厦门花岗岩残积土物理力学指标关联性定量表征初探

厦门地区花岗岩残积土的颗分试验表明其粒度呈“两头多,中间少”的特征,级配较独特。孔隙比等物性指标与压缩模量等设计中常用指标定量关联性不强,离散性大且没有明显规律。结合厦门地铁工程地质勘察资料,通过粒间状态参量、级配控制模式确定所研究土体的关键物理状态参量,分析该参量与岩土工程设计中常用指标之间的相关关系。结果表明,引入Thevanayagam提出的粒间孔隙比作为参变量,压缩模量随粒间孔隙比的增大而减小,建立了估计残积砾质黏性土、残积砂质黏性土压缩模量的经验公式。级配控制模式下的特征粒径比可以作为估计花岗岩残积土抗剪强度指标的关键参变量,黏聚力随特征粒径比的增大而增大,内摩擦角随特征粒径比的增大而减小,且线性相关性较好。文中建立的预测花岗岩残积土压缩模量、抗剪强度指标经验公式,可供厦门地区工程设计时参考。     

北京地区大气污染分布的“南北两重天”现象

利用2006年北京地区空气质量监测站和自动气象站网资料,以及华北地区中尺度气象观测资料,分析了北京地区大气污染分布的“南北两重天”现象.通过对此类现象发生过程中天气形势和北京地区气象要素的分析,指出了造成该现象的天气学成因和气象要素特征.研究结果表明,2006年北京共发生47次“南北两重天”现象,其中大部分发生在秋、冬季的午夜至次日上午,且多为南差北好的污染物分布情景.该现象的发生与北京地区中-α尺度天气系统活动的一些特征有关,特别是与干冷空气进入北京地区的路径以及移动速度的区域差异有关.另外,在弱天气系统控制下,北京西南部地区经常出现的小尺度辐合型流场,也是形成北京地区“南北两重天”现象的重要原因.     

中国3个典型城市气溶胶光学厚度地基观测及其MODIS气溶胶产品精度分析

利用中国太阳分光观测网的观测资料结合MODIS(中分辨率成像光谱仪)的气溶胶产品分析了北京、兰州、上海3个典型区域城市的气溶胶光学特性。结果表明:北京AOD(气溶胶光学厚度)年平均为0.41±0.35,春夏高,秋冬低,Angstrm波长指数α年平均为1.40±0.85表现为细模态粒子,MODIS的光学厚度为0.52±0.39与地面观测相关系数为0.91,存在系统性高估;兰州AOD年平均为0.55±0.21,夏季最低,秋冬较高,α年平均为0.95±0.20表现为粗模态粒子,MODIS光学厚度为0.43±0.21与地面观测相关系数仅为0.07,存在系统性低估;上海AOD年平均为0.55±0.21,无明显季节变化,α平均为1.03±0.25,MODIS光学厚度为0.74±0.30与地面观测相关系数为0.75,存在系统性高估。城市地理位置和复杂地表等原因造成反照率的不确定,MODIS气溶胶产品在这3个城市的反演效果仍有很大提升空间。     

基于SVM的海底声纳图像底质识别*

对海底底质声纳图像分割,提取单元特征向量进行主成份分析,选取均值、标准差、对比度、相关系数、能量及同质性作为训练特征向量,优化支持向量机(SVM)参数.利用多分类 SVM 对砂、礁石、泥进行训练,有效、快速地分离出了3种底质类型,测试精度高于80%,表明该方法可有效用于海底底质声纳图像的识别和分类.     

The accuracy of methods used to estimate the whole-lake accumulation rate of organic carbon, major cations, phosphorus and heavy metals in sediment

The accuracy of three methods used to estimate the whole-lake accumulation rate of chemicals in sediment, the simple mean accumulation rate, regression against water depth and the mean accumulation rate in sedimentation zones, was assessed. The concentrations and accumulation rates of organic carbon, four major cations, phosphorus and four heavy metals in the 1902 to 1988 sediment layer at 43 sites in Kassjön were used and the three methods gave identical results. The accuracy of the simple mean accumulation rate method using 5 or 10 sites was investigated using Monte Carlo simulation and both versions gave accurate results. If the method used the dry sediment accumulation rate at 5 or 10 sites, along with chemical concentration at one central site, then the errors were less than ±10% for five of the chemicals and larger for the others (?20 or 20–40%), although the direction of the bias was predictable. If chemical accumulation rate at the central site only was used to estimate the whole-lake value, the bias increased to 25% for the major cations, 50% for the heavy metals and P, and 85% for organic carbon. Having 43 sites in Kassjön meant that the true whole-lake chemical accumulation rate was known and so the accuracy of the methods and their variants could be assessed for the first time. These findings allow the particulars of the simple mean accumulation rate method to be chosen to suit the accuracy needed for a palaeolimnological investigation.     

