藏南白垩系黑-红层沉积岩有机质组成分布特征

对藏南江孜县床得剖面白垩系黑层和红层沉积岩进行的有机地球化学研究表明,黑层有机碳含量高于红层5～10倍,红层和黑层饱和烃主峰碳数分别为nC25和nC23;黑层和红层沉积有机质的母质来源都以水生植物和菌藻类等低等生物为主,陆源有机质的输入非常有限;但饱和烃的分布和主峰碳数的差异可能反映了有机母源物质在种群方面的差异,而这种差异可能主要是水体温度存在差异造成的,即红层发育时期水体温度可能高于黑层沉积时期.而在高温度条件下,水生生物和陆生植物的生长发育受到限制,造成原始有机质产率和有机质沉积保存量低可能是红层沉积岩形成的主要原因.     

Experimental solidification of anhydrous latitic and trachytic melts at different cooling rates: The role of nucleation kinetics

Two sets of cooling experiments were run at atmospheric conditions for two anhydrous starting latitic and trachytic melts: 1) five cooling rates (25, 12.5, 3, 0.5, and 0.125 °C/min) between 1300° and 800 °C, and 2) a 0.5 °C/min cooling rate from 1300 °C with quench temperatures at 1200°, 1100°, 1000° and 900 °C. Trachytic run-products are invariably glassy. Nucleation is also suppressed in the latitic run-products at the three highest cooling rates. Conversely, in the 0.5 and 0.125 °C/min runs, latites have a crystal content of  90 vol.%. The phases are: plagioclase, clinopyroxene, glass and iron-bearing oxide (in order of abundance). The variable quench temperatures, investigated by coupling experiments with Pt wire and Pt capsule sample containers in set 2, again did not produce crystallization of trachyte, whereas latitic samples are characterized by  10 vol.% of oxides, pyroxenes and plagioclase (in order of appearance), at temperature < 1000 °C. Effects of (preferential) heterogeneous nucleation on sample holders, of superheating degree, and chemical species loss during cooling are absent for both melt compositions. The difference of solidification paths between these two silicate melts can be ascribed only to their small chemical differences. In comparison with calculated equilibrium conditions all the experimental latitic and trachytic run-products revealed strong kinetic effects, interpretable in the light of the nucleation theory. The glass-forming ability (GFA) of trachyte is higher, whereas their critical cooling rate (Rc) is lower (< 0.125 °C/min), in comparison to latitic melts (Rc > 0.5 °C/min). The experimental results carried out in this study can be applied to lava flows and domes; trachytic lavas are able to flow for longer period with respect to latitic ones in a metastable condition. Glass-rich terrestrial lavas, i.e. obsidians, can be the result of sluggish nucleation kinetics due to the relative high polymerisation of evolved silicate melts.     

Case history of controlling a landslide at Panluo open-pit mine in China

Controlling of landsides safely and economically is a great challenge to mine operators because landslides are major geological problems especially in open-pit mines. In this paper, a case history at Panluo open-pit mine is presented in detail to share the experiences and lessons with mine operators. Panluo open-pit mine is located in the southwestern Fujian province of China. It is the largest open-pit iron mine in the Fujian province and was planned in 1965 and is in full operation from 1978. In July 1990, an earthquake of magnitude 5.3 in Taiwan Strait and big rainstorms impacted the mine slope, causing tension cracks and rather large-scale failures, and forming a U-shaped landslide. Total potential volume was estimated to be up to 1.0 × 10⁶ m³. This directly threatened the mine production. In order to protect the mine production and the dwellers’ safety around, a dynamic comprehensive method was implemented including geotechnical investigations, in-situ testing and monitoring, stability analysis, and many mitigation and preventive measures. These measures slowed down the development and further occurrence of the landslide. The results showed that the landslides were still active, it was slowed with the control measures and moved rapidly with rainfall and mining down. However, no catastrophic accidents occurred and the pit mining was continued till it was closed at the elevation of 887 m in 2000. As a successful case of landslide control at an open-pit mine for 10 years, this paper reports the controlling measures in details. These experiences of landslide control may be beneficial to other similar mines for landslide control.     

