Theoretical Analysis of A Buoyant Jet Interacting with Small Amplitude Waves

A new theoretical solution is presented here for the dynamic characteristics of a buoyant jet due to opposing small amplitude waves.The conservation equations of mass,tangential momentum and vertical momentum are solved by the integral method which encompasses the Gaussian profiles of velocity and density.The action of waves is incorporated into the equations of motion as an external force and a new exact solution is obtained to predict the trajectory,velocity distribution and boundary thickness of the buoyant jet over an arbitrary lateral cross section.It is found that the velocity along the centerline is inversely proportional to the ratio of the momentum of the wave to the buoyant jet.The averaged boundary width varies with the fluctuation of the boundary width,the distance from the orifice and the velocity correction function.Owing to the motion d waves,the fluctuation of the boundary width is proportional to the wave steepness.     

风场反演中距离圈上速度退模糊方法研究

在深入分析速度模糊的特点后,根据在距离圈上不模糊点到模糊点的不连续性,以及对模糊跳变处风速差和最大不模糊速度间关系的判定,从零方位开始在距离圈上逐点进行速度模糊的判定,并引入模糊标记的形式以确定退模糊处理的区间.然后通过实例分析,证明了方法的可用性和正确性.最后利用经过该方法处理的低仰角基本速度资料成功反演了雷达风场.     

Study on drilling mechanism and optimization of percussion-extruding DTH hammer bit

The authors tested the percussion-extruding Down-the-hole （DTH）hammer bit with five different structures and mainly analyzed the drilling mechanism between conical bit and stepped bit. In addition, aiming at ＂the pile effect＂ in combination with the advantage＇ of stepped bit, we design a new cam spinning bit and test it outdoors. The result shows that using cam spinning bit can solve the problem of ＂the pile effect＂, which can also obtain higher drilling efficiency than using conical bit in high confining pressure strata. It is characterized by novel structure and high drilling speed as well as good guiding, and it is significant for improving efficiency in percussion-extruding drilling technique.     

The effect of current and wave on whitecap coverage via relative speed： the Atlantic Ocean case

Whitecapping plays an important role in many air-sea exchange and upper ocean processes. Traditionally, whitecap coverage is parameterized as a function of wind speed only. At present, the relative speed of ocean current to wind is considered to be important in the air-sea exchange parameterization which is the function of wind speed only. In this paper, the effects of ocean surface velocity (current velocity and wave induced velocity) and the wave parameters on whitecap coverage through relative speeds are investigated, by applying a 2-parameter whitecap coverage model to the Atlantic Ocean. It is found that the impacts of both current and wave on whitecap coverage are considerable in the most part of the Atlantic Ocean. It is interesting that the effect of wave is more significant than that of current.     

多孔介质中天然气水合物注热开采影响因素实验研究

利用自制的一维天然气水合物开采模拟实验系统,模拟海洋地质条件,在填砂模型中生成天然气水合物,再注入热盐水进行注热开采的物理模拟实验,分析注热参数对水合物分解动态及注热开采能量效率的影响.分别设定注热水温度为60、80、100℃,注热水速度为12、15、18 mL/min,最长注热水时间220 min.结果表明:在相同的...     

昆承湖水流水质计算分析

在模拟昆承湖水流流场的基础上,模拟化学需氧量(CODMn)在湖水中的扩散情况;同时,利用昆承湖实测资料和水质的浓度场计算结果,得到其枯季环境容量.可以看出,昆承湖的流速较小,且方向由西北流向东南,可能是受长江径流和湖底西北高东南低的地形特征影响;从昆承湖的CODMn浓度实测值和计算值中,可以看出小于其水环境质量标准限值.这将进一步为实现常熟市湖泊水环境质量的不断提高、生态状况的持续改善与科学管理提供依据.     

丁字湾增殖中国对虾适宜量的研究

丁字湾位于山东省海阳、莱阳、即墨三市交界处,面积为１３０ｋｍ２。该海湾局封闭式内湾,不易受风浪影响,地势平坦,潮间带宽阔,水深较浅,最深处１０ｍ。湾内水质肥沃,营养丰富,中国对虾（Ｐｅｎａｅｕｓ　ｃｈｉｎｅｎｓｉｓ喜食的寻氏肌蛤、鸭嘴蛤资源丰厚。该湾春季有亲虾产卵繁殖,６,７月份有幼对虾分布,是进行对虾增殖的优良海湾。但因受饵料和空间等制约,放流数量并非可以无限增加,据１９８８～１９９２年对丁字湾中国对虾放流增殖适宜量的研究表明,随放流数量增加,对虾个体变小,生长减慢,自然死亡率上升。因此,放流…     

长江河口三角洲区有孔虫沉降速度试验

作者对有孔虫壳体沉降速度进行了测试和研究,提出了不同属种有孔虫的壳径与沉降速度相关方程,引进了“当量直径”的概念,并用于长江口三角洲地层中的化石群,提出了解释潮汐河口有孔虫埋葬群的形成机理,从而定量的研究和辨别三角洲地层中的原地埋葬和异地埋葬化石群。     

南中国海定常环流的一种模型

南海是我国沿海最大最深的海域，中外学者曾作过一些研究。徐锡祯等用动力计算方法研究了南海的水平环流，首次给出了整个南海海域四个季度各层次的平均密度流图(如图2A、2B均引其动力计算结果)。该文给出的500米层(即中层)的环流与表层基本一致，并说明了南海环流有着较大的深度，至少在800米层的深度上，环流运动依然清晰可见。其动力计算的速度零面选为1200分巴。     

2DVAR方法在台湾海峡海表流场融合中的应用

高频地波雷达可以提供沿岸大面积海表流的观测,但单个地波雷达只能提供径向流观测。本研究发展了一套二维变分(Two-Dimensional VARiational Method, 2DVAR)数据融合方法,将台湾海峡海域的地波雷达径向流数据与ROMS (Regional Ocean Model System)模式输出结果进行融合,得到一套较好的融合产品。结果显示,融合产品与雷达径向流的平均相对误差相较于模式输出与雷达径向流的平均相对误差由9.70%降低至1.54%。为进一步检验融合方法,设计了两种独立样本试验。试验一将雷达径向流按空间均匀划分为融合样本与独立样本,使用雷达融合样本与模式输出进行融合,此时融合结果的平均均方根误差(Root Mean Square Error, RMSE)相较于模式输出由0.41 m/s降低至0.19 m/s。试验二将雷达径向流和模式输出在空间上都均匀划分为融合样本与独立样本,对两种数据的融合样本进行融合,使用TC (Triple Collocation)方法估计模式输出、雷达观测与融合结果的误差方差,此时融合结果的平均误差方差最小,且其误差方差相对于独立的雷达径向流与模式输出在远岸处有明显减小。以上结果都表明融合数据更加接近实际海流,证明了2DVAR方法融合海表流的有效性。