Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

H2O-CH4-H2-CO2-CO-O2在高温、高压和高密度条件下的状态方程

为了计算高温，高压和高密度流体的热力学性质，提出了一个具有19个参数的维里型状态方程，其中参数与温度间的函数关系采用由Sutherland位能函数导出的维里系数近似式。除临界点附近以外，在已报道的pVT数据所覆盖的大部分超临界区域内，该方程均可适用。用该方程对H2O，CH4，H2，CO2，CO和O2等流体pVT关系的计算结果令人满意，其中pVT上限分别为：91-610GPa,1.6-11.0cm^3/mol,4000-5000K。计算体积的平均偏 小于0．8％，最大偏差小于5．4％。     

三类高强度悬式瓷绝缘子的成分和物相分析

为探讨高原牌70kN和进口120，210kN瓷绝缘子的成分和结构性能，中采用原子吸收光谱（AAS）和X射线衍射（XRD）方法，对三类产品进行了检测。结果表明，有效成分除K2O外，70kN和210kN的SiO2,Al2O3,Fe2O3含量接近，主晶相基本相同，有刚玉，莫来石、石英和长石等；结晶相总量：70kN35%，120kN40%,210kN48%，这表明机械强度愈大，结晶相含量愈高，只需调整70kN原样的部分成分，粒度和工艺，即生产出高等级（如210kN)瓷绝缘子。     

高温高压下电解质溶液热力学性质的研究进展

高温高压下电解质溶液热力学性质的研究不仅对探讨地球内部流体的作用具有重要意义，而且在很多实际工业过程中也都有广泛应用。本综述了近10年来高温高压下电解质溶液热力学参数的实验测量和理论计算的进展，实验设备还有待进一步的改进和完善，以获得更高温度和压力下的数据，理论计算不仅有待于实验的发展，也与溶液的结构理论密切相关。     

厚层覆盖区综合物化探方法找金试验研究——以广西兴安金石金矿为例

在兴安金石金矿外围 4号分散流异常区 ,通过地电化学提取金测量法 ,查明测区存在 5个走向规模小于 5 0 m的金异常区 ,W( Au) 最大值为 72 .4× 10 - 9,高出背景值十几倍 ,并藉综合土壤吸附汞测量 ,高精度磁测和激发极化法等多种物化探方法来确定这些异常区的地质、地球化学和地球物理特征 ,提出金矿成矿的有利部位在金的地电提取高异常区、高汞量异常区、高磁性异常区、低视电阻率异常区和中等视极化率异常区的“三高一低一中”的找矿模式。确定测区的北北东角 (右下角 )一带具备有利的金矿成矿条件     

X线侧位片与高分辨率CT对鼻骨骨折的对比研究

目的　通过86例鼻骨骨折的鼻骨X线侧位片与高分辨率CT(HRCT）对比研究，确定HRCT检查对鼻骨骨折的诊断价值。材料与方祛　86例鼻外伤或/和He、面外伤的患者均进行了鼻骨X线侧位摄影、HRCT扫描检查，经集体讨论，由有经验的放射医师对全部影像资料进行分析并进行统计学处理。结果HRCT显示所有的86例鼻骨骨折，但在此86例骨折中X线平片只显示了35例阳性，包括15例鼻骨汇合部骨折，7例双侧鼻骨骨折，3例复合骨折(鼻骨汇合部及双侧鼻骨骨折)，l0例鼻区骨折。X线平片显示5l例为阴性。结论　对鼻骨骨折的诊断，HRCT明显优于鼻骨X线侧位片，HRCT扫描检查可提高X线隐性鼻骨骨折的诊断，并可明确鼻骨骨折的类型、范围和程度，为临床诊断和治疗提供可靠的依据。     

关于绝对重力仪的发展和我们的思考

介绍了近年来出现的新型绝对重力仪，认为该仪器是控制地球重力场信息的重要工具，特别对FG5型的如何改进及我国绝对重力仪的如何发展，提出了建议。     

结构动力反应分析的三阶显式方法

本通过对传统动力反应分析方法的总结，阐明了建立隐式和显式方法的一般思路及数学本质，提出了使用系统位移反向向量三阶导数的隐工和实用显式积分方法－3阶显式方法，分析了该显式方法的精度和稳定性，并对建立更高阶隐式和显式方法以及方法的精度和稳定性作了初步讨论。最后，通过算例对本方法、献[1]方法和经典的常平均加速度法（隐式方法、视为精确解）的精度和稳定性进行了比较分析。结果表明，本方法具有明显的优点。     

The experimental studies on electrical con-ductivities and P-wave velocities of anortho-site at high pressure and high temperature

Introduction The measurements of the compressional wave velocity and electrical conductivity of minerals and rocks are of fundamental importance to look into the earths interior, including composition, geotherm, generation and distribution of fluids and melts. Hydrous minerals formed by metamatu-siom are abundant within the earth. Previous studies have been carried out on the dehydration effect on the electrical conductivity and wave velocity of rocks such as serpentine, amphibole, most of whi…