利用遥感综合分析西风引导气流与地形对沙尘运移路径的影响

沙尘暴的发生受大气环流、地表状况、降雨的影响，还受到局部地区地形的影响。一次规模较大的沙尘暴过程，沙尘可以从蒙古国和我国西部沙源地输送到我国东部、韩国、日本乃至夏威夷、美国西海岸。中日亚洲沙尘暴ADEC项目对亚洲沙尘暴的起沙、传输和降落的运行机制已经作了深入的研究，并建立了亚洲沙尘暴的数值模拟系统。本文以影响北京地区的沙尘暴事件为例，利用遥感技术，综合DEM地形数据和地面实测数据分析西风引导气流和地形对沙尘运移路径影响，将MODIs影像数据和DEM地形数据以及地面观测站点实测数据相结合，进行综合分析，结果表明在一次沙尘暴过程中，沙尘在运移过程中的运移路径明显地受到西风引导气流、沙尘粒子自然沉降规律以及局部地形的影响，要预防(减少)北京地区的沙尘暴仅仅作好北京地区的生态环境建设是不够的，加强北京周边地区，尤其是张家口地区、官厅水库库区及库区周围地区的生态环境建设尤为重要。     

沙尘天气等对西安市空气污染影响的研究

通过对西安市1981—2000年TSP、SO2和NOx年平均浓度资料,1998—2000年周报和日报环境监测资料以及相应的地面、高空常规气象观测资料的统计分析,研究了该市空气污染的时间变化特点以及沙尘天气等几种气象条件对其浓度变化的影响。结果表明:(1)颗粒污染物(TSP和PM10)是西安市的首要污染物,其次是SO2。1981—2000年期间,TSP年平均浓度降低了75%,SO2年平均浓度降低了77%,NOx年平均浓度总体上变化不大;这三种污染物月平均浓度的年变化都呈单周期型,冬季1月份最高,夏季最低(TSP是7月份最低,SO2和NOx是8月份最低)。(2)2001年春季3～4月份沙尘天气的频繁发生,使西安市空气污染日出现全年的第二个多发期(23d·月-1),这有别于正常年份仅在冬季1月份出现一个浓度峰值的特点;强沙尘暴天气过程会使西安市PM10浓度在非常短的时间内提高3倍左右,造成严重的颗粒物污染。(3)西安市冬半年出现轻度污染以上级别的几率明显大于夏半年。影响西安市的地面天气系统可归纳为12类,当受不同天气系统控制时,其污染状况会有较大差异。(4)西安市一年四季都有逆温存在,100m平均逆温强度为0.90℃;全年以低层逆温出现日数最多,但冬季贴地逆温出现日数最多,厚度最厚,强度最大,是造成西安市冬季空气污染严重的最重要气象因素之一。(5)西安     

利用热红外温差识别沙尘

沙尘识别是沙尘灾害监测和沙尘气溶胶特性研究的首要工作。利用辐射传输方程进行了沙尘气溶胶的辐射计算 ,对不同沙尘气溶胶光学厚度下的热红外通道温差ΔT(T11μm-T12 μm)的变化进行了分析。理论分析表明 ,利用热红外通道的温度差ΔT进行陆地沙尘识别是可行的。并利用NOAA AVHRR热红外通道的温度差ΔT进行了陆地沙尘识别的实验 ,经与地面气象站实测的沙尘天气现象相比较 ,结果一致。     

Submillimeter-wave and observations of the event on 28 November, 2001

We present a detailed study of a 1B/M6.9 impulsive flare combining high time resolution (1 ms) and instantaneous emission source localization observations at submillimeter frequencies (212 GHz), obtained with the solar submillimeter telescope (SST), and Hα data from the Hα solar telescope for argentina (HASTA). The flare, starting at 16:34 UT, occurred in active region (AR) 9715 (NOAA number) on November 28, 2001, and was followed by an Hα surge. We complement our data with magnetograms from the Michelson Doppler Imager (SOHO/MDI). SST observed a short impulsive burst at 212 GHz, presenting a weak bulk emission (of about 90 sfu) composed of a few shorter duration structures. The integrated Hα and the 212 GHz light curves present a remarkable agreement during the impulsive phase of the event. The delay between both curves stays below 12 s (the time resolution of the Hα telescope). The flare as well as the surge are linked to new flux emergence very close to the main AR bipole. Taking into account the AR magnetic field evolution, we infer that magnetic field reconnection, occurring at low coronal levels, could have been at the origin of the flare; while in the case of surge this would happen at the chromospheric level.     