Seal integrity and feasibility of CO<Subscript>2</Subscript> sequestration in the Teapot Dome EOR pilot: geomechanical site characterization

This paper reports a preliminary investigation of CO₂ sequestration and seal integrity at Teapot Dome oil field, Wyoming, USA, with the objective of predicting the potential risk of CO₂ leakage along reservoir-bounding faults. CO₂ injection into reservoirs creates anomalously high pore pressure at the top of the reservoir that could potentially hydraulically fracture the caprock or trigger slip on reservoir-bounding faults. The Tensleep Formation, a Pennsylvanian age eolian sandstone is evaluated as the target horizon for a pilot CO₂ EOR-carbon storage experiment, in a three-way closure trap against a bounding fault, termed the S1 fault. A preliminary geomechanical model of the Tensleep Formation has been developed to evaluate the potential for CO₂ injection inducing slip on the S1 fault and thus threatening seal integrity. Uncertainties in the stress tensor and fault geometry have been incorporated into the analysis using Monte Carlo simulation. The authors find that even the most pessimistic risk scenario would require ∼10 MPa of excess pressure to cause the S1 fault to reactivate and provide a potential leakage pathway. This would correspond to a CO₂ column height of ∼1,500 m, whereas the structural closure of the Tensleep Formation in the pilot injection area does not exceed 100 m. It is therefore apparent that CO₂ injection is not likely to compromise the S1 fault stability. Better constraint of the least principal stress is needed to establish a more reliable estimate of the maximum reservoir pressure required to hydrofracture the caprock.     

Shear strength characterization of municipal solid waste at the Suzhou landfill, China

The current practice of slope stability analysis for a municipal solid waste (MSW) landfill usually overlooks the dependence of waste properties on the fill age or embedment depth. Changes in shear strength of MSW as a function of fill age were investigated by performing field and laboratory studies on the Suzhou landfill in China. The field study included sampling from five boreholes advanced to the bottom of the landfill, cone penetration tests and monitoring of pore fluid pressures. Twenty-six borehole samples representative of different fill ages (0 to 13 years) were used to perform drained triaxial compression tests. The field and laboratory study showed that the waste body in the landfill can be sub-divided into several strata corresponding to different ranges of fill age. Each of the waste strata has individual composition and shear strength characteristics. The triaxial test results showed that the MSW samples exhibited a strain-hardening and contractive behavior. As the fill age of the waste increased from 1.7 years to 11 years, the cohesion mobilized at a strain level of 10% was found to decrease from 23.3 kPa to 0 kPa, and the mobilized friction angle at the same strain level increasing from 9.9° to 26°. For a confinement stress level greater than 50 kPa, the shear strength of the recently-placed MSW seemed to be lower than that of the older MSW. This behavior was consistent with the cone penetration test results. The field measurement of pore pressures revealed a perched leachate mound above an intermediate cover of soils and a substantial leachate mound near the bottom of the landfill. The measurements of shear strength properties and pore pressures were utilized to assess the slope stability of the Suzhou landfill.     

GMOs and their contexts: A comparison of potential and actual performance of GM crops in a local agricultural setting

In this paper, I argue that genetically modified organisms (GMOs) have inherent potential to contribute to socially and environmentally sustainable agriculture by virtue of their ‘biological embeddedness’. Their actual ‘performance’ and how this contributes to sustainability depends on the ‘mutual shaping’ of technology and context. While much attention has been given to the design context of GMOs, this paper considers the influence of the application context and of users. A case study investigating the use of insect-resistant and herbicide-tolerant GM cotton in the cotton-growing region of New South Wales in Australia is presented. The study was based on focus groups with farmers and other stakeholders in a cotton-growing community. It demonstrated a range of direct and indirect effects of GM cotton use, both positive and negative for sustainability, and the ways in which these effects were influenced by the local social context. The influences of the biotechnology industry context, in limiting the contributions that gene technologies can make to sustainability, were also considered, and remedies suggested. I argue that the polarity of the GM debate is hindering progress on these issues, and that a more balanced approach to our analysis of GMOs is necessary in order to fully understand, and to influence, their role in the future of rural spaces.     

