ADAPT数字遥测地震台网中传递函数的辨识

Adapt系统可以利用脉冲标定波形得到系统的传递函数，它将复杂的传递函数计算过程简化了，用户可以将传递函数的测定作为一种日常工作来做。     

地震前兆观测仪器标定问题的探讨

标定工作，在地震前兆观测仪器的研究，使用及所得数据的处理中均已成为一个不可少的环节，但缺少有关标定问题的基石性研究和讨论。本文就标定的定义、种类、目的、要求、存在的问题等做一粗线的讨论，以期今后加强这一工作的深入研究。     

规整化标定在地震遥测系统中的应用

规整化标定是模拟观测地震仪器标定的一种方法。系统介绍了规整化标定仪器的方法、参数，发现它有许多优点，是标定遥测地震仪器的一种较理想的方法。     

VICARIOUS RADIOMETRIC CALIBRATION OF SATELLITE FY-ID SENSORS AT VISIBLE AND NEAR INFRARED CHANNELS

For the problem of in-flight test site radiometric calibration for the FY-1D Meteorological Satellite onboard sensor's visible and near infrared channels,this paper described the calibration method,satellite-ground synchronous observation data acquired at China Dunhuang Calibration Test Site,parameter derivation and radiative transfer computation during the calibration,and the calibration result analysis.At FY-1D seven channels (with central wavelength at Channels 1:630 nm,2:865 nm;6:1610 nm;7:455 nm,8:505 nm;9:555 nm;10:932 nm),calibration coefficients obtained during the ground site calibration were compared with that respectively of prelaunch calibration.It is demonstrated that results of FY-1D onboard two sensors' (A and B) at channels 1,2,6 and 10 were close to pre-calibration,and the absolute difference of Gobi desert reflectance computed using test site and pre-launch calibration coefficients was no more than 2%. At other channels,large pre-launch calibration errors resulted in a poor consistency between the test site and pre-launch calibration.The errors can be corrected by the test site calibration results. Based on a rough estimation,the overall error of the calibration was about 6%. The paper also presented the in-flight vicarious calibration at the visible and near infrared channels of FY-1C sensor A which was launched in 1999 and has been put into operational mode since 2002.The results exhibit that FY-1C sensor's response has 23% attenuation at Channels 7 and 8,while only minor degradation at the other channels was found. During the mission,calibrations were also conducted at NOAA-17's Channels 1 and 2 (1:430-830 nm,2:500-1072 nm).A very good consistency has been achieved between the test site and pre-launched calibration results.     

颗粒分析用量筒的规格标准和计量标定

文章讨论了国内外用于密度计法颗粒分析用量筒的计量标准的规定，提出了相应的建议和标定方法。     

中巴地球资源一号卫星CCD图像质量评价和交叉定标研究

使用定量分析方法评价了中巴地球资源卫星CCD相机遥感数据质量 ,在此基础上利用LANDSAT 7ETM 对CCD的对应波段进行交叉定标计算 ,得到了一组CCD的参考定标系数。在遥感数据质量评价研究中 ,使用统计分析方法计算得到了CCD相机图像数据的条纹强度 ;应用结构函数方法计算获得了CCD的噪声数据 ;通过功率谱计算 ,对比分析了CCD和LANDSAT 7ETM 对应波段图像空间纹理特征。该文通过交叉定标计算 ,得到了CCD相机前 4个波段的参考定标系数、动态范围和噪声等效反射率等参考指标 ,并对这组定标系数进行了验证 ,从验证结果中发现CCD1,2 ,3和LANDSAT 7ETM 对应波段反射率最大相差 1 98% ,最小0 0 3% ,平均差要低于 1 31% ,而波段 4最大也仅相差 4 4 1% ,平均差 3 0 2 % ,证明计算得到的交叉定标系数具有较高的参考价值     

A comparative study of concentrated plasticity models in dynamic analysis of building structures

