基于ANSYS与OpenGL的高速公路结构物仿真建模及三维地层地表修剪方法

现代三维视景建模与仿真技术在高速公路工程选线、施工以及运营管理中具有良好的应用前景。结构物的仿真建模以及能反映施工前后地表形态变化的三维地层模型研究是高速公路信息化中的重要问题。介绍了一种借用ANSYS有限元分析软件提取结构物三维模型表面几何信息的简便方法;结合OpenGL纹理贴图技术,实现了结构物的仿真建模;针对结构物施工后对地表形态改变较大的问题,提出利用结构物表面数据对三维地层模型地表网格进行修剪的方法--地表网格竖直投影修剪法。把上述方法应用到广东省某高速公路高边坡的三维视景仿真建模中,结果表明,边坡的仿真模型较逼真。三维地层模型修剪后的地表形态与真实情况接近,验证了方法的合理性、可靠性。     

土钉支护弹塑性数值分析及稳定性探讨

用三维弹塑性有限元法对土钉支护进行了边开挖、边安装土钉和喷射混凝土面层的施工过程的数值模拟分析。通过一种强度折减技术探讨了土钉支护的稳定性。研究结果表明，施工过程中在不同的使用荷载作用下受力最大的土钉并不是一成不为的，因此，在土钉支护工程中不能随意地缩短某层土钉的长度。数值计算确定的潜在滑裂区和局部破坏区符合实际情况，认为钉体拔出是土钉支护最可能出现的内部失稳形式。     

毛乌素沙漠地震勘探历程及效果

总结陕西省煤田地质局物探测量队在毛乌素沙漠开展地震勘探攻关的三个阶段及各阶段取得的成果,认为该区虽然表浅层地震地质条件复杂,地震勘探难度较大,但勘探精度基本上可以达到解释5m断层的的精度。并以国家重大产业技术开发专项的依托工程,内蒙古鄂托克前旗新上海庙地区SZT井田三维地震勘探为例,对地震激发、接收技术进行改进,并采取精细静校、地表一致性振幅补偿等处理手段,结合多参数信息,进行资料精细解释。成果表明：依托工程野外原始资料甲级率达到70％以上,获得的三维数据体信噪比高,构造及煤层解释成果可靠、准确。     

安塞油田坪桥水平井区沉积微相三维建模研究

以安塞油田坪桥水平井区为例,探讨了应用水平井和露头资料及标点过程(示性点过程)方法进行沉积微相三维建模的思路与方法,同时对研究区三角洲前缘分流河道的定量结构模式进行了深入的研究。研究表明,坪桥水平井区三角洲分流河道单砂体宽度一般为40～100m左右。砂体结构呈两种模式,其一为“迷宫状”,砂体离散地分布于湖相泥岩中,其二为“拼合板状”,多个砂体在侧向上叠置而形成连片分布的砂体,但部分单砂体间可被泥质或钙质薄层侧积层所隔挡。应用水平井资料和露头资料,可有效地提取三维建模所必须的地质统计学参数。研究表明,采用标点过程方法,可建立符合地质实际的沉积微相三维模型。     

火山岩覆盖区三维地震勘探方法探究

宣化——下花园煤田位于燕山山脉的西段,区内地形复杂,成孔形式不一,采集难度大;火山岩覆盖范围广,浅层地震地质条件较差,地震记录信噪比低,静校正问题突出。为了查清宣东矿井深部煤炭资源状况,除了克服地表影响因素外,还需攻克该区火山岩对地震信号的屏蔽难题。通过对岩石出露区及黄土覆盖区进行试验分析,采取了高叠加次数等措施,有效地压制了干扰,提高了信噪比,在此基础上对地震记录进行一些有针对性资料处理技术,如绿山静较正技术等,使目的层有效波反应明显。本次勘探圈定了上覆火成岩范围及火成岩破坏区,控制了区内主要可采煤层Ⅲ3、Ⅴ2煤层的埋藏深度及构造形态,解释断层20条及Ⅲ3煤层火成岩破坏区3处,勘探成果表明,本次勘探所采用的野外采集措施和资料处理方法是行之有效的。     

Characteristics of carbonaceous particles in Beijing during winter and summer 2003

Campaigns were conducted to measure Organic Carbon (OC) and Elemental Carbon (EC) in PM2.5 during winter and summer 2003 in Beijing. Modest differences of PM2.5 and PM10 mean concentrations were observed between the winter and summer campaigns. The mean PM2.5/PM10 ratio in both seasons was around 60%, indicating PM2.5 contributed significantly to PM10. The mean concentrations of OC and EC in PM2.5 were 11.2±7.5 and 6.0±5.0μg m-3 for the winter campaign, and 9.4±2.1 and 4.3±3.0 μg m-3 for the summer campaign, respectively. Diurnal concentrations of OC and EC in PM2.5 were found high at night and low during the daytime in winter, and characterized by an obvious minimum in the summer afternoon. The mean OC/EC ratio was 1.87±0.09 for winter and Z39±0.49 for summer. The higher OC/EC ratio in summer indicates some formation of Secondary Organic Carbon (SOC). The estimated SOC was 2.8 μg m-3 for winter and 4.2μg m-3 for summer.     