Absence of extraterrestrial He in Permian-Triassic age sedimentary rocks

Helium concentration and isotopic composition were measured in a suite of samples across the Permian-Triassic boundary at Opal Creek, Canada, to determine whether high extraterrestrial helium concentrations are associated with a possible extinction-inducing impact event at this time. No extraterrestrial ³He was detected, implying that neither fullerene-hosted nor IDP-hosted He is present at or near the boundary. This observation is consistent with similar studies of some Permian-Triassic sections, but contrasts sharply with reports of both fullerene- and IDP-hosted extraterrestrial ³He at other sections.Step-heat experiments indicate rapid diffusion of extraterrestrial helium from sediments heated to temperatures above ∼ 70 °C. Given the likelihood of burial and associated heating in Permian-Triassic age rocks, the initially unexpected absence of IDP-hosted ³He likely indicates thermally induced diffusive loss. Indeed one of the key sections (Graphite Peak, Antarctica) from which extraterrestrial ³He has been reported at and near the Permian-Triassic boundary has been sufficiently heated that the reported preservation of extraterrestrial helium, in both IDPs and fullerenes, is inexplicable. Recent contamination provides a plausible explanation for extraterrestrial ³He in these samples.While no extraterrestrial ³He was detected at Opal Creek, there is a sharp increase in nucleogenic ³He very close to or at the Permian-Triassic boundary. This presumably arises from the major lithologic change at this time, from cherts in the Permian to shales and siltstones in the Triassic. Increased nucleogenic ³He is associated with increases in both lithium and organic carbon content into the Triassic. Either the production rate or the retention of this ³He is higher in the shales and siltstones than in the cherts. Care must be taken to eliminate such artifacts before interpreting changes in ³He concentration in terms of fluctuations in the delivery of ³He from space.     

Experimental study on soil CO2 emission in the alpine grassland ecosystem on Tibetan Plateau

The Tibetan Plateau, the Roof of the World, is the highest plateau with a mean elevation of 4000 m. It is characterized by high levels of solar radiation, low air temperature and low air pressure compared to other regions around the world. The alpine grassland, a typical ecosystem in the Tibetan Plateau, is distributed across regions over the elevation of 4500 m. Few studies for carbon flux in alpine grassland on the Tibetan Plateau were conducted due to rigorous natural conditions. A study of soil respiration under alpine grassland ecosystem on the Tibetan Plateau from October 1999 to October 2001 was conducted at Pangkog County, Tibetan Plateau (31.23°N, 90.01°E, elevation 4800 m). The measurements were taken using a static closed chamber technique, usually every two weeks during the summer and at other times at monthly intervals. The obvious diurnal variation of CO2 emissions from soil with higher emission during daytime and lower emission during nighttime was discovered. Diurnal CO2 flux fluctuated from minimum at 05:00 to maximum at 14:00 in local time. Seasonal CO2 fluxes increased in summer and decreased in winter, representing a great variation of seasonal soil respiration. The mean soil CO2 fluxes in the alpine grassland ecosystem were 21.39 mgCO2 · m-2 · h-1, with an average annual amount of soil respiration of 187.46 gCO2 · m-2 · a-1. Net ecosystem productivity is also estimated, which indicated that the alpine grassland ecosystem is a carbon sink.     

Vertical dynamic and thermodynamic characteristics of urban lower boundary layer and its relationship with aerosol concentration over Beijing

