A Review About SAR Technique for Shallow Water Bathymetry Surveys

Synthetic Aperture Radar(SAR)has become one of the important tools for shallow water bathymetry surveys.This has significant economic efficiency compared with the traditional bathymetry surveys.Numerical models have been developed to simulate shallow water bathymetry SAR images.Inversion of these models makes it possible to assess the water depths from SAR images.In this paper,these numerical models of SAR technique are reviewed,and examples are illustrated including in the coastal areas of China.Some issues about SAR technique available and the research orientation in future are also discussed.     

舰载浅水激光测深系统研究

本文提出了近海浅水区域水深测量的激光双频相位法测量方案，采用声光调制1064nm和532nm光波分别测量水面和水底距离。在实验室进行了该系统的模拟实验，证实了该方案的可行性。     

采用重力异常的导纳理论推估海底地形

系统探讨了采用重力异常的导纳理论推估海底地形的方法。在频率域内对海底地形和重力异常的相关性进行了分析,确定在20~300 km波段内两者相关系数最高,适合通过重力异常反演。以皇帝海山链为例,分别采用未补偿导纳模型和顾及挠曲补偿的导纳模型开展研究,其中涉及的地壳厚度和有效弹性厚度等参数通过均衡响应函数法得到。引入余弦低通滤波器,有效地解决了向下延拓过程中产生的高频震荡问题。算例结果表明,采用重力异常的导纳理论能够有效地反演海底地形,结果真实可靠,反演模型的相对精度在6%左右,与ETOPO1模型相当,且能够刻画出ETOPO1模型中未显现的地形细节。由于地形变化剧烈,反演模型在海山链沿线附近精度不甚理想。     

Hydrologic and geoenvironmental characterization of wetlands in quarries of the Vinalopó Mitjà (Alicante, Spain)

This paper deals with the environmental characterization of the “Collao de Candela” enclave (Alicante, SE Spain), which in the early 1980s reported strong mining activity mainly due to the extraction of marls. The subsequent abandonment of such quarries produces floods in depressed areas that are constituted as pools. These anthropogenic wetlands are the object of this research. In order to characterize the geometry of the studied wetlands a bathymetry was carried out. Bathymetric data are very important for water managers tasked with assessing wetlands’ status. A chemical and mineralogical characterization has been carried out on the lithologies in the study area. A study was also conducted of the physical and chemical parameters of the waters contained in these pools during one hydrologic cycle. The climate of the zone, having elevated evapotranspiration measurements, favors a progressive concentration of salts in the pools consequence of runoff water washing, the evaporitic sediments as well as from elevated evaporation. The results obtained justify the environmental protection of these marl-gypsum mining quarries as potential wetlands.     

大面阵CCD影像多通道不一致性消除算法

大面阵CCD多通道影像转移过程中,由于通道硬件的偏置和增益的不一致,将造成各通道影像的亮度和反差的微小差异,以致重建后的大面阵CCD影像出现条带效应。提出基于随机序列分析的模拟运动影像拼接算法,并将这种方法与基于影像直方图均衡化和影像直方图规定化的影像拼接算法进行比较。实验证明,基于随机序列分析的模拟运动影像拼接算法不仅能保持拼接后的影像整体一致性,而且能较好的消除拼接缝。该算法已经应用于我国第一台大面阵彩色CCD数字航测相机的影像预处理。     

The topographic data source of digital terrain models as a key element in the accuracy of hydraulic flood modelling

