3-D rheologic model of earthquake preparation (I)—Displacement field

Introduction The rock medium shows mainly elastic character under low-temperature, low-pressure and external force for short duration, yet it shows rheologic property under high-temperature, high-pressure and long-time external force. It is reasonable that the rapid earthquake generating process lasted for tens seconds is analyzed by the elastic theory. As for the earthquake generating process for hundreds or thousand years, nevertheless, the rheologic property of rock must be taken into accou…     

Modeling of Rayleigh waves dispersion in the Sannio region (Southern Italy) from seismic active refraction data

Short period surface waves, recorded during a seismic refractionsurvey in the Sannio region (Southern Italy), have been modeled to infera shallow velocity model for the area. Based on the decrease of resolutionwith depth, due to the bias on group velocity estimates arising frominterference of the Rayleigh waves with higher modes, we carried out aprocedure of fitting, with synthetic seismograms, of selected filtered traceswith a gaussian filter, having a width at half height equal to 1 Hz and acentral frequency lying in the range [1,4] Hz. We estimated the likelihoodbetween synthetic and observed seismograms by measuring their semblance.In this way we were able to infer a more refined local velocity modelcharacterized by a high Vp and Vs vertical gradient in the sedimentarycover. Two ad hoc resolution studies, based on group velocity andamplitude data respectively, indicate that the local velocity model is a goodvelocity model also for the entire studied area. The increase in the numberof available data when using amplitude information allows us to make amore selective choice in the model parameter space (Vp and Vs of eachlayer) and to solve for the Vp/Vs ratio. The inferred Vp velocity in thehalf-space is equal to 2.8 km/s. This value is in excellent agreement withthat inferred by other authors (3 km/s) by modeling P-wave travel timevs. distance. The best-fit model furnish low Vp/Vs for the sedimentarycover so indicating a high degree of the sediment's compaction in thestudied area. The inferred shallow high-velocity gradient indicates thatthe shallow sedimentary layer in the area could trap and focus the energytraveling into it.     

Tensor time domain electromagnetic resistivity measurements at Ngatamariki geothermal field, New Zealand

Experimental measurements in the Ngatamariki geothermal field, North Island, New Zealand were made to test the applicability of the time domain electromagnetic method for detailed investigation of the resistivity structure within a geothermal field. Low-frequency square wave signals were transmitted through three grounded bipole current sources sited about 8 km from the measurement lines. Despite high levels of electrical noise, transient electric field vectors could be determined reliably for times between 0.02 and 3.3 s after each step in the source current. Instantaneous apparent resistivity tensors were then calculated. Apparent resistivity pseudosections along the two measurement lines show smooth variations of resistivity from site to site. Over most of the field the images consistently show a three-layer resistivity structure with a conductive middle layer (3–10 Ωm) representing the conductive upper part of the thermal reservoir. A deep-seated region of low resistivity in the northwest of the field may indicate a conductive structure at about 1 km associated with a deeper diorite intrusion. Measurements sited closer than about 100 m to drillholes appear to have been disturbed by metallic casing in the holes. A change in resistivity structure in the east of the field may indicate a major geological or hydrothermal boundary.     

Regional Stress Field and Seismic Dynamics Along the Border Zone Between Fujian, Guangdong and Jiangxi Provinces

The regional stress field and seismic dynamics along the border zone between Fujian, Guangdong and Jiangxi Provinces are studied based on the seismo-geological data, GPS measurement, and seismicity. The results show that: (1) the principal compressional stress of the stress field is oriented in NW-SE direction and the principal extensional stress is in NE-SW direction; (2) the WNW-ward compression and collision of the Philippine Sea Plate to the eastern coast of Taiwan Island are the most direct and most important dynamic source for preparation and occurrence of strong earthquakes in the Taiwan area and along the border zone between Fujian, Guangdong and Jiangxi Provinces.     

Evaluation of predictors of non‐linear seismic demands using ‘fishbone’ models of SMRF buildings

Predictors (or estimates) of seismic structural demands that are less computationally time‐consuming than non‐linear dynamic analysis can be useful for structural performance assessment and for design. In this paper, we evaluate the bias and precision of predictors that make use of, at most, (i) elastic modal vibration properties of the given structure, (ii) the results of a non‐linear static pushover analysis of the structure, and (iii) elastic and inelastic single‐degree‐of‐freedom time‐history analyses for the specified ground motion record. The main predictor of interest is an extension of first‐mode elastic spectral acceleration that additionally takes into account both the second‐mode contribution to (elastic) structural response and the effects of inelasticity. This predictor is evaluated with respect to non‐linear dynamic analysis results for ‘fishbone’ models of steel moment‐resisting frame (SMRF) buildings. The relatively small number of degrees of freedom for each fishbone model allows us to consider several short‐to‐long period buildings and numerous near‐ and far‐field earthquake ground motions of interest in both Japan and the U.S. Before doing so, though, we verify that estimates of the bias and precision of the predictor obtained using fishbone models are effectively equivalent to those based on typical ‘full‐frame’ models of the same buildings. Copyright © 2003 John Wiley & Sons, Ltd.     

