江苏岸外条子泥二分水滩脊的沉积特征

2000年1月16日在江苏岸外条子泥沙洲二分水滩脊选取三条断面，进行底质沉积物采样及滩面高程测量。共采集样品27个，对其用激光粒度仪进行粒度分析，发现沉积物的粒度参数、粒度组分及其分布均具有一定的变化规律，且与滩面高程变化具有很好的相关性。     

ECOM模式在丁字湾的应用

应用河口、陆架和海洋模式 (ECOM模型 ) ,引入干湿网格法模拟潮滩涨落的改进 ,并建立丁字湾及近岸海域的三维变动边界潮流模型。该模型考虑了湾口拦门沙、湾内水道和人工围海等地形特点。计算结果与实测值比较符合良好 ,较好地刻画出丁字湾 M2 分潮潮流场的时空分布特点。     

Two-Dimensional Mathematical Model of Tidal Current and Sediment for Oujiang Estnary and Wenzhou Bay

A 2-D mathematical model of tidal current and sediment has been developed for the Oujiang Estuary and the WenzhouBay. This model accomodates complicated features including multiple islands, existence of turbidity, and significant differ-ence in size distribution of bed material. The governing equations for non-uniform suspended load and bed load transport arepresented in a boundary-fitted orthogonal curvilinear coordinate system. The numerical solution procedures along with theirinitial conditions, boundary conditions, and movable boundary technique are presented. Strategies for computation of thecritical condition of deposition or erosion, sediment transport capacity, non-uniform bed load discharge, etc. are suggested.The model verification computation shows that, the tidal levels computed from the model are in good agreement with the fielddata at the 18 tidal gauge stations. The computed velocities and flow directions also agree well with the values measuredalong the totally 52 synchronously observed verticals distributed over 8 cross sections. The computed tidal water throughputsthrough the Huangda‘ao cross section are close to the measured data. And the computed values of bed deformation fromYangfushan to the estuary outfall and in the outer-sea area are in good agreement with the data observed from 1986 to 1992.The changes of tidal volumes through the estuary, velocities in different channels and the bed form due to the influence of thereclamation project on the Wenzhou shoal are predicted by means of this model.     

Investigation of the hydrate reservoir production under different depressurization modes

Abstract

Large reserves of natural gas hydrates exist, and the depressurization method has the greatest potential for gas hydrate reservoir recovery. Currently, the most commonly adopted depressurization simulation method is a constant bottom-hole pressure production scheme. This study proposes a new depressurization mode with decreasing bottom-hole pressure. The production characteristic was numerically investigated using this method. The results show the following: (1) As the depressurization exponent (n) decreases, the development effect improves, and production indexes including cumulative gas production/dissociation and gas-water ratio increase. However, the reservoir energy consumption is higher and the hydrate reformation is more severe. (2) Compared to the proposed depressurization mode, the hydrate production index of the constant bottom-hole pressure production (n?=?0) is better. However, the hydrate reservoir energy consumption is higher and the hydrate reformation is more severe using constant bottom-hole pressure production. (3) To achieve a balance between production and reservoir energy consumption during depressurization production, the bottom-hole pressure should be controlled by selecting a suitable depressurization exponent between n_min and n_max, which can be determined through numerical simulations.     

Sea-level fluctuations in a coastal lagoon

Sea-level observations made during December, 1979, at six stations in Great South Bay (which is a coastal lagoon on the south shore of Long Island, New York) reveal that there were significant subtidal fluctuations in addition to the tidal oscillations. Harmonic analysis of the tidal oscillations of sea level indicates that M₂ is the dominant tidal constituent. The M₂ amplitude, however, suffered a more than 50% reduction in the interior of the Bay due largely to the narrow inlet. The subtidal sea level fluctuations within the Bay were forced primarily by the low-frequency fluctuations of the adjacent shelf water. The active subtidal exchange induced by this Bay-shelf coupling appeared to have suffered only minor attenuation within the Bay. As a consequence, the variance associated with subtidal sea level fluctuations was greater than that associated with the tidal oscillations over most of Great South Bay.     

Implementation of High Resolution Tidal Current Fields in Electronic Navigational Chart Systems

A system for displaying tidal currents in an electronic chart display and information system (ECDIS) has been developed and implemented in compliance with the standards of the International Hydrographic Organization (IHO). The tidal current fields can be displayed in real time on the electronic navigational chart and several options and functions for updating and zooming have been designed. The current fields are calculated from a data base with the harmonic constants for the four major tidal constituents. The harmonic constants are obtained from a high resolution numerical model with horizontal grid resolution of 100 m. The model is validated by comparing with sea level and current measurements. The depth matrix for the central part of the model domain was calculated from data from multibeam bathymetric surveys. An application example of the implementation is given for Trondheimsleia, a part of the main sailing route along the western coast of Norway.     

