均布荷载下钢纤维混凝土叠合梁抗剪性能试验研究

本文通过１１根叠合梁的试验，分析了均布荷载作用下钢纤维混凝土叠合梁的抗剪性能，提出了无腹筋和配箍筋钢纤维混凝土叠合梁斜截面受剪承载力的计算公式。研究结果表明，钢纤维的掺入改善了叠合梁的抗剪性能，提高了斜截面受剪承载力     

Physical mechanism of strong negative storm effects in the daytime ionospheric F2 region observed with EISCAT

A self-consistent method for daytime F-region modelling was applied to EISCAT observations during two periods comprising the very disturbed days 3 April 1992 and 10 April 1990. The observed strong N_e decrease at F2-layer heights originated from different physical mechanisms in the two cases. The negative F2-layer storm effect with an N_mF2 decrease by a factor of 6.4 on 3 April 1992 was produced by enhanced electric fields (E 85 mV/m) and strong downward plasma drifts, but without any noticeable changes in thermos-pheric parameters. The increase of the O⁺ + N₂ reaction rate resulted in a strong enrichment of the ionosphere with molecular ions even at F2-layer heights. The enhanced electric field produced a wide mid-latitude daytime trough on 03 April 1992 not usually observed during similar polarization jet events. The other strong negative storm effect on 10 April 1990 with a complete disappearance of the F2-layer maximum at the usual heights was attributed mainly to changes in neutral composition and temperature. A small value for the shape parameter S in the neutral temperature profile and a low neutral temperature at 120 km indicate strong cooling of the lower thermosphere. We propose that this cooling is due to increased nitric oxide concentration usually observed at these heights during geomagnetic storms.     

天山东部冰川雪坑离子浓度特征的对比研究——以奎屯河哈希勒根51号冰川和哈密庙尔沟平顶冰川为例

对2004年获取的天山奎屯河哈希勒根51号冰川1个雪坑和哈密庙尔沟平顶冰川4个雪坑的离子浓度特征进行了研究,结果表明:Ca2 、NO3-和SO24-是哈密庙尔沟平顶冰川雪坑雪层和积累区雪坑底部冰中的主要离子(尤其是Ca2 ),其雪层中的主要阳离子关系可在底部冰中得以较好的反映,但雪层中各离子浓度与海拔的相关性不明显,可能与海拔的跨度较小和挖取的雪坑较疏有关;雪坑底部冰中的离子浓度与海拔间明显的相关性说明淋融作用随着海拔升高、气温降低而逐渐减弱。SO24-和Ca2 是奎屯河哈希勒根51号冰川雪坑中的主要离子(尤其是SO42-),其雪坑离子化学特征与哈密庙尔沟平顶冰川差别较大,可能与哈密庙尔沟平顶冰川处于塔克拉玛干沙漠、古尔班通古特沙漠和鄯善沙漠的下风向相关,还可能与雪层内淋融作用的强弱和沉积通量的高程效应有关。哈密庙尔沟平顶冰川积累区雪坑中NH4 、NO3-和K 的Cs/Ci较Ca2 、Mg2 和Na 要大,奎屯河哈希勒根51号冰川Na 和NH4 的"雪冰比"较Cl-、SO42-、Mg2 和Ca2 要大,说明这两条冰川雪坑中的Ca2 和Mg2 信号较其它离子可能更易于在冰芯记录中保存下来,为冰芯研究和古气候记录的恢复提供了保障。     

A Method for Analyzing the Self-Supported Earth-Retaining Structure Using Stabilizing Piles

The self-supported earth-retaining structure using stabilizing piles (SSR is used from here) has the advantages of less deformation and less internal force compared with conventional cantilever retaining structure. It is easier to conduct the excavation when SSR is used for an excavation instead of using braced excavation with struts. The SSR is better than other methods to the 10 m shallow excavation depth in terms of economical and constructional efficiency when the ground is not very soft. However, this SSR method lacks a theoretical basis in terms of geotechnical engineering. The objective of this study is to develop a method of analysis by laboratory model tests. A variety of model tests were performed in order to analyze the behavior of SSR and the ground, and to measure the stress acting on stabilizing piles relative to excavation steps and earth pressures on the wall. The analysis reveals the failure mechanism of a wedge and then suggests a method for calculating a virtual supported point. These findings were incorporated into a method for analyzing retaining wall, stabilizing piles, and beams connecting two structures. Future research is geared toward developing a design program that uses the analytical methodology for this SSR.     

Analysis of bromate and bromide in drinking water by ion chromatography-inductively coupled plasma mass spectrometry

A method for the detection of bromate and bromide in drinking water by ion chromatography-inductively coupled plasma mass spectrometry (IC-ICP-MS) was developed. The optimized conditions of IC including pH and concentration of the effluent were studied. The results showed that the above two species of bromine were baseline separated within nine minutes under the optimized conditions. The detection limits (S/N=3) of bromate and bromide were 0.23 and 0.12 μg/L, respectively. The RSD (n=6) of the peak areas was 1.2%-3.5%. The method has been successfully applied to the determination of the type bromide in drinking water samples. The recoveries were 95%-109%. The method can be used for the regular analysis of bromate and bromide in real drinking water samples.     

