螺旋藻多糖对肿瘤细胞生长及Hela细胞早期凋亡作用的实验研究

采用MTT法(四甲基偶氮唑盐比色法)研究了钝顶螺旋藻多糖(PSP)对Hela细胞及HepG2细胞生长的抑制作用。结果表明,随PSP浓度及培养时间的增加,肿瘤细胞存活率逐渐降低,抑制率逐渐增加,以PSP40 mg/L作用72 h最为显著。应用Annexin V/PI双染色流式细胞仪检测了早期Hela细胞凋亡,未经PSP处理的正常Hela细胞凋亡细胞极少,经PSP处理的细胞,凋亡细胞的百分比明显高于正常对照组,其作用随着剂量的增加和时间的延长而增强,具有量效关系和时效关系。结果说明PSP的抗肿瘤机制,除了诱导肿瘤细胞凋亡,还存在细胞毒性等其他机制,是多种机制共同作用的结果。     

Formation control of multiple underwater vehicles subject to communication faults and uncertainties

This paper proposes a novel approach to analyze and design the formation keeping control protocols for multiple underwater vehicles in the presence of communication faults and possible uncertainties. First, we formulate the considered vehicle model as the Port-controlled Hamiltonian form, and introduce the spring-damping system based formation control. Next, the dynamics of multiple underwater vehicles under uncertain relative information is reformulated as a network of Lur’e systems. Moreover, the agents under unknown disturbances generated by an external system are considered, where the internal model is applied to tackle the uncertainties, which still can be regulated as the Lur’e systems. In each case, the formation control is derived from solving LMI problems. Finally, a numerical example is introduced to illustrate the effectiveness of the proposed theoretical approach.     

Study on copper complexing ligand concentrations in several China’s coastal waters

Copper complexing ligand concentrations in the Daya Bay, Qingdao coast, Jiaozhou Bay, South China Sea and Huanghe Estuary waters were determined by the anodic stripping voltammetry technique. The distribution regularity and the relationship with other parameters were discussed. The results were as follows: Copper complexing ligand concentrations of the South China Sea were a little higher than those of other sea areas, and they were apparently higher than those of the ocean. Compared with the subsurface layer (SSL) in the sea surface microlayer copper complexing ligand concentrations showed an enrichment phenomenon, of which the mechanism is similar to dissolved organic matter. The metal complexing ligand concentration profiles of the South China Sea showed that the value in the sea surface was the highest, then it decreased with depth accruing, and a higher value appeared at the bottom. Copper complexing ligand concentrations were higher than those of cadmium and lead. Ligands in each sea area exhibited a complicated property. In short, the distribution regularity of copper complexing ligand concentrations in China' s coastal waters was consistent with that of other regions in the world. Meanwhile, the positive relationship between the copper complexing ligand concentrations and biological oxygen demand, chemical oxygen demand, dissolved organic carbon, and viscosity were found clearly.     

The South East Regional Marine Plan: Implementing Australia's Oceans Policy

In 1998, the Australian Government released Australia's Oceans Policy (AOP), a world first policy initiative focused on providing a framework for integrated ecosystem-based management of Australia's vast marine domain. The South East Regional Marine Plan, the first regional marine plan to be implemented under AOP, was released on 21 May 2004. This paper argues that although full integration across sectors and jurisdictions has not occurred, new AOP initiatives, institutions and governance processes have considerably increased sectoral and jurisdictional coordination in the South East region.     

Application of advanced system identification technique to extract roll damping from model tests in order to accurately predict roll motions

In this paper our previously developed advanced system identification technique [1] has been applied to extract the frequency dependent roll damping from a series of model tests run in irregular (random) waves. It is shown that this methodology accurately models the roll damping which can then be used to produce accurate predictions of the ships roll motion. These roll motion predictions are not only more accurate than the potential flow predictions but more accurate than potential flow models corrected using either empirical prediction methods [2] and even those corrected using roll damping obtained from free decay sallying experiments. This methodology has the potential to significantly improve roll motion prediction during full scale at sea trails of vessels in order to dramatically improve safety of critical operations such as helicopter landing or ship to ship cargo transfer.     

