四川米易海塔地区混合岩型铀矿流体包裹体特征

混合岩型铀矿是康滇地轴上最有希望取得找矿突破的铀矿类型,海塔地区的铀矿化即是该类型铀矿的典型代表。本文针对区内的长英质脉矿石、富晶质铀矿石英脉矿石和含矿热液石英脉中的石英流体包裹体进行了研究。结果表明,海塔地区混合岩型铀矿的成矿作用可分为2个阶段:早期混合岩化热液成矿阶段为高温、中低盐度流体,流体包裹体均一温度集中在380~540℃,盐度变化范围为16.15%~23.18%NaCl eqv,是区内铀成矿的主要阶段;晚期热液叠加改造成矿阶段为中低温、低盐度流体,流体包裹体均一温度集中在140~220℃,盐度变化范围为5.56%~23.18%NaCleqv,是区内富铀矿的形成阶段。流体包裹体的气相成分测试表明,长英质脉矿石石英包裹体中以CH4、CO2为主,其次为H2O和N2;而富晶质铀矿石英脉及含矿热液石英脉石英包裹体中以H2为主,部分含有CO2、CH4、H2O。氢、氧同位素研究表明,早期混合岩化成矿阶段的成矿流体可能为岩浆水与变质水的混合,而晚期热液叠加改造成矿阶段成矿流体中可能有大气降水的加入。     

Talus slope geomorphology investigated at multiple time scales from high-resolution topographic surveys and historical aerial photographs (Sanetsch Pass,Switzerland)

Talus slopes are common places for debris storage in high-mountain environments and form an important step in the alpine sediment cascade. To understand slope instabilities and sediment transfers, detailed investigations of talus slope geomorphology are needed. Therefore, this study presents a detailed analysis of a talus slope on Col du Sanetsch (Swiss Alps), which is investigated at multiple time scales using high-resolution topographic (HRT) surveys and historical aerial photographs. HRT surveys were collected during three consecutive summers (2017–2019), using uncrewed aerial vehicle (UAV) and terrestrial laser scanning (TLS) measurements. To date, very few studies exist that use HRT methods on talus slopes, especially to the extent of our study area (2 km²). Data acquisition from ground control and in situ field observations is challenging on a talus slope due to the steep terrain (30–37°) and high surface roughness. This results in a poor spatial distribution of ground control points (GCPs), causing unwanted deformation of up to 2 m in the gathered UAV-derived HRT data. The co-alignment of UAV imagery from different survey dates improved this deformation significantly, as validated by the TLS data. Sediment transfer is dominated by small-scale but widespread snow push processes. Pre-existing debris flow channels are prone to erosion and redeposition of material within the channel. A debris flow event of high magnitude occurred in the summer of 2019, as a result of several convective thunderstorms. While low-magnitude (<5,000 m³) debris flow events are frequent throughout the historical record with a return period of 10–20 years, this 2019 event exceeded all historical debris flow events since 1946 in both extent and volume. Future climate predictions show an increase of such intense precipitation events in the region, potentially altering the frequency of debris flows in the study area and changing the dominant geomorphic process which are active on such talus slopes. © 2020 John Wiley & Sons, Ltd.     