哈尔滨市磨盘山水利枢纽区三维渗流数值模拟模型研究

哈尔滨市磨盘山水库防渗型式拟采用垂直砼防渗墙及帷幕灌浆方案。为了分析左岸不同长度防渗对水库渗漏量及坝基渗透稳定性的影响。对磨盘山水利枢纽区渗流场进行了三维数值模拟研究。结果表明，随着左岸防渗长度的增大。渗漏量及下游渗流出口渗透比降基本呈线性趋势减小。当左岸防渗长度为200m时。渗漏量及各渗透比降均小于允许值，为推荐的渗控方案。     

Aseismic negative dislocation model and deformation analysis of crustal horizontal movement during 1999——2001 in the northeast margin of Qinghai-Xizang block

Through numerical simulation for GPS data, aseism/c negative dislocation model for crustal horizontal movement during 1999-2001 in the northeast margin of Qinghai-Xizang block is presented, combined with the spatial distri-bution of apparent strain field in this area, the characteristics of motion and deformation of active blocks and their boundary faults, together with the place and intensity of strain accumulation are analyzed. It is shown that: a) 9 active blocks appeared totally clockwise motion from eastward by north to eastward by south. Obvious sinistral strike-slip and NE-NEE relative compressive motion between the blocks separated by Qilianshan-Haiyuan fault zone was discovered; b) 20 fault segments (most of them showed compression) locked the relative motion between blocks to varying degrees, among the total, the mid-east segment of Qilianshan fault (containing the place where it meets Riyueshan-Lajishan fault) and the place where it meets Haiyuan fault and Zhuanglanghe fault, more favored accumulation of strain. Moreover, the region where Riyueshan-Lajishan fault meets north boundary of Qaidam block may have strain accumulation to some degree, c) Obtained magnitude of block velocities and locking of their boundaries were less than relevant results for observation in the period of 1993-1999.     

易门式大型铜矿床构造成矿动力学模型

针对金属矿床隐伏矿定位预测的关键问题,在提出构造成矿动力学的分支学术方向的基础上,以易门式大型铜矿床为例,从成矿地质背景、矿田构造、构造地球化学和成矿构造应力场等方面进行构造成矿动力学研究,阐述在构造应力场控制下成矿流体运移和聚集的规律。构造地球化学研究认为,构造地球化学异常反映矿体的原生晕;构造地球化学异常受构造控制,其分带特征可指示成矿流体的流向,并提供矿床成因和隐伏矿(化)体相对埋深的信息。构造应力场的控矿特征主要表现在:构造应力场导致控矿构造的形成,并驱动成矿流体的运移;构造应力场控制了成矿能量场;应力和能量的高值集中区分布特点可反映某些构造型式。在此基础上建立构造成矿动力学模型,概括隐伏矿成矿预测准则,据此提出若干重点找矿靶区和靶位,其中部分靶区得到工程验证,表明构造成矿动力学方法对隐伏矿定位预测和评价具有重要的指导意义。     

Recent ventifact development on the central Oregon coast,western USA

The unusual location of ventifacts, on a boulder‐built jetty at the mouth of the Siuslaw River, Oregon coast, western USA, allows ventifact age and wind abrasion rates to be estimated with some precision. The jetty was built mainly between 1892–1901 and extended throughout the twentieth century. Consideration of historical shoreline position and the history of jetty construction and repair suggests the ventifacts have formed since about 1930. Morphologically the ventifacts are aligned south‐to‐north reflecting winter winds and sediment transport from the adjacent beach. Wind‐parallel grooves and ridges with sharp, sinuous crests are developed on inclined boulder surfaces on top of the jetty and reflect suspended sand transport in wind vortices. Deeply pitted surfaces on steep boulder surfaces nearest the beach reflect impact by saltating sand grains. Based on present wind regimes (1992–2000) from three regional weather stations, southerly winds above the sand transport threshold occur for 21·9–29·6 per cent of the time. Based on estimated depth of loss from boulder surfaces, wind abrasion rates are calculated to be on the order of 0·24–1·63 mm a^?1. This is the first well‐constrained field estimate of ventifact age and ventifaction rate from a modern coastal environment. Copyright © 2003 John Wiley & Sons, Ltd.     

Simulation and measurement of surface shear stress over isolated and closely spaced transverse dunes in a wind tunnel

Topographic interactions generate multidirectional and unsteady air?ow that limits the application of velocity pro?le approaches for estimating sediment transport over dunes. Results are presented from a series of wind tunnel simulations using Irwin‐type surface‐mounted pressure sensors to measure shear stress variability directly at the surface over both isolated and closely spaced sharp‐crested model dunes. Findings complement existing theories on secondary air?ow effects on stoss transport dynamics and provide new information on the in?uence of lee‐side air?ow patterns on dune morphodynamics. For all speeds investigated, turbulent unsteadiness at the dune toe indicates a greater, more variable surface shear, despite a signi?cant drop in time‐averaged measurements of streamwise shear stress at this location. This effect is believed suf?cient to inhibit sediment deposition at the toe and may be responsible for documented intermittency in sand transport in the toe region. On the stoss slope, streamline compression and ?ow acceleration cause an increase in ?ow steadiness and shear stress to a maximum at the crest that is double that at the toe of the isolated dune and 60–70 per cent greater than at ?ow reattachment on the lower stoss of closely spaced dunes. Streamwise ?ow accelerations, rather than turbulence, have greater in?uence on stress generation on the stoss and this effect increases with stoss slope distance and with incident wind speed. Reversed ?ow within the separation cell generates signi?cant surface shear (30–40 per cent of maximum values) for both spacings. This supports ?eld studies that suggest reversed ?ow is competent enough to return sediment to the dune directly or in a de?ected direction. High variability in shear at reattachment indicates impact of a turbulent shear layer that, despite low values of time‐averaged streamwise stress in this region, would inhibit sediment accumulation. Downwind of reattachment, shear stress and ?ow steadiness increase within 6 h (h = dune height) of reattachment and approach upwind values by 25 h. A distance of at least 30 h is suggested for full boundary layer recovery, which is comparable to ?uvial estimates. The Irwin sensor used in this study provides a reliable means to measure skin friction force responsible for sand transport and its robust, simple, and cost‐effective design shows promise for validating these ?ndings in natural dune settings. Copyright © 2003 John Wiley & Sons, Ltd.