The validity of generic trends on multiple scales in rock-physical and rock-mechanical properties of the Whitby Mudstone,United Kingdom

Finding generic trends in mechanical and physical rock properties will help to make predictions of the rock-mechanical behaviour of shales. Understanding the rock-mechanical behaviour of shales is important for the successful development of unconventional hydrocarbon reservoirs.This paper presents the effect of heterogeneities in mineralogy and petrophysical properties on the validity of generic trends on multiple scales in rock-mechanical and rock-physical properties of the Whitby Mudstone. Rock-mechanical laboratory experiments have been performed on Whitby Mudstone samples from multiple outcrops within five kilometres laterally in order to investigate the heterogeneity and possible trends on an outcrop scale. Unconfined compression tests and acoustic measurements have been conducted to obtain the rock-mechanical properties, including rock strength, Young's modulus, Poisson's ratio, and velocity anisotropy. The rock-physical properties, including mineralogy, porosity, and matrix density, were measured using X-ray fluorescence and helium pycnometry. Various methodologies have been applied to the resultant data in order to derive different brittleness indices.Significant heterogeneity in rock-mechanical and rock-physical properties is present on an outcrop scale. There is no obvious correlation between mineral content and rock-mechanical properties on an outcrop scale in the Whitby Mudstone. Comparison with shales from different basins show, however, correlations between composition and elastic properties. The presence of significant heterogeneities on an outcrop scale and between shales from different basins make it difficult to find generic trends in rock-physical and rock-mechanical properties.     

Lateral dynamic response of a partially embedded pile subjected to combined loads in saturated soil

In this article, an analytical solution is proposed to investigate the lateral dynamic response of a pile which is partially embedded in saturated soil layer and subjected to combined lateral and vertical loads. The saturated soil is described by Biot’s poroelastic theory and the resistance of soil is derived by potential function method. The governing equation of the pile is solved by coupling soil resistance and continuity conditions between the pile and the soil. The dynamic impedances of the pile are then obtained through transfer matrix method. To verify the validity of the proposed procedure, the present solution is compared with available solution for an idealized case. Finally, a parametric study is performed to investigate the effects of various parameters on the stiffness and damping properties of the pile-soil system. It is found that permeability of the soil and vertical load has significant effects on the dynamic response of the pile.     

Morphology and affiliation of the centric diatom Anaulus birostratus (Grunow) Grunow from South Africa

The morphology of a rectangular, pillow-shaped, centric diatom from the surf zone in False Bay and Algoa Bay was studied with the light microscope and by scanning and transmission electron microscopy. Acid-cleaned (i.e. free of organic material), and critical-point- and freeze-dried material was used. Certain important features were seen. There was a large variation in cell size and shape. Threads connecting the cells in chains, an external organic layer covering the cell, and chromatophore colour, number and shape are reported for the species, probably for the first time. Valve, girdle and areolar structure was studied in detail, and the notch seen with the light microscope in the middle part of the valve was identified with the electron microscope as a labiate process, the off-centre position of this process being distinctive of the species. The geographical distribution of the species, as described in available literature, is discussed.     

Implementation of Tidal Constituent Interpolation Method for the Israeli Coastline

Many ship-borne geodetic surveys at sea, such as Global Navigation Satellite System (GNSS)-based sea surface height (SSH) observation, acoustic profiling of the bottom, and others, deal with a dynamic topography which undergoes several changes during the survey campaign (e.g., changes in tide, salinity and currents). Those changes affect the measurements and may causes for some variations in the results. There are several methods for tidal variations correction, being the most dominant phenomena, such as tidal zoning, tidal constituent interpolation or ocean tidal models. In this study, we have implemented the tidal constituent interpolation method for the Israeli coastline in order to assess its quality and determine whether it is suitable for use in this particular region. This paper depicts the interpolation method, discusses some difficulties in the implementation for the Israeli coast and presents results from exemplary processing. In addition, we compare the results to those obtained using global and regional tidal models.     

Cement Deep Soil Mixing (CDSM) for Solidification of Soft Estuarine Sediments

A preliminary study was conducted to determine the potential for cement deep soil mixing (CDSM) technology as a method for in-situ solidification of contaminated river and estuarine sediments. The study was conducted in Newark Bay, near the mouth of the Passaic River, New Jersey. The primary objective of the study was to evaluate the viability of CDSM for the in-situ S/S with a focus on: 1) determining the correct mix of the cement slurry, which provides rapid stabilization of the sediment matrix, 2) potential resuspension of solids during CSDM operations, 3) the effects of high organic content on the solidification process, and 4) the feasibility of using conventional dredging/extraction methods once the sediments have been stabilized and allowed to cure. The results of the study show CDSM slurry mixtures, as low as 7% in cement content, result in significant solidification and strength gain of in-situ sediments under ambient conditions. In sediments with very high organic contents (> 20%), the slurry mix would need to be adjusted to account for retardation effects of organics on cement hydration. Sediment resuspension during application was shown to be minimal at a distance of as little as 75 feet from the mixing head. Strength gains were considerable, effectively consolidating the sediment particles in a secure matrix, but not so high as to preclude extraction of solidified sediments with conventional dredging equipment. Dredged solidified sediment exhibited characteristics of a stiff glacial clay, and as such was easier to handle and transport than untreated dredged sediments. This technique has high potential to be used as an interim remedial measure prior to either extraction and decontamination/disposal or proper capping.