The importance of oxygen isotope provenance in relation to solute content of bulk meltwaters at Imersuaq Glacier,West Greenland

Stable oxygen isotope analysis and measurement of several dissolved cations and anions of bulk meltwater samples have provided information about the hydrochemical environment of the glacial hydrological system at Imersuaq Glacier, an outlet tongue from the Greenland ice‐sheet, West Greenland. The samples were collected at frequent intervals during the period 20–28 July 2000 in a small (<20 L s^?1) englacial meltwater outlet at the glacier margin. The results document the following findings: (i) a marked diurnal variation of δ¹⁸O is related to the composition of oxygen isotope provenances, mainly near‐marginal local superimposed ice and basal up‐sheared ice further up‐glacier; (ii) a relationship is seen between all base cations (Na⁺, K⁺, Ca²⁺, Mg²⁺), SO₄^2? and δ¹⁸O, indicating that solute acquisition is provided by solid–solution contact with the up‐sheared ice—as the relationship with Cl^? is weak the influence of seasalt‐derived solutes is small in the area; (iii) when the melt rate is high, two diurnal maxima of δ¹⁸O values and solute concentrations are measured, and it is suggested that a snow meltwater component is responsible for the second maximum of δ¹⁸O—a short residence time leads to a delayed decrease in ion concentrations. Copyright © 2003 John Wiley & Sons, Ltd.     

The Preboreal climate reversal and a subsequent solar‐forced climate shift

Accurate chronologies are essential for linking palaeoclimate archives. Carbon‐14 wiggle‐match dating was used to produce an accurate chronology for part of an early Holocene peat sequence from the Borchert (The Netherlands). Following the Younger Dryas–Preboreal transition, two climatic shifts could be inferred. Around 11 400 cal. yr BP the expansion of birch (Betula) forest was interrupted by a dry continental phase with dominantly open grassland vegetation, coeval with the PBO (Preboreal Oscillation), as observed in the GRIP ice core. At 11 250 cal. yr BP a sudden shift to a humid climate occurred. This second change appears to be contemporaneous with: (i) a sharp increase of atmospheric ¹⁴C; (ii) a temporary decline of atmospheric CO₂; and (iii) an increase in the GRIP ¹⁰Be flux. The close correspondence with excursions of cosmogenic nuclides points to a decline in solar activity, which may have forced the changes in climate and vegetation at around 11 250 cal. yr BP. Copyright © 2004 John Wiley & Sons, Ltd.     

The influence of macrophyte growth,typical of eutrophic conditions,on river flow velocities and turbulence production

The influence of emergent and submerged macrophytes on flow velocity and turbulence production is demonstrated in a 140 m reach of the River Blackwater in Farnborough, Hampshire, UK. Macrophyte growth occurs in patches and is dominated by Sparganium erectum and Sparganium emersum. In May 2001, patches of S. erectum were already established and occupied 18% of the channel area. The flow adjusted to these (predominantly lateral) patches by being channelled through a narrower cross‐section. The measured velocity profiles showed a logarithmic form, with deviations attributable to topographic control. The channel bed was the main source of turbulence. In September 2001, in‐stream macrophytes occupied 27% of the channel, and overhanging bank vegetation affected 32% of the area. Overall flow resistance, described by Manning's n, showed a threefold increase that could be attributed to the growth of S. emersum in the middle of the channel. Velocity profiles showed different characteristic forms depending on their position relative to plant stems and leaves. The overall velocity field had a three‐dimensional structure. Turbulence intensities were generally higher and turbulence profiles tended to mirror the velocity profiles. Evidence for the generation of coherent eddies was provided by ratios of the root mean square velocities. Spectral analysis identified deviations from the Kolmogorov ?5/3 power law and provided statistical evidence for a spectral short‐cut, indicative of additional turbulence production. This was most marked for the submerged vegetation and, in some instances, the overhanging bank vegetation. The long strap‐like leaves of S. emersum being aligned approximately parallel to the flow and the highly variable velocity field created by the patch arrangement of macrophytes suggest that the dominant mechanism for turbulence production is vortex shedding along shear zones. Wake production around individual stems of S. emersum close to the bed may also be important locally. Copyright © 2006 John Wiley & Sons, Ltd.     

Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)

Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.     

Sedimentary evolution of a Late Pleistocene temperate red algal reef (Coralligène) on Rhodes,Greece: correlation with global sea‐level fluctuations