The effects of the topographic data source and resolution on the hydraulic modelling of floods were analysed. Seven digital terrain models (DTMs) were generated from three different altimetric sources: a global positioning system (GPS) survey and bathymetry; high‐resolution laser altimetry data LiDAR (light detection and ranging); and vectorial cartography (1:5000). Hydraulic results were obtained, using the HEC‐RAS one‐dimensional model, for all seven DTMs. The importance of the DTM's accuracy on the hydraulic modelling results was analysed within three different hydraulic contexts: (1) the discharge and water surface elevation results from the hydraulic model; (2) the delineation of the flooded area; and (3) the relative sensitivity of the hydraulic model to changes in the Manning's n roughness coefficient. The contour‐based DTM was the least accurate with a root mean square error (RMSE) of 4·5 m in the determination of the water level and a variation of up to 50 per cent in the estimation of the inundated area of the floodplain. The GPS‐based DTM produced more realistic water surface elevation results and variations of up to 8 per cent in terms of the flooded area. The laser‐based model's RMSE for water level was 0·3 m, with the flooded area varying by less than 1 per cent. The LiDAR data also showed the greatest sensitivity to changes in the Manning's roughness coefficient. An analysis of the effect of mesh resolution indicated an influence on the delineation of the flooded area with variations of up to 7·3 per cent. In addition to determining the accuracy of the hydraulic modelling results produced from each DTM, an analysis of the time–cost ratio of each topographic data source illustrates that airborne laser scanning is a cost‐effective means of developing a DTM of sufficient accuracy, especially over large areas. Copyright © 2006 John Wiley & Sons, Ltd.     

A bathymetric overview of the Mariana forearc

Bathymetric data at a 200-m contour interval for the entire Mariana forearc, from south of 13°N to 25°N, permits the first comprehensive overview of this feature. The Mariana forearc represents a sediment-starved end-member. The forearc in its southern and central sections is divisible into a structurally complex eastern province and a less-deformed western province. Despite the absence of an accretionary complex the Mariana forearc has a well-defined outer-arc high; this probably results from a greater concentration of low-density serpentinized mantle lithosphere beneath the outer forearc relative to the inner forearc. This serpentinization gradient is coupled with differing deformational styles of thinner and more brittle lithosphere beneath the outer forearc compared to thicker and more ductile lithosphere beneath the inner forearc. The bathymetric data also support models calling for extension along-strike of the forearc, reflecting an increase in arc length accompanying the crescent-shaped opening of the Mariana Trough back-arc basin. Both northeast and northwest ridges and grabens can be identified, with the latter restricted to the southern part of the forearc and the former widely distributed in the central and northern forearc. Northeast-oriented extensional structures are supplanted northward by long, linear northwest-trending structures that are interpreted as left-lateral strike–slip faults. These variations in deformation along-strike of the forearc manifest a transition from nearly orthogonal convergence in the south to highly oblique convergence in the north.     

Enregistrement de la dernière remontée du niveau marin dans l'architecture interne d'une vallée incisée : le pertuis Breton (Charente-Maritime)

Recent very high-resolution seismic profiles ground-truthed by vibrocores allow us to evidence an atypical incised valley fill in a drowned valley segment, the ‘Pertuis Breton’ (Bay of Biscay, France). The sedimentary valley-fill architecture mainly includes five superimposed progradational wedges composed by marine sands. Sandbodies show a landward migration of their depocentres upward and are topped by almost flat unconformities extended by submarine terraces. This sedimentary infill pattern is similar to backstepping wedges, described on continental shelfs. It suggests that this valley fill records sea-level rise during the last transgression. To cite this article: N. Weber et al., C. R. Geoscience 336 (2004).     

Évolution temporelle et architecture interne d'un banc sableux estuarien : la Longe de Boyard (littoral atlantique,France)

The evolution and the internal architecture of an estuary type sand ridge has been studied with a set of bathymetric data recorded during the last two centuries and with a dense grid of recent very high resolution seismic profiles. Bathymetric data of the so-called, Longe de Boyard sand ridge, displays sand losts due to wave and tide erosion. Internal geometry, through seismic profile analysis, indicates two main phases of deposition recording both, a recent high energy environment and an older low energy one, respectively. Such an evolution is believed to record changes in sedimentation processes mainly related to the end of the Holocene transgression (8 000–5 000 yr BP). To cite this article: É. Chaumillon et al., C. R. Geoscience 334 (2002) 119–126.