Vertical Observations and Analysis of PM2.5, O3, and NOx at Beijing and Tianjin from Towers during Summer and Autumn 2006

During the period between 18 August and 22 September 2006, an ultraviolet photometric O3 analyzer, a NO-NO2-NOx chemiluminescence analyzer, and a quartz micro-oscillating-scale particle concentration analyzer were simultaneously used for monitoring at three different heights each at Beijing (325-m tower) and Tianjin (255-m tower). These towers belong to the Institute of Atmospheric Physics (IAP) of the Chinese Academy of Sciences (CAS) and to the Tianjin Municipal Meteorological Bureau, respectively. These measurements were used to continuously measure the atmospheric O3 and NOx volume-by-volume concentrations and the PM2.5 mass concentration within a vertical gradient. When combined with meteorological data and information on the variation of vertical characteristics of the various atmospheric pollutants in the two cities, analysis shows that these two cities were seriously polluted by both PM2.5 and O3 during summer and autumn. The highest daily-average concentrations of PM2.5 near the ground in Beijing and Tianjin reached 183 μg m-3 and 165 μg m-3, respectively, while the O3 concentrations reached 52 ppb and 77 ppb, and NOx concentrations reached 48 ppb and 62 ppb for these two cities, respectively. The variations in the daily-average concentrations of PM2.5 between Beijing and Tianjin were demonstrated to be consistent over time. The concentrations of PM2.5 measured in Beijing were found to be higher than those in Tianjin. However, the overall O3 concentrations near the ground in Tianjin were higher than in Beijing. NOx concentrations in Tianjin were consistently lower than in Beijing. It was also found that PM2.5 pollution in Beijings atmosphere may also be affected by the pollutants originating in and delivered from Tianjin, and that Ti     

利用辐射数据构建云物理结构

本文运用CloudSat卫星上搭载的雷达探测数据和AQUA卫星搭载的辐射光谱仪探测数据,选择2007年1月至2010年12月期间,地理位置位于（15°~45°N,145°~165°E）区域内（远海）发生的云场数据开展分析,研究云的物理结构特征与其光谱辐射特性的相互关系。不同光谱波段对云物理结构变化的响应情况各有不同,首先从MODIS光谱仪22个云相关光谱波段中分析并选择出与云物理结构特征密切相关的光谱组合（包含13个波段）,而后开展了这些光谱波段的云辐射特性与云物理结构特征的相互变化关系研究。统计分析表明,在外部大气、地表条件以及太阳入射辐射变化不大情况下,云的结构变化与其光谱辐射变化之间总体存在单调相关关系,物理结构变化不大的云廓线之间其光谱辐射的变化也小,反之也成立,即光谱辐射变化小的云廓线之间物理结构变化也小。从而,对于某些内部物理结构特征未知的云,利用与其光谱辐射特性相近的云结构数据可实现自身垂直结构信息的重建。基于光谱辐射相近则云物理结构很可能相近的特点,本文对未知云场的物理结构重建开展了模拟试验,试验结果表明光谱相近原则匹配物理结构的方法一定程度上能够实现云物理结构的构建,为利用被动遥感数据推测云物理结构特征研究提供参考。     

Analysis and simulation of magma mixing processes in 3D

Magma mixing structures from the lava flow of Lesbos (Greece) are analyzed in three dimensions using a technique that, starting from the serial sections of rock cubes, allows the reconstruction of the spatial distribution of magmas inside rocks. Two main kinds of coexisting structures are observed: (i) “active regions” (AR) in which magmas mix intimately generating wide contact surfaces and (ii) “coherent regions” (CR) of more mafic magma that have a globular shape and do not show large deformations. The intensity of mingling is quantified by calculating both the interfacial area (IA) between interacting magmas and the fractal dimension of the reconstructed structures. Results show that the fractal dimension is linearly correlated with the logarithm of interfacial area allowing discrimination among different intensities of mingling.

The process of mingling of magmas is simulated using a three-dimensional chaotic dynamical system consisting of stretching and folding processes. The intensity of mingling is measured by calculating the interfacial area between interacting magmas and the fractal dimension, as for natural magma mixing structures. Results suggest that, as in the natural case, the fractal dimension is linearly correlated with the logarithm of the interfacial area allowing to conclude that magma mixing can be regarded as a chaotic process.

Since chemical exchange and physical dispersion of one magma inside another by stretching and folding are closely related, we performed coupled numerical simulations of chaotic advection and chemical diffusion in three dimensions. Our analysis reveals the occurrence in the same system of “active mixing regions” and “coherent regions” analogous to those observed in nature. We will show that the dynamic processes are able to generate magmas with wide spatial heterogeneity related to the occurrence of magmatic enclaves inside host rocks in both plutonic and volcanic environments.     

基于三维激光扫描技术的钢结构扰度检测及应用

钢结构在长期荷载及不均匀受力的作用下会产生空间变形,其中扰度是其重要的衡量指标。通常采用全站仪采集钢结构轴线上若干特征点进行分析、计算,由于钢结构特征点难以捕捉,测量存在误差,并且有限的空间离散点难以全面反应钢结构空间变形。本文采用徕卡RTC360三维激光扫描进行钢结构扰度测量;介绍了其作业流程及数据处理方法;利用标靶将各个测站的三维点云拼接成一个整体;采用拟合的方法提取空间特征点及轴线;利用三维点云构建空间模型,并与设计模型进行碰撞分析;可全面地反映钢结构的空间变形情况。