Gabor‐frame‐based Gaussian packet migration

We present a Gaussian packet migration method based on Gabor frame decomposition and asymptotic propagation of Gaussian packets. A Gaussian packet has both Gaussian‐shaped time–frequency localization and space–direction localization. Its evolution can be obtained by ray tracing and dynamic ray tracing. In this paper, we first briefly review the concept of Gaussian packets. After discussing how initial parameters affect the shape of a Gaussian packet, we then propose two Gabor‐frame‐based Gaussian packet decomposition methods that can sparsely and accurately represent seismic data. One method is the dreamlet–Gaussian packet method. Dreamlets are physical wavelets defined on an observation plane and can represent seismic data efficiently in the local time–frequency space–wavenumber domain. After decomposition, dreamlet coefficients can be easily converted to the corresponding Gaussian packet coefficients. The other method is the Gabor‐frame Gaussian beam method. In this method, a local slant stack, which is widely used in Gaussian beam migration, is combined with the Gabor frame decomposition to obtain uniform sampled horizontal slowness for each local frequency. Based on these decomposition methods, we derive a poststack depth migration method through the summation of the backpropagated Gaussian packets and the application of the imaging condition. To demonstrate the Gaussian packet evolution and migration/imaging in complex models, we show several numerical examples. We first use the evolution of a single Gaussian packet in media with different complexities to show the accuracy of Gaussian packet propagation. Then we test the point source responses in smoothed varying velocity models to show the accuracy of Gaussian packet summation. Finally, using poststack synthetic data sets of a four‐layer model and the two‐dimensional SEG/EAGE model, we demonstrate the validity and accuracy of the migration method. Compared with the more accurate but more time‐consuming one‐way wave‐equation‐based migration, such as beamlet migration, the Gaussian packet method proposed in this paper can correctly image the major structures of the complex model, especially in subsalt areas, with much higher efficiency. This shows the application potential of Gaussian packet migration in complicated areas.     

Estimation of base motion in instrumented steel buildings using output‐only system identification

A procedure to estimate the seismic motion at the base of a building from measured acceleration response at two or more floors is presented. The proposed method is comprised of two steps. In the first step, the dynamic characteristics of the building are inferred by using an output‐only system identification procedure. In the second step, the motion of the base of the building is estimated by using the transfer function of a simplified building model consisting of a shear and flexural continuous beam together with dynamic properties obtained in the first step. The proposed method is validated first with an analytical model subjected to the 1940 El Centro ground motion and then with an instrumented building in California that experienced the 1994 Northridge earthquake, and the ground motions at the base of the building are available. It is shown that the proposed method is capable of providing very good estimates of the motion at the base. The use of the proposed method is finally illustrated on an instrumented building, where the sensor at the base of the building did not function during the 1994 Northridge earthquake. Copyright © 2013 John Wiley & Sons, Ltd.     

H-implantation in SO2 and CO2 ices

Ices in the solar system are observed on the surface of planets, satellites, comets and asteroids where they are continuously subordinate at particle fluxes (cosmic ions, solar wind and charged particles caught in the magnetosphere of the planets) that deeply modify their physical and structural properties. Each incoming ion destroys molecular bonds producing fragments that, by recombination, form new molecules also different from the original ones. Moreover, if the incoming ion is reactive (H⁺, Oⁿ⁺, Sⁿ⁺, etc.), it can concur to the formation of new molecules.Those effects can be studied by laboratory experiments where, with some limitation, it is possible to reproduce the astrophysical environments of planetary ices.In this work, we describe some experiments of 15-100 keV H⁺ and He⁺ implantation in pure sulfur dioxide (SO₂) at 16 and 80 K and carbon dioxide (CO₂) at 16 K ices aimed to search for the formation of new molecules. Among other results we confirm that carbonic acid (H₂CO₃) is formed after H-implantation in CO₂, vice versa H-implantation in SO₂ at both temperatures does not produce measurable quantity of sulfurous acid (H₂SO₃). The results are discussed in the light of their relevance to the chemistry of some solar system objects, particularly of Io, the innermost of Jupiter's Galilean satellites, that exhibits a surface very rich in frost SO₂ and it is continuously bombarded with H⁺ ions caught in Jupiter's magnetosphere.     

2001年9月至2002年11月峨眉山降雨化学组成动态变化

2001年9月初在峨眉山从金顶气象站(海拔3070m)到成都理工大学实习基地(海拔486m)大约每隔100m放置了一个雨水收集桶,共25个雨水采集点,并从2001年9月至今每月收集雨水分析。本文选取了2001年9月至2002年11月在25个雨水采集点采集的雨水样的阴阳离子,pH,EC(电导度)等分析结果进行研究,归纳了pH,PAi,EC以及主要的阴阳离子的变化规律,即它们的变化基本受季节变化以及高程的控制。     

Removal of Copper,Nickel, and Zinc Ions from Electroplating Rinse Water

Removal of copper, nickel, and zinc ions from synthetic electroplating rinse water was investigated using cationic exchange resin (Ceralite IR 120). Batch ion exchange studies were carried out to optimize the various experimental parameters (such as contact time, pH, and dosage). Influence of co‐existing cations, chelating agent EDTA on the removal of metal ion of interest was also studied. Sorption isotherm data obtained at different experimental conditions were fitted with Langmuir, Freundlich, Redlich–Peterson, and Toth models. A maximum adsorption capacity of 164 mg g^?1 for Cu(II), 109 mg g^?1 for Ni(II), and 105 mg g^?1 for Zn(II) was observed at optimum experimental conditions according to Langmuir model. The kinetic data for metal ions adsorption process follows pseudo second‐order. Presence of EDTA and co‐ions markedly alters the metal ion removal. Continuous column ion exchange experiments were also conducted. The breakeven point of the column was obtained after recovering effectively several liters of rinse water. The treated rinse water could be recycled in rinsing operations. The Thomas and Adams–Bohart models were applied to column studies and the constants were evaluated. Desorption of the adsorbed metal ions from the resin column was studied by conducting a model experiments with Cu(II) ions loaded ion exchange resin column using sulfuric acid as eluant. A novel lead oxide coated Ti substrate dimensionally stable (DSA) anode was prepared for recovery of copper ions as metal foil from regenerated liquor by electro winning at different current densities (50–300 A cm^?2).