平板载荷试验应思考的几个问题

提出了平板载荷试验中的几个问题:(1)复合地基平板载荷试验垫层的重要性;(2)复合地基平板载荷试验存在尺寸效应;(3)单墩或单桩平板载荷试验不完善。重点对目前广泛使用的复合地基荷载试验进行了讨论,以引起检测人员注意。     

盾构隧道壁后注浆效果的雷达探测研究

盾构隧道的纵向力学与变形性态研究,尤其是盾尾壁后注浆效果已经引起国内外学者的广泛关注,笔者首次利用探地雷达方法,对上海某盾构隧道盾尾壁后注浆分布进行探测,并进行了初步的分析,结果表明,利用该方法可有效地探测隧道壁后的注浆分布,为隧道纵向力学变形性态的控制提供一定依据。     

Development of Geological Data Warehouse

Data warehouse (DW), a new technology invented in 1990s, is more useful for integrating and analyzing massive data than traditional database. Its application in geology field can be divided into 3 phrases: 1992-1996, commercial data warehouse (CDW) appeared; 1996-1999, geological data warehouse (GDW) appeared and the geologists or geographers realized the importance of DW and began the studies on it, but the practical DW still followed the framework of DB; 2000 to present, geological data warehouse grows, and the theory of geo-spatial data warehouse (GSDW) has been developed but the research in geological area is still deficient except that in geography. Although some developments of GDW have been made, its core still follows the CDW-organizing data by time and brings about 3 problems: difficult to integrate the geological data, for the data feature more space than time; hard to store the massive data in fifferent levels due to the same reason; hardly support the spatial analysis if the data are organized by time as CDW does. So the GDW should be redesigned by organizing data by scale in order to store mass data in different levels and synthesize the data in different granularities, and choosing space control points to replace the former time control points so as to integrate different types of data by the method of storing one type data as one layer and then to superpose the layers. In addition, data cube, a wide used technology in CDW, will be no use in GDW, for the causality among the geological data is not so obvious as commercial data, as the data are the mixed result of many complex rules, and their analysis needs the special geological methods and software; on the other hand, data cube for mass and complex geo-data will devour too much store space to be practical. On this point, the main purpose of GDW may be fit for data integration unlike CDW for data analysis.     

Researches on Cartographic Database-Based Interactive Three-Dimensional Topographic Map

With the development of computer graphics, the three-dimensional (3D) visualization brings new technological revolution to the traditional cartography. Therefore, the topographic 3D-map emerges to adapt to this technological revolution, and the applications of topographic 3D-map are spread rapidly to other relevant fields due to its incomparable advantage. The researches on digital map and the construction of map database offer strong technical support and abundant data source for this new technology, so the research and development of topographic 3D-map will receive greater concern. The basic data of the topographic 3D-map are rooted mainly in digital map and its basic model is derived from digital elevation model (DEM) and 3D-models of other DEM-based geographic features. In view of the potential enormous data and the complexity of geographic features, the dynamic representation of geographic information becomes the focus of the research of topographic 3D-map and also the prerequisite condition of 3D query and analysis. In addition to the equipment of hardware that are restraining, to a certain extent, the 3D representation, the data organization structure of geographic information will be the core problem of research on 3D-map. Level of detail (LOD). space partitioning, dynamic object loading (DOL) and object culling are core technologies of the dynamic 3D representation. The objectselection, attribute-query and model-editing are important functions and interaction tools for users with 3D-maps provided by topographic 3D-map system, all of which are based on the data structure of the 3D-model. This paper discusses the basic theories, concepts and cardinal principles of topographic 3I)-map,expounds the basic way to organize the scene hierarchy of topographic 3D-map based on the node mechanism and studies the dynamic representation technologies of topographic 3D-map based on LOD, space partitioning, DOL and object culling. Moreover. such interactive operation functions are explored, in this paper, as spatial query, scene editing and management of topographic 3D-map. Finally, this paper describes briefly the applications of topographic 3D-map in its related fields.     

气象卫星观测资料的分析在城市区域气象环境研究中的应用

目前 ,我国气象部门相当普遍地拥有气象卫星观测资料 ,但是 ,这些资料如何在城市气象服务以及为城市建设规划等方面的决策研究中发挥作用 ,急待进一步研究并开展工作。本文试图通过合理的反演处理 ,给出卫星观测对地面温度的测量结果 ,由此可比较细致地分析了解地面热状况及其与土地利用类型 ,地面覆盖性质等的关系。本文利用有限的 NOAA- AVHRR气象卫星遥感资料 ,采用修正的 Ulivieri分裂窗方法反演出同期的地表温度场 ,通过对北京地区的卫星观测资料进行算例分析 ,揭示出一个 2 0 0 km× 2 0 0 km范围内的地面温度分布特征。反演结果可以明显地揭示出城市热岛现象的变化规律 ,并且能较为清楚地反映出相对的高温区和低温区     