Greening as strategic development in industrial change - Why companies participate in eco-networks

Networking between companies and other regional key actors has grown into a widespread instrument for economic development since the 1990s. Participatory networks have formed the concept for many activities of Local Agenda 21. Simultaneously, economic geography has focused on network theories to explain innovation in and the economic success of regions.This article focuses on the reasons why individual actors participate in environmentally oriented information networks. The questions approached are: Does the concept of learning within networks influence a firm’s development? How do the participants interact with each other? What effects do the networks have on their environment (arenas)?The changing arenas of a firm are analysed with regard to environmental concerns. These changes need to be anticipated for reliable strategies. To gain information and knowledge about current behaviour and activities, the functions of networks as learning platforms are discussed. Drawing upon arguments from different network theories, the motivations of participating in a network are threefold: actor and firm oriented, network internal (inter-firm), and network external. From these, a generic target cube of network motivations and actions is set up.The concept is reviewed by examining 12 ‘regional environmental information-oriented corporation networks’ (RUN) in the Greater Munich Area. The empirical material reveals that this type of network does not provide a guarantee for significant improvements in a firm’s environmental behaviour. However, participants learn about best practices while pursuing explicit or implicit aims as to influence their arenas.     

Probing the (in)compatibilities of social theory and policy relevance in Piers Blaikie’s political ecology

One of Piers Blaikie’s most important contributions to the development of political ecology is his critique of land and resource conservation policy in the global South. In this paper I trace the development of Blaikie’s ideas about the policy relevance of political ecology, focusing particularly on the challenges posed by the introduction of poststructural social theory into the field. I begin by revisiting Blaikie’s earlier critiques of environment and development policy. This will provide the departure point to explore how his thinking on the relationship of theory and policy and of academic and development practices has evolved in subsequent writings. I have invented two personas, “early Blaikie” and “late Blaikie”, to facilitate this task. Second, I want to probe some of the challenges that late Blaikie presents for doing political ecology research, to some extent by pitting early Blaikie against late Blaikie and letting them hash it out. Third, I turn to my own and others’ research and consultation experiences as a way to examine the possibilities for reconciling theoretically driven critiques with policy relevant research.     

Depths of Partial Crystallization of H2O-bearing MORB: Phase Equilibria Simulations of Basalts at the MAR near Ascension Island (7 11{degrees}S)

Phase equilibria simulations were performed on naturally quenchedbasaltic glasses to determine crystallization conditions priorto eruption of magmas at the Mid-Atlantic Ridge (MAR) east ofAscension Island (7–11°S). The results indicate thatmid-ocean ridge basalt (MORB) magmas beneath different segmentsof the MAR have crystallized over a wide range of pressures(100–900 MPa). However, each segment seems to have a specificcrystallization history. Nearly isobaric crystallization conditions(100–300 MPa) were obtained for the geochemically enrichedMORB magmas of the central segments, whereas normal (N)-MORBmagmas of the bounding segments are characterized by polybariccrystallization conditions (200–900 MPa). In addition,our results demonstrate close to anhydrous crystallization conditionsof N-MORBs, whereas geochemically enriched MORBs were successfullymodeled in the presence of 0·4–1 wt% H₂O in theparental melts. These estimates are in agreement with direct(Fourier transform IR) measurements of H₂O abundances in basalticglasses and melt inclusions for selected samples. Water contentsdetermined in the parental melts are in the range 0·04–0·09and 0·30–0·55 wt% H₂O for depleted and enrichedMORBs, respectively. Our results are in general agreement (within±200 MPa) with previous approaches used to evaluate pressureestimates in MORB. However, the determination of pre-eruptiveconditions of MORBs, including temperature and water contentin addition to pressure, requires the improvement of magma crystallizationmodels to simulate liquid lines of descent in the presence ofsmall amounts of water. KEY WORDS: MORB; Mid-Atlantic Ridge; depth of crystallization; water abundances; phase equilibria calculations; cotectic crystallization; pressure estimates; polybaric fractionation