Concentrated plasticity (CP) models are frequently used in static and dynamic building analysis and have been implemented in available commercial software. This investigation deals with three different CP‐models, a simplified macroelement model (SEM) for a complete building story, a frame element with elasto‐plastic interaction hinges (PH), and a frame element with fiber hinges (FB). The objectives of this work are to evaluate the quality of the earthquake responses predicted by these models and to identify important aspects of their implementation and limitations for their use in dynamic analysis. The three elements are tested in a single‐story asymmetric plan building and in a three‐story steel building. Results show that base shear and global response values are usually computed with better accuracy than interstory deformations and local responses. Besides, the main limitation of elasto‐plastic CP models is to control the displacement offsets that result from perfect elasto‐plastic behavior. On the other hand, calibration of the SEM‐model shows that global responses in steel structures may be computed within 20% error in the mean at a computational cost two orders of magnitude smaller than that of the other CP elements considered. However, the three element models considered lead to increasing levels of accuracy in the dynamic response and their use depends on the refinement of the analysis performed. Copyright © 2005 John Wiley & Sons, Ltd.     

一种基于时延的水下声基阵坐标估算方法

阵形估算是水听器阵列应用中的关键问题,基于时延的水下声基阵大地坐标标定方法利用声源发射和声阵接收的CW脉冲之间的时延获得空间中的三个声源发射点到阵元的距离,并以这三个声源发射点为圆心,以声源发射点到阵元的距离为半径做球面,得到的交点即为阵元的大地坐标.通过实验数据分析结果可以得出如下结论:基于时延的球面交汇法得到的阵形标定结果的绝对误差均值为0.13 m,可以把该方法运用于实际的工程测量当中.     

Ablation Characteristic of Ilmenite using UV Nanosecond and Femtosecond Lasers: Implications for Non‐Matrix‐Matched Quantification

Ilmenite (FeTiO₃) is a common accessory mineral and has been used as a powerful petrogenetic indicator in many geological settings. Elemental fractionation and matrix effects in ilmenite (CRN63E‐K) and silicate glass (NIST SRM 610) were investigated using 193 nm ArF excimer nanosecond (ns) laser and 257 nm femtosecond (fs) laser ablation systems coupled to an inductively coupled plasma‐mass spectrometer. The concentration‐normalised ⁵⁷Fe and ⁴⁹Ti responses in ilmenite were higher than those in NIST SRM 610 by a factor of 1.8 using fs‐LA. Compared with the 193 nm excimer laser, smaller elemental fractionation was observed using the 257 nm fs laser. When using 193 nm excimer laser ablation, the selected range of the laser energy density had a significant effect on the elemental fractionation in ilmenite. Scanning electron microscopy images of ablation craters and the morphologies of the deposited aerosol materials showed more melting effects and an enlarged particle deposition area around the ablation site of the ns‐LA‐generated crater when compared with those using fs‐LA. The ejected material around the ns crater predominantly consisted of large droplets of resolidified molten material; however, the ejected material around the fs crater consisted of agglomerates of fine particles with ‘rough' shapes. These observations are a result of the different ablation mechanisms for ns‐ and fs‐LAs. Non‐matrix‐matched calibration was applied for the analysis of ilmenite samples using NIST SRM 610 as a reference material for both 193 nm excimer LA‐ICP‐MS and fs‐LA‐ICP‐MS. Similar analytical results for most elements in ilmenite samples were obtained using both 193 nm excimer LA‐ICP‐MS at a high laser energy density of 12.7 J cm^?2 and fs‐LA‐ICP‐MS.     

附有约束条件的最小二乘影像匹配及其在交通事故中的应用

影像匹配技术在图像处理与计算机视觉中有着非常重要的作用。最小二乘影像匹配方法是常用的匹配方法之一。本文简单介绍了目前影像匹配的几种方法及其优缺点，探讨了数字相机的检校原理与方法。重点介绍附有约束条件的最小二乘影像匹配的原理及匹配过程，结合交通事故处理的实例，论证了该方法的可行性。与传统方法相比，在测量精度、自动化程度以及数据三维可视化等方面具有明显优势。