Hydrothermal Fluid Sources of the Fengjia Barite–fluorite Deposit in Southeast Sichuan,China: Evidence from Fluid Inclusions and Hydrogen and Oxygen Isotopes

The Fengjia barite–fluorite deposit in southeast Sichuan is a stratabound ore deposit which occurs mainly in Lower Ordovician carbonate rocks. Here we present results from fluid inclusion and oxygen and hydrogen isotope studies to determine the nature and origin of the hydrothermal fluids that generated the deposit. The temperature of the ore‐forming fluid shows a range of 86 to 302 °C. Our detailed microthermometric data show that the temperature during mineralization of the fluorite and barite in the early ore‐forming stage was higher than that during the formation of the calcite in the late ore‐forming stage. The salinity varied substantially from 0.18% to 21.19% NaCl eqv., whereas the density was around 1.00 g/cm³. The fluid composition was mainly H₂O (>91.33%), followed by CO₂, CH₄ and traces of C₂H₆, CO, Ar, and H₂S. The dominant cation was Na⁺ and the dominant anion Cl^‐, followed by Ca²⁺, SO₄^2‐, K⁺, and Mg²⁺, indicating a mid–low‐temperature, mid‐low‐salinity, low‐density NaCl–H₂O system. Our results demonstrate that the temperature decreased during the ore‐forming process and the fluid system changed from a closed reducing environment to an open oxidizing environment. The hydrogen and oxygen isotope data demonstrate that the hydrothermal fluids in the study area had multiple sources, primarily formation water, as well as meteoric water and metamorphic water. Combined with the geological setting and mineralization features we infer that the stratabound barite–fluorite deposits originated from mid–low‐temperature hydrothermal fluids and formed vein filling in the fault zone.