Morphodynamics of intertidal bars on a megatidal beach, Merlimont, Northern France

The morphology, bedforms and hydrodynamics of Merlimont beach, in northern France, characterised by intertidal bars and a spring tidal range of 8.3 m, were surveyed over a 10-day experiment with variable wave conditions that included a 2-day storm with significant wave heights of up to 2.8 m. The beach exhibited two pronounced bar-trough systems located between the mean sea level and low neap tide level. Waves showed a cross-shore depth modulation, attaining maximum heights at high tide. The mean current was characterised dominantly by strong tide-induced longshore flows significantly reinforced by wind forcing during the storm, and by weaker, dominantly offshore, wave-induced flows. Vertical tidal water-level variations (tidal excursion rates) showed a bimodal distribution with a peak towards the mid-tide position and low rates near low and high water. The two bar-trough systems in the mid-tide zone remained stable in position during the experiment but showed significant local change. The absence of bar migration in spite of the relatively energetic context of this beach reflects high macro-scale bar morphological lag due to a combination of the large vertical tidal excursion rates in the mid-tide zone, the cross-shore wave structure, and the pronounced dual bar-trough system. The profile exhibited a highly variable pattern of local morphological change that showed poor correlation with wave energy levels and tidal excursion rates. Profile change reflected marked local morphodynamic feedback effects due mainly to breaks in slope associated with the bar-trough topography and with trough activity. Change was as important during low wave-energy conditions as during the storm. Strong flows in the entrenched troughs hindered cross-shore bar mobility while inducing longshore migration of medium-sized bedforms that contributed in generating short-term profile change. The large size and location of the two pronounced bars in the mid-tide zone of the beach are tentatively attributed respectively to the relatively high wave-energy levels affecting Merlimont beach, and to the cross-shore increase in wave height hinged on tidal modulation of water depths. These two large quasi-permanent bars probably originated as essentially breakpoint bars and are different from a small bar formed by swash and surf processes in the course of the experiment at the mean high water neap tide level, which is characterised by a certain degree of tidal stationarity and larger high-tide waves.     

Tidally incised valleys on tropical carbonate shelves: An example from the northern Great Barrier Reef, Australia

The formation of incised valleys on continental shelves is generally attributed to fluvial erosion under low sea level conditions. However, there are exceptions. A multibeam sonar survey at the northern end of Australia's Great Barrier Reef, adjacent to the southern edge of the Gulf of Papua, mapped a shelf valley system up to 220 m deep that extends for more than 90 km across the continental shelf. This is the deepest shelf valley yet found in the Great Barrier Reef and is well below the maximum depth of fluvial incision that could have occurred under a − 120 m, eustatic sea level low-stand, as what occurred on this margin during the last ice age. These valleys appear to have formed by a combination of reef growth and tidal current scour, probably in relation to a sea level at around 30–50 m below its present position.

Tidally incised depressions in the valley floor exhibit closed bathymetric contours at both ends. Valley floor sediments are mainly calcareous muddy, gravelly sand on the middle shelf, giving way to well-sorted, gravely sand containing a large relict fraction on the outer shelf. The valley extends between broad platform reefs and framework coral growth, which accumulated through the late Quaternary, coincides with tidal current scour to produce steep-sided (locally vertical) valley walls. The deepest segments of the valley were probably the sites of lakes during the last ice age, when Torres Strait formed an emergent land-bridge between Australia and Papua New Guinea. Numerical modeling predicts that the strongest tidal currents occur over the deepest, outer-shelf segment of the valley when sea level is about 40–50 m below its present position. These results are consistent with a Pleistocene age and relict origin of the valley.

Based on these observations, we propose a new conceptual model for the formation of tidally incised shelf valleys. Tidal erosion on meso- to macro-tidal, rimmed carbonate shelves is enhanced during sea level rise and fall when a tidal, hydraulic pressure gradient is established between the shelf-lagoon and the adjacent ocean basin. Tidal flows attain a maximum, and channel incision is greatest, when a large hydraulic pressure gradient coincides with small channel cross sections. Our tidal-incision model may explain the observation of other workers, that sediment is exported from the Great Barrier Reef shelf to the adjacent ocean basins during intermediate (rather than last glacial maximum) low-stand, sea level positions. The model may apply to other rimmed shelves, both modern and ancient.     

The dynamic behaviour of a river-dominated tidal inlet, River Murray, Australia

Australia's largest river, the River Murray, discharges to the southern ocean through a coastal lagoon and river-dominated tidal inlet. Increased water extractions upstream for irrigation have led to significantly reduced flows at the mouth and, as a result, the area is undergoing rapid change, particularly with regard to the rate at which sediment is being transported into the lagoon. Based on detailed and accurate bathymetric surveys it has been possible to estimate that the rate of lagoon in-filling is of the order of 100,000 m³ per year for the period June 2000 to May 2003, although the actual rate shows significant year to year variability. Dredging of the lagoon commenced in 2000 in an attempt to reverse the trend.In an effort to understand the behaviour of the inlet a one-dimensional numerical model of the inlet has been developed. The model extends the original of van de Kreeke by including a dynamic inlet throat area based on predicted river flows and a sediment transport module to predict the resulting net sediment transport. Comparisons with water level data collected on both the ocean and lagoon sides of the mouth have shown that the model is able to predict the attenuation and lag of the tidal signal reasonably well. The sediment transport model was based on predicted sediment concentrations in the surf zone and was found to predict the rate of sediment in-filling to an acceptable level of accuracy. It is envisaged that the model will be a useful management tool, especially since it is possible to manipulate river discharges to the mouth.     

Investigation on the Deposition in an Excavated Trough at the East Shore of Jiaozhou Bay, China

- Based on field investigations, this paper analyzes three types of harbour basinns and navigation channel excavated on seabed in Jiaozhou Bay, get a general rule of deposition for excavated trough, it found that pollution is one of crucial factors resulting in the deposition of the excavated trough in the east shore of Jiaozhou Bay. With these results, it predicted the annual deposition thickness for the excavated trough and disclosed the fact that it can't be deposited deadly during one storm. At the same time, with two-dimensional numerical model, it studied the effects of the excavated trough and the reclamation near shore on tidal cureent and said that the excavated trough can decrease the current velocity passing through the trough about 10- 15%, but only limited inside and near the trough and there are no effect on other regions; reclamation can cut off the pollution sources and no obvious effect on the currents of the Jiaozhou Bay. Connecting the deep trough and Cangkou tidal channel with a new