The impact of accelerometry on CHAMP orbit determination

 The contribution of the STAR accelerometer to the CHAMP orbit precision is evaluated and quantified by means of the following results: orbital fit to the satellite laser ranging (SLR) observations, GPS reduced-dynamic vs SLR dynamic orbit comparisons, and comparison of the measured to the modeled non-gravitational accelerations (atmospheric drag in particular). In each of the four test periods in 2001, five CHAMP arcs of 2 days' length were analyzed. The mean RMS-of-fit of the SLR observations of the orbits computed with STAR data or the non-gravitational force model were 11 and 24 cm, respectively. If the accelerometer calibration parameters are not known at least at the few percent level, the SLR orbit fit deteriorates. This was tested by applying a 10% error to the along-track scale factor of the accelerometer, which increased the SLR RMS-of-fit on average to 17 cm. Reference orbits were computed employing the reduced-dynamic technique with GPS tracking data. This technique yields the most accurate orbit positions thanks to the estimation of a large number of empirical accelerations, which compensate for dynamic modeling errors. Comparison of the SLR orbits, computed with STAR data or the non-gravitational force model, to the GPS-based orbits showed that the SLR orbits employing accelerometer observations are twice as accurate. Finally, comparison of measured to modeled accelerations showed that the level of geomagnetic activity is highly correlated with the atmospheric drag model error, and that the largest errors occur around the geomagnetic poles. Received: 7 May 2002 / Accepted: 18 November 2002 Correspondence to: S. Bruinsma Acknowledgments. The TIGCM results were obtained from the CEDAR database. This study was supported by the Centre National d'Etudes Spatiales (CNES). The referees are thanked for their helpful remarks and suggestions.     

Geoid determination using adapted reference field, seismic Moho depths and variable density contrast

 The traditional remove-restore technique for geoid computation suffers from two main drawbacks. The first is the assumption of an isostatic hypothesis to compute the compensation masses. The second is the double consideration of the effect of the topographic–isostatic masses within the data window through removing the reference field and the terrain reduction process. To overcome the first disadvantage, the seismic Moho depths, representing, more or less, the actual compensating masses, have been used with variable density anomalies computed by employing the topographic–isostatic mass balance principle. In order to avoid the double consideration of the effect of the topographic–isostatic masses within the data window, the effect of these masses for the used fixed data window, in terms of potential coefficients, has been subtracted from the reference field, yielding an adapted reference field. This adapted reference field has been used for the remove–restore technique. The necessary harmonic analysis of the topographic–isostatic potential using seismic Moho depths with variable density anomalies is given. A wide comparison among geoids computed by the adapted reference field with both the Airy–Heiskanen isostatic model and seismic Moho depths with variable density anomaly and a geoid computed by the traditional remove–restore technique is made. The results show that using seismic Moho depths with variable density anomaly along with the adapted reference field gives the best relative geoid accuracy compared to the GPS/levelling geoid. Received: 3 October 2001 / Accepted: 20 September 2002 Correspondence to: H.A. Abd-Elmotaal     

协同空间决策的概念、过程与特点研究

对空间决策支持系统和计算机系统协同工作环境进行系统分析和总结，概括了较为完整的协同空间决策概念，提出了协同空间决策的空间问题协同分析、方案生成与可视化、方案分析、方案表决等基本过程。在此基础上，作者详细分析了协同空间决策的复杂性、交互可视化、多用户参与、方案探索性分析、多层次协同等基本特征。     

用MODIS遥感资料分析四川盆地气溶胶光学厚度时空分布特征

利用MODIS卫星遥感光学厚度产品，分析了四川盆地光学厚度分布和季节变化特征。由于受沙尘天气的影响，春季四川盆地具有最大的平均光学厚度。盆地内几个大值区中，西部成都一带的中心常年维持，季节变化小；南部中心位于宜宾到重庆沿长江流域一带；东部南充到重庆间的大值中心，季节变化大，在夏季消失。光学厚度分布和季节变化的数据结果为研究区域气候变化提供了依据。     

中-吉-乌铁路(中国段)设计洪水的研究

根据中—吉—乌铁路(中国段)沿线近10个水文观测站40多年(建站一2000年)最大洪峰流量资料，对中—吉—乌铁路(中国段)最大洪峰流量设计值进行系统的研究。应用统计学导出的P—Ⅲ分布，预测了中—吉—乌铁路(中国段)最大洪峰流量不同概率设计值。这对于中—吉—乌铁路(中国段)工程设计和施工及未来铁路养护等具有重要的科学意义和工程价值。