颗粒破碎效应对堆石坝应力变形的影响

颗粒破碎对堆石体的变形有重大影响,颗粒破碎除与母岩强度有关外,与应力状态密切相关,高堆石坝堆石体的大部分变形正是高应力场下颗粒破碎的反映。沈珠江院士提出的南水双屈服面模型虽可以较全面地反映堆石体的变形特性,但未充分考虑颗粒破碎引起的剪缩特性,因此坝体变形计算结果往往偏小,适用于中低堆石坝的分析中。本文的计算方法在南水双屈服面模型的基础上,考虑了堆石体在一定应力状态下颗粒破碎引起的应变,较真实地反映了堆石体的变形特性,可为堆石坝尤其是高堆石坝的应力变形研究提供更为合理的结果。     

Storm event sediment fingerprinting for temporal and spatial sediment source tracing

Sediment fingerprinting has been widely used to distinguish discrete sediment sources; however, application to intra-storm sediment source variability has received relatively little focus despite the benefit being long recognized. In this investigation, sediment fingerprinting was applied to a 53-hr storm event sampled hourly to determine sediment source dynamics throughout the event. Sediment sources were differentiated using 16 variables, and source contribution determined using Bayesian and Frequentist mixing models for comparison. Both models provided comparable source predictions for the dominant source estimates and the general temporal pattern. The Frequentist model appeared to exhibit some unreliable values coinciding with low GOF and attributed to inherent model structure. The Bayesian model showed higher uncertainty, likely due to the “process error” utilized associated with single sample mixtures. High variability in sediment source contribution was observed between hourly time steps; however, local smoothing reveals temporal trends during the event. A higher average proportion of mudstone is found in the falling limb (0.544) compared with the rising limb (0.464), and the reverse is observed for mountain range (0.218 vs. 0.283) and unconsolidated (0.073 vs. 0.055). In the initial hours of the storm, mudstone source contribution significantly drops, whereas mountain range and unconsolidated contributions peak. The SSC-Q clockwise hysteresis indicates proximal sediment sources, suggesting the mudstone sediment is stored channel sediment and easily entrained. This sediment flushes through, coinciding with a drop as the distal mountain range and unconsolidated sources arrive to peak contribution. The wider Manawatū discharge and sediment load then arrive, delivering increasing levels of mudstone throughout the remainder of the event while mountain range sediment diminishes. Spatial representation of the sediment source contribution was derived from distributing sediment source loads to the spatial extent of the source material according to sub-catchment sediment loads and was weighted according to slope. This provided an effective means to visualize the origin of the sediment and a better spatial interpretation of sediment fingerprinting results, which is typically limited by poor spatial resolution.     

Modelling changes in suspended sediment from forest road surfaces in a coastal watershed of British Columbia

Erosion from logging road surfaces, cut slopes, banks, and ditches represents a chronic source of sediment input to streams that can degrade aquatic habitats. Road surface erosion is of particular concern because the magnitude of sediment generation when traffic levels are high can be large. Current models for predicting sediment production from roads require information on area‐specific sediment delivery, which is not often available. Here, we developed a model to quantify suspended sediment concentrations (SSC) generated by forest roads surfaces under different conditions of use and density. This model is designed for a typical medium‐size coastal watershed of British Columbia or the American Pacific Northwest, and was applied to the Chilliwack River watershed as a case study. The results illustrate that intensive use of forest roads combined with high road density can increase the number of extreme sedimentation events over a predetermined threshold. A comparison of the effects of road density and the level of road use suggests that the level of road use is more important than the road density for the generation of fine sediment from road surfaces. However, the model omits the impact of roads on mass movements in a watershed, which represent a major source of sediment in steep watersheds, so the effect of road density is likely more substantial than the model predicts. The model is an attempt to overcome field data limitations by using an empirical relation between SSC and traffic variables, and presents a starting point for more intensive field studies that could be used to validate it. Copyright © 2013 John Wiley & Sons, Ltd.     