Geochronology of the Duguer range metamorphic rocks,Central Tibet: implications for the changing tectonic setting of the South Qiangtang subterrane

The Duguer area represents one of the few occurrences of high-grade metamorphic rocks in the ‘Central Uplift’ zone of the Qiangtang terrane, central Tibet. The metamorphic rocks consist mainly of orthogneiss, paragneiss, and schist. To better understand the formation of these rocks, seven samples of gneiss and schist from the Duguer area were selected for in situ zircon U–Pb analysis and Ar–Ar dating of metamorphic minerals. The results suggest two distinct metamorphic stages, during the Late Triassic (229–227 Ma) and Late Jurassic (150–149 Ma). These stages correspond to the closure of the Palaeo-Tethys Ocean and northward subduction of the Bangong–Nujiang Neo-Tethys oceanic crust, respectively. We suggest that the Late Triassic metamorphic rocks of the Duguer area in the central South Qiangtang subterrane provide evidence of continental collision between the North and South Qiangtang subterranes, following the subduction of oceanic crust. It is likely that deep subduction of oceanic crust occurred along the Longmu Co–Shuanghu–Lancangjiang suture zone (LSLSZ), which would have hindered exhumation owing to the high density of oceanic crust. Subsequent break-off and delamination of the subducted oceanic slab at ~220 Ma may have resulted in exhumation of high-pressure and high-grade metamorphic rocks in the South Qiangtang subterrane. The Late Jurassic ages of metamorphism and deformation obtained in this study indicate the occurrence of an Andean-type orogenic event within the South Qiangtang subterrane. This hypothesis is further supported by an apparent age gap in magmatic activity (150–130 Ma) along the magmatic arc, and the absence of Late Jurassic sediments.     

云南先峰中新世木乃伊化木化石α-纤维素的提取

本文对云南先锋中新世木乃伊化木化石进行α-纤维素实验提取,以验证化石纤维素的可得性。实验利用有机溶剂分离、碱液分离、无机酸分离等方法分别对研究区5件木乃伊化化石样品进行处理,并采用红外光谱检测方法与现代木材α-纤维素和国际标准α-纤维素进行对比试验。实验结果显示,3种提取方法均可以从化石木材中提取出α-纤维素,但过程特征各有不同。其中,有机溶剂分离实验过程耗时最长,碱液分离方法样品损失最大。相比之下,无机酸分离方法对于木乃伊化木化石α-纤维素提取的效率最高。     

利用水合硅酸钠钙渣回收碱并用于制备硅灰石纳米粉体的实验研究

从高硅含铝原料霓辉正长岩中提取氧化铝时,硅以水合硅酸钠钙的形式排出。实验研究了水合硅酸钠钙渣的高效利用技术。利用水合硅酸钠钙自身的水解作用和在NaOH溶液中使之分解两种方法来回收其中的Na2O,所得NaOH溶液经蒸发浓缩后可循环利用。回收碱后剩余的固体渣用来制备硅灰石粉体。实验得出回收碱的优化条件为温度180 ℃,起始溶液的Na2O浓度为20 g/L,液固比为4∶1,洗涤6~7次。在此条件下,碱回收率可达90%以上。对回收碱后所得固体渣进行差热-热重分析,确定制备硅灰石粉体的煅烧温度。在820 ℃下煅烧2 h,制得颗粒尺寸为50~100 nm的α-CaSiO3纳米粉体,对其反应机理进行了初步的探讨。     

Exploring self-affine properties in seismograms

Self-affine properties have been observed in a large variety of rough profiles and time series from natural data sets. In this work, seismograms used for oil prospecting, which contain information of distinct subsurface features collected by seismic waves reflected or scattered at their interfaces, are taken into consideration. It is expected that any self-affine property, measured by the Hurst exponent H, depends on the depth. For each seismic trace, H is evaluated locally within a moving window, which is chosen narrow enough to reveal space dependency but also wide enough to display scale invariance. With the use of color code diagrams, it is possible to draw two-dimensional diagrams that show the local dependence of H for the analyzed seismogram. The reliability of the method is tested by the investigation of seismograms that contain ground roll components, as well as multiple reflections. The effect of different kinds of filter in the scaling properties is also investigated. In this case, comparisons are drawn among the diagrams obtained from original seismograms and those subjected to appropriate filter to eliminate spurious components. Work supported by the Brazilian agencies CNPq, FINEP-CTPETRO and Petrobras.