Autochthonous red algal structures known as coralligène de plateau occur in the modern warm‐temperate Mediterranean Sea at water depths from 20 to 120 m, but fossil counterparts are not so well‐known. This study describes, from an uplifted coastal section at Plimiri on the island of Rhodes, a 450 m long by 10 m thick Late Pleistocene red algal reef (Coralligène Facies), interpreted as being a coralligène de plateau, and its associated deposits. The Coralligène Facies, constructed mainly by Lithophyllum and Titanoderma, sits unconformably upon the Plio‐Pleistocene Rhodes Formation and is overlain by a Maerl Facies (2 m), a Mixed Siliciclastic‐Carbonate Facies (0·2 m) and an Aeolian Sand Facies (2·5 m). The three calcareous facies, of Heterozoan character, are correlated with established members in the Lindos Acropolis Formation in the north of the island, while the aeolian facies is assigned to the new Plimiri Aeolianite Formation. The palaeoenvironmental and genetic‐stratigraphic interpretations of these mixed siliciclastic‐carbonate temperate water deposits involved consideration of certain characteristics associated with siliciclastic shelf and tropical carbonate shelf models, such as vertical grain‐size trends and the stratigraphic position of zooxanthellate coral growths. Integration of these results with electron spin resonance dates of bivalve shells indicates that the Coralligène Facies was deposited during Marine Isotope Stage 6 to 5e transgressive event (ca 135 to 120 ka), in water depths of 20 to 50 m, and the overlying Maerl Facies was deposited during regression from Marine Isotope Stage 5e to 5d (ca 120 to 110 ka), at water depths of 25 to 40 m. The capping Aeolian Sand Facies, involving dual terrestrial subunits, is interpreted as having formed during each of the glacial intervals Marine Isotope Stages 4 (71 to 59 ka) and 2 (24 to 12 ka), with soil formation during the subsequent interglacial periods of Marine Isotope Stages 3 and 1, respectively. Accumulation rates of about 0·7 mm year^?1 are estimated for the Coralligène Facies and minimum accumulation rates of 0·2 mm year^?1 are estimated for the Maerl Facies. The existence of older red algal reefs in the Plimiri region during at least Marine Isotope Stages 7 (245 to 186 ka) and 9 (339 to 303 ka) is inferred from the occurrence of reworked coralligène‐type lithoclasts in the basal part of the section and from the electron spin resonance ages of transported bivalve shells.     

Techniques to measure grain-size distributions of loamy sediments: a comparative study of ten instruments for wet analysis

Ten instruments for measuring the grain‐size distribution of loamy sediments in water were tested in a comparative study. Instruments tested were: the Malvern Mastersizer S, the Coulter LS 200, the Fritsch Analysette 22 (version C), the Horiba Partica LA‐950, the Sedigraph 5100, the Atterberg cylinder, the Coulter Multisizer 3, the CIS‐100, the EyeTech and the image analysis software Histolab. The first four instruments use laser diffraction. The Sedigraph and Atterberg cylinder are based on sedimentation. The Coulter Multisizer 3 uses impedance measurements and the last three instruments use optical techniques. Grain‐size analyses were carried out on four sediments with median grain diameters of approximately 35, 30, 12 and 9 μm, respectively, and with no particles >90 μm. The laser diffraction instruments produced the best results for the various criteria considered in this study, followed by the Coulter Multisizer 3 (electrical sensing zone technique), the sedimentation techniques and the optical methods. However, the study also showed that there is no such thing as an ‘ideal’ method because techniques may score differently according to the criterion tested. An appropriate evaluation thus requires that various criteria be considered. Issues to be taken into account are: type of sediment, quantity of sediment available, speed of measurement, complexity of the measurement protocol, processing of the data, reproducibility of the results and the specific aims of the study undertaken.     

Anthropogenic affects on lake sedimentation process: a case study from Lake Sapanca, NW Turkey

Lake Sapanca in NW Turkey is a fault originated freshwater basin fed by seasonally variable flows of 15 streams. Considerations of lake–river interaction, supported by statistical measures of 47 bottom samples, suggest that sediment transport and deposition within the lake is controlled by two types of human constructed structures in addition to natural factors: (1) the dykes constructed in the front of streams, which feed the lake by strong flows, to prevent the filling of lakebed by coarse-grained sediments; (2) the constructed regulator on the outflowing Çarksuyu stream results in a higher sedimentation rate of clay-sized material on the NE corner of the lake, which is extraordinary in the shelf environment.     

冲绳海槽中段沉积岩芯碳酸盐和烧失量的古环境意义

对冲绳海槽中段 3个沉积岩芯碳酸盐和烧失量的系统分析得知 ,岩芯沉积物的CaCO3含量一般 >1 0 % ,最高含量接近 30 % ,烧失量大都在 1 0 %～ 30 %之间变化 ,反映了该海区处于溶跃面之上钙质生物极为发育的生物地球化学环境。结合δ1 8O曲线所反映的气候环境变化 ,探讨了 1 2 0kaB .P .以来碳酸盐旋回的“大西洋型”演变特点 ,同时对该区沉积地层中的火山热液活动印记作了一定的探讨。     

Siltation Prediction for Navigation Channels and Harbour Basins on Muddy Beach

- This paper, after briefly reviewing the experimental research on sediment transport on muddy beach since the 1950s, improves and perfects the method for forecasting siltation in navigation channels and harbour basins which was first put forward in China by the authors. In consideration of silty sediment and sand, some factors in forecasting methods have been changed and modified. Consequently, the modified methods can be used either to compute siltation in navigation channels and harbour basins on muddy beach or to compute siltation and scouring in navigation channels and harbour basins on both silty beach and sandy beach. The verification of field data from eleven large, medium and small natural harbours shows a good agreement between the forecasting by the modified method and the natural conditions. Finally, the paper deals with the rational utilization of water area after the construction of the West Dyke in Lianyungang, the maintenance of water depth of the navigation channel at the entrance, siltation distribution, siltation in the navigation channel and harbour basin for ships of 100 thousand tonnnage. Results once again prove that the prospect of constructing Lianyungang Harbour into a deepwater harbour is bright.     

纳米碳酸钙材料的工业合成与应用

该文对目前工业上生产纳米碳酸钙的方法作了较为详细的综述。对一步碳化法、两步碳化法、多段喷雾碳化法、旋转填充床碳化反应器碳化技术制备链形、纺锤形、球形、立方形等不同形状的纳米碳酸钙材料的方法进行了比较和总结