The responses of hydrological processes and sediment yield to land‐use and climate change in the Be River Catchment,Vietnam

In this study, we investigated the responses of hydrology and sediment yield with impacts of land‐use and climate change scenarios in the Be River Catchment, using the Soil and Water Assessment Tool (SWAT) hydrological model. The calibration and validation results indicated that the SWAT model is a powerful tool for simulating the impact of environmental change on hydrology and sediment yield in this catchment. The hydrologic and sediment yield responses to land‐use and climate changes were simulated based on the calibrated model. The results indicated that a 16.3% decrease in forest land is likely to increase streamflow (0.2 to 0.4%), sediment load (1.8 to 3.0%), and surface runoff (SURQ) (4.8 to 10.7%) and to decrease groundwater discharge (GW_Q) (3.5 to 7.9%). Climate change in the catchment leads to decreases in streamflow (0.7 to 6.9%) and GW_Q (3.0 to 8.4%), increase in evapotranspiration (0.5 to 2.9%), and changes in SURQ (?5.3 to 2.3%) and sediment load (?5.3 to 4.4%). The combined impacts of land‐use and climate changes decrease streamflow (2.0 to 3.9%) and GW_Q (12.3 to 14.0%), increase evapotranspiration (0.7 to 2.8%), SURQ (8.2 to 12.4%), and sediment load (2.0 to 7.9%). In general, the separate impacts of climate and land‐use changes on streamflow, sediment load, and water balance components are offset each other. However, SURQ and some component of subsurface flow are more sensitive to land‐use change than to climate change. Furthermore, the results emphasized water scarcity during the dry season and increased soil erosion during the wet season. Copyright © 2012 John Wiley & Sons, Ltd.     

The effect of soil type,meteorological forcing and slope gradient on the simulation of internal erosion processes at the local scale

Numerical simulation experiments of water erosion at the local scale (20 × 5 m) using a process‐based model [Plot Soil Erosion Model_2D (PSEM_2D)] were carried out to test the effects of various environmental factors (soil type, meteorological forcing and slope gradient) on the runoff and erosion response and to determine the dominant processes that control the sediment yield at various slope lengths. The selected environmental factors corresponded to conditions for which the model had been fully tested beforehand. The use of a Green and Ampt model for infiltration explained the dominant role played by rainfall intensity in the runoff response. Sediment yield at the outlet of the simulated area was correlated positively with rainfall intensity and slope gradient, but was less sensitive to soil type. The relationship between sediment yield (soil loss per unit area) and slope length was greatly influenced by all environmental factors, but there was a general tendency towards higher sediment yield when the slope was longer. Contribution of rainfall erosion to gross erosion was dominant for all surfaces with slope lengths ranging from 4 to 20 m. The highest sediment yields corresponded to cases where flow erosion was activated. An increase in slope gradient resulted in flow detachment starting upstream. Sediment exported at the outlet of the simulated area came predominantly from the zone located near the outlet. The microrelief helped in the development of a rill network that controlled both the ratio between rainfall and flow erosion and the relationship between sediment yield and slope length. Copyright © 2010 John Wiley & Sons, Ltd.     

Responses of water yield and dissolved inorganic carbon export to forest recovery in the Houzhai karst basin,southwest China

Karst terrain (carbonate rocks) covers a vast land of 0.446 million km² in southwest China. Water yield and carbonate rocks weathering in this region have been receiving increased attention due to a large‐scale forest recovery. Using both hydrological measurements and forest inventories from 1986 to 2007 in the Houzhai karst basin (HKB), we analyzed the responses of water yield and dissolved inorganic carbon (DIC) export to forest recovery in southwest China. With implementation of both the Natural Forest Conservation Program (NFCP) and the Conversion of Farmland to Forests Program (CFFP), the fraction of forest area in HKB was increased from near zero to 18.9% during the study period, but the ratio of total water yield (surface and underground) to precipitation varied very little over the annual period, neither in wet season nor in dry season. By contrast, the concentration of DIC in water, especially in the surface water had a pronounced increase during the study period, with an increase of 0.53 and 0.25 g C m^?3 yr^?1 for surface water and underground water, respectively. As a result, total annual DIC export at mean annual rainfall significantly increased from the low to high forest area stage. This increase was largely driven by surface water during the wet season, presumably being related to biological activity. It was concluded that forest recovery in HKB had no significant effect on water yield, but resulted in more carbon dioxide (CO₂) dissolved in karst water accompanying with carbon uptake by forests. Our results suggested that implementations of both NFCP and CFFP had no shifted water yield regimes in southwest China; instead, they might have alleviated global climate change by increasing carbon uptake through combined biological processes and carbonate rocks weathering. Copyright © 2013 John Wiley & Sons, Ltd.     

A yield criterion for isotropic and cross‐anisotropic cohesive‐frictional materials

This paper proposes a yield and failure criterion for cohesive and frictional materials. The function is given by the combination of a Lode dependence for the behaviour in the deviatoric plane and a meridian function for the pressure‐dependent behaviour. A variety of shapes can be achieved with the proposed criterion including Lode dependences which are able to reproduce the behaviour of isotropic and cross‐anisotropic materials in the deviatoric plane. The criterion is validated through the comparison with experimental data based on multiaxial experimental tests on clays, sands, rocks and concrete. Finally, the convexity of the criterion is analysed and discussed. Copyright © 2009 John Wiley & Sons, Ltd.     

