Influence of Structural Non-Stationarity of Surface Roughness on Morphological Characterization and Mechanical Deformation of Rock Joints

Summary Structural non-stationarity of surface roughness affects accurate morphological characterization as well as mechanical behaviour of rock joints at the laboratory scale using samples with a size below the stationarity threshold. In this paper, the effect of structural non-stationarity of surface roughness is investigated by studying the scale dependence of surface roughness and mechanical behaviour of rock joints. The results show that the structural non-stationarity mainly affects the accurate characterization of the surface roughness of the fracture samples. It also controls the amount and location of the contact areas during shear tests, which in turn affects the mechanical properties and asperity degradation of the samples. It is concluded that for accurate determination of the morphological and mechanical properties of rock joints at laboratory and field scales, samples with size equal to or larger than the stationarity threshold are required. Author’s address: Nader Fardin, Rock Mechanics Group, Department of Mining Engineering, Faculty of Engineering, University of Tehran, P.O. Box: 11365/4563, Tehran, Iran     

Implementing low-cost landslide risk reduction: a pilot study in unplanned housing areas of the Caribbean

Landslides pose a serious physical and environmental threat to vulnerable communities living in areas of unplanned housing on steep slopes in the Caribbean. Some of these communities have, in the past, had to be relocated, at costs of millions of dollars, because of major slides triggered by tropical storm rainfall. Even so, evidence shows that: (1) risk reduction is a marginal activity; (2) there has been minimal uptake of hazard maps and vulnerability assessments and (3) there is little on-the-ground delivery of construction for risk reduction. This article directly addresses these issues by developing a low-cost approach to the identification of the potential pore pressure changes that trigger such slides we seek to address these three commentaries directly. A complex 45–60° slope site in St Lucia, West Indies was selected as a pilot for a modelling approach that uses numerical models (FLAC and CHASM) to verify the need for surface water management to effectively reduce landslide risk. Following the model confirmation, a series of drains were designed and constructed at the site. Post-construction evidence indicates the methodology to be sound, in that the site was stable in subsequent 1-in-1 to 1-in-4 year rainfall events. A critical feature of the approach is that it is community-based from data acquisition through to community members participating in construction.     

舟山国家石油储备基地堆载预压加固效果分析

介绍了舟山国家石油储备基地试验区软基堆载预压大型现场试验结果,根据现场试验测得的数据,分析了软土地基堆载预压下沉降变化规律、分层沉降变化规律、深层土体位移变化规律、超静孔隙水压力变化规律,进一步探讨了根据应力和应变分析得到的地基固结性状,其中通过应变分析得到适用于储备基地的沉降经验系数m。结果表明,打设塑料排水板结合堆载预压处理软弱地基具有良好的效果。     

预防油页岩地层钻进中压差卡钻的措施

分析了油页岩地层钻进中压差卡钻发生的原因,提出了预防压差卡钻的途径及处理方法,并通过工程实例来强调预防为主的重要性。     

GYD-300型全液压动力头工程钻机的研制

GYD-300型全液压动力头工程钻机为全液压驱动,动力头反循环式机型。液压系统采用插装阀集成结构,电液复合操作。使用PC控制监测系统,适时检测孔底各相关压力,对不同地层进行范围设置,实现钻进过程中孔底的自动、手动恒压钻进。重点介绍了该钻机的结构特点、实验情况、主要技术参数等。     

饱和软黏土动力学特性循环扭剪试验研究

以饱和软黏土的循环扭剪试验研究为基础,阐明不固结不排水条件下饱和软黏土的动力学特性。在循环扭剪和循环三轴两种不同试验应力状态下,通过研究不同围压和不同静、动应力组合下饱和软黏土的应力等效破坏关系和应变等效破坏关系,提出在循环荷载作用下饱和软黏土的循环破坏同样遵循Mises屈服准则,且在Mises屈服准则下,饱和软黏土的循环强度趋于不变量。循环破坏的过程可以等效为一种拟静力弹塑性循环蠕变,建立了饱和软黏土循环累积变形随静荷载、循环荷载以及循环破坏振次之间的关系式。上述结论分别从应力和变形两个方面阐述饱和软黏土的动力学特性,与试验应力状态和围压无关,可以推广到一般应力状态下。     

岩石破坏前后曲线分类及脆-延转换围压研究——蚀变岩常规三轴压缩试验Ⅰ

蚀变岩是工程中少见的软弱岩类,在西南某重大水电工程中,蚀变岩处于工程的重要部位,为保证工程的长期稳定性,对蚀变岩力学特性进行了深入全面的试验研究.通过对孔隙度不同的饱水蚀变岩进行系统的常规三轴压缩试验和总结分析,提出了蚀变岩三轴压缩下破坏前应力.应变曲线可分为3大类,破坏后应力-应变曲线亦可分为3大类的形态模式.并得出结论:蚀变岩的破坏类型受围压与孔隙度的共同影响,在给定的12 MPa围压下蚀变岩以脆性破坏为主,只有孔隙度大于16%且围压大于4 MPa时才有可能进入脆-延转换状态,且脆-延转换围压随孔隙度增加而降低,临界状态应力比随孔隙度增大而增加.     

大黄鱼皮肤溃烂病病原的研究

从福建省厦门西海域某渔排养殖大黄鱼(Pseudosciaena cyogga)患皮肤溃烂病的肝脏、肌肉分离到2株优势菌。人工感染试验证实其中1株为致病菌。该菌的主要生理生化特性为革兰氏阴性，短杆状，极生单鞭毛，发酵葡萄糖，氧化酶阳性，赖氨酸脱羧酶、鸟氨酸脱羧酶阳性，精氨酸脱羧酶、水杨素、枸橼酸盐阴性，不产生H2S，利用葡萄糖、甘露醇产酸，对O／129(10μg)不敏感。在含0％，10％NaCl的普通培养基上不生长；在含2％，4％，6％，8％NaCl的普通培养基中生长；在温度30，35，40℃下生长良好，但4℃不生长。初步鉴定该病原菌为副溶血弧菌(Vibrio parahaemolyticus)。药敏试验表明，该菌对卡那霉素、复方新诺明、链霉素等10种药物敏感，对青霉素G、氨苄青霉素、利福平等6种药物不敏感。     

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.     

Centrifugal test of a road embankment built after new dredger fill on thick marine clay

Abstract

The construction of a 100-km road network is planned on a land reclamation area in the Oujiang Estuary in China. The embankment had a height of 4 m and a base width of 60 m. The reclamation area is newly filled by a 3-m dredger fill on a 48-m thick layer of marine clay. Estimation of the settlement of the future road network is difficult. To guide the construction of the road network, a 1/100-scale centrifuge model test was performed with a marine clay sample from the construction site to simulate the layered settlements and evaluate the drainage effect of prefabricated vertical drains in the dredger fill in the following 10 years. The results of the centrifuge modeling test are verified by 10-month in situ monitoring, which shows agreement between the centrifuge modeling test results and the in situ results. The test results indicate that additional time is needed to reinforce the newly added dredger fill by the surcharge preloading method to uplift the elevation of the reclamation area with dredger fill.