Changes in stream water quality due to logging of the boreal forest in the Montmorency Forest,Québec

Summer stream water quality was monitored before and following the logging of 50% of the boreal forest within three small watersheds (<50 ha) nested in the ‘Ruisseau des Eaux‐Volées’ Experimental Watershed, Montmorency Forest (Québec, Canada). Logging was conducted in winter, on snow cover according to recommended best management practices (BMPs) to minimize soil disturbance and protect advance growth. A 20‐m forest buffer was maintained along perennial streams. In watershed 7·2, cut‐blocks were located near the stream network and logging was partially allowed within the riparian buffer zone. In watersheds 7·5 and 7·7, logging occurred farther away from the stream network. Observations were also made for watershed 7·3 that collected the runoff from watersheds 7·2 and 7·5, and watershed 7·6, the uproad portion of watershed 7·7. The control watershed 0·2 was contiguous to the impacted watersheds and remained undisturbed. Following clearcutting, changes in summer daily maximum and minimum stream temperatures remained within ± 1 °C while changes in diurnal variation did not decrease by more than 0·5 °C. Concentrations of NO₃^? greatly increased by up to 6000% and concentrations of K⁺ increased by up to 300% during the second summer after logging. Smaller increases were observed for Fe_total (up to 71%), specific conductance (up to 26%), and Mg²⁺ (up to 19%). Post‐logging pH decreased slightly by no more than 7% while PO₄^3? concentration remained relatively constant. Suspended sediment concentrations appeared to increase during post‐logging, but there was not enough pre‐logging data to statistically confirm this result. Logging of moderate intensity and respecting established BMPs may account for the limited changes of water quality parameters and the low exceedances of the criteria for the protection of aquatic life. The proximity of the cutover to the stream network and logging within the riparian zone did not appear to affect water quality. Copyright © 2008 John Wiley & Sons, Ltd.     

Définition et datation de la Formation de Venaco (Corse) : dépôt d’origine gravitaire d’âge Priabonien

Priabonian age is highlighted for the first time in Corsica in the Venaco Formation using the presence of specific microfauna (in particular some representatives of Turborotalia cerroazulensis lineage). This silicoclastic formation is mainly represented by coarse facies. It is composed of three members from south to north and from oldest towards youngest: member of Uboli, Cardo and Orsu. The sedimentologic analysis reveals a gravity depositional environment, involving different type of currents. Sedimentologic and chronologic characteristics make the Venaco Formation and the Annot Formation (p.p.) equivalent. Dating the Venaco Fm. brings confirmation that the green schist metamorphism of the Variscan batholith and the related deformation are from the pre-Priabonian period.     

Simultaneous Determination of Fluorine,Chlorine, Bromine and Iodine in Six Geochemical Reference Materials Using Pyrohydrolysis,Ion Chromatography and Inductively Coupled Plasma‐Mass Spectrometry

Concentrations of halogens (fluorine, chlorine, bromine and iodine) were determined in six geochemical reference materials (BHVO‐2, GS‐N, JG‐1, JR‐1, JB‐1b, JB‐2). Halogens were first extracted from powdered samples using a pyrohydrolysis technique, then hydrolysis solutions were analysed by ion chromatography for F and Cl and inductively coupled plasma‐mass spectrometry for Br and I. The detection limits in solutions were 100 μg l^?1 for both F and Cl and 10 ng l^?1 for Br and I. Considering the extraction procedure, performed on a maximum of 500 mg of sample and producing 100 ml of pyrohydrolysis solution, detection limits in rock samples were 20 mg kg^?1 for F and Cl and 2 μg kg^?1 for Br and I. The mean analytical errors on the studied composition ranges were estimated at 10 mg kg^?1 for F and Cl, 100 μg kg^?1 for Br and 25 μg kg^?1 for I. The concentration values, based on repeated (generally > 10) sample analysis, were in good agreement generally with published values and narrowed the mean dispersion around mean values. Large dispersions are discussed in terms of samples heterogeneity and contaminations during sample preparation. Basaltic RMs were found to be more suitable for studies of halogen compositions than differentiated rock material, especially granites – the powders of which were heterogeneous in halogens at the 500 mg level.     

An Optimised 1,10‐Phenanthroline Method for the Determination of Ferrous and Ferric Oxides in Silicate Rocks,Soils and Minerals

A precise, accurate and rapid method for the sequential determination of FeO and Fe₂O₃ in rocks, soils and some non‐refractory minerals by 1,10‐phenanthroline spectrophotometry is described. Fe(II) and Fe(III) were leached from the sample (?200 mesh) using a mixture of NH₄HF₂ and H₂SO₄ at 40–80 °C for 10 min on a hot plate. Both Fe(II) and Fe(III) could be conveniently estimated sequentially from the same reaction mixture at the μg g^?1 to percentage level. The method is better than the existing wet chemical methods, including the commonly used Pratt's titrimetric redox method, for Fe(II) and Fe(III) determinations in rock and soil samples in terms of precision, accuracy and rapidity. The throughput of the method was very high; at least forty to fifty samples could be estimated easily in a day. The results obtained compare favourably with those obtained by Pratt's method, as well as for certified/recommended values of a set of eleven certified reference materials having FeO and Fe₂O₃ contents in the range 0.21–14.63% and 0.58–8.48%, respectively. The optimised 1,10 phenanthroline method was found to be accurate to within 0.21% m/m FeO and 0.30% m/m Fe₂O₃ compared with the literature values of the certified reference materials studied.     