利用地面激光与地质雷达综合探测活断层浅层三维结构——以川西理塘毛垭坝盆地北缘正断层为例

快速获取活断层的高精度微地貌形态和对应的浅层三维结构是揭示活断层浅地表形迹与活动特征的关键。文中综合利用地面三维激光扫描仪和地质雷达技术,以川西理塘地区毛垭坝盆地北缘主边界断裂禾尼段的正断层崖为研究对象,获取了该处正断层错动2期最新地貌面的精确地表垂直位移量和浅层二维地质雷达图像,并初步建立了基于地面三维激光与地质雷达的活断层微地貌精细化三维测量方法,构建了断层崖微地貌的精细三维模型和浅表三维图像,揭示了正断层崖处发育的伸展地堑结构,同时初步实现了断层微地貌地表地下三维数据的一体化融合显示及相互解译。应用结果表明,该方法可以同时快速、高效、无损地获取大范围内的活断层微地貌及浅层结构的多层次、多视觉的空间数据,极大地提高了对活动断层微地貌形态与浅层结构进行快速调查与研究的精度和认识水平,也为更全面地认识和理解活断层的空间分布与变形特征、活动习性和多期古地震遗迹等提供重要的数据和方法支持。因此,对该方法的继续探索和完善,将显著提升和扩展其在活断层定量化和精细化研究中的实用性及应用前景。     

基于三维激光扫描的堆积体滑坡变形机理及阈值模型试验研究

为分析白龙江流域舟曲段江顶崖滑坡的变形演化机理及其阈值,设计降雨条件下的大型堆积体滑坡物理模型试验,采用FARO FocusS 350三维激光扫描仪进行滑坡数据采集、处理,获取滑坡在不同降雨工况的点云模型数据,对比分析不同降雨工况下滑坡宏观及局部特征点的变化情况。研究表明：滑坡模型表面出现持续、快速、变化鲜明的整体变形特征,伴随出现滑坡模型中、前部横向、纵向的张拉裂缝,表明在非饱和渗流影响下,堆积体滑坡模型的基质吸力降低、孔隙水压力以及滑坡体重力荷载增加,导致滑坡模型临近失稳;根据滑坡模型宏观变形情况,其变形演化过程可划分为：初始变形阶段、等速变形阶段和加速变形阶段,3个不同变形阶段坡体宏观变形各自有其特点。通过对试验阶段的变形特征分析,设立了滑坡变形速率阈值,分别为0.01 m/h、0.02 m/h、0.2 m/h。基于三维激光扫描技术坡体监测,结合坡体变形宏观和局部分析的优势,在保证高精度监测、采集、处理的同时,得到坡体的整体变形和位移。     

Assessment of micro‐aggregation using laser diffractometry

In order to evaluate the influence of the measuring technique on the determination of (micro‐)aggregation in soil and sediment samples, results of grain size distributions of undispersed silty soil samples obtained by the sieve‐pipette method are compared with those obtained using a laser diffraction grain size analyser, the Coulter LS‐100. Reduced major axis relationships are calculated which may be used to convert Coulter LS‐100 results to those obtained by the sieve‐pipette method. The relationships obtained are very similar to the reduced major axis relationships established for dispersed silty soil samples. The results also show that the Coulter LS measurements have a systematic bias compared to the sieve‐pipette data. This implies that, if the percentage of (micro‐)aggregation is determined, the (interpretation of the) results will be strongly dependent on the measurement technique used. Using the calibration relationships that were established, nomographs can be developed to predict the level of sieve‐pipette (micro‐) aggregation from Coulter LS‐100 data. Copyright © 1999 John Wiley & Sons, Ltd.     

堆石料三维形状量化及其对颗粒破碎的影响

筑坝堆石料由于尺寸较大,必须对其按一定比例缩尺后才能用来开展室内三轴试验。但缩尺前后颗粒形状难免会有差异,如何评价颗粒形状变化对堆石料变形特性的影响是十分重要的。引入了高精度的三维激光扫描技术对紫坪铺面板坝筑坝堆石料2.5～5、5～10、10～20 mm以及20～40 mm 4个粒径组的颗粒进行了空间形状分析,在此基础上进一步开展了单一粒组的三轴试验,研究了4个粒组的颗粒形状指标与颗粒破碎率的相关性。试验表明,紫坪铺堆石料颗粒破碎率随着其平均球度的增加而减小,并且呈近似半对数线性关系;随着围压的增加,颗粒形状对颗粒破碎的影响逐渐减弱,颗粒强度的影响逐渐增大。紫坪铺堆石料的颗粒强度随着颗粒尺寸的增加逐渐减小,但其破碎率反而随着颗粒尺寸的增加而逐渐减小,主要是因为试验所采用的紫坪铺堆石料颗粒尺寸越小时,其形状越不规则。因此,研究缩尺效应对颗粒破碎率的影响时,要同时考虑颗粒尺寸和颗粒形状。     

