CBERS-02星图像几何纠正方法试验研究

为了研究中巴地球资源卫星CCD多光谱数据规模化应用的可行性,扩大基础地理信息更新的影像资料来源,以CBERS-02星（简称02星）CCD多光谱数据的标准景为例,对2种几何纠正模型进行了对比研究,分析了3种不同基础控制资料对纠正精度的影响,并对精度评价方法进行了试验研究。在此基础上,总结形成了针对02星CCD多光谱数据1∶10万比例尺影像最为省时有效、精度最佳的几何纠正技术方法。     

鄱阳湖HJ-1A/B卫星CCD影像大气校正研究

以准同步的Terra/MODIS反演的气溶胶为辅助,采用FLAASH模型对2009-10-24鄱阳湖HJ-1A/B卫星CCD影像进行大气校正处理。结果表明,大气影响可以被有效去除,在水体遥感反射率较高的红、绿波段,大气校正精度较高,平均相对误差分别为13.4%和9.8%;而在水体遥感反射率较低的近红外、蓝波段,大气校正精度较低,这可能与波段不同的信噪比和陆地邻近像元效应有关。     

The Ultimate CCD for Laser Guide Star Wavefront Sensing on Extremely Large Telescopes

All of the extremely large telescopes (ELTs) will utilize sodium laser guide star (LGS) adaptive optics (AO) systems. Most of these telescopes plan to use the Shack-Hartmann approach for wavefront sensing. In these AO systems, the laser spots in subapertures at the edge of the pupil will suffer from spot elongation due to the 10 km extent of the sodium layer and the large separation from the projection laser. This spot elongation will severely degrade the performance of standard geometry wavefront sensing systems. In this paper, we present a CCD with custom pixel morphology that aligns the pixels of each subaperture with the radial extension of the LGS spot. This CCD design will give better performance than a standard geometry CCDs for continuous wave lasers. In addition, this CCD design is optimal for a pulsed sodium laser. The pixel geometry enables each subaperture to follow a laser pulse traversing the sodium layer, providing optimal sampling of a limited number of detected photons. In addition to novel pixel layout, this CCD will also incorporate experimental JFET sense amplifiers and use CMOS design approaches to simplify the routing of biases, clocks and video output. This CCD will attain photon-noise limited performance at high frame rates, and is being incorporated in the plans for the Thirty Meter Telescope (TMT).     

基于系统模型的CCD图像MTF补偿及误差分析

航天线阵推扫CCD图像在获取、传输过程中存在图像模糊的现象,而MTF是评价CCD图像质量的最可靠指标。为了改善图像质量,通过分析影响MTF的主要因素,提出基于系统模型的MTF补偿方法:首先建立系统模型,提出模型参数的估计方法,然后结合约束最小二乘算法复原图像。在仿真实验中,模拟图像的模糊和加噪过程,利用MTF模型复原图像,并评价MTF补偿图像质量,定量分析模型参数估计误差对图像复原结果的影响。实验结果表明:基于系统模型的MTF补偿方法能够有效而简便地复原图像,提高图像质量。     

提高卫星三线阵CCD影像空中三角测量精度及摄影测量覆盖效能

利用数字模拟方法,进一步探讨了类似MOMS-02参数的卫星三线阵CCD影像单航线、航线首末4角隅设一个控制点(以下简写为单航线4控点)的空中三角测量高程精度低的问题。研究得出,宽高比特别小(1:9)只是原因之一,更主要的因素还在于平差整过程数学关系带有近似性(包括EFP法和定向片法)。提出了改善精度的措施,并拟订了提高卫星三线阵CCD影像空中三角测量精度及摄影测量覆盖效能的系统。模拟计算表明,航线长度可以≥2B,在有外方位元素或无外方位元素少量控制点条件下,不论二线交会区,还是三线交会区均可达到高程精度为6m的摄影测量成果。     

Phenological metrics-based crop classification using HJ-1 CCD images and Landsat 8 imagery

Crop type data are an important piece of information for many applications in agriculture. Extracting crop type using remote sensing is not easy because multiple crops are usually planted into small parcels with limited availability of satellite images due to weather conditions. In this research, we aim at producing crop maps for areas with abundant rainfall and small-sized parcels by making full use of Landsat 8 and HJ-1 charge-coupled device (CCD) data. We masked out non-vegetation areas by using Landsat 8 images and then extracted a crop map from a long-term time-series of HJ-1 CCD satellite images acquired at 30-m spatial resolution and two-day temporal resolution. To increase accuracy, four key phenological metrics of crops were extracted from time-series Normalized Difference Vegetation Index curves plotted from the HJ-1 CCD images. These phenological metrics were used to further identify each of the crop types with less, but easier to access, ancillary field survey data. We used crop area data from the Jingzhou statistical yearbook and 5.8-m spatial resolution ZY-3 satellite images to perform an accuracy assessment. The results show that our classification accuracy was 92% when compared with the highly accurate but limited ZY-3 images and matched up to 80% to the statistical crop areas.     

无地面控制点卫星摄影测量高程误差估算

本文推导了星载测定外方位元素参与下,无地面控制点卫星摄影测量高程误差估算公式。分别按姿态变化率为1 0 -6°/s的二线阵CCD推扫式影像、姿态变化率低于1 0 -6°/s的二线阵CCD推扫式影像以及LMCCD推扫式影像进行推算。各个估算公式均给出算例,供设计无地面控制卫星摄影测量工程应用。     

基于影像交叉学习的CBERS CCD波段模拟

与TM/ETM+相比,CBERS CCD缺少2个红外波段(波段5和波段7),这便导致了许多针对TM/ETM+数据的图像处理方法难以直接应用于CBERS CCD图像.为此,采用基于影像交叉学习的波段模拟方法,即以ETM+数据作为先验知识,通过支持向量回归( Support Vector Regression,SVR),拟...     

机载三线阵CCD摄影测量的直接解算模型与精度分析

机载三线阵CCD摄影测量系统是GPS/INS与三线阵CCD相机联合工作的测量系统.通过GPS/INS给出的投影中心位置、视准轴姿态观测值及三线阵CCD像空间坐标,可以直接计算地面点在物空间的坐标.介绍了直接解算的几何模型,并依据共线方程建立地面点像空间坐标与控制点或同名点物空间坐标的关系,从而把问题归结为间接平差,给出了平差的误差方程.最后对直接解算模型进行了精度分析.     

数字天顶摄像仪中CCD星象亚像素定位的改进二维矩方法

在利用数字天顶摄像仪通过天文测量确定天文垂线偏差的工作中,要求对CCD数字图像中星象中心进行亚像素定位。本文利用MATLAB实现对FITS格式CCD天文图像的正常读取,并与FV读取结果比较分析。在已有亚像素定位的修正矩方法基础上,提出一种利用迭代法寻求合适门限对二维修正矩方法进行改善。利用MATLAB实现对实测图像数据的处理与分析,探讨门限的取值对不同星等恒星定位精度的影响,给出门限的最佳取值。通过与已有修正矩算法处理结果比较分析,在以往修正矩方法计算基础上改进计算区域后再用迭代法计算,暗星定位精度有了很大提高。