By utilizing observational data from a 325 m tower of the Institute of Atmospheric Physics (IAP), Chinese Academy of Sciences (CAS) on March 19-29, 2001 and August 11-25, 2003, a comprehensive study was conducted on the vertical dynamical and thermodynamic characteristics of the urban lower boundary layer (ULBL) and its relationship with aerosol concentration over Beijing. Firstly, a comparative analysis was made on the gradient data (wind, temperature and humidity), ultrasonic data (atmospheric turbulences) and air-quality observations at different tower heights (47, 120 and 280 m). Secondly, a diagnosis was made to reveal the major features of normalized variances of velocity and temperature, turbulence kinetic energy as well as their relationship with aerosol concentrations. Furthermore, the characteristics of the ULBL vertical structure and the TSP concentration/distribution variations during a sand/dust weather process were also analyzed. The outcome of the study showed that under unstable stratification, the normalized variances of velocity (σu/u*, σv/u*, σw/u*) and temperature (σT/T*) at 47 and 120 m heights fit the Monin-Obukhov similarity (MOS) framework and the fitting formulas were given out accordingly. According to the stratification parameter (z′/L), the stable ULBL could be divided into 2 zones. With z′/L<0.1, it was a weakly stable zone and MOS framework was applicable. The other was a highly stable zone with z′/L>0.1 and the normalized velocity variances tended to increase along with higher stability, but it remained constant for normalized temperature variances. At daytime, the near-surface layer includes two heights of 47 and 120 m, while 280 m has been above it. The ULBL analysis in conjunction with a sand/dust weather process in Beijing in March 2001 indicated that the maximum concentration of Total Suspended Particulates (TSP) at 320 m reached 913.3 μg/m3 and the particles were transported from the upper to lower ULBL, which was apparently related to the development process of a low-level jet and its concomitant strong sinking motion.     

Study of statistically correcting model CMAQ-MOS for forecasting regional air quality

Based on analysis of the air pollution observational data at 8 observation sites in Beijing including outer suburbs during the period from September 2004 to March 2005, this paper reveals synchronal and in-phase characteristics in the spatial and temporal variation of air pollutants on a city-proper scale at deferent sites; describes seasonal differences of the pollutant emission influence between the heating and non-heating periods, also significantly local differences of the pollutant emission influence between the urban district and outer suburbs, i.e. the spatial and temporal distribution of air pollutant is closely related with that of the pollutant emission intensity. This study shows that due to complexity of the spatial and temporal distribution of pollution emission sources, the new generation Community Multi-scale Air Quality (CMAQ) model developed by the EPA of USA produced forecasts, as other models did, with a systematic error of significantly lower than observations, albeit the model has better capability than previous models had in predicting the spatial distribution and variation tendency of multi-sort pollutants. The reason might be that the CMAQ adopts average amount of pollutant emission inventory, so that the model is difficult to objectively and finely describe the distribution and variation of pollution emission sources intensity on different spatial and temporal scales in the areas, in which the pollution is to be forecast. In order to correct the systematic prediction error resulting from the average pollutant emission inventory in CMAQ, this study proposes a new way of combining dynamics and statistics and establishes a statistically correcting model CMAQ-MOS for forecasts of regional air quality by utilizing the relationship of CMAQ outputs with corresponding observations, and tests the forecast capability. The investigation of experiments presents that CMAQ-MOS reduces the systematic errors of CMAQ because of the uncertainty of pollution emission inventory and improves the forecast level of air quality. Also this work employed a way of combining point and area forecasting, i.e. taking the products of CMAQ for a center site to forecast air pollution for other sites in vicinity with the scheme of model products "reanalysis" and average over the "area".     

Localization of mining-induced horizontal fractures along rock layer interfaces in overburden: field measurements and prediction

The locations of mining-induced horizontal fractures along rock interfaces in the overburden of Donetsk Coal Basin were identified using an original experimental device. The device traps methane from horizontal fracture zone (100–fold coal seam thickness) over an active longwall mining excavation. Presence or absence of horizontal fractures along rock layer interfaces is correlated with physical characteristics of the overburden, such as thickness, uniaxial compressive strength of overburden rock layers, location of rock layer interfaces and thickness of extracted coal seams. As a result, a combined criterion based on these physical characteristics is proposed to predict the presence of overburden horizontal fracturing in coal mine operations.     

On Tension Failure of 2-D Rock Specimens and Associated Acoustic Emission

Summary To understand the failure mechanism of quasi-brittle materials like rock under tensile stress, observations on the failure process of granite and marble plate specimens under tension are summarized and presented. Micro- and macro-failure properties of rock plates under uniaxial tension have been characterized by using an acoustic emission technique. Acoustic emission signals associated with micro-fractures are captured to locate the sources. An algorithm based on arrival time difference is developed for this purpose. The results reveal clearly the failure processes of rock which include initiation, nucleation and propagation of micro-fractures when the axial stress is close to the peak strength of rock. It is believed that the difference in heterogeneity between granite and marble specimens leads to different fracture shapes and different behaviors of associated acoustic emissions. Numerical simulation of acoustic emissions for two-dimensional tensile test is also carried out. The simulated characteristics are in good agreement with the experimental results.