Enhanced Oxygen Isotope Determination in Uranium Oxides Using BrF5 Fluorination

A new method for accurate determination of oxygen isotopes in uranium oxides encountered in the nuclear fuel cycle was developed using the conventional BrF₅ fluorination technique. Laser‐assisted fluorination was tested for comparison. We focused on fine powders of triuranium octoxide (U₃O₈), uranium dioxide (UO_2±x with 0 ≤ x ≤ 0.25), uranium trioxide (UO₃.nH₂O, with 0.8 ≤ n ≤ 2) and diuranates (M₂U₂O₇.nH₂O, with M = NH₄, Na or Mg_0.5 and 0 ≤ n ≤ 6). Fluorination at room temperature and heating under vacuum at 150 °C are shown to eliminate both adsorbed and structural water from the powder samples. Precision fit for purpose of δ¹⁸O values (± 0.3‰, 1s) and oxygen yields (close to 100%) were obtained for U₃O₈ and UO₂ where oxygen is only bound to uranium. A lower precision was observed for UO₃.nH₂O and M₂U₂O₇.nH₂O where oxygen is both present in the structural H₂O and bonded to uranium and where the extracted O_2(g) can be contaminated by NF₃ and NO_x compounds. Laser‐assisted fluorination gave shifted δ¹⁸O values between +0.8 and +1.4‰ for U₃O₈, around ?0.8‰ for UO₃.nH₂O and between ?3.9 and ?4.5‰ for M₂U₂O₇.nH₂O (± 0.3‰, 1s) compared with the conventional method.     

基于星载激光测高估计南极冰盖高程变化

利用NSIDC公布的ICESat运行期间的19个任务期的观测数据, 采用重复轨迹分析方法估计近年来南极冰盖高程的时空变化。结果表明,南极大陆冰盖整体上呈现消融趋势,基于不同的GIA模型和ICESat激光测高数据的南极大陆冰盖高程变化的趋势约为 -1.17~-1 cm/a。     

Ultra‐rapid topographic surveying for complex environments: the hand‐held mobile laser scanner (HMLS)

Terrestrial laser scanning is the current technique of choice for acquiring high resolution topographic data at the site scale (i.e. over tens to hundreds of metres), for accurate volume measurements or process modelling. However, in regions of complex topography with multiple local horizons, restricted lines of sight significantly hinder use of such tripod‐based instruments by requiring multiple setups to achieve full coverage of the area. We demonstrate a novel hand‐held mobile laser scanning technique that offers particular promise for site‐scale topographic surveys of complex environments. To carry out a survey, the hand‐held mobile laser scanner (HMLS) is walked across a site, mapping around the surveyor continuously en route. We assess the accuracy of HMLS data by comparing survey results from an eroding coastal cliff site with those acquired by a state‐of‐the‐art terrestrial laser scanner (TLS) and also with the results of a photo‐survey, processed by structure from motion and multi‐view stereo (SfM‐MVS) algorithms. HMLS data are shown to have a root mean square (RMS) difference to the benchmark TLS data of 20 mm, not dissimilar to that of the SfM‐MVS survey (18 mm). The efficiency of the HMLS system in complex terrain is demonstrated by acquiring topographic data covering ~780 m² of salt‐marsh gullies, with a mean point spacing of 4.4 cm, in approximately six minutes. We estimate that HMLS surveying of gullies is approximately 40 times faster than using a TLS and six times faster than using SfM‐MVS. © 2013 The Authors. Earth Surface Processes and Landforms Published by John Wiley & Sons Ltd.