一种基于实践九号卫星的快速系统误差补偿技术

直接利用光学遥感卫星的严格成像模型对地面点进行定位,定位误差与卫星姿态测量误差有关,其中包括地球自转引起的偏流角误差和姿态角常差。偏流角误差可以根据星历数据予以有效消除,而姿态角常差一般要利用少量控制点进行消除。基于此,在消除偏流角的影响下,这里采用了一种改进的四元数算法——P-H算法用于快速计算姿态角常差,并对系统误差进行补偿。该技术较常用的欧拉角解算,具有原理简单,计算速度快和结果稳定的特点。通过实践九号卫星影像的实验表明,运用该技术能快速和大幅度提高卫星在稀少控制点情况下的定位精度。     

混合表面活性剂存在下镓与O—Cl—PF显色反应的研究

本文研究了在pH 6.5-7.8的(CH_2)_6N_4-HCl缓冲介质中,CDMAA和TritonX-100对Ga与o-Cl-PF和F~-显色反应的增敏作用。结果表明,Ga-o-Cl-PF-F-CDMAA-TritonX-100多元配合物λ_(max)为565nm,表观摩尔吸光系数ε=1.74×10~5L·mol~(-1)·Cm~(-1),Ga含量在0～6.0μg/25ml范围内符合比尔定律,用合成样和标样进行本方法考验,结果满意。     

Calculation of partial melting equilibria in the system Na2O–CaO–K2O–FeO–MgO–Al2O3–SiO2–H2O (NCKFMASH)

A thermodynamic model for haplogranitic melts in the system Na₂O–CaO–K₂O–Al₂O₃–SiO₂–H₂O (NCKASH) is extended by the addition of FeO and MgO, with the data for the additional end‐members of the liquid incorporated in the Holland & Powell (1998) internally consistent thermodynamic dataset. The resulting dataset, with the software thermocalc , is then used to calculate melting relationships for metapelitic rock compositions. The main forms for this are P–T and T–X pseudosections calculated for particular rock compositions and composition ranges. The relationships in these full‐system pseudosections are controlled by the low‐variance equilibria in subsystems of NCKFMASH. In particular, the solidus relationships are controlled by the solidus relationships in NKASH, and the ferromagnesian mineral relationships are controlled by those in KFMASH. However, calculations in NCKFMASH allow the relationships between the common metapelitic minerals and silicate melt to be determined. In particular, the production of silicate melt and melt loss from such rocks allow observations to be made about the processes involved in producing granulite facies rocks, particularly relating to open‐system behaviour of rocks under high‐grade conditions.     

The impact of fragment “L” of comet SL-9 on Jupiter

Filtergrams of high spatial and temporal resolution were obtained in the methane band centred at 892 nm during the impact of fragment L of comet Shoemaker-Levy 9 on Jupiter. The light curve shows two maxima of an emission ball observed above the limb shortly after the impact. The second maximum was the brightest and had a short life time of about 90 seconds. During it's life, the apparent height of the emission ball declined towards the surface of Jupiter; the amount of displacement is larger than the expected effect caused by Jupiter's rotation. About half an hour after the impact, a domelike feature became visible when the location of the impact rotated into the illuminated hemisphere of Jupiter.     

Herbig-Haro objects—tracers of the formation of low-mass stars and sub-stellar objects

Herbig-Haro objects (HHOs) are caused by outflows from young objects. Since the outflow relies on mass accretion from a circumstellar disk, it indicates ongoing growth. Recent results of infrared observations yielded evidence for disks around brown dwarfs. This suggests that at least a certain fraction of brown dwarfs forms like stars. Thus, young sub-stellar objects might cause HHOs as well. We present selected results of a general survey for HHOs based on DSS-II plates and CCD images taken with the Tautenburg Schmidt telescope. Numerous young objects could be identified due to their association with newly detected HHOs. In some cases the luminosity is consistent with very low-mass stars or close to sub-stellar values. This holds for L1415-IRS and a few infrared sources embedded in other dark clouds (e.g., GF9, BHR111). The question on the minimum mass for outflow activity is addressed.     

An integrated linear/non-linear flow model for the conduit-fissure-pore media in the karst triple void aquifer system

Most karstic aquifer media may be characterized as the triple-void media with highly-varied hydraulic properties, including matrix pore, fissure and conduit, in which liner flow may co-exist with non-linear flow. In this paper, an attempt is made to couple linear flow with non-linear flow in a single unified flow governing equations by introducing the concept of equivalent hydraulic conductivity (EHC) and deriving a general Darcys law for various flow. The expression of EHC in the karst conduit and fissure are also derived. The procedures of numerical implementation are demonstrated via an ideal model and a case study of karst aquifer system in the Beishan Ore Formation area, Guangxi Autonomous Region, China.