How did the suspended sediment load change in the North Caucasus during the Anthropocene?

Quantifying and understanding catchment sediment fluxes is crucial both from a scientific and environmental management perspective. To deepen the understanding of landuse impacts and climate change on sediment load, we explore factors controlling the suspended sediment load formation in the Northern Caucasus during the Anthropocene. We examine how sediment flux of various river basins with different land-use/landcover and glacier cover changes during the 1925–2018 period. Our analysis is based on observed mean annual suspended sediment discharges (SSD, kg s⁻¹) and annual fluxes (SSL, t year⁻¹) from 33 gauging stations of The Federal Service for Hydrometeorology and Environmental Monitoring (Russia). SSL series have been analysed to detect statistically significant changes during the 1925–2018 period. The occurrence of abrupt change points in SSD was investigated using cumulative sum (CUSUM) charts. We found that SSL has decreased by −1.17% per year on average at most gauges. However, the decline was not linear. Several transition years are expected in the region increasing trends from the 1950s and decreasing trends from 1988 to 1994. Correlation analyses showed that variation in SSL trend values is mainly explained by gauging station altitude, differences in landuse (i.e. the fraction of cropland), and catchment area. Nonetheless, more accurate quantifications of SSL trend values and more refined characterizations of the catchments regarding (historical) landuse, soil types/lithology, weather conditions, and topography may reveal other tendencies.     

Factors controlling specific sediment yield in the upper Indus River basin,northern Pakistan

Estimates of sediment yield are essential in water resources analysis, modelling and engineering, in investigations of continental denudation rates, and in studies of drainage basin response to changes in climate and land use. The availability of high resolution, global environmental datasets offers an opportunity to examine the relationships between specific sediment yield (SY_sp) and drainage basin attributes in a geographical information system (GIS) environment. This study examines SY_sp at 14 long‐term gauging stations within the upper Indus River basin. Twenty‐nine environmental variables were derived from global datasets, the majority with a 1 × 1 km resolution. The SY_sp ranges from 194 to 1302 t km^?2 yr^?1 for sub‐basins ranging from 567 to 212 447 km². The high degree of scatter in SY_sp is greatly reduced when the stations are divided into three groups: upper, glacierized sub‐basins; lower, monsoon sub‐basins; and the main Indus River. Percentage snow/ice cover (LC_s) emerges as the single major land cover control for SY_sp in the high mountainous upper Indus River basin. A regression model with percentage snow/ice cover (LC_s) as the single independent variable explains 73·4% of the variance in SY_sp for the whole Indus basin. A combination of percentage snow/ice cover (LC_s), relief and climate variables explains 98·5% of the variance for the upper, glacierized sub‐basins. For the lower monsoon region, a regression model with only mean annual precipitation (P) explains 99·4% of the variance. Along the main Indus River, a regression model including just basin relief (R) explains 92·4% of the variance in SY_sp. Based on the R²_adj and P‐value statistics, the variables used are capable of explaining the majority of variance in the upper Indus River basin. Copyright © 2007 John Wiley & Sons, Ltd.     

Assessing the vulnerability to soil erosion of the Ukai Dam catchments using remote sensing and GIS

Abstract

The investigation of basins for planning soil conservation requires a selective approach to identify smaller hydrological units, which would be suitable for more efficient and targeted conservation management programmes. One criterion, generally used to determine the vulnerability of catchments to erosion, is the sediment yield of a basin. In India, sediment yield data are generally not collected for smaller sub-catchments and it becomes difficult to identify the most vulnerable areas for erosion that can be treated on a priority basis. An index-based approach, based on the surface factors mainly responsible for soil erosion, is suggested in this study. These factors include soil type, vegetation, slope and various catchment properties such as drainage density, form factor, etc. The method is illustrated with a case study of sub-catchments immediately upstream of the Ukai Reservoir located on the River Tapi in Gujarat State, India. The area is divided into 16 watersheds and different soil, vegetation, topography and morphology-related parameters are estimated separately for each watershed. Satellite data are used to evaluate the soil and vegetation indices, while a GIS system is used to evaluate the topography and morphology-related indices. The integrated effect of all the parameters is evaluated to find different areas vulnerable to soil erosion. Two watersheds were identified as being most susceptible to soil erosion. Based on the integrated index, a priority rating of the watersheds for soil conservation planning is recommended.