Study on Paleoenvironment since Late Glacial Eooch in Lanzhou Area, China

The Hongzuisi Section in Lanzhou area is used to infer the paleoclimate since the late glacial epoch. Through combined analysis of organic carbon isotope and CaCO3 content, paleoenvironment evolution of Hongzuisi Section since the late glacial epoch is discussed. There were changes in both drymoist and warm-cold. Especially the climate changes can be compared with synchronous sections of other areas, which provides useful information for our future forecast.     

以2000年4月29日河南内乡地震为例谈谈关于计算震级误差的有关问题

2000年4月29日河南内乡发生地震，地这次地震，河南地震局台网和中国地震局台网震级量度之间有一定差异。采用不同量规函数和尾波持续时间震级公式计算发现，它们之间所产生的最大差异可达0.5-0.7级。综合分析后认为，2000年4月29日河南内乡地震震级定为ML5.0级较为适宜。     

螺旋CT三维重建在骨盆骨折中的应用

目的：探讨用螺旋CT三维重建评价骨盆骨折的临床应用价值。方法：收集骨盆骨折17例，采用螺旋CT三维重建检查。结果：17例检查均取得清晰立体图像，且可消除某一骨性结构，单独观察骨盆某一组成骨的骨折情况。结论：螺旋CT三维重建在骨盆骨折的诊断、手术方案的设计及教学等有较高价值。     

2002年CT扫描和三维成像学术年会评述

由CT理论与应用研究编辑部和北京信息工程学院主办、有中国体视学学会多位理事和会员参加的“2002年CT扫描和三维成像研讨会（CT科技学术年会）”于2002年10月18－20日，在北京大学逸夫苑理科楼学术报告厅举行。中国体视学学会副理事长刘国权教授出席致辞，对于这次CT科技年会的召开表示祝贺，并介绍了2003年在美国圣迭戈和北京将要召开第11届国际体视学会大会的有关情况，希望有关专家准备论文出席，来自全国各地48位专家，教授出席了会议，本次会议涉及CT理论、计算方法和软件及硬件技术；医学CT扫描成像和疾病诊断；工业CT和三维成像：地球层析和工程CT。美国爱荷华大学王革教授，纽约罗彻斯特大学宁若拉教授专程到会，分别做了精彩的特邀主题报告：显微CT的锥束重建新方法和近年来在这方面的进展和展望”，“锥光束三维CT技术在美国的过去、现在和未来”“国内专家也报告了前沿研究的新成果，在会前，CT理论与应用研究编辑部，根据收到的论文和摘要汇编和印制了专集，在会议最后一天，召开了“CT理论与应用研究”期刊编委会，传达了中国科协对于办好科技期刊的新要求，会议开得很成功。     

中国西南及邻区上地幔P波三维速度结构/

利用ISC报告以及中国和NEIC基本测震台网报告中的80974条P波初至到时资料（地震数为7053，台站数为165，且地震和台站都分布在研究区内），对中国西南及邻区（北纬10～36、东经70～110）的深至400km的上地幔三维速度结构进行了研究，分辨率达22．初步结果表明:①研究区速度的横向不均匀性，虽随深度增加而减弱，但至400km深度时仍很明显；②在北纬16和24的纵剖面上，可以看到与印度板块向东和欧亚板块相碰撞挤压相对应的速度结构，以及印度板块与欧亚板块速度结构的差异．在东经90的纵剖面上，与印度板块向北俯冲到欧亚板块（青藏高原）之下相对应的速度结构也比较明显；③在90ｋｍ深度的横剖面上，由缅甸的密支那至越南的洞海的低速条带，可能与红河断裂带有关；④ 提出并使用了能够更为准确直观地描述分辨率好坏的图示方法．      

Bedrock structure in Adapazari, Turkey—a possible cause of severe damage by the 1999 Kociaeli earthquake

The 1999 Kocaeli earthquake brought serious damage to downtown of Adapazari. To study why strong motions were generated at the town, a bedrock structure was investigated on the basis of Bouguer gravity anomaly, and SPAC and H/V analyses of microseisms. It was revealed that, the basin consists of three narrow depressions of bedrock with very steep edges, extending in E–W or NE–SW directions along the North Anatolia faults, and the depth to bedrock reaches 1000 m or more. Downtown of Adapazari is located 1–2 km apart from the basin-edge. It is considered that, the specific configuration of bedrock amplifies ground motions at the downtown area by focusing of seismic waves and/or interference between incident S-waves and surface-waves secondarily generated at the basin-edge. Studying 3D bedrock structure is an urgent issue for microzoning an urban area in a sedimentary basin.     

Melting of β-quartz up to 2.0 GPa and thermodynamic optimization of the silica liquidus up to 6.0 GPa

Melting relations of β-quartz were experimentally determined at 1.0 GPa (1900±20 °C), 1.5 GPa (2033±20 °C), and 2.0 GPa (2145±20 °C) using a new high-pressure assembly in a piston–cylinder apparatus and substantial differences were found with data previously reported. The new melting data of β-quartz were combined and optimized with all available thermodynamic, volumetric, and phase equilibria data for β-cristobalite, β-quartz and coesite to produce a P–T liquidus diagram for silica valid up to 6.0 GPa. Using the new optimized thermodynamic parameters, the invariant point β-cristobalite+β-quartz+liquid and β-quartz+coesite+liquid were determined to lie at 1687±17 °C and 0.457 GPa, and 2425±25 °C and 5.00 GPa, respectively.     

Improved treatments for evaluating horizontal magnetic components through the 3-D FDM in E -polarization induction problems

To improve the accuracy of the numerical evaluation through the 3-D finite difference method, the surface boundary conditions are added to modify the old program. The author has tested the new program by making calculations for the model constructed by Wanamaker, et al (1984). The comparison between the numerical results obtained from this paper and those by Wannamaker, et al (1984) indicates that a pronounced improvement is realized in the evaluation of the horizontal magnetic components. Moreover, better calculations for the vertical magnetic components are also obtainable by using the new program.